Having problems with your Vacuums ?

My sebo vacuum just won't lift up 50% of the stuff it should

\015 It feels like there's suction there..and half the time it picks up stuff, but sometimes only to push it somewhere else. Its only a yr old but i bought it online from an ebay seller and didn't remember about garauntees etc.\015\012\015\012What can be done to fix it?\015

Answers :

Is this an upright? Pull the bottom cover plate off and check the air passages for blockage. Also, check the belt driving the brush for tension and condition. Remove the belt from the motor shaft, and remove the brush assembly. Clean all of the debris from both bearing ends--pull the bearings from both ends and clean the bearing surfaces with a Q-tip swab soaked in rubbing alcohol. Re-lubricate both bearings with with 3-1 or sewing machine oil. Before replacing the brush and belt in the machine, turn it on and check the air flow up into the bag. It sometimes becomes becomes plugged near where the handle joins the base.
Repair Help & Product Troubleshooting for Vacuums

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

My sebo vacuum just won't lift up 50% of the stuff it should


Is this an upright? Pull the bottom cover plate off and check the air passages for blockage. Also, check the belt driving the brush for tension and condition. Remove the belt from the motor shaft, and remove the brush assembly. Clean all of the debri ... Vacuums

I have a bissell lift off and the brushes wont spin, i think it maybe because of the internal switch that tells the vacuum that the canister is installed is bad. is there a replacement part for that or do i have to get a new vacuum?


Hi,If you take out the brush roll, holding the ends, make sure that it \015\012spins freely, if not, replace it. Belts stretch after a short time of \015\012use and need to be replaced often.So you could either have a bad brush roll and ... Bissell Lift-Off(R) Revolution(R) Turbo Upright Vacuum

Brush wont go round but the belt is ok - Bissell Lift-Off(R) Revolution(R) Turbo Upright Vacuum


The belt may look okay but it can still be stretched. If it is stretched it won't turn the brush against the resistance of the carpet. Here is a link to the belts you need and to the manual which has instructions: ... Bissell Lift-Off(R) Revolution(R) Turbo Upright Vacuum

Bissell handle wont stay locked - Bissell Lift Off Floors and More Vacuum Cleaner - 53Y8


Sorry to hear you're having problems with the handle. You may want to have a qualified technician at one of our Authorized Service Centers inspect your vacuum. Here's a quick link to assist you in locating one. ... Bissell Lift Off Floors and More Vacuum Cleaner - 53Y8

All 4 lghts are on on my sebo x4 and the vacuum wont run


... Sebo X4 Bagged Upright Vacuum

Simplicity vacuum My vacuum just cut off and now it wont start. I pressed there restart button but nothing happens I have 2 fairly old Industrial hitachi dry vacuum in my workshop both 110v and both wont start. Both i was told were manufactured in Italy and both have a manual and auto switch. It has a black top, takes an orange paper filter inside and its bin is dark blue. Sorry i've forgotton the model number. I've inspected the wiring but it's fine, could it be the motor and how do i gain acc


Just take it in to your vacuum store. ... Hoover U5753-900 WindTunnel Bagless Upright Vacuum

Why wont an Oreck vacuum pick up rock salt from a commercial entrance rug


... Vacuums

Vacuum sebo not going up and down - Sebo X4 Bagged Upright Vacuum


... Sebo X4 Bagged Upright Vacuum

Take handle apart sebo vacuum - Sebo Automatic X1 Bagged Upright Vacuum


... Sebo Automatic X1 Bagged Upright Vacuum

Vacuum wont **** and turns off after 2 minutes of vacuuming


You must av some of the blanket still stuck in there that's why it keeps stopping because it's overheating check for more blockages ... LG Electronics Kompressor Pet Care Upright Vacuum Cleaner LUV200R

Lift-Off Pet Hair vacuum doesn't lift off pet hair!


Very light "stuff" like dog hair will get stuck to the filter since that is where the suction goes. it's primary purpose was to keep dust out of the motor. This is a problem with many "bagless" cleaners. A bagged cleaner keeps all dirt and hair away ... Bissell 37604 Lift-Off Pet Bagless Upright / Canister Vacuum CleanerVacuum

The vacuum comes on but the standup vacuum assessory won't turn on. I"ve pushed the reset button; unhooked everything, including reattaching the canister but it still wont' come on. Any other ideas? By the way, I hated the price, but it's the best vacuum I've ever had - especially when I have three shedding pets!


