Having problems with your Vacuums ?

Hayward Tiger shark pool cleaner: impellar rotates freely by hand but not on its own even though the unit moves in both directions; results in unit unable to climb pool walls


Answers :

Do you have a booster pump for this unit and is it running?
Repair Help & Product Troubleshooting for Vacuums

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Hayward Tiger shark pool cleaner: impellar rotates freely by hand but not on its own even though the unit moves in both directions; results in unit unable to climb pool walls


Do you have a booster pump for this unit and is it running? ... Vacuums

My Roomba will not move forward. It will try and spin itself and then try to move forward but then spin itself again until it stops and beeps. I tried cleaning the whole unit but it still is unable move forward. Help please!


Heyis it 5xx Roomba ? is it 9 beep that it sounds ?Please look for other same problem posted here ;-)You are probably facing a bumper sensor issue.Try to clean the bumper first and if this goes ... iRobot Roomba 530 Robotic Vacuum

How long are the batteries for virtual wall supposed to be working for? Even though I try to remove them after each cleaning , or use fresh batteries, the wall does not respond straight away. I can n


... iRobot Vacuums

Doesn't work Our home was built and finished in August 07.  The central vac doesn't work.  There is supposed to be a slot that opens in the kitchen where you sweep the dust and it sucks it up.  Also, the mounted unit on the garage wall has a hose that goes up into the house but there is a hole open at the bottom of the unit.  Where can I get someone to help us?  Or, is there an installation manual I can download to see if the builder did it properly.  He stole our solar heater for our pool and s


Has the slot in the kitchen (VacPan) been installed? Or is it just not working? There should be tubing coming into the unit in the garage, and possibly another piece to exhaust the unit to the outdoors, although this isn't always necessary. The intak ... Electrolux Centralux Vacuum

Motor will not come on when hose is plugged in wall outlet. Green light is on, circuit breaker is on, changed bags even though 1/2 full, cleaned sec. filter. What is the problem?


... Broan-NuTone VX475 Bagged Central System Vacuum

My VX550CC also shuts down after about 15-20 minutes. My problem is that I can't find my sales receipt. Nutone told me after contacting them several times that they will not honor their warranty unless I can produce the original sales receipt only. Tech assist person was very rude about whether I actually bought it myself. We bought this unit when we moved into a new house 4 years ago and can't find the slip anywhere. Totally bad customer service and they won't honor their warranty even for a p


Some People Hu...........Make sure that all filters are clean if need be renew..Sounds like overheating fault resulting in Thermal cut out operating....Good luck ... Broan-NuTone VX475 Bagged Central System Vacuum

Neato vacuum help: even though the unit is on the floor it won't stop reading "please put me on the floor"


... Vacuums

Why is my shop vac blowing dust out even though both foam and blue fiber filter are on the unit?


... Vacuums

Kenmore Elite 721.66463500 Microwave died. Didn't even notice until I went to use it. Changed fuse and screen asked to enter the time of day. Entered the time and hit start. The microwave buzzed for 0.5sec and it blew the new fuse I installed.. put in another fuse and the same thing happened.. I measured the resistance in the noise filter. Results: L1-L2 < 1ohm N1-N2 < 1ohm L1 or L2 - N1 or N2 = 0ohms I'm thinking I need a new filter but I also was unable to measure any resistance o


... Vacuums

My simplicity 7 series vacuum belt turns the agitator (beater brush) turns freely by hand when the vacuum is unplugged or off but when I turn the vacuum on the agitator does not spin even though the belt is moving. Could there be a worn out part at the agitator pin where it connects to the flywheel that the belt is connected to?


... Vacuums

Kenmore 39522 vacuum beater bar keeps rotating after unit is shut off. Even unplugged it to move to another room and when I plugged it back in, the bar rotated a few more times! Has a definite clicking sound when this happens. Purchased in January 2008.


The berings or something inside might be going bad. ... Vacuums

I have hoover mdl U6459-900 and the brush will not rotate even though the main pulley belt is rotating. i have changed booh belts and this did not solve the problem. the suction on the unit seems ok. thanks??


Sound like you need tear down and find whats jamed in it to stop it from turning like string ore hair ... Hoover U6437-900 / U6439-900 Windtunnel Bagged Upright Vacuum

I have a Shark Steam Mop, model S3101, that caught on fire. Looks as though a wire inside rubbed until it became exposed and then caught fire. I have had this unit for about 1 1/2 to 2 years; liked the concept of steaming my floors rather than using detergents. I am not happy though about spending $100 on this unit and then it only lasted this long.


