Having problems with your Vacuums ?

Hello, we have a Miele cat and dog turbo 5000 vacuum cleaner which we bought in December. It has just started blowing air out of the grid on the top of the cleaner instead of sucking from the tube. The whole top section which is opened to change the bags doesn't seem to want to clip down properly either. Do you have any ideas> I'm gutted as it was so good until this happened. Thanks Michelle.


Answers :

The lid not closing properly is almost certainly the cause of your problem. Without that lid sealed tight to the body you will get no suction through the hose. So, the question is: why isn't the lid clipping down properly? Did you just change the bag? You need to check that the bag is properly located and that there's nothing getting caught where it shouldn't be. Get the lid closing properly and your problem should be solved. Good luck!
Repair Help & Product Troubleshooting for Vacuums

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Hello, we have a Miele cat and dog turbo 5000 vacuum cleaner which we bought in December. It has just started blowing air out of the grid on the top of the cleaner instead of sucking from the tube. The whole top section which is opened to change the bags doesn't seem to want to clip down properly either. Do you have any ideas> I'm gutted as it was so good until this happened. Thanks Michelle.


The lid not closing properly is almost certainly the cause of your problem. Without that lid sealed tight to the body you will get no suction through the hose. So, the question is: why isn't the lid clipping down properly? Did you just change the bag ... Vacuums

I have a Z345 Electrolux cylinder vacuum cleaner, from the 1970s probably, but not used much. I have lost the guide. I forgot to change the bag before it was full. Smoke started to come out - smelling of burnt paper, not rubber. So switched off. It did not blow the fuse, and may be OK. I wish to inspect it. How do I open it up? Alos I have an air filter and a motor filter for it. I have often changed the air filter on the top. How do I get at the motor filter, if there is one? Than


Good day! OK you have to is replaced the bag and that's it.And don't forget to change the bag again to avoid that problem.Thank you ... Electrolux Guardian Bagged Canister Vacuum

Filter queen masjestic vacuum cleaner has a light that should light up when the filter needs changing, it doesnt want to light up. I dont think its burnt.


That is a overhead light not a filter light. If your waiting for the light to come on before changing your filter or haveing the vacuum serviced your going to kill it. Every time you empty the container you should replace your white filter come and O ... Bosch Vacuums

I do not know how to open the vacuum to get access to change bags. the bosch pro parquent vacuum cleaner


... Bosch BSA2822 Pro-Parquet Bagged Canister Vacuum

How do I change the outer bag clip? Can't figure out how to get the top apart to put in the new clip. The clip that goes to the handle.


I had a Kirby Classic and I had to slide off the clip.Don't rate me if this doesn't work. ... Kirby Generation 3 Bagged Upright Vacuum

I want to open the motor of vassum cleaner ....how


Let me know what kind of vacuum it is and the model # and ill walk you through it ... Vacuums

How to open a electrolux ultra one vacumn cleaner model z8871p to change the dust bag


Canker Sores Vs. Cold Sores http://www.youtube.com/watch?v=iJ4mg3xrPDM ... Electrolux Vacuums

I have Sharp vacuum cleaner Model EC-8400C-A. It is not working and I want to remove the cover so that I can fix the problem. I do not want to break to casing as there are no screws just some hidden clips. Please guide me. Thanks


... Sharp EC-6312P Bagged Canister Vacuum

My electrolux epic 6500sr vacuum has a seized motor. How do I acess the motor to service or change it? There are no obvious screws or clips to open the motor outer case


... Vacuums

How do you open a wertheim 2000P vacuum cleaner?


Hi there, \012SmartAlec from NelsonVacuums.com.au here. The ET2000 has a latch that is located at the very end of the machine lid (about 6 cm in front of where hose clips in. If you sit the machine up on its back end you should see the black le ... Vacuums

Trying to change belt in kenmore 3116890 upright vacuum cleaner model116. Can't open vac


... Kenmore Vacuums

I want to open the motor of vacuum cleaner model Samsung SC5991....how ?


... Vacuums

My vacuum cleaner stopped working without any smell or anything. I took to a local repair person and he said nothing wrong except motor he tried new hose, etc. And he wants to change the motor..


I would go with the repair man and what he says. They know what they are talking about and if he was trying to rip you off he would have suggested many things to repair and then after you had spent a few hundred he would have told you to replace the ... Kenmore 25512/ 25513 Progressive Canister Vacuum

I want to change the motor on my Electrolux 6500 Epic. How do you get the shell open?


