Having problems with your Vacuums ?

I am in ecuador and have had a local "plumber" install a lpg tankless water heater for me. After more difficulty than there should have been it's up on the wall with the water and gas lines attached but it won't light. There are 2 "c" batteries installed that seem to be the ignition system but when i turn on the gas and try to ignite the system nothing happens. No lights no sound no gas smell no hot water. Thoughts?


Answers :

The system is ignited by turning on a hot water faucet causing water to flow through the unit activating the igniter.You could disconnect the gas line at the unit turn the valve on and off real quick and smell for gas.If there is air in the line you may have to let it run or purge the line just long enough to make sure gas and not air is comming out.You might want to have utility company do this if you have any worries .I would make sure it is set up for lpg and not natural gas. And then and this is quite often the problem the gas line feeding the unit should be at least 3/4 inch pipe and fairly close to the main supply and in no instance the last fixture in system unless the pipe sizing is adequate for the amount of gas the unit needs to run.If sizing is the problem sometimes rather than running new pipes your utility company might be able to adjust the pressure comming out of the tank to make up for it. Hope this helps good luck
Repair Help & Product Troubleshooting for Vacuums

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I am in ecuador and have had a local "plumber" install a lpg tankless water heater for me. After more difficulty than there should have been it's up on the wall with the water and gas lines attached but it won't light. There are 2 "c" batteries installed that seem to be the ignition system but when i turn on the gas and try to ignite the system nothing happens. No lights no sound no gas smell no hot water. Thoughts?


The system is ignited by turning on a hot water faucet causing water to flow through the unit activating the igniter.You could disconnect the gas line at the unit turn the valve on and off real quick and smell for gas.If there is air in the line you ... Vacuums

I just bought kaz model K76P (M) humidifier in Kyoto. I filled it to the right water level (a bit below) and plugged it in (nothing else is plugged in at that socket). The light comes on, but the water doesn't heat up. I can't read Japanese so can't read the instruction manual but it seems a simple procedure: fill with water, set the heating thing the water, plug in. Am I missing something or is the humidifier defect?


Take it back to the shop it should work and even though its in japanese ,they will know if your doing it wrong ,but i think it may have a damaged heater or a wire off where its been in transit ... Vacuums

When pluged, in the unit turns on ( green light illuminates ) and feels warm. Yes, I filled the water container. The unit does not generate any steam. For some reason, I do not have an "operation manual" --- but it doesn't seem to be all that complicated! Have left it plugged in for 25 minutes. A small amount of water came out while just sitting. Then another small amount of water comes out when I push the handle in. I will assume that steam should come out when I push the handle in. Well, it do


Hi,Here is a tip that I wrote about the Euro-Pro Shark Steam Mop and why it maynot be getting steam to the head...Euro-Pro Shark Steam Mop Problem ... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

Universal Lighting and Decor company: i have one of their Halogen Three Light Torchiere and Reading Floor Lamp and the Torchiere or top light has a defective socket which works only intermittently. It seems to have some resistance and you can turn it on and nothing happens, then if you wait 5, 10, 15 minutes, it will suddenly go on. I don't think this is safe. Can I get a replacement socket system for the top lamp or what can I do?


... Vacuums

I have a Bissell Proheat 2x cleaner which has worked perfectly on every occasion. Today I filled the machine as usual with water and formula and switched on, the motor ran, the lights were on and the brushes rotated but upon pressing the spray trigger no water or formula was released. I have cleaned the jets underneath and also followed instructions to release any airlock. It still wont release the water/formula. What else can I do? Thanks Charles


Please check the following with liquid in both tanks.\015\012 \015\012- Check to see if the machine will spray through the hose with the setting on tools. If it does, the pump is fine. Continue troubleshooting.\015\012- ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

Wont spray i have a bissell pro steam 2x and it wont spray the water out, i have cleaned everything and nothing seems to be working ...please help


Hi,Here is a tip that will give you all the information you need to fix your BissellProheat Vacuum Problem.Bissell Proheat Upright Wet/ ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

My kenwood steam mop makes for very wet mopping is this supposed to be? My floors are a lot wetter than when I use a traditional mop. When I fill the tank and turn it on the water seems to just leak from the bottom so I have only been half filling it and then the water light comes on within 2 mins of when steam starts to appear. What am I doing wrong??


... Vacuums

My new H2O Mop Ultra (Danoz) seems to heat up ok then when the light switches to green and I start using it, the orange light comes back on as well as the green. Produces steam to start with but then it starts to spit water too and everything ends up wet. Any ideas on whats wrong or should I just send it back?


