Having problems with your Vacuums ?

How do you cut closet doors after installing laminate floor?


Answers :

If they are 1 3/8" doors then you pull them of the top tracks and take out side and cut the bottom with a skill saw. On some doors there is an adjustment where you can raise the door up to 1".
\015\012
\015\012To remove the doors from the track you need to pull the bottom of the door towards you at a 45 degree angle then lift them off the track.
Repair Help & Product Troubleshooting for Vacuums

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

How do you cut closet doors after installing laminate floor?


If they are 1 3/8" doors then you pull them of the top tracks and take out side and cut the bottom with a skill saw. On some doors there is an adjustment where you can raise the door up to 1". \015\012\015\012To remove the do ... Vacuums

How do I remove a hardwood floor polish safely from a laminate floor


Www.hard-wood-floor-cleaners.com and select the best chemicals and use for your hardwood polish laminate flooring.God bless you ... Vacuums

Shark Floor Cleaner streaking on pergo laminate floor


Start with a clean pad. A dirty pad wil spread the wet residue around and strek the pergo. After steaming use a clean microfiber dust mop to buff the pergo. It will dry and shine yur laminate. ... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

Laminate flooring repair


Use a skill saw or multitool and carefully cut an x from 4 corners and remove bad pc. The you can shave the locking toe on 2 sides and install the new pc with wood glue on the toes you shaved. It's hard to explain on here but You tube has some good ... Vacuums

May i use the Shark steamer S3251 on Laminate floors or would that damage the floors?


... Shark S3251 Lite and Easy Steam Mop

My eureka optima upright bagless vaccum has VERY low suction using the floor part. the hose has excellent suction. i removed the little translucent door underneath and there were no blockages, i cleaned the brushroll thoroughly and that hasnt helped either. i know this probably isnt recommended but i turned it on to the floor setting with the brushroll off and stuck my fingers up the intake as far as i could, the suction was good further up but it just seems to stop down at the base. because i s


I will try and help here. Is the sole plate on the bottom of the vacuum complety on and there are no visible cracks along the seam where it meets the body? This is the usual cause for this. Onc you take of the plate to access the roller and brushes, ... Eureka 431A Optima Bagless Upright Vacuum

I have a Shark Steam mop and loved it for my kitchen vinyl floor. We just moved into a new home with hardwoods everywhere and I was wonder how well it worked on wood and laminated wood floors.


Normal\012 0\012 \012 \012 \012 \012 \012 \012 MicrosoftInternetExplorer4\012 \012\012\012\012\012\012 /* Style Definitions */\012 table.MsoNormalTable\012\011{mso-style-name:"Table Normal";\012\011mso-tstyle-rowband-size:0;\012\011mso-ts ... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

I have a Dyson all-floor model (not the ball). I recently replaced my carpet to a Frieze. Since replacing the carpet, the Dyson is extremely hard to push. It almost forms a "seal" with the carpet. Seems to work fine on Berber carpet and laminate floor. My husband has checked to make sure the brushes are working, hoses are not clogged and belts are OK. I've had it for about a year. It is virutally impossible to push on the new carpet. Any ideas?


Have you adjusted the brush control system. If you look at the link below page 6 will tell you how to adjust. If this is not you vacuum please give the model # of the one you have so I can help you more.\015\012\015\012 ... Dyson DC14 All floors Bagless Upright Cyclonic Vacuum

HI, I have a Kenmore 25813 and it seems like there is an intermittent short. When I have the extension wand on and the power floor attachment on, when it rotate the wand the light cuts out and so does the power floor attachment, when I twist it back it comes on again. I don't have this problem if I remove the wand and just use the crevice tool with the hose. Any idea where the short might be and can I fix it myself? Thanks. Gary


This is common you may have a short in the contacts from the handle to the wand or a break in the cord that goes into the powerhead ... Kenmore 25812 / 25813 Progressive Bagged Canister Vacuum

Clarke Instructions helo there. on the front brush head assembly the actuator motor that lifts the brushes up and down from the floor has a sleave and a finger that turns the motors on and off. when the head is lowered it comes on and brought back up it turns them off. this assembly controls when the pads start to spin and also determins the downward pressure of the pads affecting the cutting and or cleaning pressure onto the floor. how do i adjust the height at which the motors turn on?? t