... Vacuums

Electrolux Centralux I have a Electrolux Centralux. When I plug the hose in at one of the wall outlets the motor will not start. If I go to the motor and slap the unit it will start.....then...it will not stop unless I unplug the power cord to the motor. If I plug the power cord back in, the unit will not restart until I slap the motor unit again. The unit has only been used 20 - 30 times. Any suggestions?? Thanks, Bruce


I dont know if you had your unit looked at yet but it sounds like the Power module is going. I repair the machines so I know some of the work. ... Electrolux Centralux Vacuum

Pool universal wall fitting for pool needs to be replaced


... Vacuums

Unit has power from Plug to unit. Current flows all the way to switch and switch seems to be ok but unit will not turn on. Wife says it was cutting on and off when moving it around. Checked conntec


You either have a bad switch oir you have a short in the cord.plug it in and turn it on then move the cord around from top to bottom and see if it acts up..if not tap on the switch afew times and if it cuts out then the switch is bad.try to plug it i ... Vacuums

I am an athletic coach and use four Terrain 550 radios and assistants to help coach, moniter and time athletes at various distances away from me. I would like to be able to communicate with the athletes directly, both ways, but have not been able to find a suitable headset unit to use with these radios. Please can you arrange to supply or recommend some headset units compatable with these radios? Even better, units with mikes to enable the athletes to run relatively hands free. Many thanks f


You can try these links 1. http:// ... Vacuums

I HAVE YOUR UNIT MODEL CD1493. THE POWER CORD PLUGS INTO THE BACK OF THE UNIT OK,BUT, IT A VERY WIGGLY CONNECTION. AS A RESULT THE UNIT OPERATES VERY INTERMITTENTLY. WHAT CAN I DO.


Hi,\012Try to spred the pins slightly so that they hold the plug more tightly...otherwise the only thing to do is to try and buy a replacement cord...\012\012heatman101 ... Vacuums

I have a Royal 7910 extractor and even though I vacuum before cleaning the carpet, by black cocker spaniel's hair gets pulled into the plastic pick-up attachment and I cannot find an easy way to clean it out. I have tried taking the screws out to separate the halves, but it seems as though they might be glues together. I have run water from a sink sprayer though the openings with some degree of success, but it still is pretty cruddy. I have tried snaking pipe smokers pipe cleaners up the pick


One person wrote this in a review:\015\012Most home carpet extractors are very difficult to take apart for cleaning and maintenance. The Royal 7910 is the exception. No tools are needed to take the front housing off to clean out all the pet hai ... Royal CE7910 Wet/Dry Vacuum

Wet/dry vac wall mount unit makes loud whistling noise


... Craftsman 17026 Wet/Dry Vacuum

The wall outlets do not turn on. The motor runs at the unit. I have reset and it blows/sucks at the unit. The canister is empty. Thanks, Je


You main low voltage line from the vac to the house is likely disconnected. Start by looking at the connection where the small wires enter the vac. Touch across those two wire terminals with a screwdriver or needle nose pliers and the vac should star ... Broan-NuTone CV450 Central Bagged Central System Vacuum

Moves in circles and backwards, though will not move forward


Sounds like your bumper switch is stuck. try pulling on the bumper to free it, then clear any obstructions you find. ... iRobot Roomba 4210 Bagless Robotic Vacuum

I've had my Dyson DC14 vacuum cleaner now for approximately 9 months and been very happy with my purchase. However, It is used sparingly maybe twice a week at the very most. The problem is when I try to use the item on my carpet, you have to push really hard to get it to move. It's as though the suction power is far to strong. It certainly doesn't glide as I think it should. It still picks up as usual but I cannot imagine that having to 'force' the machine to move is the normal operating procedu


Thanks for your question!I'm sorry that you haven't received an answer yet.The response rate on FixYa FREE questions is usually over 80%, but sometimes questions go un-answered when:1. the question is unclear, incomplete, or poorly ... Dyson DC14 All floors Bagless Upright Cyclonic Vacuum

I have Nutone VX550C. Motor runs intermittently (cycles on and off rapidly--the light on the handle is blinking furiously) when I use the on/off switch on the hose. This happens at all of the wall connectors, so suggests a hose contact problem. Motor runs continuously when I turn it on at the switch on the wall unit.


The unit does have a switchs the PVC outlets, and it sounds like the hose mech to operate the switches is broken, and intermittently making contact. A replacement hose would likely fix the problem. Looked them up on the net, and they're not che ... Broan-NuTone VX550 Bagged Central System Vacuum

I bought Hoover Wind tunnel central vacuum 2 weeks ago from Costco. There are no instructions how to mount the metal canister to the garage wall. Brackets to mount to wall not supplied with the unit. How can I download the instructions ?


There is a hinged bracket for this unit which has a 5" bolt through it. It comes from CanaVac who manufactures under label. If you cannot find this large U shaped bracket on the body or in the bucket, either return to COSTO or call Canavac and explai ... Vacuums
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0403 seconds