Having problems with your Vacuums ?

My hoover windtunnle modle #u6425-920 leaks oil. where would it be coming from?


Answers :

There is no oil in these self propelled vacuums.
Repair Help & Product Troubleshooting for Vacuums

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

My hoover windtunnle modle #u6425-920 leaks oil. where would it be coming from?


There is no oil in these self propelled vacuums. ... Vacuums

Where would OIL come from by the right side back wheel?I have a hoover wind tunnle model # u6425-920. Does the drive moter have oil in it if so and it is leaking should we replace the motor?


The motor does not have oil in it. The onnly thing I can think of is that if soemone had tried to free up something by using a spray lubricant, and not it is running out. I've never seen this issue. You would have to let a repair shop look at it. ... Vacuums

I was using my Henry Hoover as usual. When i sucked up quite a fair sized puddle of water. The hoover instantly cut out and a strange burning smell was coming from it. Would this be the fuse, motor etc ? Or would it be worth my while just replacing the entire hoover ?


Hi. I have to wonder why anyone would **** up a puddle of water with a dry vacuum cleaner (with no earth lead). I realise that your question may simply be a joke, but if you are serious, I think it is probably fair to assume that it is now dead and p ... Vacuums

I have a Hoover Platinum carpet cleaner, and it has stopped dispensing cleaning agent and water. This model has a separate tank for water and separate tank for shampoo dispensing. It also has a power hand unit that dispenses shampoo. All along the hand unit has continued to dispense shampoo. Symptom #1, the water tank seemed to be taking on shampoo, as it was getting sudsy. Symptom #2 - On wash mode, nothing would come out, on Rinse mode, sudsy water would come out. Later, symptom #3 - not


Somewhere on the outlet is a control tap thats driven by a rubber band and something is up with this control ,best advice here is put it in the boot of the car and take iot to a hoover dealer ,they will do it seconds for you ... Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum

We have a hoover porta vac. that at first it would sometimes come on and sometimes not. It did completely stop coming on, so I have changed the switch and the cord but with no luck. Could you offer any suggestions or is this a motor situation. To my knowledge the motor was not making any noise. Your help would be greatly appreciated. Thank You, Molly Maid of NW Fla.


If this has had heavy use, the carbons in the motor may be worn. ... Hoover CH30000 Bagged Canister Vacuum

I have a hoover F5915-900. Today when I got it our to use it I noticed that it was leaking. I did some troubleshooting, but not sure where to go from here. The solution tank leaks out if the recovery tank is connected also. If I remove the recovery tank and leave the solution tank on it does not leak. Any suggestions would be appreciated.


It dont shamppoo my carpet dont come out or **** it up the hose for funture workes good no sham pooer for rugs ... Hoover F5915910 Upright Steam Cleaner

My hoover steamvac(purchased less than a year ago) leaks the dirty water. I checked the tank and nothing is broken/cracked. Im not sure how the water would be leaking. Please help!


... Hoover F5915910 Upright Steam Cleaner

THE NEUTRAL/DRIVE LEVER HAS COME AWAY FROM THE HOOVER AND SOME OF THE INSIDES HAVE ALSO COME AWAY. I WOULD LIKE TO KNOW HOW TO PUT IT ALL BACK TOGETHER


I dismantled the cover, withdrew the gear drive assembly and found the bits that had come loose. The mechanism that selects neutral or drive had come away from its shaft. I simply put it all back together and tightened everything back up. Works a dre ... Kirby Heritage II Vacuum

My hoover steam vac is leaking. the water seems to come out where it should by the brushes but it all leaks out even when not depressing the button. seems to be suctioning fine.


The problem you describe is a bad resevoir. I have replaced a few in this model series. Take it to an authorized dealer for repair. ... Hoover F6212-900 / F6215-900 SteamVac Agility Upright Vacuum

I have a hoover steamvac dual v and is leaking, bristels not working very food only two are speaning and is not sucking any water Very little solution comes out, or comes out in streaks when pressing the solution dispenser button on the handle. I think the lines may be stopped upped.


Http://geeksquad.fixya.com/ThreadView.aspx?prdid=41020&thid=634728\015\012I have a Hoover SteamVac\015\012Posted by albazo on May 30, 2008\015\012I have a Hoover ... Hoover F5866-900 SteamVac Deluxe Wet/Dry Vacuum

Using my hoover steam vac tonight and too much water coming out. once it's turned on, water and shampoo continuously come out underneath until tanks are empty. looks to be leaking from left side bottom as looking at it standing behind the unit


Make sure that you have filled everthing properly and the hoover steam is in a good condition. or check else is there any loose coonections in the bottom of the hoover, which makes the tank empty.if the problem persists take it to service. ... Hoover Steam Vac Dual V w/ SpinScrub Vacuum

I have a Hoover U5750-900 Windtunnel Bagless and For some reason, the belt has been replaced correctly, but there is a very LOUD vibration/rattling coming from the agitator, like it's hitting the assembly/bottom plate? Is there a reason that there would not be enough distance from the plate?


