Having problems with your Vacuums ?

I have a ge dehumidifier Model# ahr40lmg1. I have a hose hooked up to it but the water keeps going into the bucket.


Answers :

Repair Help & Product Troubleshooting for Vacuums

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I have a ge dehumidifier Model# ahr40lmg1. I have a hose hooked up to it but the water keeps going into the bucket.


... Vacuums

We have a zenith dehumidifier model ZD300 & the bucket full light keeps flashing. the percentage number wont go higher than 1%. we have turned it off/on & unplugged it. When we do this it will reset to 40% for about 2 seconds & then goes back to 1% & the bucket full light starts flashing again. The bucket is empty & we have cleaned the filter. We have only had this dehumidifier about 7 months. Please help us.


I've had the same issue with mine. I am a 12 year refrigeration tech. I checked the float switch which would normally cause that indication light. However manually pushing the switch and then checking it with an electric meter that was not the case. ... Vacuums

I hooked up a hose to my Whirlpool dehumidifier for continuous drain and returned the bucket like the manual states. The bucket continues to fill and shut off. Model AD25DSS1 Serial Q1123013


Hi, check to make sure the drain hole connection on the Dehumidifer's reservoir, that you have the hose hooked to, isn't plugged.\015\012\015\012Also, you might want to see if the hose connection on the reservoir,\015\012still has the "kn ... Vacuums

Dehumidifier Zenith ZD300y0, indicates that the bucket is full. Bucket empty, water is going through a hose to a floor outlet in basement.


Hi, Make sure that you have water bucket and drain hose properly connected. You may need to replace the sensor. ... Vacuums

I have a Bissell proheat model 9200. It dispenses soap but not water. The little pump is running and the heater is not plugged. Can I get a diagram of the hose hook up to see if they are all going where they should?


Hi, My Bissell also STOPPED SPRAYING WATER.I've owned a Bissell\015\0129200 for a few months. I've used it twice, the last time most likely\015\012being around August. I attempted to use it this past weekend and it\015\012wouldn't s ... Vacuums

My dehumidifier, model # HD 456E, : motor runs continually, no water being pulled, bin is always dry. Also, how do I set the humidity/temp control to keep my basement dry? D


First, check and clean your filter, since a clogged filter could be your problem. Here's suggestions for the humidity levels from answerbag.com:\015\012 \015\012On One Hand: Low Humidity Levels\015\012According to an ... Vacuums

Hoover SteamVac Plus 1200 upright hot water extractor Water/carpet cleaner applying o.k. Suction on the "floor" does not work. Suction on the hand tool works somewhat, but water is not collecting in the bucket. There is suction coming from the floor but water is not going into the bucket. It does not appear to be clogged because I can feel with my hand that air is flowing from the floor. The water is not being sucked into the bucket.


... Hoover Vacuums

I have a Zenith ZD300 Dehumidifier. Bucket full light blinks. The water bucket was not completely full. Emptied the water bucket and re-inserted. The bucket full light continues to blink. The humidity setting LCD shows 1%. What is needs to be done to correct the problem?


... Vacuums

The automatic drain hose is hooked up to the back of the unit, but when the bucket is full, the automatic pump does not work. The automatic pump should come on and empty the bucket, but it does not come on unless the water is siphoned manually through the tube. Then the pump come on and empties the bucket. I have reattached the tube and still had to manually siphon the water through the tube. Any suggestions?


Any automatic pumps operate off a swith that is turned on when the water rises. They normally have some type of ball lift, that will raise the switch when water is high and then drops with the water and shuts the pumps off. It sounds like yours is ... Vacuums

I have a tear in the hose of my old model # F6030-900 unit which doesn.t allow water from the attachment to **** back into dirty water bucket. The model #F6039-900 is the same model # but different year I understand. The tear is at the bottom where set the recovery tank in the lay down position and can look in the unit at the bend of the hose.


You will have to replace the hose asm. You can order online at: \015\012http://vacuumsuperstore.com/F6019.html\015\012\015\012H-90001334 (43 ... Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum

The water in my vax rapide powerjet pro v-028 keeps emptying when I let the trigger go until the tank is empty


... Vacuums

We have a Bissell Proheat 2X (model 8920). The problem we are having is when water/soap is initially released (all settings) it continues to leak out the front water spray nozzles unit the water containers are empty. The vacuum works but can't keep up with the continuous water leaking out. Do you have any idea what is sticking open to allow the continued release of water when the machine is running? Thanks Rick


Return it. It is faulty and should not do that. Mine does not. Does require changing water about evrery 10 minutes but one can see the filth in the water. Also re-clean with plain water over areas that were cleaned to remove all cleaner. Old cleaner ... Bissell 8920 ProHeat 2XTM Upright Vacuum

My Steam mop (model 90Y5F) is dripping water from the join at base of water bottle. It started off small and is now rapidly increasing. I spend more time going over the spills than actually mopping. Is there a way to prevent it as the little area where the water is meant to drip thru is flooded - I still get plenty of water through to the pad though.


