Having problems with your Vacuums ?

I have a Taski Baby Bora that looses suction and has a loud high-pitch squeal coming from the motor. Where can I take it for service? Type: S1C No: 7384 Series: 0302 E-Mail: [email protected] Thanks Heidi

Answers :

Check it carefully for clogs in any tubes where the dirt passes through. A clog can cause it to make a very loud whistle or whine.
Repair Help & Product Troubleshooting for Vacuums

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I have a Taski Baby Bora that looses suction and has a loud high-pitch squeal coming from the motor. Where can I take it for service? Type: S1C No: 7384 Series: 0302 E-Mail: [email protected] Thanks Heidi

Check it carefully for clogs in any tubes where the dirt passes through. A clog can cause it to make a very loud whistle or whine. ... Vacuums

E series How did you take your rainbow e series apart? Do you have a manual? I've got a few pieces off mine but can't see where any other screws are to completly take apart to be able to look at motor. Thanks Kelly

The clear lenses on either side of the top part of the E-series Rainbow are removable. If you look at the each lens you will see two sections on the top edge of each lens that looks like this |___| |___| about 1 1/2 inches in from each end. Put a ... Rainbow E series Canister Wet/Dry Vacuum

The nut on the seperator on my e series is frozen on , how do I get it off and can I use the e2 series seperator on an e series. Aparently the e series nut and seperator had to be take off more often or it freezes on...I bought a used one that's stuck and It works but I can get the seperator off to clean.

Do you have a friend who is a car or motorcycle mechanic? The acorn nut you refer to can be removed with the use of a small air impact wrench. Make sure the wrench is set to REMOVE (anti clockwise) the nut and give it a short burst. Never fails. ... Rainbow E series Canister Wet/Dry Vacuum

How can you take the top of a rainbow D-4 series to repalce the plug for the power head? I can't find any screws to take out

This is a time consuming jod. You will need to carefully peel back thew rubber gasket around the separator . Underneath you will find several hidden screws.Loosen them off. With the separator removed you will be able to loosen the upper body and moto ... Vacuums

I paid to have ny DC07 serviced a few months ago and it still takes a few minutes to start picking up dust . Why do you think this is because I have checked it over thoroughly for blockages . This was why I had it serviced in the first place .

There is a selecting mechanism that engages when the handle is brought from the upright position .It's one of the snap in parts on the right hand side which you actually see pivot when the vacuum is engaged, I just found this out with my own DC ... Dyson DC07 Bagless Upright Cyclonic Vacuum

Hey. how could ii take the raibow e series vacume

The E series has two clear side panels that are made of plexiglass. Look at them. There is some grooves on the top and bottom of each. VERY carefully, pop those out using a thin flat screwdriver. Under each of those panels, you will find the hous ... Rainbow E series Canister Wet/Dry Vacuum

I need to take apart a vax cylinder hoover to service it

... VAX Appliances 2000 Canister Vacuum

I need a service repair guide for a Bissell ProHeat Self Propelled 7950 Series Cleaner

... Bissell Vacuums

What type of belt does eureka vacuum 2998 upright take

... Vacuums

Belt type Ok, thank you for the help! I did have the top off, but did not know the taking the motor loose trick, thank you for that! Now I have a couple of more questions, and thank you so much for all of the help! I got a belt from sears, & the sales guy sold me an off brand belt. It looks just like the belt that broke, although do you have to force the motor back down into place? I think it may be the wrong belt? I have looked on the Hoover website & they do not even have parts listed fo

The belt number is 91001028. The belt will be snug but not real tight, so the belt you got may not be the right one. Most repair shops for vacuums should have this belt in stock. ... Hoover U8145-900 Savvy Bagless Upright Cyclonic Vacuum

I have the Electrolux Intensity upright vacuum. The roller bar underneath that is used for carpet no longer turns. I have checked the belt that is attached to it. I'm afraid that it may be the motor. Where can I take it for service or shat do I do now? Kay

... Electrolux Vacuums

We have the bissell quicksteamer and as I was shampooing I began to notice something burning so I unplugged our machine immediately; then my mom and I started cleaning all the filters assuming that could be the source of our problem and yes it was a little dirty but I suspected that it would take more thant that to cause our machine to somke soI turned it upside down and noticed there is a cable of copper threads that appear to have some type of rubber or plastic insulation tubing around it but

Was the exposed copper wiring on the electrical cord? If is then replace the cord. The main problem with this model is that Bissell obsoleted it as well as parts for it. But if all you need is a cord, you should be able to get one from a repair shop. ... Bissell 1960-3 QuickSteamer Plus Upright Vacuum

Hello yes was i was wondering if you could possibley instruct me as to how the inner tubing hoses go back on the 8910 series it appears i am having no luck as to what tube hooks to what port ect? i figured somewhere surley there had to be a service diagram but guess what no luck?

