Having problems with your Vacuums ?

Hoover spin vac wont **** up the dirty water!


Answers :

Check the lid on the dirty water tank. This is a very common problem. If the lid is not engaged in the tabs of the tank, the lid will not sit down properly and all the suction will leak out between the lid and tank.
Repair Help & Product Troubleshooting for Vacuums

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Hoover spin vac wont **** up the dirty water!


Check the lid on the dirty water tank. This is a very common problem. If the lid is not engaged in the tabs of the tank, the lid will not sit down properly and all the suction will leak out between the lid and tank. ... Vacuums

Can't find info for hoover steam vac spin scrub model # F5905900 on Hoover website, doesn't show that model number at all...looking for mesh (kind of cone/cylinder shape) that goes in dirty water tank (I think) and also the tool (wand) that slides into front to clean it out. It doesn't pull all the water up very well and the filter has been missing for some time. I don't know if that has anything to do with it or not. As far as the wand tool goes, I have taken the cover off at this point and


The cleanout tool is part # 43514001. The filter is # 90001398. Be sure to leave a 1/2 inch gap between the top of the filter and the bottom of the lid. If you need a manual, try model F5914-900 0r F5912-900 on Hoover.com ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

Hoover F7431-900 my carpet shampooer/steam vac was working fine until the brushes at the bottom of it just miraculously stopped working. they wont spin at all. Is this a motor problem? perhaps a water flow problem? please write back if you can be of any help. thanks


If the screen is not dirty, and the flapper valve to the turbine inlet is open, then the problem is mostly a stuck turbine impeller. The turbine impeller on my F7431-900 has seized TWICE!! The shaft for the turbine is not made of stainless steel, t ... Hoover F7431-900 SteamVac Vacuum

I have a hoover steam vac spin scrub that won't pick up the dirty water heeelllllllppppppppppppp please


\015\012The most common reason for lack of pick up is that the lid is not fully seated on the dirty water tank. Be sure to hook the two tabs on the front of the lid, and then snap the rear latch into place. Another reason is that the duct on th ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

Hoover Steam Vac Deluxe Wont **** up water?


... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

Hoover Agility Steam Vac has no suction for the dirty water


Broken suction hose. ... Hoover F6212-900 / F6215-900 SteamVac Agility Upright Vacuum

Need instructions how to use Hoover Steam Vac Spin Scrub. I borrowed it from my Sister and she left it with no instruction book or letting me know how to operate it. I put water & cleaner in top tank. That's all I know to do. Do I put any water in bottom tank? I figured not, since that is probably where the water goes when sucked up by vac. Do I leave lid on bottom tank? I usually use a commercial cleaner, and this is very different. I need to know NOW, as I must return it to her today, and I'm


I did have a solution in just a few minutes. Someone responded with a solution that gave me the website where I could go and print the manual in pdf, so did that, and checking instructions I was able to clean my carpets and get the shampooer back to ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

The suction on my Hoover Spin Scrub 50 is suddenly not working. This is the 2nd or 3rd time I've used it and until now it has done a great job. But now it leaves my carpets soaking wet with no hope of drying and no dirty water is being suctioned into the dirty water tank. Help!


... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

The hoover steam vac 5 brush agitator dispenses water and soap but does not show any return water to dirty water reservoir. The carpet seems damp but not soaked, still a bit troubling no waste water...what up ?


You do not have the needed vacuum on the dirty water intake. Possible causes are:\015\0121. No adapter sleeve in the back of the dirty water tank (the one that you remove to put the fabric hose adapter in)\015\0122. The dirty water top i ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

My hoover steamvac wont **** up dirty water float


This will also happen if the recovery tank lid is not securely latched or the lid gasket is bad and is leaking air. No vacuum, and the tank overflow ball snaps into place. I had a tank lid latch fail, and the symptoms you report were identical. ... Hoover F7431-900 SteamVac Vacuum

My Hoover steam vac dual v's brushes will not spin and the square that the peg goes into wont spin either. There is suction but it is making a loud noise.