... Vacuums

We have the water hooked up at the back of machine. there is a spout for the water to come in and fill the ice tray.but is does not. If we turn the water on it fills up the space under the ice basket. I keep getting red light and then the two smal llight one ice and one water come on. We can hear the motor trying to fill the ice try and then lights come on. Please help me this so I can use this product. It did not come with a manual.


The water inlet valve on the back of unit opens when the ice maker needs water. If the valve doesn't seal good because of sediment or wear it will continue to drip and when the water reaches the ice maker supply tube it will freeze blocking the fill ... Vacuums

Just bought a used bissell steamcleaner 2x model 9300 needs fluid tank tried it out by filling water bladder does not dispense water when I pushed the tigger it does **** up water that I spilled on the carpet is it worth keeping after I buy the fluid tank


Click this link for spares for bissell 9300http://www.vacsite.com/en/bissell-parts-1/bissell-parts/9300-upright-deep-cleaner-se ... Hoover F5906-900 Upright Steam Vacuum

Hoover aquamaster recently purchased hoover aquamaster, trying to shampoo carpet, can't get water to come down tubes, water keeps going into dirty water tank.help!!!!!!!!!!!!!!!


Sounds like you need to attach the air hose\015\012\015\012with reservoir in place you clip on the lid with tubes attached, one of them goes down to the floor cleaning nozzle, the other tube should be about 20cm long with an end piece, ... Vacuums

My Bissell Quicksteamer Model 1960-R won't spray cleaning solution. I have cleaned it and taken apart the whole thing. I can't find any problems. The holes are not cloged where the water comes out as I disconnected it and blew through it to be sure. The lines show water trying to go through. It is as if it doesn't have enough power to pump the water out when I squeeze the trigger. I am thinking it is the pump thing but can't find a replacement part for it.


... Bissell 1960-3 QuickSteamer Plus Upright Vacuum

My Bissell proheat shampooer releases the shampoo on the carpet but when I go to ****-up the dirty water into the plastic bucket to empty it there is no dirty water. Please advise or refer a repair place close to Pinellas Park, FL 33782. I have used this machine for about 2 years.


Hi,Here is a tip that will give you all the information you need to fix your BissellProheat Vacuum Problem.Bissell Proheat Upright Wet/ ... Bissell 1699 ProHeat Clear View Upright Steam Vacuum

How does lower and upper buckets work . is it the dirty water suppose to go in lower bucket or what . as i am trying to use this vac i am not able to


I've had the same issue but the dirty water doesn't go into the recovery tank....so its staying on the carpet. Why would that happen? and it looks like a piece on the bottom may be missing when I turn the vac over. ... Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum

UH70115 Model Red keeps going on, cleaned all filters , not dirt going into canister


... Hoover Vacuums

Model 8905...water or cleaner will not come out the bottom, only through the hand sprayer. Everything at the user level has been cleaned and the water and cleaning solutions are full. Nothing is going through the flow assembly. The selection switch is in the correct position


Hi, I checked through the troubleshooting for this model and came up with 2 possibilities. It could be that the tank is not seating well. If this is the case, trying putting a small amount of vegetable oil or vaseline on the seal. Please, ... Bissell 8910 ProHeat Clear View Upright Vacuum

I have a sta rite (pentair) cristal high rate sand filter model T-200-BP-1....its leaking water thru the top of the valve, where the valve cover screws on the valve body assembly. it leaks water out where they go together around the screws. Also when i vacuum it, everything that i vacuum gets washed back in the pool when its on the filter position. Also the backwash leaks when its turned 2 the filter position, does it supposed to do that?...the only way i have gotten it to stop is to put a seper


... Vacuums

I have a dehumidifier from Hampton Bay bought in Jan. 2001. The water container is leaking. The model is HB40 REV. N. Serila # FN8306511781. Where can a get a replacment for thsi water container?


Hello my name is Heath it will be my pleasure to assit you. Unfortunaley the manufacture has discontinued the bucket and it is no longer available. If you know where the water is leaking from and can see the crack or the hole you can try and repair i ... Vacuums

Hi, I have a cleanview bagless model# 3576-2 and my belt keeps breaking (it seems like one of the rings it should wrap around is missing) right now I have been wrapping it around the brush and a metal rod. Also, the dirt collected is going directly into the hose and not the bagless filter. What is going on?


... Bissell 3576 CleanView II Bagless Upright Vacuum

The solution in my smart mix will not mix with water and the button just keeps going round and clicks and will not stop on either water or solution.


The smart mix knob is connected to a piston that slides up and down into the automix assembly. This piston has come off of the smartmix knob and left the unit on water only setting. Sometimes the smart mix knob breaks on the ... Bissell 7901-1 ProHeat Scotchgard Upright Wet/Dry Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0760 seconds