Having problems with your Vacuums ?

Cannot locate a new/used hose/pipe for Goblin multisystem 3000 type 7413B


Answers :

Repair Help & Product Troubleshooting for Vacuums

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Cannot locate a new/used hose/pipe for Goblin multisystem 3000 type 7413B


... Vacuums

Cannot locate where to plug adaptor in. Sharper Image LumiNight Weather Station EW400 Instructions do not show or explain. Unit comes with adaptor which is mentioned in manual, but cannot locate a plug in on actual unit or sensor.


Hello--to plug in the power you'd need to open the base battery compartment ... Vacuums

GM 150 freestyle - need to separate 2 red halves to locate a problem. I am a retired electrician but cannot locate the means of opening the speed control end so that the whole top section may be removed. I would appreciate your help. Thank you. Ken.


... Nilfisk Vacuums

Dyson DC17 Animal User's Guide says put plunger in out position. I cannot get the plunger to move and I'm not really sure if I'm trying to move the correct part. Cannot locate my user's manual for help.


... Dyson DC17 Animal Bagless Upright Cyclonic Vacuum

The removable filter at the front is cleaned regularly, and is not clogged. However, the machine appears to be suffering from being clogged by dust, as it has started to make a high pitched noise, and I fear it may burn out. I can see some dust inside the front panel but cannot see how to remove the front to clean it out. (NB. I have located two screws - one on either side - but cannot see how to proceed further.) Please help! Thank you.


\015\012\015\012Hi,Here\015\012is a tip that I wrote about my Bissel but I bet you have the same\015\012problem and the hose is clogged...Bissell Bagless Upright\015\012 ... Vacuums

Cannot find a manual for Volta Electrolux Model ELV5505 Type Ae PN 77754


... Electrolux Vacuums

My new domestic Pentax cam 50 water pump is sometimes going to 0 bar and not cutting in I would like to adjust the lower pressure from 1.5 bar (22 psi) to 2 bar (30).I have a diaphram type pressure tank.


... Vacuums

Hoover Model U8185-900 beater bar part keeps smoking and burning up We've replaced the part Hoover PCB Display Bridge U8172 three times and the vac beater bar works for about a minute then the part starts to smoke and burns out again. I've taken everything apart but cannot locate anything that would cause this part to burn up. I think if I did not disconnet immediately, he vac would catch my rug on fire. Help? I didn't send back the warranty card, so I can't get any help from Hoover. Any suggest


I'm not sure why this is happening. Perhaps if you would contact Hoover and explain the problem to them such that it appears that there is a safety issue with their product, they might be more cooperative. If that fails, I have had luck writing let ... Hoover U8185-900 Upright Vacuum

I need a filter fo my Eureka/bagless vacuum cleanerez kleen upright 12 amps serial # 0805 00826 Model 432 Volts 120AC Type ae Hertz 60 Made in china i bought my vacuum in Wal Mart but they do not have a replacement filterindeed not convienent for me. So if you cannot supplied me with a new filter I will never buy another of your products. thanks iris Stevenson


... Vacuums

Goblin multi system - aqua cleaner 7413B.


... Vacuums

The roller has stopped rotating and I wanted to see if the belt needs changing. I cannot find out how to get to where the old belt is located.


Remove the bottom to find the belt. There is usually a spare in the compartment. I think there is 8 or 10 screws.\015\012\015\012Thanks for your interest in FixYa.com\015\012 ... Oreck XL21 Bagged Upright Vacuum

How do I replace the motor brushes in my DC11? I cannot dismantle beyond removing the pipe attachment. I've removed the 6 fixing screws that are visible, but the machine is still firmly "together" as if there are still screws that I've not located. Does it snap apart? Are there hidden screws? Paul


You can buy brushes but if the armature is overheating changing the brushes wont help ... Dyson Vacuums

My kenmore intuition vacuum seems to have lost suction and the check bag light comes on. the bag has just been changed (2x). cannot see if there is any type of blockage. any ideas? thanks. ps. only had this vacuum for 3 months.


If you bought it new then do not screw w it take it back to sears and demand a replacement or your money back Sears is very reasonable re this ... Vacuums

The electrical cord that plugs into the machine has burnt the tips so they don't make good contact also the points where they plug into are burnt. I cannot seem to locate where I can buy these ends


The only place you will be able to get these is through the manufacturer. ... Vacuums

My rival crockpot has settings of 0, I, II and a diagram of a pot. I have lost the manual and cannot remember what these symbols signify. For example, which is high?


O= off\015\012i= low\015\012ii= hi\015\012symbol= warm ... Vacuums

I have a Broan Nutone central vacuum. The power head seems to stall unless you lift up on the handle. I think I may need to change the belt but cannot find a place to purchase one to see if this is the problem Model number BN180 type 1


You are correct, you need a new belt. You can find belts for the Broan BN180 at www.vacbelts.com. ... Vacuums

I cannot locate an online manual for my floormate spinscrub 500


Http://www.hoover.com/pdfs/manuals/H3030.pdf\015\012\015\012Here it is. Thanks, let me know if this helps!Rene(The Vacuum Doctor) ... Hoover H3030 FloorMate SpinScrub 500 Upright Wet/Dry Vacuum

I bought an Ergorapido stick and hand vacuum EL 1002 type A and cannot find a new filter for it. I live in Camlachie Ontario Canada. Where can I buy one ? Thank you Ginette Robar [email protected] 519-869-4838


Try here Ginette\015\012\015\012http://electroluxservice.stores.yahoo.net/prontofilter.html\015\012\015\012Andy\01 ... Electrolux Vacuums

Need replacement drive belt for tempest Z178 cannot locate a supplier. any assistance please?


... Electrolux Vacuums

I have been given a Sanyo upright vacuum cleaner. It is a Performax 10.0 amps, Model SC-A102. I cannot locate bags for it. I live in Houston, Texas


Two solutions come to mind---1) Find a local vac store, NOT a department or big box store, and bring the bag to them.Sometimes on the bag is an identifying letter or number and on many you need to remove the bag to see it. Also bring your make/model ... Sanyo Vacuums

Beater Bar The "Beater Bar" or roller with brushes on it, is not spinning, therefore not picking up. I cannot locate my manual and need to know if it is belt driven and how to get at the belt to identify the size and purchase and install a new belt. Thank you for any assistance. [email protected]


Take off the bottom plate, then you can get to the brush roll and belt, on the model number plate, the number of the belt is on that, it is also on the belt if you can still make it out. ... Hoover U6437-900 / U6439-900 Windtunnel Bagged Upright Vacuum

I cannot locate a store in Nashville TN that carries a Royal Dirt Devil Vacuum style 12 belt. Can you?


Try a walmart store ... Vacuums

I have lost instructions on how to use goblin multisystem 1200


... Vacuums

We have a Bissell 2090 quick multi surface steam cleaner and no steam comes out. We cannot locate the manual on how to operate the system


... Bissell 2090 QuickSteamer Upright Vacuum

I am trying to get to the on/off switch on a Panasonic MC-E851 . One of the two screws has a very unusual head and I Cannot find a tool to fit . What is the head type of the screw called to allow me to buy a tool to foit?


... Vacuums
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0333 seconds