Having problems with your Vacuums ?

Eureka 12 amp vaccum lost all suction how do I fix this?


Answers :

There must be a clog somewhere in the line. I don't know this model, but if it has a hose, disconnect it and see if the machine has suction. If yes, then you know hose is clogged. If you don't hace hose, then you can try to take apart the air intake to unclog it. It is also possible that the motor runs, but the impeller on the motor is loose and is not spinning to create the suction. I would try checking and cleaning any clog first. Good luck!
Repair Help & Product Troubleshooting for Vacuums

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Eureka 12 amp vaccum lost all suction how do I fix this?


There must be a clog somewhere in the line. I don't know this model, but if it has a hose, disconnect it and see if the machine has suction. If yes, then you know hose is clogged. If you don't hace hose, then you can try to take apart the air inta ... Vacuums

Hello, I have a Hoover 3200 Turbo Power vaccum. while the motor appears to be working fine the vaccum no longer picks up the dirt. I turned the vaccum upside down and the belt appears to be broken. would a broken belt stop the pick up, there appears to be no suction. This vaccum is approximately 10 years old. is it worth fixing? I live in Virginia Beach Va, where would I take the vaccum for repair? my zip code is 23456- Thanks Cleta Goode


... Hoover Vacuums

Eureka lightforce 300 poor suction, power paw doesn't spin and self cleaning duster doesn't clean its self when the button is depressed.


When this happens to me I do two things. The first is to empty the cannister but when you do (with the vacuum unplugged) stick your hand up inside of where the cannister goes.Sometimes that is filled with debris. Pull as much as you can out. There is ... Eureka 4718AVZ LightForce 300 Bagless Upright Vacuum

My eureka optima upright bagless vaccum has VERY low suction using the floor part. the hose has excellent suction. i removed the little translucent door underneath and there were no blockages, i cleaned the brushroll thoroughly and that hasnt helped either. i know this probably isnt recommended but i turned it on to the floor setting with the brushroll off and stuck my fingers up the intake as far as i could, the suction was good further up but it just seems to stop down at the base. because i s


I will try and help here. Is the sole plate on the bottom of the vacuum complety on and there are no visible cracks along the seam where it meets the body? This is the usual cause for this. Onc you take of the plate to access the roller and brushes, ... Eureka 431A Optima Bagless Upright Vacuum

NO SUCTION My Electrolux Z2274 upright vacuum cleaner has lost it's suction and is very noisy. Have checked and rechecked there is no blockage. Have cleaned the filters. In fact done everything I can think of. Any one know why and how to fix this??


If you have no suction, there are only a couple of things that could cause it. As you have checked for blockage, and changed your filters, you may have a vacuum motor with bad bearings, or broken fan blades (inside/on the vacuum motor). Either sympto ... Electrolux Central Vacuum

I own a Eureka Whirlwind Life Speed 12 amps 15" wide. I have suction thru the attachments but no suction from the main vacuum.


... Eureka Whirlwind Litespeed 5840 Bagless Upright Cyclonic Vacuum

I have Infinity NV30 for 3 yrs. Now it has very low suction and spreades dust around while vaccuming. While vaccuming the dibries doesn't come in the container a lot. Pl advise how to fix the problems.


... Euro-Pro NV30 Infinity Bagless Upright Cyclonic Vacuum

I have Infinity NV29 for 3 yrs. Now it has very low suction and spreades dust around while vaccuming. While vaccuming the dibries doesn't come in the container a lot. Pl advise how to fix the problems.


... Euro-Pro NV30 Infinity Bagless Upright Cyclonic Vacuum

I have a Sanyo Performax 12 amp upright vaccuum. It has lost its suction completely. All hoses and airways are clear, new bag, exhaust works, roller bar works.... but no suction - what might the problem be? thanks, Shelley


... Sanyo Permax SC-A102 Bagged Upright Vacuum

I have the Eureka Whirlwind upright vacuum. All of a sudden there is no suction- the hose has suction but not main part. I have no idea- but the brush part is not turning??? should I get a new vacuum or is this an easy fix? thanks!!!!!


