Having problems with your Vacuums ?

My rumba keeps going backwards before stopping and locking up


Answers :

Mine was doing this too. I think the stair sensors might have been dirty. I used compressed air to blow out the entire front of it and it started acting normal again.
Repair Help & Product Troubleshooting for Vacuums

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

My rumba keeps going backwards before stopping and locking up


Mine was doing this too. I think the stair sensors might have been dirty. I used compressed air to blow out the entire front of it and it started acting normal again. ... Vacuums

I have a infinuvo QQ-2L it just started at random to only go backwards. Once this starts it get locked up and stops runing. I tried cleaning behind front bumper no luck. any ideals?


... Infinuvo Vacuums

My scooba when switched on starts to spray water then spins round faster than normal then starts to go backwards quite quickly then stops then continues to reverse more then stops & with the nor


... iRobot 5800 Scooba Vacuum

Runs but doesn't vacuum/****. Sidebrush works fine. Cleaned the roller brushes, and that seemed to confuse the robot and now it keeps going backward a few inches, turning, and then starts going backward again.


Sounds like a sensor problem. pull and clean the front black/white caster assembly and the revealed movement sensor and the 4 cliff sensors along the bottom of the front. Make sure the front caster wheel turns freely. You may have to remove the rolle ... iRobot Roomba 560 Robotic Vacuum

The agitator on my kenmore progressive vacuum won't keep going. It keeps stopping while vacuuming.


This sounds like the belt that drives the beater bar on the vacuum. The beater bar bearings and brushes could be plugged with debris and/or the belt is simply worn out and needs to be replaced. Unplug the vacuum, turn it over and look for clogging. ... Vacuums

My roomba going in circule, backward a few than stop. it is not going a normal vacuum forward


Tear it down and clean the dirt and dust inside of it thoroughly. Also blow compressed air in the entire motor and circuit area at 5 PSI\012Reassemble and it should work like new again ... iRobot Roomba 530 Robotic Vacuum

Keeps stopping. My Roomba Discovery says it has a full charge, but it runs for a few minutes, then stops and beeps and the status light comes on. If you press the clean button, it will start again and go for a few minutes before the same thing happens again.


Your battery isn't holding a charge ,buy a new battery ... iRobot Roomba Discovery SE Bagless Robotic Vacuum

I have a bissell bagless easy vac. When I vacuum the debris keeps getting stuck in the hose (also going into the filter area and the apparatus above the cannister with none of it going into the cannister. I have made sure the cannister is properly placed and the lock is pushed in all the way.


... Bissell 3102-0 EasyVac Upright Vacuum

My irobot starts out running fine and then it will turn and slow down as if something is keeping it from going. all at once it will go full speed again. it does this until finally it stops and the red status light comes on. I just replaced the battery 6 months ago.


... iRobot 4296 Robotic Vacuum

Suction button Although my Hoover Spin scrub is working perfecting dispensing the solution, when I go to suck up the solution from the carpet--I am having problems with the RED suction button that keeps popping up. I have to stop the cleaner and lift up the dirty water container to break the suction. Ive tried cleaning the netting that is encased around it, but still no luck. Any help would be appreciated! Thanks


This happens when the filter on the inside of the lid for the dirty water tank is pushed all of the way up. You need to leave a 1/4 in. gap from the top to the top of the filter ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

Filter keeps popping out and stopping ball going round


... Dyson Ball DC24 Bagless Upright Vacuum

I robot rumba- does not go forward, keeps backing up and turning


Sounds like one of the cliff sensors has gone bad. I think your options are to send it in for repair or buy a replacement sensor and swap it in. \012\012Good luck, \012 immorion\012check out robotreviews.com for detailed walk throu ... iRobot Roomba 560 Robotic Vacuum

My roomba 560 will not go forward, just keeps tuning to the sides or backwards. Ihave taken it apart and cleaned it very well but that did not help. What can I do?


