Having problems with your Vacuums ?

Noisy sparking james hoover

\015 I have a james hoover which has suddenly gone very noisy and sparking is visable through the top casing,when i opened it the disposable bag had a split so i presumed dust had escaped through filter into motor, this is still happening despite cleaning the motor. What part is likely to be the probem and which part do i need to buy to sort this out. Any advice would be appreciated, Thanks\015

Answers :

Repair Help & Product Troubleshooting for Vacuums

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Noisy sparking james hoover


... Vacuums

I have a Hoover, Steam spin scrub, Model F5897-900. Only used it a couple times and the motor gave out. First started being noisy then a bad smell. It did seem noisier that what I would expect from the start but I didn't realize it was a problem with the shaft of the motor. I took it apart and found the motor shaft wasn't true and causing sparks. The motor looks like it can not be taken apart and repaired. This seems like a default from the beginning but it is past warranty. Also noti


You will have to replace the motor and the hose asm. thehooverstore.com may be able to help, or you should be able to find a repair shop that can order them for you. ... Vacuums

Hoover steamvac shooting sparks from motor


The motors shot some times i have fixed them if it hasn't been ran to long let me know im sure i have a motor ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

Hoover very noisy after new belt installed.


What is the belt # you have installed (generic)? Yes, there are problems with using generic belts on Hoover Vacuums. If you have noise I would suspect the roller, and replace it. the cost is about $25 and is something that you can install. The newer ... Hoover U5753-900 WindTunnel Bagless Upright Vacuum

Noisy motor on Hoover 2100w


... Hoover Vacuums

My hoover dual v steamvac make loud noise and sparks


Unfortunately the motor did go out on this machine. the commentator brushes and the armature are burnt and the motor or the machine will have to be replaced ... Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum

Not full suction, noisy, sparks at the unit


Yup you need a motor. try and find a nutone service center. they will have the parts and be able to repair it. ... Broan-NuTone CV450 Central Bagged Central System Vacuum

Which Kenmore vacuum cleaners are made by Panasonic? Are all of their direct drive machines made by Panasonic? We have a blue Hoover Windtunnel with the dirt sensor. It cleans well, but it is unbelievably noisy. I wondered if something was out of place and the brushes were hitting, but everything looks normal. We bought Kenmore models 36722 and 36724 and love them. I believe they were made by Panasonic. Our Kirby sits in the basement. Much heavier. These are quiet and clean well. I would like an


Some Kenmore vacuums are made by Panasonic, some are made by Hoover or Eureka or even Sebo. I would go to a Panasonic dealer for that kind of machine instead of trying to go by the Kenmore brand. Sears has a hard time with service. A good Vacuum C ... Kenmore 31913 Progressive Direct Drive Bagged Upright Vacuum

I have a Hoover Fold Awaw, U5175-900. Have had it for 4 months and from the "get-go" it has been extremely noisy especially with the atachements. Have a warranty but thought it might be a minor item I could fix.


I have a hoover wide path fold away vacume and it stopped picking up . I wanted to clean it out but cant figure out how to open the part where the belt is . Any suggestions ... Vacuums

I have Hoover whisper Cyclonic. I just opend beacuse it was showing Clogged. I removed all dirt etc from the belt and now roller are not moving round and the smell of burning is coming due to rubber not moving on the roller. I looked at the manual which tells me in cased on roller being Jamed if need to use the stich to reset. I looked all over could not find the switch. Can you guys help me please.


... Hoover Sh40080 Zen Whisper Bagless Multi-Cyclonic Canister Vacuum

HI, my motorized brush barely turns.It makes a hot rubber smell. I took apart and noticed the spindle the belt turns on discolored from heat. Cleaned it, but still no turning of the brush.The vac is a hoover wind tunnel. As it moved accidentally touched the belt/ spindle and burned my hand a little. Very hot in area. Bright spark from motor noted. Was careful not to touch that part!


That means that the belt is stretched and it is slipping on the motor shaft, that is why it is hot and smells like burning rubber. You need to replace the belt. Here is the correct belt you need: ... Hoover S3765-040 WindTunnel Bagless Canister Vacuum

Loss of suction and very noisy - Hoover Encore Supreme Energy U4293-930 Vacuum


The most obvious and first fix would be to clean the filter. The noise is the tip-off. If your vacuum is noisier than usual the most common issue is a clogged filter, hose or bag. Check all of these. UNPLUGGED, use a straightened wire coat hanger to ... Hoover Encore Supreme Energy U4293-930 Vacuum

Hoover U8147-900 WindTunnel V2 Bagless Upright has sparks coming from motor housing


Most bagless uprights are exposed to dirt being drawn through their motors and filtered afterwards. As a result when you see sparks the motor has generally suffered its final breath... Today's uprights often run with high RPM disposable motors where ... Hoover U8147-900 WindTunnel V2 Bagless Upright Cyclonic Vacuum

My hoover alyx 2000w became too noisy.. the noise comes from the top small spot on the cyclone system pot, when i cover it with my finger it goes away so the problem is there


... Hoover U6630-900 WindTunnel Bagless Upright Vacuum

My Hoover TFV2015 has excessive sparking at the motor.


Get new one fast do not turn on anymore, if you have a warrenty i would take it back if not look for a used one, hope this helped, jamie ... Hoover Freespace Evo Pets TFV2015

I bought a Hoover Wind Tunnel in January 2008. At first it worked great though very noisy. Now it will not pick up small fuzz on medium shag carpeting. I have checked the bag, the filter, the belt, and obstructions and there are none. Plus the noise level has increased. What is wrong? I am very dissatisfied.


Http://www.geeksquad.fixya.com/ThreadView.aspx?prdid=0&thid=563001 Generic problem for all Vacuums I bought a Hoover Wind posted by smithcarolj1 on May 01, 2008 I bought a Hoover Wind Tunnel in January 2008. At first it wo ... Vacuums

Since hoovering & getting a tie stuck in the fan my oreck xl is making a very loud noise & the motor is sparking! please help


... Oreck XL Ultra Bagged Upright Vacuum

Poor electrical connection on Hoover


THE PRODUCT HAD TO GO TOGETHER...SO IT HAS TO COME APART!! KEEP LOOKING FOR MORE SCREWS..OR A LATCH TYPE SET UP. ONCE INSIDE, SECURE ALL LOOSE WIRING TO CONTACT SCREWS...OR? MAKE SUR PLASTIC CORD RETAINING COLLAR IS AROUND CORD, AND FASTENED PROPERLY ... Vacuums

Its spark at the back of the motor when its turn on.


Yep very common of dyson vacs you will have to get the motor replaced not an easy job to do you might if you dowant to give it a go go on to youtube n search for fit dyson motor that will show how its done good luck  ... Dyson DC14 All floors Bagless Upright Cyclonic Vacuum

Sparking moter and smell of burning


Will be a good idea to go the repair shop for testing and repair.you must test the Motor for bearing,brushes, winding faulty, etc.Of course and clean hoses, and any parts from any debris.God bless you. Use the common sense. ... Vacuums

Replace motor on Hoover Steam Vac F5888-900


... Hoover F5888-900 SteamVac Upright Wet/Dry Vacuum

I recently bought a samsung silencio hoover and it has just stopped working whilst i was in the middle of hoovering, when i took the panel off to empty the contents the filter was really hot, has my hoover blown up? I was only had the hoover 4 months?


... Samsung Vacuums
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0404 seconds