Sometime when the brush is not turning their are less resistance to the motor, so it will turn allot faster than normal. The turbine gear assembly which connected to the brush assembly probably broken, all the g ... Hoover Steam Vac Dual V w/ SpinScrub Vacuum

Hoover steamscrubber I loaned my vac to my daughter who used it to clean shag carpet with lots of dog hair......now the scrubbers wont spin I have taken them (scrubbers) out and cleaned the vac....don't know where the lint trap is...but i DON'T see any part moving that would make the spinners rotate either Thnks...Lydia


I had the same problem. Fixed it by taking the machine apart and lubricating the bearing inside the turo tunnell. It's a pain, but not impossible if I could do you can. You must start by taking off the cover. Don't forget the scvrews on the front by ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

I'm using a steam vac for the first time, i wanted to know if the bottom piece that you empty out the dirty water has to have water in to use it. or is it suppose to be empty?it's an upright hoover steamvac for heavy traffic areas and spot cleaning


Hello,\012The bottom piece should be empty when you use your machine. Make sure you rinse it our real good when you are finished.I hope this helps. ... Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum

My hoover spin brush steam vac brushes wont spin


Unplug vac turn it over and check for belts that drive the brushesThey are located at the very end of the brush They are probably missingor they snapped and sitting in the housing somewhere. If you ar mechanically inclined not very difficult ... Hoover Vacuums

I own a hoover steam vac model f5915-900 and i currently have two problems. 1. the brushes are spinning at a much slower speed. 2. the steam vac is not picking up the water it leaves on the carpet. Please help Josie


The reason the brushes are not spinning is because the belt is slipping, the belt is the bad that connects to the brush to a shaft that makes it spin. Next problam is it is probobly clogged. so water is not going through all the way ... Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum

I have a Hoover spin vac # 7410-900 the brushes don't spin but i can hear the pump running , checked the brush block stem thats fine the unit feeds water and soap. but i have no vacuu.me or brush movement getting ready to rip the turbine out to check it . the weird thing is it worked fine and then just stopped


... Hoover Steam Vac Dual V w/ SpinScrub Vacuum

I HAVE A HOOVER STEAM VAC SPIN SCRUB CARPET SCRUBBER. I KNOW HOW TO PUT THE WATER IN. I CAN'T REMEMBER HOW TO **** THE WATER BACK UP. PLEASE HELP


Hi,\015\012\015\012Please check the related links…\015\012\015\012http://www.ehow.com/way_5 ... Hoover Vacuums

My Steam Vac F59149 will not vacuum up the cleaning solution. I have checked the usual culprits. The dirty water tank is empty, the yellow float is not up too high. This is a relatively new appliance, so the way for the water is not blocked, there is just no suction. The warm air is blowing, the brushes are spinning. What next?


... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

My hoover steam vac spinscrub f5915100 wont despence water


... Hoover Steam Vac Dual V w/ SpinScrub Vacuum

Hoover spin scrub wont spray water


... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

HOOVER STEAM VAC DUAL V STEAM CLEANER BRUSHES WONT SPIN


... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

My Hoover steam vac is stuck on the tools setting and wont stop leaking water from the tools hose


... Hoover Vacuums

My steam VAC upright wont **** up water - Hoover SteamVac F5914-900 SpinScrub Upright Vacuum


The most common and simple problem with these involves the recovery tank. Take it off, remove the cover and check to be sure it fits snugly. All tabs must be locked front AND back. If this machine has tools you have to hook up in order to use you ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

Hoover spin brush model f5914-900 wont draw water back out of carpet


Please remove the recovery tank and check and see there is a black rubber ring seal on the large vacuum tube that rises from the base to meet the bottom corner of the recovery tank. This rubber seal may have fallen off the tube and be found laying u ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

My hoover steamvac spin scrub wont suck up the water. Can someone help me?


... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0712 seconds