Having problems with your 267856 prolex steam mop ?

Reservoir tank broken

Where can I get spare tank

Answers :

Repair Help & Product Troubleshooting for 267856 prolex steam mop

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Hoover SteamVac Model F6056-900 SteamVac/SpinScrub. Indicator light and high pitch suction noise indicates that dirty water tank is full. However, water level indicator (yellow bobbing plastic thing) is at the bottom of the tank and there is no water in the tank. Have check all the hoses for clogs, none found. Checked water port from motor area to receptacle tank for clogs, none found. Fixed broken hose to upholstery wand with duck tape, (wire not broken, just cracked plastic hose). The onl


There are 2 filters, make sure they are clean, one is on the tank lid, the other is from the bottom, it is red, pull it out and clean it. If yours has a foam filter on the tank lid covering the yellow ball, make sure there is at least a 1/4 in. gap ... Hoover Vacuums

The clip that secures the Solution/Clean water tank on my Bissell Little Green Model #1720-W is broken so that the tank does not stay in place on the machine


... Bissell 1720-1 Little Green Wet/Dry Vacuum

My Delonghi DSS50 steam floor cleaner water reservoir has a broken valve on the bottom where it fits into the steam unit. It leaks water rather than producing steam. I would like to find the valve and replace it or buy a new water reservoir with the valve in it. I cannot find the part I need. Can you help me?


... DeLonghi DSS50 Scopa Upright Steam Vacuum

I own a vaporetinni steam cleaner[PGEU0001]and have broken the water tank. Where and how can I obtain a replacement water tank HR Williams


... Vacuums

I have a Bissell Little Green Scruber Model #1720-W that has a broken clip which secures the solution/clean water tank to the front of the machine. Where can I purchase the clip to repair this machine


... Vacuums

Leaky reservoir tank


For low suction, check that the flapper on top of the recovery tank hasn't lost its foam rubber gasket. If that's gone, you will get zero suction. If that's in place and the motor is running, you likely have a split in the hose. A service center c ... Bissell SpotBot Robotic Wet/Dry Vacuum

Broken water tank on steam vac duel w/rinse #f7205-910


If this is a Hoover, you can go to thehooverstore.com and order what you need. But you will need your model number. You will have to replace the tank. ... Vacuums

Broken water tank for prolex steam mop item 267856 can I get a replacement


... Vacuums

Cleaning solution tank dumping


Maverick_bea may be describing a different model than mine... but on my Steam Vac, remove the clean water tank... and locate the black rubber gromet seal. JUST BEHIND the gromet is an opening that allows you to see the trigger actuator. Inspect that ... Hoover F5906-900 Upright Steam Vacuum

We have a Bissell Powerwash 1690 with a broken "Latch assy dirty (bottom) tank. Bissell state a replacement part is no longer available. Does anyone out there have a spare or one off a defunct powerw


Sorry, we no longer have this part available for this unit. If you are interested in a new deep cleaner you can use one of these coupon codes currently to get $10 off a machine up to $99.99, or $20 off a machine priced $100 or more. The codes are S ... Bissell Vacuums

Solution seals The seals on the bottom of the solution tank are broken. I need to get a replacement as well as a breakdown on how to put alll these parts back together????


Please use the following link:\015\012http://www.hoover.com/parts/?category=carpetcleanertanks&part=42272134\015\ ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

Rubber ring in tank broken - Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum


... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

There is a broken part between the tank and the handle on mine.


I have the same problem and we are on our third head as they do not sell the round gasket by itself. ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

My Shark 3501 has a broken handle above the resevoir. Called Euro pro and stayed on hold for 25 min with no answer. I am looking for a handle from top down to tank. Can you help?


Hi,No, you need to call them... check the manuals link...Here is a tip that I wrote about the Euro-Pro Shark Steam Mop and why it maynot be getting steam to the head... ... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

Broken hose The hose on my Hoover F5837-900 Steam vac Supreme broke away from the coupler on the bottom of the unit - under/behind the recovery tank (solution tube is till attached). It might have gotten pinched in there a couple times. Problem - it was glued in the coupler really well, and I cannot get the whole thing out - hose will be too short anyway - is there a way to fix this or a part I can order instead??


You will have to replace the complete hose asm, part # 90001337 ... Hoover F5837-900 SteamVac Supreme Wet/Dry Vacuum

Royal procision 7910 water from clean tank fills soap reservoir until it is overflowing through vent hole diluting soap completely


... Royal Vacuums

Hoover floormate handle release pedal broken. Need diy repair information.


... Hoover Vacuums

Bissell ProHeat 2x Upright Carpet cleaner-water tank valve


Www.usavacuum.com/category-s/387.htmYou can find the parts you need here ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

I need a small tube that runs from the water reservoir to the pump


Go to the hardware store with the old hose. They have several sizes and can cut to length for about a dollar. If you want it to last go to auto parts store and get rubber fuel hose. ... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

Hoover steam vac hose broken so I get no suction.


The entire hose has to be replaced. I beliive they run about 39.99 ... Hoover F5872-900 SteamVac Wet/Dry Vacuum

Leaking tank After I put the water in the tank and put the tank in its spot, water leaks from the bottom of the tank. Also from the detergent tank.


(1) Does water or chemical leak from the tank when filled, but before it is installed? If not, then the tank is OK.\015\012(2) If the tank is not properly aligned to the lower handle when assembled and latched, the black rubber seals on the ha ... Hoover Steam Vac Dual V w/ SpinScrub Vacuum

I have a Bissell Proheat 2XTurbo carpet cleaner. No water will come out when I squeeze the trigger. I have filled the solution tank and the water tank. I read the troubleshooting in the manual and have tried turning it off for a minute and restarting and nothing. I took out both tanks and reseated them and nothing. It has sat for over a year but did not have any water in the water tank. Some solution was left in the solution tank. How can I make the water come out? HELP!


Call BISSELL Consumer Services.\015\0121-800-237-7691\015\012Mon-Fri: 8am to 10pm ET\015\012Sat: 9am to 8pm ET ... Bissell ProHeat Turbo Deep Cleaner Upright Steam Vacuum

Scooba 5800 "check tank" light always goes on. - I have checked tank. I have cleanout brushes, tank; rinsed, sloshed, dumped. The check tank light comes back on when I want to clean. What should I do now? Pat


... iRobot 5800 Scooba Vacuum

I have a hoover F5915-900. Today when I got it our to use it I noticed that it was leaking. I did some troubleshooting, but not sure where to go from here. The solution tank leaks out if the recovery tank is connected also. If I remove the recovery tank and leave the solution tank on it does not leak. Any suggestions would be appreciated.


It dont shamppoo my carpet dont come out or **** it up the hose for funture workes good no sham pooer for rugs ... Hoover F5915910 Upright Steam Cleaner

How do I fix Bissell Quicksteamer leaking from water tank through wheels? After I place the filled Clean/Solution tank on the Lower body of the QuickSteamer, water pours out from the body of the machine through the wheels even before I turn the power switch on. I checked the tank and there are no holes in the plastic tank.


I have the same problem... seems to be because of a bad, or worn, rubber gasket. ... Bissell Vacuums
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0253 seconds