Having problems with your Vacuums ?

Bagless upright with no suction

\015 There is no suction from bottom only from the hose. I already tried with eureka themselves, but they were no help neither were was the approved service company.\015

Answers :

What model do you have?
Repair Help & Product Troubleshooting for Vacuums

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Dyson DC07 bagless - upright mode v poor suction, wand mode ok


I suffered with a serviced but not sucking DC07, its fixed now. How? By replacing the cyclone unit via anotherbay, it was an accumulation of dust and debris in the section that is not accessible. Borrow a working cyclone if you can and check the diff ... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum

My eureka optima upright bagless vaccum has VERY low suction using the floor part. the hose has excellent suction. i removed the little translucent door underneath and there were no blockages, i cleaned the brushroll thoroughly and that hasnt helped either. i know this probably isnt recommended but i turned it on to the floor setting with the brushroll off and stuck my fingers up the intake as far as i could, the suction was good further up but it just seems to stop down at the base. because i s


I will try and help here. Is the sole plate on the bottom of the vacuum complety on and there are no visible cracks along the seam where it meets the body? This is the usual cause for this. Onc you take of the plate to access the roller and brushes, ... Eureka 431A Optima Bagless Upright Vacuum

Noisey DC07 Bagless Upright Cyclonic Vacuum; lack of suction...


The washable filters very seldom wear out, they are sponge, but the prefilter on the housing CERTAINLY wears out. You can fix it here:\015\012\015\012 ... Dyson DC07 Bagless Upright Cyclonic Vacuum

Hoover upright bagless vacum.motor runs, brush turns, no suction through hole behind brush roller. however there is suction going out of dust cannister filter flap to motor. what could possible problems be?


Sorry to read about your problem, I hope this helps you out.you have a clog between the brush and bagI tried to help you. Please help me and Rate/Vote on my response, thanks and good luck ... Hoover U6437-900 / U6439-900 Windtunnel Bagged Upright Vacuum

There is no suction when using as an upright - Dyson DC07 Bagless Upright Cyclonic Vacuum


Detach the hose from power nozzle and check PN for clog. This is the most likely problem if the accessory tools work with the vacuum. ... Dyson DC07 Bagless Upright Cyclonic Vacuum

Dyson DC 14 upright not suctioning - Dyson DC14 Animal Bagless Upright Cyclonic Vacuum


Start by cleaning the filters. Watch this video: \015\012\015\012\015\012 ... Dyson DC14 Animal Bagless Upright Cyclonic Vacuum

Loss of suction in my Hoover Windtunnel bagless selfpropelled upright


There's also the possibility that the fan/impeller has stripped loose from the motor shaft and is basically sitting there while the motor turns. Also, you may have broken vanes on the fan/impeller that will drastically reduce the suction. Replacemen ... Hoover Self-Propelled WindTunnel Bagless Upright VacuumVacuum

Bagless upright with no suction


What model do you have? ... Vacuums

M084600 Dynamite Bagless Upright Vacuum: loss of suction...


A few weeks ago I ran into the same problem, virtually no suction. First I replaced the bad belt (make sure you fit it right or it'll destroy the belt, luckily I bought 2!) and while the vacuum sounded more "alive" it didn't seem to pick up anythi ... Dirt Devil M084600 Dynamite Bagless Upright Vacuum

No suction with Eureka Boss Pro Lightweight Bagless Upright, 411A


I checked the vacuum hose to see if there was a clog. 1st, disconnect the hose from the unit so you have access to both ends. Now, place a marble or other ball in one of the hose and see if it will make it all the way through. I found ... Eureka 411A Upright Vacuum

Suction is very poor - Eureka Whirlwind 4388 Bagless Upright Cyclonic Vacuum


I would start with replacing the back hepa filter, the yellow filter on the bagless tank and the white filter beneath the intake housing. If that does not solve your problem, you have a clog in the system ... Eureka Whirlwind 4388 Bagless Upright Cyclonic Vacuum

No suction using extension hose for Bissell Bagless Upright vacuum. i checked for clogs and found nothing. shannon


Check the sole plate where the beater bar is. You may have to remove the roller brush flap to get into the roller brush and then check the main dust channel beside it. Usually if there's no suction on the hose it means that:\015\012\015\0121) T ... Bissell CleanView II Plus Upright Bagless VacuumVacuum

