Having problems with your Vacuums ?

I need to know where the different vacum lines connect

\015 I need a diagram of the vacum lines on a 1985 ?Ford F350 6 cyclinder 4.9\015

Answers :

Your on the wrong site ,this is for vacuum cleaners and i don't think ford makes one
Repair Help & Product Troubleshooting for Vacuums

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I need to know where the different vacum lines connect


Your on the wrong site ,this is for vacuum cleaners and i don't think ford makes one ... Vacuums

I have my vacume electrical cord tangled inside and disconnected (I can see the open end of the connection from the power cord collector wheel! I need to take the vacume apart so get access to the wire inside. I need to know if there is something else to open other than the 4 screws. Your help is highly appreciated in advance.


Since you did not provide a model number for your vacuum, it is difficult to provide any precise directions regarding disassembly.\015\012\015\012However, most vacuum cleaners are fairly straightforward machines, and as long as you unplug ... Vacuums

I have a Craftman 5hp snowthrower model 53688501 that will not start. It will fire with gas down sparkplug hole, but runs only untill that gas is burned up. Fuel is present at carb, but I noticed that there are two brass fittings on each side of the carb for vacume lines or something, and they have no lines connected to them. Did I lose the lines that should be connected? Or do I have some other problem. The unit is 4 years old and has the Briggs and Stratton eng model 9A413-0202-E1


This sounds like the carburetor needs disassembled and cleaned. This happens over time and the tiny orifices plug up. Usually from letting gas set in them for extended periods of time and it gums up. If you are not familiar with them, I would take ... Craftsman Vacuums

Need instructions how to use Hoover Steam Vac Spin Scrub. I borrowed it from my Sister and she left it with no instruction book or letting me know how to operate it. I put water & cleaner in top tank. That's all I know to do. Do I put any water in bottom tank? I figured not, since that is probably where the water goes when sucked up by vac. Do I leave lid on bottom tank? I usually use a commercial cleaner, and this is very different. I need to know NOW, as I must return it to her today, and I'm


I did have a solution in just a few minutes. Someone responded with a solution that gave me the website where I could go and print the manual in pdf, so did that, and checking instructions I was able to clean my carpets and get the shampooer back to ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

Owner/user manual Before my sister died she gave me the little grren machine model 1425 turbo brush with heat. That is all I know about it as she did not find the manual and now no one knows where it is and I really want to get it working and learn about it, as I know she loved it. so I really need a manual. thank any one that can tell me if it is on line or something.


Http://www.bissell.com/images/UserGuides/1400_206.pdf ... Bissell 1425 Little Green ProHeat Handheld Steam Vacuum

I have a model 2016S chain saw and need to know how the fuel lines are hooked up from the fuel tank to the primer bulb and to the carburetor. does the filler line in the fuel tank go directly to the carburetor or does it go to the primer bulb and then to the carb?


Tank filter goes to the primer bulb and then to the carb. ... McCulloch MC1275 Steam Vacuum

1992 4.0L explorer need diagram for vacume line


Here is the link from where you can download your diagram\015\012\015\012http://www.pdfoo.com/resultpage10~1992-ford-explore ... Vacuums

Need diagram to attach pump assembly for my bissel proheat 2x model 73a5. have two lines I do not know where they go


Hi,\015\012\015\012Go to below website \015\012\015\012http://newzealand.bissell.com/i ... Vacuums

I would like to know where i can get a manual for the bissel 3760-4 model. i bought this used and i would like a book on parts i might need down the line. thank you.


BISSELL User’s Guides can be downloaded at www.bissell.com\012On the front page under Customer Service click on User’s Guides and enter the model number of your unit.\012User Guide will be displayed as a PDF file. ... Bissell 37604 Lift-Off Pet Bagless Upright / Canister Vacuum CleanerVacuum

Kirby g4 vacuum- need to replace the plastic connection piece between the vacuum bag and the vacuum base...anyone know where and how to do this?


See if this helps\015\012http://www.goodvac.com/kb_results.asp?ID=12\015\012\015\012Good Luck,\015\012Rocky ... Kirby G4 Bagged Upright Vacuum

I built a new house nearly a year ago but didn't move in until recently. The Nutone central vacum system doesn't have much suction. I've tried different things but am afraid there is a break or breaks in the system. My question is how can breaks or joints that come a part in the suction system be located so I will know where to cut into the wall.


