Having problems with your Vacuums ?

How to remove Dyson DC01 filters

\015 Got a dyson that won't **** properly but is ok through the hose, figuring blocked filter. where is it and how do i remove it.\015

Answers :

Here's the manual to your vacuum. You can see where you change the filter and what else might be the problem.

www.thinkvacuums.com/pdf/uprights/Dyson_DC01.pdf
Repair Help & Product Troubleshooting for Vacuums

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

How to remove Dyson DC01 filters


Here's the manual to your vacuum. You can see where you change the filter and what else might be the problem.www.thinkvacuums.com/pdf/uprights/Dyson_DC01.pdf ... Vacuums

Hepa filter on dyson dc01


Not sure about you model, but some of the dyson's have the hepa filter under the dirt container. Remove the container, there is a cover that comes off and the filter is under that cover. ... Vacuums

How do you remove the HEPA filter on Dyson DC07


I use a screw driver to pry them up.\015\012Joe ... Dyson Vacuums

How do I remove the washable filter to clean it on my Dyson bagless vacuum?


As you are looking down at the base of the machine (viewing from the front) you will notice a yellow button on the right side just inside of the the wheel area. push up the button to release the casing that holds the hepa filter and the spongy filter ... Dyson DC07 Bagless Upright Cyclonic Vacuum

Dyson DC07 Filter Release Catch removal


If its the part im thinking of its a small spade like catch thats glued into a hole in the chassis normally id lay the machine on its front and gently tap the old catch out with a flat end screwdriver and a small hammer be carefull its very brittle ... Dyson DC07 Bagless Upright Cyclonic Vacuum

My dyson has started to give off an acrid smell when I use it. I have checked all areas for blockages, cleaned the removable filter and removed all hair from the brush but this has not helped. I am worried the motor is getting hot in use. Whats the best thing to do next? Thanks


... Dyson DC14 All floors Bagless Upright Cyclonic Vacuum

How to remove hepa filter on dyson 18 - Dyson Slim DC18 All Floors HEPA Bagless Upright Vacuum - Iron/Titanium/Yellow


How do I remove hepa filter, and how many filters does it have? ... Dyson Slim DC18 All Floors HEPA Bagless Upright Vacuum - Iron/Titanium/Yellow

Dyson DC07 The plastic pre filter catch snapped on my Dyson. I have a replacement already, but can't figure out how to remove the bottom of the broken one. It looks easy enough to slide/snap the new one in but accessing the old one isn't easy. What do I need to do to get it out?


Turn your dyson over so you can get to the bottom undo the screw and then you can see the bottom of the clip a gentle tap with with a screw driver blade will knock it out and the other one slips in ... Dyson DC07 Bagless Upright Cyclonic Vacuum

The hose to my Dyson Dc24 has no suction. There is suction from the exhaust when I move the cyclone bin. I have removed, washed and replaced filters. The valve next to the top filter keeps flapping. I've checked for blockages and can't find anything.


... Dyson Ball DC24 Bagless Upright Vacuum

Dyson DC 14 hose has no suction, with or without brush attachments. Hot air shoots out from the base of the canister when I try to use the hose. I cleaned the top filter, but can't figure out how to remove the hepa filter to clean it without destroying the case. It looks like it might take three hands to insert pennies and "flip" the case open as is suggested on a youtube video for a different model. Would this even help, assuming I could get the thing open?


... Dyson DC14 Animal Bagless Upright Cyclonic Vacuum

How do I remove the filter on a Dyson DC04 - Dyson Vacuums


... Dyson Vacuums

How to remove filter on Dyson DC04 - Dyson Vacuums


... Dyson Vacuums

How do I remove a motor from a Dyson DC04? The bottom plastic cover can be removed by unsrewing the tork screws but the cover beneath the filter won't come off


I can't say exactly how to do this, but when you can't find the screws to take something apart, they are usually hidden by something else. You did good looking under the bottom cover, but what you're looking for is elsewhere. If there is a seam or ... Vacuums

Dyson animal loses suction when I let the handle down from the upright position to use, I've cleaned the foam filter, and the plastic filter holder and dried thoroughly, removed and cleared the right side U-bend, and the center, rear U-bend access, also made sure nothing was in the way of the beater bar. Any thoughts? thanks. lorri


