Having problems with your Vacuums ?

Hoover cuts out after 5 minutes and will not restart until its cooled down.


Answers :

OK - so it cuts out because it's overheating. The cause of this is almost always a blockage. You don't say what model of vacuum this is, so I can't guide you where to look. If you've got flexible hoses, check them. Also check all filters and any other airways you can get at. If you are 100 percent sure that everything is clear, but the problem persists, then the motor's at the end of its useful life.
Repair Help & Product Troubleshooting for Vacuums

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Hoover cuts out after 5 minutes and will not restart until its cooled down.


OK - so it cuts out because it's overheating. The cause of this is almost always a blockage. You don't say what model of vacuum this is, so I can't guide you where to look. If you've got flexible hoses, check them. Also check all filters and any othe ... Vacuums

DC07 cuts out and stops after about 1 minute's use. It will restart after being left for c. 5 minutes. It seems, therefore that it must be overheating, but an independent electrician could not find any problem.


... Dyson Vacuums

Vax mach 7 cuts out then restarts after a few minutes


... VAX Appliances Vacuums

Why does my MCE3011 cut out after a few minutes-it restarts after being switched off and left for a short while?


... Panasonic MC-V7380 Vacuum

Nutone central vacuum shuts off after a few minutes running then will restart after motor cools down I cheked motor and vent ports blown out all clean


Sounds like you have an overtemp switch that is tripping and shutting your motor off. Many motors use what they call a 'snap switch" ( looks like a small disk with two wires on it ) to sense motor temp and if that trips, then it will temporarily disa ... Vacuums

Hi my dyson vacuum keeps cutting out after several minutes, We have to leave until it cools down. Anything we can do?


It either has a clog (most likely) or a bad heat sensor ... Dyson DC07 Bagless Upright Cyclonic Vacuum

Cutting out after five minutes use


Sounds like not good air flow check for blockage new filter ... Vacuums

After using the unit for a few minutes it cuts off.


The electric motor inside your Dyson has a built in over-current trip to protect itself (and you if it seriously overheated and caught fire). This normally automatically resets itself, however if the motor has just about had it, next time it is switc ... Dyson DC07 Bagless Upright Cyclonic Vacuum

Roomba cuts off after a minute or so.


If you have a 400 series Roomba, try removing the battery, then holding down the power button for ten seconds, then recharging the unit before you run it again.\015\012\015\012If you have a 500 series Roomba, don't take out the battery-- ... iRobot 4150 Roomba Vacuum

My Dyson DC07 stops working after a few minutes. It works again after a further 10 minutes and then cuts out again. I have cleaned the filter and checked for blockages but is still cutting out. Can anyone help?


Have you tried calling Dyson? I had a problem with my Animal, and their tech department talked me though the fix. Worth trying them first. ... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum

CUTTING OFF Our Dco7 cuts off after a few minutes of use. If we wait a few minutes and power it back on it will turn on but turn off again by itself.


Ok What is probably causing the problem is an internal error inside the vacuum. What I recomend you to do is take it back where you bought it and tell them what ever is wrong with it.PLEASE RATE MY ANSWER AS SOON AS POSSIBLE! ... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum

My Panasonic MC-E3001 vacuum cleaner works for a few minutes & then cuts out. I changed the bag & it worked again for 2 minutes but then cut out again.The pipe that sticks out of the side has a clip on it but it doesn't seem to be holding anything.


... Vacuums

We just purchased a Miele upright s7000. I vacuumed for 5 minutes (literally) and it completely shut down. Waited the suggested 30 minutes for cool down, but nothing happens. Waited another 30 minutes and still nothing. My husband checked for clogs according to the manual but still nothing at all. Is it just a dud?


... Miele Vacuums

Why does my dyson dc04 work for about 5 mins then cut out the wire on my dyson 04 needs replacin but i cant get the casing off. My DC04 cuts out after abou 5 minutes use. I think there may be a thermal cut-out somewhere?


Thermal cut out in coils of motor,you have not been keeping filers clea,I THINK.\015\012motor is avaliable ... Vacuums

I HAVE A BRAND NEW HOOVER MACH-3 CYCLONIC THAT CUTS OFF EVERY FEW MINUTES. IT IS DRIVING ME CRAZY! IT'S LIKE AFTER 5 MINUTES OF VACUUMING IT HAS TO SIT FOR A LEAST AN HOUR THEN YOU CAN VACUUM FOR ANOTHER 5 MINUTES. HELP!


