Having problems with your Vacuums ?

Euro-pro iron. red light on. green light blinks on but iron will not heat up. lights do not progress through yellow (does not go past green) purchased from walmart with warranty extention on 12/08. Never had a problem before--what is wrong.


Answers :

The inner grid that heats up the iron has an open which will not give continuity to heat the iron up. These grids are not serviced so more than likely a replacement iron will be on your list to purchase
When the green light stops blinking and is solid, the iron is ready for use. Touch the handle and begin using.\015\012\015\012\015\012but as you mentioned that green light is blinking and the iron is not heating then there is definitely a short in wire some where it has to be checked.most probably its the short in the heating coil wire.but if the heating coil wire is proper and not short then your irons heating coil probally went bad its alot cheaper to just buy a new iron .because heating coil costs near to new iron.but still get confirm if its short in wire.\015\012This\015\012will help. Thanks please keep updated.please do rate\015\012the solution positively .thank you for using fixya
Repair Help & Product Troubleshooting for Vacuums

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Euro-pro iron. red light on. green light blinks on but iron will not heat up. lights do not progress through yellow (does not go past green) purchased from walmart with warranty extention on 12/08. Never had a problem before--what is wrong.


The inner grid that heats up the iron has an open which will not give continuity to heat the iron up. These grids are not serviced so more than likely a replacement iron will be on your list to purchase ... Vacuums

I have only had my shark steam mop for about a month and only used it twice. I tried to use it yesterday and it would not work. The green light came on and it worked for maybe ten seconds, then it completely shut off. I tried switching outlets and draining the water but nothing worked. It still doesn't work today either. What do you think is wrong? Does this product have a warranty?


Yes has warranty call Shark/europro. ... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

I have a Roomba 560 (it's still in warranty !!) and, after my summer vacation, it has a problem. When I'm charging Roomba, the orange light blinks (and this is normal!) but this orange blinking continues forever.... the light doesn't change to green. If I detach Roomba from the charger, the light become green and it works normally until the light changes to red and I have to charge it again. WHY, DURING THE CHARGING PHASE, THE LIGHT DOESN'T CHANGE FROM ORANGE-BLINKING TO GREEN? HAVE I


The problem is not with the charger itself but it is with the battery inside the Roomba. It sunds like one or more of the cells has gone bad so its not holding the same charge as it did. I would recomend sending it in while the warranty is still vali ... Roomba Robotic Floor Bagless Vacuum

The unit is charged, the charge indicator light is green, and the three lights on the top are lighted and steady but nothing happens. What am I doing wrong?


Press each cycle button and see if it starts up. I don't know if this is new and you just got it, but if so, you may need to remove any straps and retainers blocking the brushes etc. ... iRobot 4150 Roomba Vacuum

The needle on the pressure gauge of my whitewing steamer does not move even after half an hour to be on. The green light illuminates, and just for the first time it release steam, After that nothing happended even with the green light illuminated. What am I doing wrong?


... Vapor WhiteWing Steamer Canister Vacuum

My new H2O Mop Ultra (Danoz) seems to heat up ok then when the light switches to green and I start using it, the orange light comes back on as well as the green. Produces steam to start with but then it starts to spit water too and everything ends up wet. Any ideas on whats wrong or should I just send it back?


That is a major hardware fault, I have seen this numerous times with these H2O mop's... They seem to either work perfectly for a long while or have problems right off the bat. You definitely want to send this unit back and either get a refund or at ... Vacuums

Scooba will not start clean cycle...the battery is fully charges and the power light is on but the clean light will not come on and it will not start cleaning...scooba also does not make any noise or beeps. what is wrong and how can i fix this?


Hi,\015\012\015\012Visit to the given link and download the manul. Manual gives the solutions, which can be applied at home... (Especially go through manual's page no 21)...\015\012\015\012 ... iRobot 5900 Scooba Robotic Wet/Dry Vacuum

Red light flashing on rainbow e2 ? just wondering if there may be something wrong ? it seems to be working alright. just cleaned the hepa filter and the seperator and light is still flashing.


The red flashing light is normal, as long as it does not give an error code, and is a steady flashing, when it is running.\012\012Thank you,\012Ralph ... Rainbow E series Canister Wet/Dry Vacuum

Hi, I can't get the warning lights to stop flashing on my vacuum.... it had caught a string on my door mat... I removed the string, did all of the trouble shooting that my guide recommended including looking for blockages etc. The vacuum seems to **** fine except I can't change the settings and the lights won't stop flashing...any advice? I bought it out of country so I have no warranty (so much for me saving over $100 in price!!)


Try to reset or find the reset button it means the trouble about the string was on the memory of your vaccum that trigger the flashing of light. try to unplug your unit then after plug it on ... Dyson DC28 Animal Bagless Upright Vacuum

Hi, we have a Sunbeam electric blanket model no. BLO750 and type 696. It's a double blanket with dual control that can be used for different settings on either side. Both sides have been working ok but last night one side wouldn't heat and the green light kept flashing and now, whatever we do the green light keeps flashing except, when we set the control to "off". We can't find our Owners Manual to see what we are doing wrong, can you help please...or can you advise us where we may be ab


... Sunbeam Vacuums

I bought the Eureka 4703D model vacuum and my very first time powering it on, it was extremely loud - abnormally loud, and I don't know if it is loud like that because I possibly put it together wrong, or there is something wrong with it or it was previously damaged and I would like to know if this is something I can fix myself or do I have to take it back apart and return it to Walmart where I purchased it from. When it makes the loud noise, it does vacuum fine but the noise is just unbearable


... Eureka Power Plus 4703D Bagless Upright Vacuum

I was vacuuming and noticed that the bag needed changing. the red light with the ! inside the triangle also came on. When the bag was changed, the vacuum would not restart. The red light came on. Tried the reset button but nothing happened. Tried unplugging and re-plugging in and nothing happened. Replaced all the filters and still it wouldh't start. So I brought it downstairs and tried one more time to get it to start. it worked! Is there something wrong with the vacuum cleaner? Was it overheat


It was overheated that is why it worked downstairs after cooling off. ... Miele S548 Bagged Canister Vacuum

Wiring Just removed hair, etc and had to remove the motor and clipped the light wires. Reinstalled but blew lights. Wired series> wired parallel> deffinetly wired wrong have a diagram?


