Having problems with your Vacuums ?

My pacer 112 eu is not turning on? I check all conections and they are getting jucie.Can you help.


Answers :

Unplug and turn motor by hand a few times then plug back in and try it again.if it don't work sounds like the motor is bad.if it comes on after turning by hand then the motor is going out
Repair Help & Product Troubleshooting for Vacuums

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

My pacer 112 eu is not turning on? I check all conections and they are getting jucie.Can you help.


Unplug and turn motor by hand a few times then plug back in and try it again.if it don't work sounds like the motor is bad.if it comes on after turning by hand then the motor is going out ... Vacuums

Help i can get suction from the hose but when i stick it in the back of the carpet head i get no suction and the beater bar will not turn. can you help


... Miele S184 Powerhouse Bagged Upright Vacuum

I have a Eureka Upright vacuum (4800 Series). When I try to start it by turning the switch on, it wont. For few days, I was able to get around this problem by repeatedly turning the switch on and off until it turned on but that does not work any more. Could it be something related to the switch it self or the power cable. My wife mentioned that one of my kids might have pulled the power cable too hard (at the back of the vacuum). Any help to solve this problem will be very much appreciated. Tha


... Eureka Smartvac 4870 Bagged Upright Vacuum

Hoover 2000W dust manager cyclone- Have had this for about 2 months and the brushes stopped turning thinking that the belt had acme off turned it over to try to get in to look at belt now the bottom wheels have came off and will not go back on have not lost any bits literally just undid one screw! Please help!


... Hoover Vacuums

I have to go into the garage to turn on the motor on the tank and to shut it off. When I plug the hoses into the outlets in the house, it doesn't turn on the tank motor. I don't know what part to get and nobody in Raleigh, NC shops can help me.


Is this Electrolux that's now known as Aerus? If so, take it in to the Aerus Electrolux store for a tech to look at. You can find the nearest Aerus Electrolux store by following the instructions on the site at bottom of page.\015\012\01 ... Electrolux Central Vacuum

SEBO Sensors Where are the SEBO X4 sensors, I have taken this apart and not too sure where the sensors are. In particular I get Replace Roller coming up, but roller seems fine and it goes round ok if I disconnect the PCB. My unit turns on spins for 10 seconds and then brings on light C. Just replaced the motor on it about 4 months ago so not too keen to get a new one. Any help welcome.


... Sebo X4 Bagged Upright Vacuum

Need to open rotating brush part of vacumm as motor functioning but roller not turning...perhaps belt broken put need to get into ..inside brush box ...Need help need instruction with diagrams Thanks for help Robert


... Panasonic MC-V9638 Bagged Canister Vacuum

I have an Electrolux Silverado deluxe canister vacuum that won't run. It was running fine, I turned it off to move the plug and then it won't turn back on. It is getting power to the switch. Any help?


... Electrolux Vacuums

I have a Dirt Devil Vision self-propelled vacuum cleaner. Recently, the self-propelled feature is stuck in the backward mode, so it only goes backwards! I can get it to go forward if I push really hard (i guess it is good for a workout!). I try to turn off the propel feature completely, but it will not turn off. please help!


Hi, the problem you are having is going to be with the switch that controls the forwards and backwards settings so with this stuck in backwards their is no way you can get this turned off, the other problem is your not going to be able to replace thi ... Dirt Devil Vision Turbo W/Bonus Upright Vacuum Vacuum

I had a shoelace get stuck in the beater bar. I turned it off, tipped it over and untangled the shoelace from the beater bar. When I plugged it back in the vacuum ran but the beater bar was not turning and there wasn't any suction. Is there a reset switch for the beater bar? Thank you for your help, Janet


Hi Janet. there is a small reset button on the outside of the head next to the brush that you can push to get it to start spinning again. ... Dyson Ball DC24 Bagless Upright Vacuum

My bissell brush band has come off and wont stay on thus the brush will not turn, there is also a black arm type thing on a spring inside (on both sides) on the pump belt side it has broken - the side where the brush belt is, help im searching for parts and a way to fix it but im getting no joy, incidentley the brush belt thickness looks way to thick for the small thickness for the brush belt cog (?) to stay on........am i missing something? so i need to get the arm thing replaced plus find a


... Bissell ProHeat Deep Cleaner Upright Vacuum

Burning smell how do I get the bottom section apart to clean it out- burning smell when i have the spin brushes turned on. Any help would be appreciated cause I love this machine and hubby told me it couldn't be taken apart to be fixed. Thank you.


