Having problems with your Vacuums ?

Hoover vacuum cleaner indicators stuck

\015 It's a Hoover windtunnel bagged upright, model U5472-900..1.\302\240 The dirt finderlight is stuck on red.\302\240 I assumed that the sensor needed to be cleaned,but I can find neither the sensor nor wires that might lead to it.\302\240 Theinstructions I found online seem to refer to other models, because theydon't work for my vacuum cleaner.\302\240 The switch is set to regular, nothigh.\302\240 No matter how long I spend on an area, the light never turnsgreen, but it flashes green occasionally, so the light still works.2.\302\240The bag check indicator is fully orange even though I just changed thebag.\302\240 Is there a particular place I should check for clogs (I haven'tbeen able to find any), or is there a way to reset the indicator?\015

Answers :

The sensor is located in the tube that the bag mounts to, if you take the bag off of the unit and have an air compressor handy you can blow out the port hole this should dislodge the particulates that are causing the false reading, there is defintely a clog in the system. let me know if this helps thanks Don the Vacuum Doctor Alb, N.M.
Repair Help & Product Troubleshooting for Vacuums

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Hoover vacuum cleaner indicators stuck


The sensor is located in the tube that the bag mounts to, if you take the bag off of the unit and have an air compressor handy you can blow out the port hole this should dislodge the particulates that are causing the false reading, there is defintely ... Vacuums

The Hoover freemotion pureair vacuum cleaner cord is stuck and won't retract.


... Vacuums

Sanyo SC 340 vacuum cleaner red indiactor is stuck


... Sanyo Vacuums

Hoover tc5238 bagless cylinder vacuum cleaner - no suction


You have a clogged hose. Sometimes a Q-tip or something like that gets sucked up and then stuff jams up against it. You can use a long stiff wire with a hook bent in the end to reach the jam and work it loose. Just be very careful not to poke the wir ... Vacuums

I have a Hoover Windtunnel vacuum cleaner and new high pile carpet. The vacuum cleaner will not move forward without extreme effort. I have been told that I need a vacuum without a beater bar and that the beater bar can be disengaged. How do I accomplish that? Thanks


You can adjust the height on some vacumes like for bare floors and medium nap it will adjust how far the beater bar is from the carpet see if your is adjustable ... Vacuums

Hi all---I have a Dirt Devil 091020V. there was a problem with the wand where it was the only thing sucking even when it was stuck in the tube it would ****--but nothing from the vacuum end--the diverter was stuck closed I took it apart and found something stuck but in the meantime the torsion spring [I think} fell out and I don't know where it goes--so now only the vacuum works --not the overhead cleaner part.. is there a digram somewhere that can tell me where it goes--I think it might b


... Vacuums

Change belt Hoover vacuum cleaner U4247-030 - Hoover Vacuums


... Hoover Vacuums

Kenmore Progressive canister vacuum cleaner: MODEL # 116 27615700 When the vacuum cleaner is running, the performance indicator light is red (lit up). What should I check in order to trouble-shoot and solve this problem?


... Kenmore Vacuums

I have a Hoover Tempo plus attached tools vacuum cleaner, 12 amps, Model #S2541, Series J3.6 and I do not have instructions on how to use it. Can you e-mail me the instructions for this vacuum cleaner? Thanks!!!


... Vacuums

Replacing wheel Hoover spirit vacuumm - Hoover Spirit Canister Vacuum Cleaner Non Electric Hose Canister Vac Cleaner Non Electric Hose


... Hoover Spirit Canister Vacuum Cleaner Non Electric Hose Canister Vac Cleaner Non Electric Hose

Hoover windtunnel red light stays on - Hoover U6476-910 WindTunnel Upright Vacuum Cleaner Bagged Vacuum


... Hoover U6476-910 WindTunnel Upright Vacuum Cleaner Bagged Vacuum

Replace motor hoover windtunnel - Hoover U6476-910 WindTunnel Upright Vacuum Cleaner Bagged Vacuum


... Hoover U6476-910 WindTunnel Upright Vacuum Cleaner Bagged Vacuum

Hoover carpet cleaner not picking up water - Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum


Assure the ring gasket is in place under the hood. A round rubber gasket must be in place on the round tube under the hood where the recovery tank sits to connect the vacuum from the motor to the round tube on the bottom of the tank. ... Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum

I own a self-propelled Hoover Wind Tunnel vacuum cleaner (Model U6425-920). I do now have an owner's manual and was wondering how to clean the Hepa filter on this model (*this model uses a vacuum cleaner bag also).