... Hoover U5750-900 WindTunnel Bagless Upright Vacuum

Hoover F7431900 I am using this for the first time in a little while and both tanks, the water tank and the cleaning tank are both leaking. Any help in this matter would be appreciated!


The tank you are talking about has the soap container attched to the back of the water tank, then probably you need to replace the tank. If this has different tanks, then you may have to replave the seals that the tank sits on. ... Hoover V1 SteamVac SpinScrub Vacuum

Vax carpet washer deluxe leaks from bottom of water tank, somewhere between coming out of the tank and going into the jet to squirt on the floor. pissing me off - any help would be great!


Just stripped VAX rapid carpet cleaner model v-025 down found out the internal plastic water valve keeps sticking in open position causing the water to free flow on the carpet when it should be closed pop the water flow regulator part out of housing ... Vacuums

I have a Hoover Steamvac model #f5888-900. Recently, after finishing use, it leaks a lot of water from the bottom of the unit onto the recently cleaned carpets. Do you know what would cause this spewing of water after completion of use?


Either the rod in the handle is holding and not releasing the resevoir asm, this where the tank sits on, is bad. So water is not being shut off completely when off. ... Vacuums

Hi,My agitator brush won't run on my hoover S3590, I changed the belt, that didn't work. I don't see a possible cause in my book except replacing the belt. I think there could be a short, the brush will come on sometimes when pulling back and slightly lifting. Any ideas would be great and can I fix it myself? Thank you for any help, Bobbie


Hi Bobbie\015\012Take apart the electro floor head if you can and inspect inside - it may well be that there's clogged dust preventing the brush from turning and also check both sides of the actual beater bar as thread and tangled hair can often lead ... Hoover S3590 Bagged Canister Vacuum

Hi, the Hoover f5915-900 that we have is leaking the clean solution when we are using the attachment. but the leakage seems to be coming from the bottom of machine


With this style of machine there are hoses, or connections to transfer the cleaning solution. these can fail after some time. Stop using the machine, leaking fluid onto the internal parts can become a electricution/fire hazard. take the unit to a ser ... Hoover F5906-900 Upright Steam Vacuum

I have a Hoover self propelled WindTunnel vacuum( Model U6425-920) that stops in the middle of cleaning. I have changed the flat belt and I'm still experiencing the problem. I usually have to wait an hour or so b/4 it would work again. Any advise?


Http://geeksquad.fixya.com/ThreadView.aspx?prdid=0&thid=632298\015\012Generic problem for all Vacuums\015\012I have a Hoover self\015\012Posted by thjunk2007 o ... Vacuums

Hi , I have an Electrolux powerplus 1800 hoover Z4492 the hose that attaches to the telescopic pipe snapped and tried to get out the grey plastic out in one bit but it snapped ..if i got another telescopic pipe would it come with the grey tube that sits in the hole to keep the hose in place ?


... Electrolux Vacuums

I need to get a manual for my hoover floormate. The modle number is 120v If you could help that would be great. Thanks


I need instructions for a hoover f5857906 ... Hoover Vacuums

Hoover uh70015 motor noise, how to put oil or lube the motor


... Vacuums

Have DC07 that won't come on. Wife said this started happening a few weeks ago. Would come on and then other times would not come on. Now will not come on at all. Believe I have a lose wire. Have taken off star screw by on off switch, but cannot find how to get plastic parts apart to get into electrical connections. How do I do this? I am sure I am missing something simple?


... Dyson DC07 Bagless Upright Cyclonic Vacuum

For some reason, our shark steam mop stop working. Usually after I plug the steam mop, the power light would light up then you would hear & see steam coming out of the mop's head but all of a sudden no power light would go on and no steam would come out. I can still use the mop, cause water from the tank still is able to flow down to the head. It's just that I'd have to use it like an ordinary mop not as the steam mop I liked. Pls help!!!


... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

Hoover wiring the blue wire that is in the lead that runs from the hoover to the plug that goes in the wall has come loose at the hoover end and has come out of the actual hoover. i've unscrewed it but am unsure as to where the blue lead (bare copper) needs to be screwed... if you see what i mean?!!


Hello lukeplayer,\015\012Based on your description, ( first disconnect the plug from the wall recptacle).You will need to open up the Hoover Vacuum Body to gaion access to the internal wiring. In order to better assist you, please provide me wi ... Hoover Vacuums

Hoover Model U8185-900 beater bar part keeps smoking and burning up We've replaced the part Hoover PCB Display Bridge U8172 three times and the vac beater bar works for about a minute then the part starts to smoke and burns out again. I've taken everything apart but cannot locate anything that would cause this part to burn up. I think if I did not disconnet immediately, he vac would catch my rug on fire. Help? I didn't send back the warranty card, so I can't get any help from Hoover. Any suggest


I'm not sure why this is happening. Perhaps if you would contact Hoover and explain the problem to them such that it appears that there is a safety issue with their product, they might be more cooperative. If that fails, I have had luck writing let ... Hoover U8185-900 Upright Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0796 seconds