Having problems with your Vacuums ?

GE Dishwasher Mod# GLD566ON00SS Will not start or run. Control board lights up and allows you to select wash options but does not start?

Answers :

I would start troubleshooting your problem by turning my attention to the safety mechanisms designed to keep people from getting cleaned by their washers:

  1. Review the action of the latching mechanism for 'locking' the door closed. If the latch is not engaged, the machine will not start.
  2. \015\012
  3. There is also a secondary safety switch that confirms for the dishwashers brain that the door is securely closed. Check it's action, clean it, confirm it is not damaged and is working.
There are more things that can go wrong with an electronic dishwasher
than the latch and the safety switch, but those are great places to start!

I hope that helps.


\015\012If electrical power\015\012 is available to the dishwasher but the appliance doesn’t run, the \015\012problem is likely to be a defective door switch.

To solve a door switch problem, you may be able to adjust the \015\012door latch’s strike slightly, using a screwdriver (turn off the power to\015\012 the dishwasher at the electrical panel first).

Thanks for contacting Fixya.

Repair Help & Product Troubleshooting for Vacuums

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

GE Dishwasher Mod# GLD566ON00SS Will not start or run. Control board lights up and allows you to select wash options but does not start?

I would start troubleshooting your problem by turning my attention to the safety mechanisms designed to keep people from getting cleaned by their washers:\015\012\015\012Review the action of the latching mechanism for ... Vacuums

I have just purchased two (2) Electrolux Nimble vacuum cleaners. Not one, but both, straight out of the box, the beater bars will not run. It turns on, select carpet, and lower the handle, the red light to check beater bar/or filter lights up. You can reset the light by unplugging the unit, then plugging it back in, but with same results. Now the kicker, if you take out the handle, select carpet, lower the body by the carry handle, it will run and operate correctly, however, as soon as you r

... Vacuums

Burning smell While using the vacuum, the running light will get dim. If I hold the handle at the point where the light gets dim the motor will start smoking. I can either raise or lower the handle and the light will brighten up and the vacuum will run fine. Any ideas???

Hi theres two things that could have made it start doing that 1 the whires have a short in it or 2 the motor has gon faulty. you might want to buy a new machine ... Bissell Lift-Off(R) Revolution(R) Turbo Upright Vacuum

Press the power button on - good got a green light (new battery) press the clean button - got a green light iRobot runs for a couple of seconds and stops, then starts, then stops. After two or three times I now have a red light on for the Status. All of the wheels seem to be clean. I used compressed air to clean the underside. But still have the start stop problem.

How many times does the red light blink before it pauses? ... iRobot Roomba Discovery SE Bagless Robotic Vacuum

I have a progressive 35923500. roller motor runs but blower motor doesn't even try to start. Intelliclean lights light but headlight does not light.

Is this issue resolved now that the nub was pressed and it runs fine? ... Kenmore Vacuums

Hoover U8311 WindTunnel2 vacuum cleaner will not run. When I press the start button, the Red dity light comes on but nothing else happens.

... Hoover U8311900 WindTunnel 2 Vacuum

Roomba 560, the small red light above the schedule button will not reset and the roomba will not run. The problem started when I the roomba sat dead for 12 hours. I tried the spot dock reset trick with no luck. The clock and sunday light stay let also.

This work ok for me ihave a 560 thanks ... iRobot Roomba 560 Robotic Vacuum

I have an Amana above range Radarange, Model #AMV4204AAB, Serial # 10168958GE. Tonight after running for a 7 minute period and finishing, it would not again start. There is power to it, but various buttons no longer work. The following buttons won't work: Kitchen timer, Light Timer, #5 button, Popcorn, Poultry, Auto Defrost, and the Start button. Any help?

Hi,\015\012\015\012Push\015\012the power cord all the way into the outlet in case it became loose and\015\012is causing the problem. If the microwave still isn't working, check for\015\012a blown circuit fuse, and repair it ... Vacuums

We just purchased a bissell pro lite and when we run it just a little while, both lights start blinking and we can't turn it back on without unplugging it for a few seconds. The manual doesn't say anything about it. What do the blinking lights mean?

... Bissell SpotBot Robotic Wet/Dry Vacuum

My Scooba floor cleaner "check tank" light stays on even after it's refilled and everything cleaned but still will not work. It just keeps beeping at me when I try to start it. How do I reset it or get the light to turn off so I can wash my floors?

Flush out the solution valve with water (aka "prime the pump"). Use water, not just air, because water will clear any obstructions that may be in the lines. Also, rinse your tank through the four ports on the *underside*-- one round, two oval, one la ... iRobot 5800 Scooba Vacuum

Vacuum cleaner does not start after getting warm, bag, that was full is changed, lights run across dispaly at top when I try to start it, cannot find my manual, can I download a manual for Excellio z 5240. Is there a fuse of something that has bo be reset?