Maybe this picture will help:\015\012 ... Bissell 8910 ProHeat Clear View Upright Vacuum

I don't know how to take apart me Rainbow e2 series vac.

I recently took mine apart because the motor stopped working. Realized the brushes were pretty well worn down and one side was completely gone. I was looking on the internet for detailed instructions on how to take it apart. I ended up just ripping i ... Rainbow E series Canister Wet/Dry Vacuum

The vacuum shuts off by itself and then sometimes takes a while to start again after several attempts, progressive canister type 25914507

Sounds like your motor is cutting out from a thermal fuse. this means that when it overheats it will turn off and then will reset, allowing you to operate the vac. The problem could be a result of poor air flow...check the filiters and hose path for ... Vacuums

Don´t know how to take my Rainbow apart. - Rainbow E series Canister Wet/Dry Vacuum

Your model is a bit newer than mine, but on mine, I have to peel off the foam rubber gasket that seals the canister to the top of the vac when you put it together. You will have to replace this gasket once you peel it off. Under the gasket are the ... Rainbow E series Canister Wet/Dry Vacuum

My vaccuum is model #U5780-950 series 7112.0. I need to know how to clean my vaccuum. Also I need to register it. All have been misplaced. I tried to email you but my computer would not let me input my correct postal code. My e-mail address is [email protected]

... Hoover U6630-900 WindTunnel Bagless Upright Vacuum

Su2914: loss of suction even when cylinder is empty!! doesnt work correctly when pet attachment is added either, only seemed to work ok for first 4 months then loss of suction, will pick up eventually but quite poorly! Should I take it for a service? Thanks

... Samsung Vacuums

Sanitaire Model S661 Type A, heavy duty commercial motor, 8840 watts. A large nail was accidentally vacuumed. There was immediate noise, and then it smelled like smoke. We can see after removing the bottom plate that the translucent plastic fan was completely broken. Can it be replaced? We have no repair service nearby.

... Eureka Sanitaire S661 Bagged Upright Vacuum

My Roomba says to clean the brushes when the brushes are already clean. Is there something to take apart to check? I have already taken the brushes out. I don't know the model number, I think it's the 500 series, black and silver.

Turn the unit upside down and remove the bottom pan should be 4 or 5 screws depending on the model. next remove the 4 screws that hold the brush cartridge and pull the whole brush assembly out.using a can of compressed air cle ... Roomba 3005 Pro Robotic Vacuum

I need an illistrtion book for my hoover floor mate H3044 series AM6.1 I was wondering if I could print one off my comp. my e-mail add. is [email protected]

I need an instruction manual for Model U5264-900, Series AG 12.0 ... Hoover Vacuums

Same here... I have a DC-15 Animal, it was making a clogged type noise and before I had time to react, it stopped working and I smelled burning rubber. I also noticed that the ball was really hot. It's too late to call support, but I intend on doing so in the morning. I've only had my Dyson for a year, so I'm sure it's covered, however, I have no idea where my receipt is. Did they take care of your issue?

You sucked up something that stopped the brush from turning. This made the belt slip causing a burning smell. ... Dyson DC14 Bagless Upright Cyclonic Vacuum

MY hooverselfproweled windtonel sound like an air craft getting ready to take off and lost alot of sucking powers. I had it serviced at a local store. It wasn't right when go it back. All belts and filters where changed.

Http://geeksquad.fixya.com/ThreadView.aspx?prdid=0&thid=761558\015\012Generic problem for all Vacuums\015\012MY Hoover self propelled WindTunnel sound like\015\012 ... Vacuums

I purchased a Pro Heat self propelled Bissell rug cleaner model 7950 from Target wherehouse on 4-26-06. I used it once and all was fine. The next time that I went to use it the smart mix for the cleaning formula would not dispense formula.I called Bissell consumer services and was told to take it to Starks Vaccumn in Sherwood, Or. That was on 10-30-06 They said that it was working so I tried it again and not a drop of formula was or has been used since.I took it back 2-13-07 and the replaced the

I assume that it is spraying water? Is the smart mix knob turning freely from one point to the end? If not then there is a problem with the smart mix asm. With liquid in the soap bottle, push the valve in to see if liquid comes out ok, couild be ... Vacuums

Motor is noisy like there is something stuck in it. I am looking for the service manual so I can see how to take it apart/

Hi\015\012Generally modern upright vacs don't have screws that you can undo to get into the motor and most Electrolux/Eureka models have sealed units. I suggest looking at the sole plate where the roller brush is, check for anything clogging the main ... Eureka 5892AVZ Bagless Upright Cyclonic Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0349 seconds