No suction to pipe tool - Dyson DC07 Animal Bagless Upright Cyclonic Vacuum


Your hose is blocked up get a wire coat hanger down the hose ... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum

Suction isn't as good as it shoule be - Dyson DC07 Bagless Upright Cyclonic Vacuum


I can help you there! Take off the whole filter unit (button near the handle) - take off the clear plastic dust bin. Wash the whole unit in water - I add a bit of washing up liquid and then keep rinsing (hose pipe outside is good) until water runs cl ... Dyson DC07 Bagless Upright Cyclonic Vacuum

Loss of suction via the tube. - Dyson DC07 Bagless Upright Cyclonic Vacuum


Hello,It sounds like you have a clog or dirty filter. Here is a link to download the manual for your model. The download link is on the right side of page. About half way down the page you'll see the Download Manual link. ... Dyson DC07 Bagless Upright Cyclonic Vacuum

No suction at bottom - Dyson DC07 Bagless Upright Cyclonic Vacuum


Check for blockage in brush roll compartment,\015\012Also under the base there is a plastic transparent hose, make sure it hasn't come off, blocked or is full of holes. ... Dyson DC07 Bagless Upright Cyclonic Vacuum

No suction - Dyson DC14 All floors Bagless Upright Cyclonic Vacuum


Your filters are clogged. Dysons have two filters. One is the washable one located directly beneathe the cannister. The other is a post filter located inside of the vacuum housing. This filter should be replaced by a Dyson technician. The Dyson ... Dyson DC14 All floors Bagless Upright Cyclonic Vacuum

The wand does not have much suction - Dyson DC14 Animal Bagless Upright Cyclonic Vacuum


Here is a link to a YouTube video that walks you through the steps to check for obstructions which may cause your low wand suction problem. If you are getting good suction from the vacuum itself, an obstruction between the motor and the wand head is ... Dyson DC14 Animal Bagless Upright Cyclonic Vacuum

Lost suction high pitched squeal - Dyson DC07 Animal Bagless Upright Cyclonic Vacuum


The motor or the fan needs to be replaced.both are a lot of money. ... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum

The sweeper doesn't have proper suction - Bissell 6594 PowerForce Bagless Upright Vacuum


Make sure all filters are clean and then check for obstructions begining at the nozzle (floor head) and follow the chamber all the way to the dust bin. Most bagless models have a dense foam filter just under the top. ... Bissell 6594 PowerForce Bagless Upright Vacuum

Loss of suction with hoss & wand with my Dyson Animal bagless - will only work as an upright.


It sounds like you have a clog through the hose. Take the entire hose off of the unit and stick a broomstick through, if it comes out the other end without anything coming with it. The clog is in the sweep below the unit. If your mechanically incline ... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum

There is no suction - Hoover U8171-900 / U8172-900 / U8173-900 / U8174-900 Savvy Bagless Upright Vacuum


If the filters are clean then as your facing the back you will see 2 channels one is shaped like a j there are 10 screws take them out and clean the chanels being careful of the thin rubber seals around the outer edge lt the piece you take off.if its ... Hoover U8171-900 / U8172-900 / U8173-900 / U8174-900 Savvy Bagless Upright Vacuum

Hose has no suction - Bissell 6590 CleanView Bagless Upright Vacuum


Take your brushroller off like your changing the belt and see if you see anything clogged up behind there if there is then pull the dirt or whatever out ... Bissell 6590 CleanView Bagless Upright Vacuum

No suction when using the hose - Dyson DC07 Bagless Upright Cyclonic Vacuum


Does the vaccuum rev higher when the hose is on? If so, there is something lodged in the hose. ... Dyson DC07 Bagless Upright Cyclonic Vacuum

I have a Dyson DC17 Animal Bagless Upright Cyclonic Vacuum and it lost suction. How do I get it fixed? Also, is it possible to get a second filter for this machine?


OK. Lost suction almost always means blockage. You need to check all the pipework, the hose and any bits you can remove at the base of the machine - if I remember right, the DC17 has a sort of U shaped bend at the bottom of the handle that you can re ... Dyson DC17 Animal Bagless Upright Cyclonic Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0607 seconds