Is the noise a loud screaming or a grinding/vibration? The screaming is an air flow problem and you'll want to check your hoses are clear and all the seals are tight. The grinding is an issue with the roller/belt/clutch/motor/housing. From what I'm r ... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum

Removing the filter on Dyson DC07


On the 07 model it is on the right side push clip and pull inside will be a foam filter wash and dry ... Dyson DC07 Bagless Upright Cyclonic Vacuum

Dyson DC07 Filter Release Catch removal


Yes sorry i know what mean you need to remove the motor casing to reduce the risk of breaking any parts. Lay dyson on the front and remove the bottom plate and roller bar. Now you need to remove the belt from the motor pin lay on left side look t the ... Dyson DC07 Bagless Upright Cyclonic Vacuum

Dyson DC07: When I first got this vacuum, it was so powerful that it lifted my area rugs off the floor. It is so weak it barely works. I have removed and cleaned the filter, but I can?t seem to improve the suction. What am I doing wrong? How do I fix it?


Hello,\015\012\015\012If your vacuum runs but still leaves dirt behind, the culprit could be the drive belt or an obstruction. If the agitator brush slips or won't turn, the belt is bad and needs to be replaced. If suction is weak when yo ... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum

I need a replacement manual for my Dyson 14. I have lost the booket and need help in replacing, removing, washing the yellow plastic filter


The information you need is in the manual. You can get a downloadable one here:\015\012\015\012http://homeappliance.manualsonlin ... Dyson DC17 Animal Bagless Upright Cyclonic Vacuum

How do i replace the hepa filter on a dyson dc18? I removed it and now I cannot put it back on.


It is very simple to change the filter and re-attach the canister. Once you have removed the main canister (the one that has the washable filter) you should see the plastic canister, which houses the Hepa Filter. \012\0121) To make life easy, turn yo ... Dyson Slim DC18 All Floors HEPA Bagless Upright Vacuum - Iron/Titanium/Yellow

Need to remove filter forcleaning - Dyson DC17 Animal Bagless Upright Cyclonic Vacuum


... Dyson DC17 Animal Bagless Upright Cyclonic Vacuum

How do I remove the filter to wash it? - Dyson DC07 Bagless Upright Cyclonic Vacuum


Hi There,Here's a step by step guide on how to clean the filter on your Dyson DC07.Turn power off and unplug the machine.\015\012 ... Dyson DC07 Bagless Upright Cyclonic Vacuum

I have a DC 15 Dyson Ball Vacuum. I've removed and cleaned the filter. I can't get the lid to close properly. I don't want to force it and break something. There is some kind of a red spring loaded tab that seems to be in the way. How do I reseal the top of the vacuum?


The red tab doesn't let the lid close if the filter is not fitted correctly or the wrong filter is fitted. Many after-market filters cause this problem. \015\012\015\012Have you recently fitted a new after-market filter? ... Dyson DC14 All floors Bagless Upright Cyclonic Vacuum

NO POWER My Dyson DCO4 Absolute (purple&lime) won't' switch on. I've checked the plug fuse, wall socket and also filters and hoses on machine all seem fine so think the problem is with the on/off button (maybe loose wire or something) but how do i get to it, is there a special way to remove the green on/off button in order to check the connection? Thankyou in advance for the help i am sure you will be able to provide.


The problem is almost certainly a fatigue break in the flex. These usually happen where the flex enters the handle through the rubber sleeve near the on off switch. You will need to cut about four inches off the wire and reconnect it to the switch. ... Vacuums

Removing the filter on a Dyson17 vacuum - Dyson DC17 Animal Bagless Upright Cyclonic Vacuum


Hi there,For step by step instructions on how to remove and maintenance your DC17 filter, please visit:http://www.dyson.com/support/ ... Dyson DC17 Animal Bagless Upright Cyclonic Vacuum

My Dyson DC24 makes a loud whining noise at shutdown, but it does not do this when I remove the ball filter. Any ideas?


Hi there,Thank you for your inquiry. Based on the description you provided, the issue appears to reside with the post motor filter. Please call us directly so we can provide further assistance. We can be reached at 1-866-693-9766 (US) or 0800 ... Dyson Ball DC24 Bagless Upright Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0481 seconds