Check the roller brush to see if anything is wrapped around it. If not, there may be a loose connection or wire between the canister and the power nozzle. I assume that's the accessory you're referring to. I could also be a defective switch, but loo ... Vacuums

Why doesnt my Dyson auto adjust on our carpet? We have a taller, soft carpet and it digs into it, making it very difficult to vacuum. We have had the vacuum for about a year at another house and it worked GREAT on the berber......our new has a tall carpet somewhat like shaved berber and now the vacuum wont work.


... Dyson DC14 Animal Bagless Upright Cyclonic Vacuum

My Eureka Altima Upright Vacuum Model 2996AVS Vacuum wont turn on. Any advice where to start? I would think it may be a fuse but do not know where it is on this vacuum.


... Eureka Altima Upright Vacuum Model 2996AVS Vacuum

Suction Problem I was vacuuming and stopped to empty the cannister. When I started vacuuming again - the suction wasn't working properly. The vacuum was just pushing stuff around the floor. I cleaned the hair out the brush on the bottom and it still isn't working. It was working fine before I emptied the tube :( I can't figure out what happened.Help!


Greetings from GoVacuum,\015\012\015\012I believe what may have happened is that your vacuum cleaner belt has either broken, or been stretched so far that ithe brushes are no longer spinning fast enough. \015\012\015\012Here' ... Vacuums

I have an endurotronic 4111 electrolux vacuum called ''the boss'' and the cable wont retract into the vacuum when i depress the button on the top. how do i dismantle parts to have a look to see if it will repair or not. does anyone have a repair manual for this vacuum. thx


... Electrolux Vacuums

No suction i have a hoover supreme wind tunnel vac and its relatively new and the suction, well......sucks. It wont pick anything up! I am extremely frustrated! I picked up a ball of fuzz off the carpet and held it under the vacuum and it still wouldn't **** it up. I then shoved the fuzz up INTO the vacuum. It fell right back out. I may as well not even vacuum. Please help!


I have found more vacuums on the way to the dump because they were full. Check. Is it full?\015\012If not the air way is clogged. ... Hoover U6437-900 / U6439-900 Windtunnel Bagged Upright Vacuum

Vacuum I have a dirt devel purpose for pets vacuum. It has worked well previously. The vacuum has started spitting out debris from the bottom when slightly lifting from one floor to the next. What could be causing this. Thank you


You may have a clog in the dirt inlet by the brush roll, and also the hose. ... Vacuums

My Eureka Altima Upright Vacuum Model 2996AVS Vacuum wont turn on. Any advice where to start? I would think it may be a fuse but do not know where it is on this vacuum.


Generally, on something with a cord and plug, the first thing I suspect is a bad spot in the cord where it connects to the plug. One way to check it is to turn the vacuum on, plug the plug into a good outlet that you have checked to make sure it wor ... Eureka Altima Upright Vacuum Model 2996AVS Vacuum

Question mark light has come on my vacuum and it wont run. I replaced the bag, but it wont start. I don't have a new filter is that the problem?


... Electrolux Vacuums

Bissell lift off pet revolution vacuum smells bad when I vacuum!


Put a BOUNCE sheet inside the filter ... Bissell 37604 Lift-Off Pet Bagless Upright / Canister Vacuum CleanerVacuum

Bissell 35k3 lift-off deep cleaner does not vacuum up water when using upholstery attachment.Water sprays out but wil not vacuum up.


... Bissell Vacuums

Bissell 35k3 lift-off deep cleaner does not vacuum up water when using upholstery attachment.Water sprays out but wil not vacuum up.


... Bissell Vacuums

No suction i have a bissell lift off revolution vacuum. I have cleaned all the filters and emptied out the canister made sure that the hoses are not plugged but it will not pick up unless you use the hose. the floor brush is clean and still no suction coming from under the vacuum... could you help me please


Is there a blockage in the small hose in the bottom of the machine \015\012take of the pod and you will see the small hose, \015\012Is the main hose pushed into the bottom housing ... Bissell 37603 Upright Vacuum

Hoover vacuum turned off and wont go back on - Vacuums


Generic problem for all Vacuums\015\012Hoover vacuum turned off and\015\012Hoover vacuum turned off and won’t go back on\015\012 ... Vacuums
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0752 seconds