Having problems with your Vacuums ?

How to replace the vacuum cleaner hose

\015 Hi: I bought a replacement hose for our vacuum cleaner, and it is a bare hose with three wires on each end. \302\240I cannot figure out how to disconnect the old hose from the plastic tubing parts that the hose goes into (and then which plug into the vacuum itself, and the wand, on the other end.) \302\240I have read of some ''tabs'' that engage the spirals of the hose, but where these tabs can be released is not obvious from looking at the plastic end pieces.\015\012\015\012Thanks for any help. \302\240Ken\015

Answers :

Repair Help & Product Troubleshooting for Vacuums

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

How to replace the vacuum cleaner hose


... Vacuums

How to replace just the Kirby 210097 Hose End For G5 Series Vacuum Cleaner to hose. can buy replacement but can not get the broken end off


Simple and rquires no tools. Fill your sink with hot water and set the end in water with attachment on it. Within a few minutes the end is soft enough to slip out. setting the hose end in the water again will let you simply slip the hose into the ... Kirby G5 Bagged Upright Vacuum

Replacing wheel Hoover spirit vacuumm - Hoover Spirit Canister Vacuum Cleaner Non Electric Hose Canister Vac Cleaner Non Electric Hose


... Hoover Spirit Canister Vacuum Cleaner Non Electric Hose Canister Vac Cleaner Non Electric Hose

I have a power drive baggless vacuum cleaner...it runs well, but suddenly it seems to have lost most of the suction coming through the hose and floor area. When I remove the dirt container, the suction below it seems strong. I have had it to repair twice--they have tuned it up and replaced all filters and belt. It still does not pick up well when I vacuum or use the hose. Can you help ?


There is something stopping it up,you will have to dissasemble the unit to find the blockage,this is the most likely problem. ... Hoover U6660-900 WindTunnel Bagless Upright Vacuum

Replace an external hose to a D07 vacuum cleaner


Remove the handle from the body of the unit slide the handle all the way out there is a small button on the plastic coller press it in and pull the handle free lay the hose on the floor and at the base of the hose there is a hook put one finger unde ... Dyson DC14 All floors Bagless Upright Cyclonic Vacuum

I have a Miele Vacuum cleaner MedicAir 5000 Plus. Recently the Dust Bag Indicator bar is full during normal cleaning and consequently the suction power is much less. I replaced the dust bag, engine pre-filter and Hepa filter but no change. When i remove the hose, the Indicator is normal, but when i attach the hose, wand, head, the indicator is full. I checked the hose, wand, head but can't see any blockage and when i blow with my mouth it seems fine. Can anybody help? thanks!


... Miele Vacuums

I have a Sears Upright vacuum cleaner, model 116.35922500. The vacuum wasn't picking up. I discovered a clog in the nozzle hose. I attempted to remove the cover of the brush unit to clear the clog. I was unable to remove the cover completely, but was able to clear the clog. My problem now is that I cannot replace the cover correctly. Is there a way to remove this cover? Thanks, Elizabeth


When you tried to remove the cover did you have to put a little force on it to get to the clog ... Vacuums

I have a kenmore vacuum cleaner model # 116.23612. When the hose is attached to the canister it runs, but if you remove the head to just use the hose the unit stops working. Is the motor dead or is there some type of reset or fuse. Could you please tell me how to test this. If so could you please send me instructions on how to replace the motor. Thank you in advance for your help, Tony


... Kenmore Vacuums

Kenmore Model 116 28014700 intuition vacuum cleaner. Latch for hose connection to cannister broke. I have the new part. How do I remove the hose from the broken part and replace it on the new part? Thanks


Hi\015\012\015\012To remove the broken part from the latch use a small screwdriver to release the tabs on the latch on the connector. When latches are released the latch assembly and the plate will slide out of the connector. When the pla ... Kenmore Vacuums

I replaced the motor in my 6500SR Epic vacuum cleaner. Now I have 3 clear plastic hoses for air flow. I know where two of them go, Im not sure where the third air hose goes? Jan


All three are connected to the control valve assembly.\015\012The long one goes through the hole in the bag container and to the door and inside.\015\012One goes to the bottom of the bag container.\015\012The last one goes to...I ca ... Electrolux Vacuums

Kenmore Model 116 28014700 intuition vacuum cleaner. Latch for hose connection to cannister broke. I have the new part. How do I remove the hose from the broken part and replace it on the new part? I have already purchaed the new part p/n KC92PDDUZV06 for this, bt can't figure out how to get the old part off. It looks like you must destroy old part in order to get it off.