Some use computer proof torx screws,youll ned a v long screwdriver.cheaper to buy another one new ... Electrolux Epic 6500 Vacuum

My Panasonic MC-E3001 vacuum cleaner works for a few minutes & then cuts out. I changed the bag & it worked again for 2 minutes but then cut out again.The pipe that sticks out of the side has a clip on it but it doesn't seem to be holding anything.


... Vacuums

Hello, Could you send me an exploded view of an engine kirby please? My Kirby vacuum cleaner I think for 1997 I think it is garnet, having wanted to change the coals, I do not know the back, is the cause of my request, I contacted a person previously in Bastogne (Belgium) several times which promised to help me but in vain, I count on your good will so I can reassemble it and use it again. In advance, thank you


Try this site out:www.onlinevacshop.com/kirby-G5-parts-manual.phpGood Luck!Jim ... Kirby G5 Bagged Upright Vacuum

I have a Electrolux Epic 6500 SR canister vacum cleaner. It is nine years old and for the past few weeks it has started shutting off for no apparent reason.The symbol for bag change lights up and it cuts off, but even after I have put a new bag in, it still does the same thing. Do you have any suggestions? There is a little button or switch that the top of the bag fits on. Do you think it could be the problem?


Your machine is probably clogged, look through the wands, look in the bottom attachment, to see if there is anything stuck there. You can also drop a marble through the hose itself to see if anything is stuck there as well. To unclog the hose try hol ... Electrolux Harmony Canister Vacuum - EL6985 Vacuum

Open top of, very-stuck closed, Steamfast 60 CJ (handheld steam cleaner)


... Vacuums

Vacuum cleaner does not start after getting warm, bag, that was full is changed, lights run across dispaly at top when I try to start it, cannot find my manual, can I download a manual for Excellio z 5240. Is there a fuse of something that has bo be reset?


... Electrolux Vacuums

I HAVE A HOOVER VACCUM CLEANER MODEL U8172-900. i HAVE TAKEN IT APART AND CANNOT TAKE THE TOP COVER OFF TO CHANGE THE BELT. CAN YOU HELP ME?


This must be a Savvy, Take off the plate covering the brush roll, then take out 2 screws from the bottom, turn it over, remove the Hoover emblem, there is another ***** there. Then the top cover will come off. ... Vacuums

I have an eureka power plus vacuum floor cleaner and i have no way of opening the botton to the brush to change my belt for the brush since the brush will not turn.


Look for two screws at the edge of the brush housing. You may see these ones on top. They will be black and recessed ... Eureka Altima Upright Vacuum Model 2996AVS Vacuum

Hover F7452-900 My brushes are not turning. I have taken the tanks off to check the switch that changes from carpet to hard terrain to Ceramic tile.I noticed that there is a spring that has came off. I tried to disassemble the top half (nose) of the cleaner but I have came to a stand still. I cannot figure out how to remove the cover so I can figure out where the spring should be attached. I have removed all the screws that are visible and it still won't budge. It is loose but on the back side o


Regarding the brushes not turning:\015\012\015\012Your filter may need to be cleaned. It is located behind your brushes. With your tanks removed and the cleaner unplugged; tilt your cleaner back. The filter screen located behind your b ... Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum

Model #22251502C. Want to change the belt on the beater. How do I get the top of the beater off?


... Kenmore Vacuums

Miele Cat & Dog vacuum gets VERY hot and is VERY loud. Hose has no restrictions and I have changed the dust compartment (motor) filter and the exhaust filter. It still gets hot when I run it with the top open and all filters removed, so I'm guessing the problem is with the motor. Should I be going into the motor compartment? If so, what am I looking for?


Hi\015\012\015\012The fact that it gets very hot could be due to a number of issues.,but the fact that it started making a very loud noise at the same time suggests that there might be more problems maybe brushes etc.\015\012\ ... Miele S514 Solaris Bagged Canister Vacuum

Hello, On the 24 of June 2010 I purchased an Oregon Scientific Solar weather Station with indoor humidity gadget in Budapest Hungary. I opened it and tried to put it in function only 10 days ago,at the end of November,because I had another one(not exactly the same),which I had had for several years and I wanted to change. I live in Israel. After I read the instructions I did everything I had read,but the outdoor temperature doesn't show off and the clock isn't correct either. What should


I'm a little confused about this question. You bought it in Budapest but live in Israel? This could be why the clock is wrong. Many of these Weather Stations (it would be helpful to know the model number) have radio controlled clocks, which pick up a ... Vacuums
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0913 seconds