... Vacuums

Clarke scrubbers helo there. on the front brush head assembly the actuator motor that lifts the brushes up and down from the floor has a sleave and a finger that turns the motors on and off. when the head is lowered it comes on and brought back up it turns them off. this assembly controls when the pads start to spin and also determins the downward pressure of the pads affecting the cutting and or cleaning pressure onto the floor. how do i adjust the height at which the motors turn on?? ther


... Clarke Vacuums

My eureka smartvac 4870 has no suction at hose or floor. all hoses are clear, filters clean and properly installed. bag not full and properly installed


Your eureka has no suction kuz the vacum hose needs cleaning ... Eureka Smartvac 4870 Bagged Upright Vacuum

Can you use irobot Scooba on laminate floors?


No. If water finds its way between the planks it will be absorbed into the core of the laminate and swelling will occur. In some cases if caught early enough and the planks are taken apart and allowed to dry they will go back to there normal size, th ... iRobot 5800 Scooba Vacuum

Restore shine to laminate flooring


... Vacuums

Power cut off after handle was dropped on floor while vacuuming


Connections inside the handle came loose. happens to me all the time. take the handle apart and connect the wires back. ... Oreck XL Ultra Bagged Upright Vacuum

I have a Dyson 39 Animal Canister vacuum that was working very well on my laminate wood floor. I have had for two months with no issue. Recently the suction is so strong that vacuum takes effort to m


... Dyson DC39 Animal Canister Vacuum

Best way to clean a laminate "wood" floor. I use Pine Sol and lately have been noticing streak marks and dullness.


... Vacuums

Bissell laminate floor cleaner wet vac and flips to dry vac


You just need to replace the cap and valve part # 2036919, You should be able to order the part thru Bissell.com, or they will tell you who you can call close to you. ... Vacuums

We have purchased a Prima lpr 471 built in microwave and have just installed it. We have no instructions with the appliance and are confused because every time we open the door the oven starts up is this normal. We have purchased the oven and it is brand new


... Vacuums

Hoover just cut out while we were vacuuming the floor, no power, is there an internal fuse somewhere?


No. there is a thermal fuse that will reset after the motor cools down. Check for blockage and clean filters and clean the cone assembly for proper air flow. ... Hoover WindTunnel Cyclonic HEPA Bagless Upright Vacuum - Plum

Can I use my steam mop on laminate floors - Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum


Hi,Yes, it works great on laminate floors...Here is a tip that I wrote about the Euro-Pro Shark Steam Mop and why it maynot be getting steam to the head... ... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

Roller Brush How do I install the roller brush. I didn't pay attention when I removed it and now when I attempt to vacuum my low carpet it doesn't seem to be working. The green light on the head of the vacuum goes out when I click it down to the floor. It didn't used to do that. Plus I think I smell something burning. Could the belt be broken?


Try a new belt. The ends of the brushroller are different sizes, so you can't put it in backwards. There are numbers and notches on the ends of the brushroll. These notches/numbers need to match on both sides when installing it. (probably need b ... Kirby Ultimate G Bagged Upright Vacuum

Hetty hoover not working. It was working ok until I opened it up to search the bag for a missing jigsaw piece and I put it all back and I hoovered the mess on the floor, then switched off and switched on and hoover would not work? Is there a cut off button on Hetty hoovers?


Know cut off switch, its just not getting power ? 2 things its ether at the wall plug or in side the unit. I have never found a fuse in side them , so it may be just a lose wire did you try other plugs in the house . good luck DFD ... Henry Numatic "" Canister Vacuum

Hello, I have a wonderful Dirt Devil vac for my carpets, model 140000, love how it works to get doggy hair off my carpet! But, I have a cute cannister model for my laminate floors and it uses the Q bags, but they are no where insight to get or order. Can you help me with this dilema?? Anna


Http://geeksquad.fixya.com/ThreadView.aspx?prdid=0&thid=821035\015\012Generic problem for all Vacuums\015\012Hello, I have a wonderful\015\012Posted by dutchtr ... Vacuums
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0453 seconds