First, what is the model number? I'll shoot you a wiring schematic. ... Oreck XL Ultra Bagged Upright Vacuum

Red light is on my bissell spot lifter when it is pluged in and switch is in the off position. When I switch it to the on possition red light goes out and the machine does nothing. What am I doing wrong?


... Bissell 1719 Spot Lifter 2X® Handheld Vacuum

I purchased the Shark Steam Mop less than a year ago and I have used it about 8 times and now it is not working. It will not steam. The light on the front is on and you can hear it tryng but it will not get hot and steam the water like it should. I think it needs to be replaced with a Warranty Item for free. It is still under warranty.


Hi,Here is a tip that I wrote about the Euro-Pro Shark Steam Mop and why it maynot be getting steam to the head...Euro-Pro Shark Steam Mop Problem ... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

I need assistance infiguring out whats wrong with my hampton bay ceiling fan i believe its the romote for the 2 stage lights and 3 stage fan the lower light will flash on and off only i cha nged the battery and stiii will not function model no on remote is o;UC7080T THANK YOU PHIL HILLEN @ [email protected]


Hi phil,I think the battery you inserted are not in a good working condition since it was working well before you changed the battery,I will suggest you replace the batteries,if the problem persists then its obvious the problem is from the remo ... Vacuums

Cant seem to get the green light going on vacuum head,hook seems to be wrong way when its should be hooking the band off its doing the opposite


1)First, you turn the square belt lifter on the front of the power nozzle until the red arrows line up (belt off)2)Remove the power head from the front of the machine. Now turn the belt lifter the other way and line the green arrows up ag ... Kirby Ultimate G Bagged Upright Vacuum

Kirby Sentria I bought my kirby sentria just before we were to move house and although I have the instructions somewhere, they will be boxed up and I so want to clean the carpets before I move. Problem is that I don't know whether the belt should be on or off when using the big silver front with the Kirby insignia on it. I know that the green light should come on when it is working properly and it does not, so I am doing something wrong. I can attach the attachments no problem but I want to use


If the green light is off, then its time to replace the band. This video shows you how. ... Kirby Ultimate G Bagged Upright Vacuum

I have a dirt devil vacemn that has a warranty of 3 years. I bought it in May 2007. Can I return this where I bought it, walmart


Unfortunately, no. Wal-Mart maintains a 90 day return policy, that is to the best of my knowledge. If the machine is broken, obtain its serial number and warranty information and have them ready and call DirtDevil support and let them know what is wr ... Dirt Devil Vision Turbo W/Bonus Upright Vacuum Vacuum

I have a Roomba Discovery. In the past, I had to replace the charging dock. Then the battery died so I did not use it for two years. I finally bought a new battery and used the Roomba. It worked great. It did not find the docking station, and died. I have been charging it and the red light pulsates, but after 16 hours, it still is not charged...any ideas?


Hello. Turn your robot over and clean the charging contacts with the eraser end of a common pencil. Then Charge it and you should be up and running again. Regards, Joe ... Vacuums

The red light is flashing and then there is a four note tune that plays - I don't know what is wrong with it - I cleaned the brushes and it still does it


I bet you have a roomba? if so you probably need to replace the battery, reset the unit, then charge for 16 hours straight, go to roomba dot com the site is very helpful, Don the Vacuum Doctor Alb,N.M. ... Vacuums

When I turned on the sweeper it would not start. I put a different power cord on it and it worked fine. now it won't start but the light on the brush and the bag full will flash when i turn it on and off but it wont start. i have 2 of these doing the same thing. do you have any idea what could be wrong. I have checked for clogs but have found none. Bob


Its sounds to me like the computer board inside the machine has gone bad. Keep in mind that the filters in these machine do need to be replaced regularly to keep the vacuum working correctly. Any good vacuum shop should be able to fix your problem. R ... Windsor SR12 Sensor Bagged Upright Vacuum

Oreck schematic Did you get the schematic you requested? I need same. I blew the lights because plugged in wrong spot. Motor has 2 opposite terminals with black dots and 2 without.


... Oreck XL21 Bagged Upright Vacuum

My Bissel proheat powerbrush is not working but the red light is on- what s wrong with it?


... Bissell 8910 ProHeat Clear View Upright Vacuum

I have a Hoover, Steam spin scrub, Model F5897-900. Only used it a couple times and the motor gave out. First started being noisy then a bad smell. It did seem noisier that what I would expect from the start but I didn't realize it was a problem with the shaft of the motor. I took it apart and found the motor shaft wasn't true and causing sparks. The motor looks like it can not be taken apart and repaired. This seems like a default from the beginning but it is past warranty. Also noti


You will have to replace the motor and the hose asm. thehooverstore.com may be able to help, or you should be able to find a repair shop that can order them for you. ... Vacuums
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0328 seconds