Having problems with your Vacuums ?

How do I restore my devices firmware for my zune 30gb


Answers :

How to restore your Zune device software:------------
When you restore your Zune device software, the startup partition and the data partition are removed and rebuilt. In addition to removing the Zune device software, this process also erases all audio, videos, podcasts, and pictures that are stored on the Zune device.
Warning To restore the Zune device software, you must have a Windows-based computer that has an Internet connection. That computer must have the Zune software installed. And you must be able to connect the Zune device to a USB port on that computer by using a Zune Sync Cable. Do not perform the following steps if you do not have any one or more of these things immediately available.

After you start to restore the Zune device software, you cannot again use the device until you complete all the steps. You will not receive any confirmation or warning on the Zune device after you start the following procedure.

To restore the Zune device software, follow these steps:
1. Set the Hold Switch to unlocked.
2. Press and hold the Back button at the same time as you press and hold the top of the Zune Pad. When the Zune device begins to power up, release the buttons.
3. Immediately after you release the buttons in step 2, press and hold the following special button combination, depending on your Zune model:• If you have the 4GB Zune, the 8GB Zune, or the 80GB Zune, immediately press and hold the Back button at the same time as you press both the left side of the Zune Pad and the Play/Pause button. Continue to hold these buttons until your Zune device restarts and "Please wait" appears on the screen.
• If you have the 30GB Zune, immediately press and hold the Back button at the same time as you press both the left side of the Zune pad and the center of the Zune pad. Continue to hold these buttons until your Zune device restarts and "Please wait" appears on the screen.

Note "Clearing contents. Please wait" appears, followed by “Connect Zune to your PC."

4. After “Connect Zune to your PC” appears, connect the Zune device to the computer that has the current Zune software installed, and then update the device to the current Zune device software.
\015\012\015\012\015\012-----------\015\012Click this link directly for more troubleshooting:--\015\012http://support.microsoft.com/kb/944909\015\012--------\015\012If error problem while restoring then click this link below:--\015\012http://support.microsoft.com/kb/945278\015\012----------\015\012Thanks. Keep updated for any more query. You can rate this\015\012solution and show your appreciation.
Repair Help & Product Troubleshooting for Vacuums

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

How do I restore my devices firmware for my zune 30gb


How to restore your Zune device software:------------When you restore your Zune device software, the startup partition and the data partition are removed and rebuilt. In addition to removing the Zune device software, this pr ... Vacuums

My ECLPISE Mp3 player will not charge no matter how many times I plug it into my computer, a message is popping up that there is a malfunction in my device and the device has worked perfectly fine until now.Could explain what I should do now?


Replace the battery in the mp3, if it has a NiCad in it now it will retain a memory of a faulty issue. If possible try to get a lithium ion battery ... Vacuums

I am using the Bissell device to vaccuum curtains. Now I


I wentto WalMart and a sales rep showed me how the machine works. I had already attached the curtain extension back in the proper place ont the machine. This action automatically returned the suction to the floor. ... Bissell 6594 PowerForce Bagless Upright Vacuum

Restore shine to laminate flooring


... Vacuums

Ease Steamer MCE 7100 blown Diode, thermal protection device?????


... Dirt Devil Easy Steamer Upright Wet/Dry Vacuum

We have a Hoover upright vacuum cleaner, model Core 7. There is a switch that turns on and off the brush drive. This operates via a cam with a bearing putting pressure on the final drive belt to engage the brush head. My brush head is not turning and with the lever set to engage the drive there is still considerable slack in the final drive belt. There appears to be only a bearing deflecting the belt, should there be a pully or other device mounted on this bearing? There is so much slack a


Yes, there should have been a white plastic sprocket on top of the bearing - in its channel the belt would sit. Unfortunately no parts are available for this unit that can be bought retail - only available by order to dealer repair shops.\012\012\012 ... Hoover Vacuums

On app MC2:BP I can't enter to see my mail....it says Ur device needs a camera but I have a friend that has same iPod and it works for him someone help please


Mine says there's a problem with ur account but I can still play online ijust can't check my friends online or mesages.. Help ... Vacuums

I was given an Auriol H13726A weather station and after 5 days of perfect functioning, now it will not find the wind station. I tried resetting the whole device, but still I have no response from the wind meter. I noticed, when changing the batteries, that the LED on the wind meter will not light up. As this was a gift, I no longer have the receipt and I don't know where the weather station was bought. Thanks for helping,


... Vacuums

Nutone Broan CV556 runs continuously and will not shut off until I unplug it.. I disconnected the low voltage wires and it still runs when I plug it in. Inside the top of the vacuum are 3 electrical devices - one looks like a transformer wire -- one is a rectangular electronic black box. The third is an on off rocker switch. Which piece it likely to be shorted out? It is about 8 years old.


... Broan-NuTone CV556 Cyclonic Bagless Central System Vacuum

Feeding device for the aquarium Mod: Z18465. I lost my operating manual. I must leave the house for a while and don't know how to adjust feeding device.please help me !


