Having problems with your Vacuums ?

When I push my Add a Minute button, it says RICE and goes to the rice cycle

Answers :

Can you tell me the brand and model number of your appliance?

Please provide more info, so that I could further check this.

Thank you!
Repair Help & Product Troubleshooting for Vacuums

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

When I push my Add a Minute button, it says RICE and goes to the rice cycle

Can you tell me the brand and model number of your appliance? Please provide more info, so that I could further check this. Thank you! ... Vacuums

Err5 When charging the battery, it starts out flashing amber, but after several minutes it turns red and the err button flashes five times. The troubleshooting says to hold the buttons above and below the power button for ten seconds and this may resolve some software issues. I tried that but it goes back to the amber light then red again. I replaced the battery hoping that was the issue, but it still does the same thing.

... iRobot Roomba 530 Robotic Vacuum

Brushes won't turn on the bissell proheat 2X steam cleaner-I don't have the manual to see if there is a button I am not pushing to turn on the brushes. Also, do you put the clean water in the "bladder" in the tank? Sorry I am so dumb-this cleaner was given to me with no manual and I can't figure it out. There is a small tank on the bottom at the back of the machine, that says "formula here" and I don't know if that is where the cleaner goes or what that is for. The machine turns on just fine

... Bissell 8910 ProHeat Clear View Upright Vacuum

REMOTE CONTROL IS MALFUNCTIONING & NOT TURNING ON CUSHION - Hello. I bought a used (by near new) Shiatsu+ Massaging Cushion from Ebay. When I installed it today the remote control was faulty. When you push the Power button, the blue light comes on, but none of the other buttons work. When you push the Power button again to turn it off, it clicks & turns itself back on again. So it's running but nothing is happening in the massage cushion. I did see a card in the box saying "For the Shiatsu

Before you use this cushion you MUST first 'unlock' the rollers which are held in place by a screw which MUST be removed or the unit will self destruct. The manufacturer provides a hex wrench to remove the shipping screw and a large label on th ... Vacuums

My swan steam generator iron s15040n is showing a push button when it is turned on. im pushing the button but it continues to say push and keeps beeping. the iron wont turn on at all. please help!!!!! thanks

... Vacuums

My Roomba stops within a few minutes of starting it and when I press the button, it says "Remove and Clean Roomba's Brushes." I have removed the brushes and cleaned them thoroughly, but within a few minutes, it stops again and says the same thing.

Hi,Accumulation of hair, dust and dirt in the Gearbox that prevents normal operation of the brushes. As a result, a power output is required to keep the brushes turning. As turning the brushes requires too much power, it con ... iRobot Roomba 4210 Bagless Robotic Vacuum

I got this sewing machine , can anyone tell me what this control box is used for ?. It is mounted under the table in front of the motor,It says Control Box on the front and two push button number settings with can be adjusted up or down from ( 0 to 9 ) ,Next to these settings are two toggle switches. One is marked start with on and off and the other switch is marked end with on and off. Above these switches it it says Back Track . The tag on the box says ( Type LE -BB -24 - 110 - 220, 2

Still struggling with your model number. I understand from the added comment this is a Brother sewing machine. I was hoping to find a manual that would be of assistance. Here is a couple of websites that lists available manuals for Brother sewing ... Vacuums

I have a Bissell Proheat 2x Model 9200. The solution goes directly through to the carpet. The tank empties extremely fast even when I am not pushing the button. I have also noticed that I have soap spots on the carpet when pushing the cleaner forward. These spots are not even associated with the cleaning mechanism. I have inspected the cap on the tank, but it seems to be OK. Any suggestions?

Hi,Here is a tip that will give you all the information you need to fix your Bissell Proheat Vacuum Problem. ... Bissell 9200 Upright Vacuum

My iRobot Roomba runs for about ten minutes, then shuts off. I can keep pushing the clean button and it will run for another ten minutes and stop again. Nothing seems to get clean.

Take the brush rolls out and you should see a copper disc. It is the dirt sensor. Clean it with Windex or some other cleaner. This works sometimes. ... iRobot Roomba 550 Vacuum

My dc35 is charged when i hold the red button in it goes on and off even though i have the red button fully pushed in - whats up with it ? what is the arrow for just above where the charging lead fits in?

... Dyson DC35 Handheld Vacuum

My Roomba runs for about 3 minutes, then shuts off. If you push the buttons(S,M,L max etc) it will restart for another 3 minutes. The battery is new???

