Having problems with your Vacuums ?

Stopped working new item given as a gift, used once, in the middle of cleaning then died. Did as manual stated for over heating, empty canister, clean all filters and allow to cool for an hour. Left over night, tried the next day but does'nt work???? What can i do???

Answers :

Repair Help & Product Troubleshooting for Vacuums

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Stopped working new item given as a gift, used once, in the middle of cleaning then died. Did as manual stated for over heating, empty canister, clean all filters and allow to cool for an hour. Left over night, tried the next day but does'nt work???? What can i do???

... Vacuums

My dyson animal just cuts out mid vacuming ,the motor gets quiet hot ,and wont start again for an hour or so when i expect the motor cools down .all filters cleaned no blockages etc.. any suggestions?????

This is a feature so that the motor does not burn up check all tubes ... Vacuums

I have an electrolux twin clean cyclonic vacuum cleaner (blue) that turned itself off. I've waited over half an hour an turned it back on. All that happens is the red filter light and the power flash. I have cleaned all filters and replaced them. The vacuum is only 5 months old.

... Electrolux Vacuums

Today i was hoovering, and then my dyson just cut out! i left it a few hours then went back to it, it gave a little noise when i switched it on, then again i tried but it failed to come on! ive even changed the fuse in the plug! and now my dyson wont turn on at all, ive cleaned everything there is too clean! help! :D

It looks like you need a professional repair. If you're really lucky this may just be a break in the flex, or the switch has failed - both relatively cheap and simple to sort out. More likely, though, is a problem with the motor (carbon brushes worn ... Dyson DC07 Bagless Upright Cyclonic Vacuum

Ive changed the filter and checked the hoses but vacuum doesnt pick up ...when its on the dust is being blown out the bottom of the vacuum....i took the canister off to test the suction its fine...also cleaned the filter ...help!

Have you check the roller brush and drive belt? It may be your belt has broke or is slipping and therefore not turning the brush.\015\012Turn on machine and power head see if brush is turning if it is put a small amount of pressure on the rol ... Kenmore Vacuums

Dyson dc7 quits after a few minutes running; runs again after an hour or two of rest. Filters are clean, beater bar is clean, can't tell about the airways because I can't see how to get to them.

Check the ducts with a small object(screw or something with a little weight)down the ducts to verify they are clean. Also check the Ubend on the back bottom of the unit. Looks just like a U. Remove with a turn of the tab by a screwdriver or quarter ... Vacuums

Overheated vacuum After I finished vacuuming the library last night I changed the bag and shook out both filters and vacuum would not restart. The canister unit felt real warm to the touch but I had been using it a least 1/2 hour non stop. The bag was pretty full but not overly so. It's a Simplicity canister with power head. The carpet is long shag from the 70's Did it just over heat? Thanks Shauna

It normally won't over heat unless the bag is too full, the filters are clogged, or you have have a clog in the hose or down by the brush roll, the inlet may be clogged. Some will restart after a while, some others have a reset to push. If it won't ... Simplicity 7850 Premier Bagged Canister Vacuum

I have a Swan Petmaster 1800w Hepa Filtration hoover s/r no SU3021 and cant find my instruction manuel. Problem is when on hoover it doesnt seem to be sucking anything up?? I have cleaned the cylinder and filters. Is it something to do with the bit that you can use to clear stairs/car etc and not converting back to an upright hoover again? Please help Julie

... Vacuums

I recently purchased a Hoover SteamVac to replace an old one because the brushes would not turn. I used it last week and then tried to use it last night and the same thing happened w/ the brand new model - the brushes won't. I've cleaned the brushed, the filter and everything else I can see. Can you help?

Those things are a waste of money you better off renting one. but the only thing i could think of is that something is stuck or your belt came off track ... Hoover Steam Vac Dual V w/ SpinScrub Vacuum

I have a DC17 which is only one year old. Today I lost suction and called for assistance. A Dyson technician told me to pull off the wand and see if it is clear. It was clogged so cleared out the obstruction. My filter was cleaned more than 24 hours ago. The vacuum still has no suction. Is it dead, any other suggestions. Please help.

Take the hoses off and give them a good shaking.\012or get a long piece of stiff wire and gently poke through the obstruction. ... Dyson DC17 Animal Bagless Upright Cyclonic Vacuum

My Fuller Brush FB90T Bagged Upright Vacuum shutdown during vacuuming. I allowed it to cool off for a 24 hours but it will now no longer restart. Is there a reset function?