If the belt isn't turning then it has snapped. Check the top of the hood for two or three crosshead screws; two at the front and one under neath by the left hand side if looking at the upright from the front. Its easy to fix if you take your ti ... Eureka WhirlWind Litespeed 5844 Upright Vacuum

Eureka SurfaceMax 300 Lost suction


... Eureka Surfacemax 200 Bagless Upright Vacuum

Kenmore progressive vaccum lost suction


HI, it's Jim from Crucial Vacuum!\012\012Here are some general vacuum maintenance tips that will help out with your Kenmore's loss of suction. After applying these solutions you should see an improvement in your vacuums suction. \012\ ... Kenmore 31913 Progressive Direct Drive Bagged Upright Vacuum

I have a model DC3 rainbow thar has lost suction. what can i do to fix it


Check suction at intake without any hose connected. If that is good, then connect hose and check suction again. If that is poor, then you have a clog. If still good, then check power nozzle by getting into the belt area.RainVac ... Rainbow E series Canister Wet/Dry Vacuum

I have a model DC3 rainbow thar has lost suction. what can i do to fix it


... Rainbow E series Canister Wet/Dry Vacuum

Eureka pet expert vacuum lost suction


I had the same problem with exact same vacuum, was working great and the one day just lost almost all suction in the hose and in very very poor suction on base when vacuuming carpet, also when vacuuming the carpet everything I vacuum shoots out the b ... Eureka 3276AZ Pet Lover Bagless Upright Vacuum

I have no suction with my Eureka Boss Vaccume and all hoses are clear


... Eureka 5849A Boss Bagless Upright Cyclonic Vacuum

I lost the suction on my whisperer cyclonic what do I do to fix this problem?


More than likely there's a wad of something stuck in the air channels.\015\012It involves locating the clog and digging it out that may involve\015\012taking it apart. Another possibility is if it has a hepa filter it may be at the end of it's servic ... Vacuums

How do the filters go back in my Eureka Whirlwind Lite 12 amp vaccum?


There are two filters for the this vacuum. The first goes behind the dump cup and there is a filter pack for that below. \015\012Filter Value Pack. Eureka Part #60951A ... Eureka Whirlwind 4388 Bagless Upright Cyclonic Vacuum

My vaccuum has lost suction. I changed the bag and cleaned everything out. The vaccuum is only 6 years old. I even replaced the belt around the brush. When I turn the vaccuum on it smells like burning rubber. My vaccuum is an upright 12 amp model #33000300C serial #Y347012385


... Kenmore Vacuums

The vacum is 7 months old andAll of a sudden is very hard to push and it has lost suction how do I fix this


Sounds like a broken belt. ... Dirt Devil Featherlite Bagless Vacuum M085845Vacuum

My Eureka Optima vacuum doesn't have any suction when on the floor option. How can I fix this?


It will as long as long as your accessory hose is properly inserted into the base. Otherwise the vacuum stays on the hose only. ... Eureka 431A Optima Bagless Upright Vacuum

The brush roll on my Eureka Bagless The Boss 4 dimension cleaning vaccum itsn't working. How do I fix it?


Take either the plate over the brush roll off, if it doesn't come off, then the top cover comes off, should be 2 or 3 screws on the top to remove. Then you can get to the belt and brush roll. Check the brush roll, make sure the ends turn freely, if ... Eureka Vacuums

My vampyr 5040 vacuum has lost suction and is starting to smell. can it be fixed economically?


Lose of suction can be from a clog in the hose, dirt inlet by the brush roll, or the motor running slow. A smell, depends which, if a rubber smell, then could be a bad belt and/or brush roll. An electrical smell, could be the motor going bad, if it ... Vacuums

The suction on my eureka optima stopped working but the roller still works, what might i do to fix it?


Hi there. Most suction problems are due to a blockage. Start with the base and look carefully for debris that is stopping air flow. You may have to remove the base plate to get to the problem. I am including a link to the manual for your machine. ... Eureka 431A Optima Bagless Upright Vacuum

I have a Dyson DC17 Animal Bagless Upright Cyclonic Vacuum and it lost suction. How do I get it fixed? Also, is it possible to get a second filter for this machine?


OK. Lost suction almost always means blockage. You need to check all the pipework, the hose and any bits you can remove at the base of the machine - if I remember right, the DC17 has a sort of U shaped bend at the bottom of the handle that you can re ... Dyson DC17 Animal Bagless Upright Cyclonic Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0866 seconds