\015\012Your bump sensors are malfunctioning. The best thing to do is order a repair kit... I ordered mine from EESolutions.ca and it worked great. I'd recommend them. ... iRobot Roomba 560 Robotic Vacuum

My irobot keeps on going in circles?how do i stop it from doing this


... iRobot Roomba 410 Robotic Vacuum

A large screw got sucked up the vacuum. Since then the motor,which I replaced probably only 12 months ago, sounds very "winey" and when you stand the dyson upright the front brush still keeps going round instead of stopping. Any ideas? David


Sounds like the clutch mechanism has somehow been damaged.\015\012\015\012Have a look at the following site which is a great source of info on faults, dismantling, repairing and re-assembling:\015\012\015\012 ... Dyson DC07 Bagless Upright Cyclonic Vacuum

The solution in my smart mix will not mix with water and the button just keeps going round and clicks and will not stop on either water or solution.


The smart mix knob is connected to a piston that slides up and down into the automix assembly. This piston has come off of the smartmix knob and left the unit on water only setting. Sometimes the smart mix knob breaks on the ... Bissell 7901-1 ProHeat Scotchgard Upright Wet/Dry Vacuum

Our Dyson keeps stopping in the middle of vacuuming and then it will not come on except when you lower it and then periodically it will go either way.


Hi its Darran at Dyson.Your machine is fitted with a thermal cutout which will stop your machine should the motor become too hot. After an hour or two it should come back on. this is caused by a dirty filter or a blockage. ... Dyson DC14 Animal Bagless Upright Cyclonic Vacuum

My roomba starts going backwards


I had the same kind of problem with my model 400 today...after starting it and having it go in a circle for 30 seconds or so it would finally run into something and then back up a few inches, turn, then go forward a few inches, then back up a few inc ... iRobot Roomba 4210 Bagless Robotic Vacuum

Roomba going backwards


I had the same kind of problem with my model 400 today...after starting it and having it go in a circle for 30 seconds or so it would finally run into something and then back up a few inches, turn, then go forward a few inches, then back up a few inc ... iRobot Roomba 4210 Bagless Robotic Vacuum

Rumba making Clicking noises - stops It has been cleaned.


Even if the 2 brush rollers are clean you need to pull the small yellow ends of the roller off [the funny lookin ones].hair ect. get jamed in there .use a knife or small screw driver to pull the build up out.hope this helps ... iRobot 53501 Roomba 500 Series Vacuum Cleaning Robot with SelfCharging Hom

My roomba backs away from docking station then starts to go then stops and spin left then stops and spins right after a few times stops and beeps many beeps. What is the problem


It sounds like the 9-beep error. You can fix it by buying a repair kit from www.eesolutions.ca. I fixed mine in about an hour and a half. ... iRobot Roomba 530 Robotic Vacuum

My Singer Futura CE-150 keeps locking up.. The wheel will not turn and the needle locks-up.. I have re-threading and cleaning out the bobbin area but it is still locked up


... Vacuums

Roomba Discovery Roomba is fully charged and cleaned with sensor wiped clean. When turned on it it sounds normal and commences to go, but it then acts like it is putting on the breaks, spins, tries to go and manages a short distance and breaks again, just not making any progress because it keeps breaking after a foot or so and turns and tries again. Sometimes is gets so stuck from moving forward at all, like it is stuck in one spot just trying to go while seemingly surrounded by barriers. Somet


I had the same back-up, turn, move forward a couple inches, backup-up, etc. problem. Try cleaning/cutting the hair, etc. out from around the brushes, as well as around the ends of the brushes. Also, try a Q-tip to clean out the four pair of sensors ... Roomba Robotic Floor Bagless Vacuum

Have model 3576-6 Bissell Cleanview II and drive belt keeps slipping off peg that is sticking out from motor pulley causing vacuum to stop working properly and brush to stop moving properly


... Vacuums

Why does my bissel proheat 2x model 8960 keeps stopping? the red valve door keeps getting shut


... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0435 seconds