Check if there is debri at the bottom behind the roller where the dust gets sucked in. There is a reset button in this area. Press it with a needle or pen tip. Hold it for about 5 seconds.There is a overburn protection if their is obstruction ... Fuller Brush FB90T Bagged Upright Vacuum

My Miele White Star Model # S3141 was running fine, then stopped mid-vacuuming. I changed the bag and cleaned the filters (which were dirty), let it cool off, and tried to start it up again, but no luck. What do I do now? Are there any repair places in Ft. Myers, FL?? Thank you for your help.

... Miele Vacuums

My bissell carpet cleaner does not spray water even though the water compartment is full and the filter has been cleaned out. Any idea what I should try before having to take it 2 hours out of town for servicing? Thanks for any help

Hi,Here is a tip that will give you all the information you need to fix your BissellProheat Vacuum Problem.Bissell Proheat Upright Wet/ ... Bissell 7920 ProHeat Pro-Tech Upright Wet/Dry Vacuum

Sharp uv219cs will shutdown until it cools. cleaned all filters and now it will not turn on.

If it shutsdown until it is cooled off, then either you have a clog in the hose or the dirt inlet by the brushroll, or a problem with the motor or motor protector. The motor protector will open when it gets too hot, it saves the motor from burning o ... Sharp Vacuums


Hello,Carnister vacuum cleaners are all built with the same \015\012principle in mind. A motor \015\012generates power which powers a vacuum which, in turn, creates suction to\015\012 lift debris. The most common areas of suction loss are ... Hoover S5615 Hush Central System Vacuum

My indesit is70cs is blowing out cold air instead of hot it is taking hours to dry the clothes. I have cleaned all filters and the water container does not need emptying ????

Could be element heater or thermostat/ likely thermostat......cut out ... Vacuums

I have a hoover Core vacuum. The problem is that the blue light flashes (as normal) when it is plugged in and the power is turned on and the blue light stays on (as normal) when you turn it on at the button but it makes no noise and doesnt work. All of the filters are clean. Can you help please?

... Hoover Vacuums

I have an old hoover turbopower approx 1986 i think its a U1102, the prob is it doesnt pick up anymore and i wondered if it had some sort of filter on it, ive cleaned all the tubes put new bag on but its still got weak suction, could you make any suggestions, thanks

Theres a tube that come up and emty's into the bag that tube is clogged.take the bag out and get a coat hanger and put a bend in it so the end is round then work it down the tube to push out the clog ... Vacuums

Eurika Whirlwind vacuum cleaner. Nearly new. Suddenly lost succion.l I cleaned and dried the filter. It developed an odor, then stopped short. I believe the motor may be burned out. Motor is cool, but it won't start. Is there a fuse??t

Look around the nozzle it might have a reset switch ... Eureka WhirlWind Litespeed 5844 Upright Vacuum

My jm3 1500w super lightweight cleaner simply just cut out last night, only had it a couple of months, changed fuse and still not working, filter was already cleaned out,pipesare not blocked either.HELP

... Vacuums

Vn2200 xe filter still cleans itself but vacuum motor doesnt go

... Vacuums

My hoover vacuum runs for about 10-15 minutes then the saftey feature shuts it off(overheat?). i have taking it apart a cleaned it with no results, added new bag also. after an hour it cools down and works again. do i just need a new vacuum?

Do you have suction through the tools? Does it look like it picks up when it runs? The machine could be clogged and that would cause the problem, but unfortunately the sensor that shuts the machine off could be bad if the machine isnt clogged. Its no ... Hoover Ultra U6430-900 WindTunnel Bagged Upright Vacuum

Max Extract cleaner stopped sucking up water! Stopped working within an hour of purchasing it! I've taken the dirty water tank apart, cleaned both filters, and it still will not draw the water out of the carpet.

Try returning it to the place of purchase. ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

Replacing filter Got a Filter Queen Majestic vacuum from my inlaws when they moved overseas. I am in middle of vacuuming, got a weird noise, so opted to check and clean the filter for first time. UGH. The lower 'pot' that's the bottom part of the thing was full of gunk, but the filter pristine clean against the cone that's attached to the upper part of the unit. In other words, I am shocked to see that the dirt goes not INTO the filter, but outside of it into the bottom portion (that I call the

Its normal operation so don't worry ... Filter Queen Majestic Canister Vacuum

I have a nearly 9 year old Electrolux Excellio Z5228 vacuum cleaner. It has recently started cutting out during operation. I cleaned the micro filter (between bag & motor) via brush & hitting against wall & seems / looks quite clean. I washed the gore filter (output from motor to clean the exhaust air) as per instructions, then let to dry. It was very clogged but now very clean. The vacuum clearner still cuts out often. Even after a long rest (say overnight) it still won't start, then ano

... Electrolux Vacuums
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0850 seconds