... Electrolux Vacuums

GE Spacemaker Microwave PVM1870 fan keeps running after door closed and won't shut off. Have to open door or unplug. As soon as door is closed and plug is back in, fan starts up. If door handle is pressed downward, microwave starts! If door handle is raised, fan shuts off but light stays on.

... Vacuums

Question mark light has come on my vacuum and it wont run. I replaced the bag, but it wont start. I don't have a new filter is that the problem?

... Electrolux Vacuums

Keeps stopping. My Roomba Discovery says it has a full charge, but it runs for a few minutes, then stops and beeps and the status light comes on. If you press the clean button, it will start again and go for a few minutes before the same thing happens again.

Your battery isn't holding a charge ,buy a new battery ... iRobot Roomba Discovery SE Bagless Robotic Vacuum

Magic chef model #MCWC45A Serial # 0902mcwc45a09720. It is a bit over a year old. it just went dead. no compressor sound.No interior light. Unplugged it, and after a day plugged it back the the compressor started running. it ran for about an hr the it shut off. the cooler was cool inside. i noticed the compressor was hot to touch.

Hi, It sounds like the compressor is going bad, but you can try to change the start components and overload to make sure they aren't at fault......Check out these tips that I wrote about that... it is a great place to starttro ... Vacuums

Everytime I vacuum the white lights (where the floor level selectors are) start flashing and then it doesn't pick up as well. I have washed the filters and the problem continues to happen.

... Dyson DC17 Animal Bagless Upright Cyclonic Vacuum

Bissell model 3575 vac won't run, when I turned the switch to on it tried to start, and now won't. The light turns on. Is there a fuse or reset button??

... Bissell 3575 CleanView Upright Vacuum

Series6500SR starts then stops-bag full light on-remove hose and it will run until Ipartially block the intake with my hand to simulate the hose. Bad sensor? how do Iopen this baby up? Can you send me parts?

There is an adjuster for the size of the dirt particles you are vacuuming on the top of the vacuum. Inside this adjuster moves an "O" ring up and down in a tube to adjust vacuum flow. The "O" ring is held in place by a plastic flange which is thin a ... Electrolux Epic 6500 Vacuum

The Roomba 535 runs but stays in 1 spot moves 2 inches turns and repeats the process about 10 times. then a red indicator light starts blinking and the unit shuts down

Any beeps? If so, how many?\015\012\015\012Is there a pattern to the light blinking?\015\012\015\012Not really enough info yet to be certain, but it sound like the cliff sensors may be dirty. \015\012\015\012Here ... iRobot 530 Roomba Vacuuming Robot, White Vacuum

My irobot starts out running fine and then it will turn and slow down as if something is keeping it from going. all at once it will go full speed again. it does this until finally it stops and the red status light comes on. I just replaced the battery 6 months ago.

... iRobot 4296 Robotic Vacuum

My electrolux vacuum cleaner twinclean cyclonic 13MXXL Reach stopped working..lights on filter clean started flashing. I washed the filters...anything else I need to do. I'm waiting for the filters to dry. Thanks .Erika

... Electrolux Vacuums

I have a G.E 1.0 Microwave Model JES1039WF02, It has power on the panel but I see a message that says -F3- It will not start or do anything when the buttons are pressed. There is power running to it. The light inside turns on when the door opens. I looked through the owner's manual and there is no reference to this message on the troubleshooting section.

If there is no heating please do not switch on unless you have confirmed the fault. It is possible that the Magnetron is faulty, the temperature cut off is faulty or the main capacitor is short. It is also quite possible that insect can get ... Vacuums

When I push the start button, unit lights up and as soon as it starts, the gfci pug trips. any suggestions

1)you must test the c. board, can be faulty. by that reason all this phenomenon appear. Any component can be in short, such diodes, capacitor, resistor, triacs, SCR. etc or IC.2) you must call you supplier for get help ONLINE chat with them. ... Vacuums

My new H2O Mop Ultra (Danoz) seems to heat up ok then when the light switches to green and I start using it, the orange light comes back on as well as the green. Produces steam to start with but then it starts to spit water too and everything ends up wet. Any ideas on whats wrong or should I just send it back?

That is a major hardware fault, I have seen this numerous times with these H2O mop's... They seem to either work perfectly for a long while or have problems right off the bat. You definitely want to send this unit back and either get a refund or at ... Vacuums

My Dyson DC07 vacuum started to run slower after being on for a little while and then would run normally again. I have switched on today and it has just stopped. When I push the start button, on occasions it almost starts and then doesn't. I am wondering if there is a problem with the switch and if so how can it be fixed? Thankyou.

The motor running slower was the motor starting to burn out. The "almost start" is the brushes making intermittent contact with the armature in the motor. \015\012\015\012Your machine needs a new motor Pam. ... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0447 seconds