If it were mine and it was brand new I would bring it back and exchange it. It sounds like the motor is over heating and shutting off automatically. Does not sound good. My advice return it. ... Vacuums

After running for 15 minutes, the windtunnel vacuum cleaner shuts off. It will not restart until it has been off for 30 minutes. Could it be overheating for some reason. All of the filters are clean; the dust tank is empty; the belts have no cracks.


It's not necessarily overheating, but the thermal-fuse is definitely tripping and it takes 30 minutes to reset. There are several causes of this (in most common order):\015\012\015\0121. A blockage in the suction system or a full dust tan ... Hoover U6630-900 WindTunnel Bagless Upright Vacuum

The unit works fine for 10-15 minutes, then the power cuts off. If I let it rest for 15-20 minutes, sometime it starts right up again. The filters clean clean, the brushes are not restricted, the retainer is empty. ???? Tom Abbott


Hi, it is over heating due to insufficient air passing through the motor and a heat sensor is cutting out the power due to a blockage maybe a filter or a cloged hose.\015\012\015\012\015\012The ... Dyson DC07 All Floors Bagless Upright Cyclonic Vacuum

Brush turning slowly while shampooing. It starts out fast, but after a minute or 2 the brush is not spinning very fast. I have powered it off and let it cool down. I just started out so I can't believe the engine is over heating, just doing 2 rooms, can't even get through the first room. If I take the brush attachment off, then put it back on and then turn it on, it spins fast, but after a a few minutes, it's spinning softly/slowly again. Kirby diamond edition


Track not set properly in grooves\015\012there could be a clog or the cleaner has built in feature to slow down heads for better cleaning this does it on its own ... Vacuums

The motor running the beater bar on ny Electrolux canister vacuum cleaner runs intermittently. It runs about 2 minutes and then cuts off and automatically starts again after a 1 to 2 minute interval. I have tried taking it apart and removing the dust and grit in the beater bar attachment but with no change in operation. What would you suggest?


Check all the wiring connections to make sure they're tight. \015\0121/2. Wiring to power nozzle motor or reset switch is loose.\015\0121. Cord from power nozzle to upper wand. If the plastic portion of the wand is cracked near the co ... Electrolux UltraLux 2000 Bagged Canister Vacuum

The unit works well for 3~4 minutes and then stops. Wait another 10 minutes to cool down and it works again but the same issue happens again and again. It is a brand new unit. I read the manual for the thermal detector and did what it says but the issue is not resolved. Thoughts?


Hi, I have a Hoover Bagless myself. I also have worked professionally fixing Vacuum Cleaners. There may be some material caught between the roller end and the end bearing or the edge of the roller compartment. This could b ... Hoover UH70015 Bagless Upright Cyclonic Vacuum

After vaccuuming for less than five minutes, the vaccuum shuts off and we need to unplug it for 5 minutes before it will restart


It sounds like the motor is getting tripped out. It could be caused by having a clog somewhere in the unit, could also be that your filters are clogged. you have 2 filters on that unit. One is under the canister, looks like a drawer that slides out a ... Hoover U5780-900 Windtunnel Cyclonic Bagless UprightVacuum

My Roomba runs for about 3 minutes, then shuts off. If you push the buttons(S,M,L max etc) it will restart for another 3 minutes. The battery is new???


You will need to remove the debris off the cleaning head module. ... Roomba Robotic Floor Bagless Vacuum

I have just purchased a new Nilfisk vaccuum cleaner 150 extreme and used it for 5 minutes and switched it offf. When I tried to restart the machine it would not start. I cannotg et it to restart-how to i solve the problem -the power light is on


If you're just purchased it I suggest you need to check where your local Warranty Agent is and take it there for a service. Since this model has an electronic switch (do the lights flash on and the middle one stays green when powered on at the power ... Vacuums

It runs for a couple of minutes shuts off then restarts 30 seconds later runs a couple of minutes and does this over and over


Most vacuum motors are protected from overheating by a thermal switch that resets after cooling down. Check for blockage in the hose,\015\012power head or a full bag that would block cooling air from cooling the motor.\015\012\015\ ... Tristar Vacuums

Run cut off -run cut off every ten minutes - Dyson Vacuums


The TOC(thermal overload cutout) on the motor is getting too hot - thats why it keeps shutting off and starting again once its cooled, so make sure your filters are clean and they are no blockages in the hose or the brushbar compartment or any where ... Dyson Vacuums
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0185 seconds