The bottom doesn't come apart. you have to remove the top cover to get to any components. But if you have a burning smell, then it is probably ther motor and would have to be replaced. Motors cost anywhere from $70 to $90. ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

I'm not getting a water/soap flow out of the steam cleaner when I turn it on. Even the power shot piece isn't squirting out. Can you help?


... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

My shop vac blows dust as soon as it's turned on and throughout use. I have changed filters, nothing is helping. What part of my vac can not get wet, or is there a better way to clean out the system?


There should be a cover or sock over the filter,this will stop the dust.the paper filter is the part that can not get wet. if you don't have a cover for your filter use an old sock or something simular to a sock. ... Shop Vac 584-04-00 Quiet Canister Wet/Dry Vacuum

Protection light the protection light on our electrolux 2100 comes on every 45 seconds and the vacuum will just stop and I have to turn off for about 1 minute to get it going again and off again after 45 sec. Please help


It might be the bag or the sensor inside the machine. ... Electrolux UltraLux 2000 Bagged Canister Vacuum

Brush will not turn, have taken off cover and cleaned helped one time before but not this time, is there a belt and how do you get to it


Yes there is a belt. I believe there is a clutch of some type and it is tricky to remove. I would recvommend going to the local vacuum store that sell and services used vac's and get them to help you they are expierienced in these machines.Other wise ... Dyson DC15 All Floors - The Ball Bagless Upright Cyclonic Vacuum

I have Bissell Model 1699-R Proheat carpet steam cleaner one of the tubings that connects into spray got mixed with some tubings during tubing replacment to the point that tubing that is conected into flow indicator cap does not turn at all to show if the chemical is sprying or not.i am looking mainly for tubing water/chemical diagram in order to verify the right connection.please help if you can bissell user. thanks


... Vacuums

Beater bar won't turn. Assume the belt is off or broken but can't see how to get to it. Help!


If the machine is still under warranty, you'll want to take it to an authorized service center for repair. If not, it can be pretty tricky to take the power head apart, replace the belt, and get it put back together correctly. I still recommend tak ... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum

Dyson dc07 The rotating brush on the bottom of my vacuum was filled with strings. I removed the brush by undoing all yellow plastic screws from plate. Removed all strings and replaced as best I could and it was hard to get the brush back in and the belt around it. I dont have my manual but it fits so it should be correct....? Right? No, not true, because when I turn it on and try to and vacuum (by lower canister with foot release) it makes that terrible ratching sound). Please help


The loud ratching is a warning to tell you that there is something stopping the roller bar from rotating this is a very common thing lay the machine on the floor front side down take off the bottom plate and just check the belt is in the centre of th ... Dyson DC07 Bagless Upright Cyclonic Vacuum

Help the roller isn't turning and I want to know how to get if off also to change the belt.  I don't have the manual, the kids stored it somewhere


With a Kenmore Canister, on the power head, there are usually 2 screws on the bottom of the unit. You must remove both screws and unlatch the top cover; first from the back by the swivel and secondly on both sides of the power head. Changing the bel ... Kenmore 25512/ 25513 Progressive Canister Vacuum

A friend used my Bissell Proheat Clearview shampooer, and didn't wash out the shamppoo bottle nor turn the dial to water only after using. The flow assembly on the bottle was destroyed. I bought a new bottle but still can't get the shampoo to flow. Hope you can help.


Pls model no ... Bissell Vacuums

Bissell powerforce My lower pickup tube became clogged so I removed it and cleaned it out and reinstalled it.Now everything runs good but the vaccum want pick up any dirt .I replaced the bag andf when I turn it on it just exhaust air but does not have any suction,I tired tp pull the bag door of while it was running whick I could not do so it has plenty of suction inside just not getting any outside can you help?


... Bissell Vacuums

When I plug in my vaccum the power light turns on, but i get no power to the machine??? I changed bags and filters and still nothing??? Can you help?


That light wire is attached to part of the wiring that is just a piece attached to the main wire coming from the switch. Your bags and filters have nothing to do with powering the machine. You may have a bad switch or there may be a ground wire off ... Vacuums

Your reply I received your reply of "Unplug the unit or turn off the circuit breaker. How is this going to help me trouble shoot what is wrong with my unit? Was there more to your message that I did not get?


... Broan-NuTone CV450 Central Bagged Central System Vacuum

I have a new Bissel # 3760 and I can't get the brush to turn on.. help


You may need a new drive belt. You can get the belt you need and view the manual here:Bissell Lift-Off Revolution Belt and ... Bissell Lift-Off(R) Revolution(R) Turbo Upright Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0889 seconds