Http://geeksquad.fixya.com/ThreadView.aspx?prdid=0&thid=794479\015\012Generic problem for all Vacuums\015\012I own a self-propelled Hoover\015\012Posted by goh ... Vacuums

Hoover Model# U8185-900 Problem: No suction, not engaging Vacuum cleaner roller spins as usual, but there's no suction when trying to vacuum the carpet. Can anyone point me in the right direction? Tha


... Hoover U8185-900 Upright Vacuum

Suction problem I have a Hoover Widepath Fold Away, 12 amp motor vacuum cleaner and the problem I am having is every time I vacuum, the vacuum gets clogged up with carpet. I am probably only able to do one stroke then it gets clogged and I have to stop and unclog it or it spits it out on the carpet. This is very frustrating and I don't get much vacuuming done. Please can you help me. Thank you. Gwen email is [email protected]


Get rid of the carpet its shredding and falling apart.no sence in vacuuming old rotten carpet.or try using a vacuum without a brush roller and just suction ... Hoover U8145-900 Savvy Bagless Upright Cyclonic Vacuum

My Miele vacuum cleaner has the red triangle light on and keeps switching on and off. Is it broken? have been hoovering upstairs and I noticed the hoover had the red triangle light on. I changed the hoover bag but it still kept going on and off. Is this an overheating problem or is the hoover on the way out?


... Miele Vacuums

Lid to kenmore canister 360 hepa vacuum cleaner, lid to change vacuum bag stuck in open position


GoVaacuum2,\012\012I have the same problem and that didn't work.. ... Kenmore 25512/ 25513 Progressive Canister Vacuum

Vacuum cleaner makes very loud noise when starting to vacuum - like something is stuck in roller area


Hi there,I'm sorry to hear you're having difficulties with your DC33. The brush control is designed to make a ratcheting sound to warn you if something is obstructing the brushbar. If you've checked the cleaner head and brushbar already, I'd ... Dyson DC33 Animal Bagless Upright Vacuum

Miele Flamenco II vacuum cleaner suction indicator not working


... Miele Vacuums

My hoover Wind Tunnel vacuum cleaner's motor spindle keeps overheating. Because of the high temperature, it keeps burning through belts (the big, wide ones). I have taken it in to the vacuum repair shop about three times now, and the problem has never been fixed. Does anyone have any advice on how to fix this or should I just buy a new vacuum?


... Vacuums

I have a Miele Vacuum cleaner MedicAir 5000 Plus. Recently the Dust Bag Indicator bar is full during normal cleaning and consequently the suction power is much less. I replaced the dust bag, engine pre-filter and Hepa filter but no change. When i remove the hose, the Indicator is normal, but when i attach the hose, wand, head, the indicator is full. I checked the hose, wand, head but can't see any blockage and when i blow with my mouth it seems fine. Can anybody help? thanks!


... Miele Vacuums

I have Hoover WindTunnel Air Upright Vacuum - UH70400 just used couple of times. While vacuuming the carpet carpet fringes were rolled up in to brushroll and brushrol stopped working. It means vacuum is not working effectively now. Brushroll indicator is flickering.


... Hoover Vacuums

Hoover vacuum carpet cleaner will not sucktion (sic)


No, this cleaner uses no belts.\015\012If you are having a suction problem, first check that the lid on the recovery tank is lined up to the tank when installed to get a good seal.\015\012Second, remove the tank and make sure the round bl ... Hoover F7425-900 SteamVac V2 Widepath Upright Vacuum

Hoover Vacuum Cleaner bagless 2000w manual instructions needed


... Hoover Vacuums
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0806 seconds