... Vacuums

My Delonghi D895 Deep Fryer was accidentally turned on without oil in it. It immediately blew the thermal safety device. I would like to repair it myself. Where can I get this part? Thanks


... DeLonghi Vacuums

DC07 DYSON REPLACEMENT HOSE. HOW DO YOU REMOVE IT FROM THE HANDLE. I have a kenmore whispertone 8540 canister vaccum. The electrical wires (3) to power the beater are embedded in the hose, in a spiral fashion. The yokes that hold the hose on both ends (and attach to the beater on one end and the unit on the other) have no screws or pressure latches; i don't want to use brute force as i may damage the attachment device inside the yoke. If someone can tell me the trick to get these yokes off each


Should be a pry off dot on the underside revealing a screw ... Vacuums

Carpet stained recently cleaned my cream coloured carpet in my entrance hall with a carpet cleaning product, wet foamy spray type, ran out of this and found a part bottle of a different brand in my cupboard, used this to finish off however must be some sort of reaction and carpet gone a greenish colour i think (colour blind sorry ) any idea's of any product that might restore my carpet, will try anything, nothing to loose. thank you Peter McGurk Goole East Yorks


Ok in the future try to have carpet cleaned only by a pro. For spot cleaning use white paper towels or dish towels and warm water. (ONLY WHITE) 99% of fabric is white and then dyed to color and if you use a color cloth you might pull the dye from the ... Bissell OxyKIC - Oxygen Activated Carpet Spot and Stain Remover Vacuum

Is this a double insulated device? - Dayton 3VE22 Canister WetDry Vacuum


If the cord plug is two prong, yes. If it's three prong (two flat, one round) no. Most all vacuums for the past many years are double insulated even though they don't state that. ... Dayton 3VE22 Canister WetDry Vacuum

The cleaner no longer vacuums up the water. I have to use the tool device to get the water up. [email protected]


Try the following suggestions to see if you can get your machine suctioning properly:\012\0121) Remove the Tank-in-Tank Assembly and place your hand over the motor intake valve. This valve is located next to the Floor Nozzle gasket (at th ... Bissell ProHeat Turbo Deep Cleaner Upright Steam Vacuum

Im having problems with the hasp-4 device drive for artista 180 sewing machine, its not letting me use it saying not installed


Is this the type that is computer controlled? Do you have the software and drivers installed and updated? ... Vacuums

I have an Electrolux Commercial Upright vacuum Model U129C. It has a device which turns off the motor driving the beater bar if something gets stuck in it. There is a simple reset button to restart the beater after clearing the obstruction. Just recently on flat dense low pile surfaces the switch cuts in after just a few seconds and turns the beater bar off. This doesn't happen on high pile carpet but the motor doesn't quite sound normal. There is no obstruction - the beater bar can spin freely


The motor is having a problem.There might be two reasons...either the coils inside it got heated up which will be needing rewinding or you can buy a new motor or there r capacitors attached sometimes u can make a check on that also if that's gone Kap ... Vacuums

I have an old Progressive vacuum cleaner that says "Hepa Filter" and "Whisper Belt". Not sure what the model # is. The problem is that the vacuum part itself (the part that touches the floor and rolls over) has ejected its filter that we can see through the little window- it just came out under the rollers under the device... we cannot see how to re-insert this piece of filter which looks like a kind of round, flat grey foam/fabric and clearly goes inside- (top of the part that touches the flo


Check this procedure:\015\012\015\012Unplug the appliance that you will be \015\012changing the filter in.\015\012\011\011\011\011\011\011\011\015\012\015\012\011\011\011\011\011\011\011\011\015\ ... Kenmore 23313 Whispertone Bagged Canister Vacuum

Bought an PlayStation 2 at our youngest dauthers 9 year birthday together with an dance mat. Caused by an accident we had to buy a new remote contol for some years ago and we chosed your URC-3445. We can't get it to work. How do we get to AV-chanel throughtout your device? There must be a solution at our problem. Please help ....! Her anniversery is unfortunally today!!! Our TV is an rater old Tandberg modell: TVF2915NT Please...


Go to menu settings, find channel edit or add/delete, turn channel to input or a/v channel, select add channel and then your good. You should now be able to use the ps2. You can also hook them up through vcr and use the vcr input/av channel. and then ... Vacuums

I need to replace the cord rewinder of my Nilfisk King series 500 vacuum cleaner, but I do not know how to open the device or where are the screws. Can you help me?


Http://www.youtube.com/watch?v=13krERCaP0U ... Vacuums

I accidentally threw away the device that holds the vauum bad in place on my Hoover Canister Model S3332. Where can I purchase/order one of these? thanks Helen


According to Hoover this part is no longer available as of 12/09\015\012PAPER BAG HOLDER-HOOVER S3332 CANISTERNLA 12-09 ... Hoover S3330 / S3332 Straight Suction Telios Bagged Canister Vacuum

I downloaded themes for my nokia 3500c from my pc. whenever i apply theme it shows 'unable to apply . Theme corrupted'. after that i updated my device software and formatted my memory card but still the same problem persist. HELP ME.


Some times its due to memory problem!\015\012mean size of theme ... Vacuums

Keeps shutting off after a few minutes of use.have changed bagsno clogs and filters have even been washed.what is auto shutoff device and where?


... Hoover U6437-900 / U6439-900 Windtunnel Bagged Upright Vacuum

I have a Neotec XJ-2000 ionic air purifier. On the bottom of the device, it says I should open the casing and take out and clean the dust filter every month. I haven't done it in years and no longer have the manual. How do I open it up to get the dust filter out?


... Vacuums

The locking device at the top of the telescoping wand for my miele whitestar broke. Can it be fixed? IF so, how?


... Miele Vacuums
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0119 seconds