That is a major hardware fault, I have seen this numerous times with these H2O mop's... They seem to either work perfectly for a long while or have problems right off the bat. You definitely want to send this unit back and either get a refund or at ... Vacuums

I have a Frigidaire lp gas stove model #FGF337AWJ. Igniter glows bright but burners never light. Gas smell not overbearing but noticeable. Oven will heat up but very slow. The problem is intermittent. Any help is appreciated greatly.


... Vacuums

Red light wont come on , kenwood 5000 steam mop , green light is on and water is coming out.


... Vacuums

The empty water red light wont quit beeping or blinking canister is full of water it is a daivolo steam canister rug cleaner


... Vapor T 2200S LadyBug Canister Steam Vacuum

I have a Tetratec IN600 Plus aquarium filter which does not seem to be pumping air bubbles through the water. I have checked inside and everything looks as if it should work. The pump system seems to be working as the filter is vibrating when on, but no bubbles! Please help!


... Tetra Vacuums

Hi I've plugged it in and all indications, green light on, heated water.. it wont steam,


Hi,Here is a tip that I wrote about the Euro-Pro Shark Steam Mop and why it maynot be getting steam to the head...Euro-Pro Shark Steam Mop Problem ... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

I have a Atwood GC10A-3E water heater. It is not working and the light for the gas side does not work either. I have changed out fuses and had the circuit board tested. Where do I start now?


... Vacuums

Producing steam i just got the shark assembled the mv2010, then it is not doing anything, it vacuumed just fine, but when i put the steam pad on it wouldnt ever produce steam or do anything,it felt like the water was heating up but even after it sat for 20-30 minutes when i pull handle back towards me nothing happens, no lights no steam no nothing, so why wont it work


This link is for the manualhttp://www.sharkclean.com/manual/MV2010_11_IB_ENG_110103.pdf ... Shark MV2010 Vac-Then-Steam 2-in-1 Vacuum and Steam Mop Purple

What to do when blue light is on and water wont come out the steam penguin


Blue light comes on top of penguin gets hot but the water tank stays cold no steam ... Euro-Pro Steam Penguin Hard Surface Steam Cleaner Vacuum

My h20 mop seems to heat up but nothing comes out, no steam or water. The green light comes on.


... H2o TR220002 Steam Cleaner

Have a bissil proheat clearview plus model 1699-1,there is no water flow. soap seems to work. It was used one time but the system was not flushed. Has not worked since.


If you have spray through your hose and no spray on your carpet then your heater will be clogged with soap. try this and post later if thats not it. ... Bissell 1699 ProHeat Clear View Upright Steam Vacuum

Hi - I have a sinkmaster premium special edition 3/4 horsepower which seems to have slowed down and the water is just sitting in the sink. I have tried to find a red button on the bottom to see whether pressing it will unclog the system but can't find it. Can someone help?


... Vacuums

We have purchased a kerosene heater wick (dura heat dh-145)for a dyna-glo model rmc-95-c4. we put the wick on the heater and it seems that now that it is soaked with the kerosene it is to thick and wont move up or down with ease and only a small part of the wick will light.


... Vacuums

Roomba Red shows pulsing red charging light, turns green, measured battery voltage - only shows about 5.5 volts. Borrowed and used neighbor's charging unit - same thing happened. It seems that the charging system inside the Roomba Red is not functioning. WShat else can I try?


... iRobot Roomba Red 4100 Bagless Robotic Vacuum

I have an older Wega 2 group espresso machine. Looks like a date of 1992 on the group head, but not sure. This has no model name that I can find. Anyway, when I turn it on I get all lights flashing after it heats up 5 minutes or so. I do get nice steam from the wands. I drained teh tank and found a little scale, but not much. I took apart the group heads and cleaned them thinking it may be a clog there, but that doesn't seem to have worked. Also fwiw the water level float is not visible and whe


For a new fridge, need more time to maintain the required temperature of the fridge abut mainly the goods in it? So everything seems normal. The time will be reduced day by day since the goods will stay for longer time in and door opening will bec ... Vacuums

I have a gemmy incredible light show trio, daughter dropped remote in dogs water bowl now it wont work, can i get a replacement remote for it? thanks Mike


You can buy a remote at holidayinflatablestore.com for 20.00 I just ordered one myself they have 61 left click on the accesories and parts on the left. ... Vacuums

I have a hayden premier supervac central vac system, while working on the switch in for the beater bar, the actual unit has turned off, the green light is no longer lit, is there a fuse on it somewhere or a reset button, i have tried unplugging it and replugging it in, but can not seem to get it to power up now?


Should be a reset on the main unit near the top ... Vacuums

I have a Danby SHCC6026-2 with the humidifer, dehumidifer, hepa system. It is not running as it used to in that warm air used to blow from the side and is no longer doing so. We only use it as a dehumidifer in the basement. It is damp down there and the unit does not seem to be registering the levels correctly anymore. It is not collecting water.


... Vacuums
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0666 seconds