... Vacuums

I have a electrolux oxy3 system vacuum cleaner. The floor is damaged, and the hose has been damaged and severed and the copper cables have been cut...so I need to purchase a replacement foot and hose/hand piece. regards Sandy


... Electrolux Vacuums

Where do u get replacement hose for vacuum cleaner


Contact Eureka directly to order a replacenent hose or find a vacuum cleaner repair facility. You may be able to get a replacement hose right away ... Eureka Smartvac 4870 Bagged Upright Vacuum

I have a vacuum cleaner model Z5245 and the flexible hose keeps sucking together and stopping suction. This is the bit with the stop start controls on it. How do I repair this or replace it?


If theres a clog, then youll have to remove the entire section of hose from the vacuum and use a non blunt stick - bamboo sticks are excellent for this purpose. Stretch the whole hose out and put the stick down the hose until you can wriggle the stic ... Vacuums

Bissell vacuum cleaner model 5770 lower hose replacement


... Bissell 5770 Healthy Home Bagless Upright Cyclonic Vacuum

I have an old Panasonic vacuum cleaner, model MC-E871, and I need a replacement hose. Where can I find one?


... Panasonic Canister Vacuum Cleaner With On Board Attachments Q19923

Vacuum Philips vision Plus Squeal from seal joinining hose to cleaner. Are there replacement seals available/ How do I order one? [email protected]


Yes there are replacement seals available. check www.trademe.co.nz ...if you dont get some there contact me for further assistance.Hope this solution has been helpful? ... Vacuums

SANYO SC-U123 I need to replace the hose on the backside of the vacuum cleaner,


... Sanyo Permax SC-U125 Bagged Upright Vacuum

How do I replace the hose on the kenmore canister vacuum cleaner


... Kenmore 22085 Bagged Canister Vacuum

Hello, I have a Hoover quadraflex Powermatic central vacuum system Model # s8099-031 that requires a new replacement 35 ft hose...I have contacted Hoover and they do not know where to buy a replacement hose for this model. I live in Canada. Any idea where I can get a replacement hose for this system? Thanks kindly, Tammy


Tammy, no info re your location, so I''l try this.Your Hoover hose is shot because it was made of rubber.There are new swivel handled, tangle proof lighter hoses made of vinyl which will last much longer and can be adapted to the old Hoover hea ... Vacuums

My bissell proheat upright steam cleaner is spraying out through the attachments just fine, but will not spray to the floor when using upright. we've taken it apart to find that there is no water at all going through one of the hoses, but it appears the hose is connected behind the on/off and heat switches, we can't seem to figure out how to get in there to replace that hose....any suggestions on how to access this?? just curious how you would get in to replace the hose, we know it is the hose..


Hi,Here is a tip that will give you all the information you need to fix your BissellProheat Vacuum Problem.Bissell Proheat Upright Wet/ ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

I have a Model 116.35922500 Kenmore upright vacuum cleaner. It makes a loud air noise when using the vacuum. I have disconnected and removed the hose to see if anything is lodged in the hose and it appears clear. It makes the noise when the hose is connected. When I remove it, the noise stops. When I place my hand over the hose, the nose re appears. I sounds as though the noise is coming from the fan or internal parts of the machine. So, when there is a load or pull on the machine, it mak


... Kenmore Progressive 35922 Bagged Upright Vacuum

Hi. Bought a M3888-3 Royalcylinder vacuum from Lidl. Lost manual that came with it. Only had it 4 mths. Need new hose. Plastic hose has snapped near whereit attaches to metal hose. Can I get a replacement hose from somewhere in U.K.? I know the vacuum is from Germany.


... Royal Vacuums

The last time the vacuum cleaner was used the outlet sparked causing it to smoke when turning on vacuum cleaner. I replaced the outlet and plugged it in and things seemed o.k. Today I turned on the vacuum, it stayed on for a mili second and went off. I checked the switch on the vacuum and it showed voltage coming and going, but would not turn on again. I checked all the wires in the area of the switch all seemed o.k. I thought maybe there might be a short in the cord. When I went to plug


... Sharp Twin Energy EC-12TWT4 Bagged Upright Vacuum

I'm using a Eureka maxima 12 amp vacuum and where the hose is connected to the vacuum by a screw that part is broken where do I find a replacement hose that includes the clear plastic part that I can attatch to the vacuum?


... Eureka 4700A Maxima Bagless Upright Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.1167 seconds