You will need to remove the debris off the cleaning head module. ... Roomba Robotic Floor Bagless Vacuum

Electrolux power nozzle quits working after just a few minutes of working. i've cleaned the head, but have to push the restart red button for it to go again for a few minutes

My guess is that hair, threads, and/or similar long fine fibers have gotten wrapped around the ends of the brush near where the bearings are. The PN may need to be disassembled to remove them. Be aware that if the vacuum is less than 5 years old, d ... Electrolux Guardian Bagged Canister Vacuum

My roomba mounts up to the charger the light blinks red then after a time it goes green but when I dismount it and push the green button it immediately goes red. It doesn't beep or do anything. It is that the battery is not charging?

You have dead nimh (nickle metal hydride) batteries. You\012will need a replacement. You can test for this by removing the battery\012and holding the power button for 15 seconds. This will restart the\012charging cycle as if the battery were new. ... iRobot Roomba 560 Robotic Vacuum

I have a westpointe dehumidifier model MDF-50AEN1-BA6. When it is running the display says "P1" and none of the buttons on it, other than the power button, do anything when pushed. I was wondering what this "P1" message meant and how I should take care of it.

... Vacuums

When it goes onto the rug it says to clean I do and it runs a few minutes and says it again. It never quits on the linoleum

If the sensors become obstructed by dust or debris the infrared signal is weakened. Regularly inspect and clean the sensors and use compressed air for better results ... Roomba Robotic Floor Bagless Vacuum

Keeps stopping. My Roomba Discovery says it has a full charge, but it runs for a few minutes, then stops and beeps and the status light comes on. If you press the clean button, it will start again and go for a few minutes before the same thing happens again.

Your battery isn't holding a charge ,buy a new battery ... iRobot Roomba Discovery SE Bagless Robotic Vacuum

Kirby Seems like you know alot about the Kirby. I know how to use my Sentria (unlike these other idiots) but I keep screwing up the shampoo tray assembly. The brush snaps into the tray just fine but the tray doesn't really stick to the head. It detaches when pushing and pulling the unit. And who knows where that cover goes? It say 'push here to open'

Machine will not come on ... Kirby G6 Bagged Upright Vacuum

This is embarassing, but I have just looked at the Dyson DC07 manual and at my Dyson for about 20 minutes, and I can't for the life of me find the wand release button on my actual Dyson.....the manual pictures don't look like the parts on my Dyson....I don't have a hose with a wand release button....the hose just goes straight up inside the handle....Can someone help me? Thanks :)

Hi the wand release button is located directly above the the Cylinder release button. The wand release button looks like the picture below. In order to releease the wand you must firstly make sure the Electrical cable is not wrapped up for storage. S ... Dyson DC07 Bagless Upright Cyclonic Vacuum

On button won't stay depressed. when pushed to on, the vaccuum goes on but won't stay on unless button is held down.

Needs a new on/off switch. You can order one from an appliance parts store, and replace it yourself or take it to a shop.\015\012\015\012Charlie ... Dyson DC07 Bagless Upright Cyclonic Vacuum

Dyson DC24 instructions say to push the red reset button for the roller bar. My vaccuum has no red reset button. Where is it?

... Dyson Ball DC24 Bagless Upright Vacuum

My Dyson DC24 sucked in a backpack strap and tripped. I then decided to pull out the brush and clean off whatever else happened to be clung onto it and put it back in. The darn thing doesn't turn anymore. Everyone says to push the reset button in until a click is heard but I put in a bit of force and I haven't heard a click so I stopped because I didn't want to break it. Is there something I haven't checked or do I keep adding force?

If the motor is running and the roller is not turning you may have to let the handle down as you would when you are getting ready to vacuum the flood. I think there is a switch you step on to let the handle down and it will engage the roller bar moto ... Dyson Ball DC24 Bagless Upright Vacuum

No vaccuming The brush is still turning so the electricity is still going through but it's not vacuuming. Push the button and nothing is happening. After only 10 minutes of "working". thanks!

Leave it to Cool may have tripped themal switch ... Bissell 37604 Lift-Off Pet Bagless Upright / Canister Vacuum CleanerVacuum

I have a two yr old Ariens model 939003 (5 HP 4-cycle) and it will not start! Have rel new gas, and an electric starter. Think I did everything right. Ignition key on and choke full; primed push button x 3 (at first when I was trying to mechanically start it I over primed it). Spark plug clean and dry. What next?

... Vacuums

Pushing reset button does not restart unit is receiving power, as light goes on.

... Riccar 8650/8625 s Vacuum

How do I remove and clean the grinder on my Saeco v'spresso? It grinds and grinds then says the coffee beans are empty when they're not. If I finally get it to finish its cycle no coffee comes out and all the water goes into the overflow tray and/or the grounds container. I am assuming the grinder is completely plugged up and I tried to clear it out from the chute underneath but no luck...

... Vacuums
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0786 seconds