Hi,\015\012\015\012Here I am giving link of manual which shows how to install the your gadget.\015\012http://www.retrevo.com/support/ ... Broan-NuTone VX475 Bagged Central System Vacuum

Wiring the switch for a kenmore vacuum cleaner I need to know where teh different colored wires go. It had a short in it so I replaced the plug but think I wired it incorrectly. Its a Whispertone 300 model 116.28612790 The canister works but the beater bar doesn't.( it worked before a rewired the switch. Thanks


... Kenmore 23313 Whispertone Bagged Canister Vacuum

Pull cord all the way out vacum doesn't start. Push the recoil switch for a second then it will start. Bad connection or new cord needed? Also how do you reinstall the coil? Thank you.


Greetings,\012This definitely sound like a cord reel issue to me. This is really the \012only problem that I ever see on a Miele vacuum cleaner ... Miele S514 Solaris Bagged Canister Vacuum

I bought a used hoover steam vac model #F5887-900 and it did not hve any manuals with it. I need to know how to operate this machine and what attachments to use on different surfaces


Hello,Here is a link for a manual that should help you with your machine. It is not the same model manual but should work for you.http://www.h ... Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum

I have a Kenmore Progressive model 116.22812204 purchased 2003. The swivel (part nuumber 8195133) that attaches the extension wand to the power mate attachment snapped, so I can't keep the parts connected. I can order a replacement part on-line, but I don't know how to replace it - is it difficult to take apart the power-mate and replace this part? Do you have instructions on how to do it? Thanks!


... Kenmore Vacuums

Shark steam blaster model # s3300h. I need to replace the handle .the connection inside that goes to the steam line is broken


... Euro-Pro Vacuums

Shampooer i need to know step by step how to switch from vacum to shampooer


Here is the link to my online guide. If I can help you further, contact me.\015\012\015\012 ... Kirby Ultimate G Bagged Upright Vacuum

I need to know how to connect the auxillary hose for cleaning stairs and upholstery on the Hoover Floormate f7458-900. I also would really like to find a maual to download.


Go to ttifloorecare.com ... Vacuums

Car dies when u put it in gear but u can drive it but when u go to stop it will die it is a 1992 chevy camaro rs 350 throttle body with brake booster vacum un done it will sit and idle with it on it will idle for about 3 mins. but with it off it will still die when u put it in gear what do i need to do john henry sparta tnn. 38583 (931)808-3624 cell phone i have tried everything i know to do ????????


Go to autozone and buy you 2 bottles of heat and put it in the gas tank.it sounds like you have built up some condensation in you tank an its pumpimg the water thats accumulated in you gas tank.put the 2 bottles in the gas and it will dry up the wate ... Kenmore Progressive Bagless Upright with Inteli-Clean SystemVacuum

I have a Z5930 vacuum and i want to trace an electrical fault. I need to disassemble it to get to the electrical connections and it is quite a tricky one to get in side. The machine will run and then cut out after a short time. It will then re-start in about 2-3 minutes and run normally again and so on. I was not able to give you the exact model but it is Ultra Filtration Oxygen line


... Electrolux EL7020A Oxygen 3 Ultra Canister Vacuum Cleaner Bagged Vacuum

I need to know how to connect the lights on a 7 ft briarwood spruce pre-lit christmas tree.


Carefully probably with a ladder ... Vacuums

I need to replace the power cord on my Eureka 2271, and would like know how to get into the connections?


... Eureka 2271 Bagged Upright Vacuum

My wand on my canister began to spark and snap and smoke. The element was melting. and now I am stuck with only a working canister. the elememt or electrical hook up is burned up...and I guess I am gonna have to BUY ANOTHER wand or connection??? I don't know what to do... but this is a HUGE dissapointment. The canister still works... but no vacume head.


How's the hose?\015\012If it's only one wand, yes, you'll need to buy a new one. It depends on where it burnt out. If it was at a connection to the hose, the other wand, or the power nozzle, you need to check the connections thoroughly for di ... Electrolux Lux 5500 Canister Vacuum

I have a Hoover Deluxe Spin Scrub carpet cleaner that has lost suction. I read the solution by Chris Jones of GoVacuum.com, in which he described the design flaw whereby the tool attachment hose tears at the point of connection with the motor housing. That is the case with my machine. Now I just need to know how to repair it. What kind of tape can I use? Plumber's tape? Please help me!!!


A tear in the hose will only affect pick up through the hose when using it to clean furniture, stairs, and such. It will have no effect on the carpet cleaning operation. If the hose cannot be replaced for a while, black electrical tape is one solutio ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

I have a Ryobi RLT-900 Line Trimmer. The trigger has broken and I need to know where I can buy another. I am situated in Centurion South Africa.


... Ryobi Vacuums
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0614 seconds