Having problems with your Vacuums ?

My Miele vacuum carpet head will not work. It is an SEB236 Powerbrush and the "reset" light is on when I turn on the vacuum. I don't know what this means! Please help!!

Answers :

If the light is on then you must be getting power to the power head. Could be a motor problem, there is a push button switch and a circuit board. Just have to checked to find the problem.
Repair Help & Product Troubleshooting for Vacuums

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

My Miele vacuum carpet head will not work. It is an SEB236 Powerbrush and the "reset" light is on when I turn on the vacuum. I don't know what this means! Please help!!

... Vacuums

You might not believe this but i don't know how to turn it on. I thought it was on the power nozzel but It is just got an orange light on. I know this sounds silly but please help me.

The on/off switch is located on the hose handle. The "O" is for off, "I" is vacuum only, and "II" is for vacuum and power nozzle. The light below the switch indicates there is power to the vacuum.\015\012If your vacuum doesn't run, there are ... Electrolux Guardian Bagged Canister Vacuum

We have a zenith dehumidifier model ZD300 & the bucket full light keeps flashing. the percentage number wont go higher than 1%. we have turned it off/on & unplugged it. When we do this it will reset to 40% for about 2 seconds & then goes back to 1% & the bucket full light starts flashing again. The bucket is empty & we have cleaned the filter. We have only had this dehumidifier about 7 months. Please help us.

I've had the same issue with mine. I am a 12 year refrigeration tech. I checked the float switch which would normally cause that indication light. However manually pushing the switch and then checking it with an electric meter that was not the case. ... Vacuums

I was putting some bedding in a bag for storage and decided to ''**** it down with my dyson hose to fit it in a smaller space. My dyson quit working and now it will not turn on can you please help...??? I know I didn't **** anything up but I can't live without a vacuum!! I have tried the brush reset button but can't find another reset...

There is no other reset. The Dyson will cut out if it gets too hot, but resets itself when it cools. In doing the job you describe, I doubt that you have operated it long enough to cause overheating, or to do any other damage. I suspect the problem i ... Dyson DC17 Animal Bagless Upright Cyclonic Vacuum

I have a dyson DC23 and the turbine head will not turn anymore can anyone help on how to reset. I have cleaned it and there is no blokage its just stopped? Please can someone help

Pull the plunger into the ''out'' position for vacuuming carpets.For vacuuming hard floors push the plunger into the ''in'' position to stop the brushbar spinning.Refit the tool onto the ma ... Dyson DC23 Bagless Canister Cyclonic Vacuum

Riccar 8750 I have a 8750 riccar vacuum and it suddenly didnt want to start. someone told me it has a reset button but I dont know where I could locate it. can you please help?

I have an 8625 and the button is now white not red. Probably fadded. Thanks that was the reset button and it solved my problem. ... Riccar 8650/8625 s Vacuum

Vorwerk vtf 732 power on but nnothing happening light on head is on when i press"reset" button still nothing please help

... Vacuums

Sponge filter I have a kirby sponge filter for my Sentria shampoo system and dont know where it goes. It stop working and making foam. Kirby sent me the sponge filter saying this is what i need and i would know where it goes. I dont nor kind I figure it out. please help!!!!!!!

On the end of the shampoo tank where it attaches to back of motor where the bag is normally attached ... Vacuums

I have a hoover Core vacuum. The problem is that the blue light flashes (as normal) when it is plugged in and the power is turned on and the blue light stays on (as normal) when you turn it on at the button but it makes no noise and doesnt work. All of the filters are clean. Can you help please?

... Hoover Vacuums

I have a fake nokia n8 cell phone(basically called chinese). i didnt know about flight mode and turned it on by mistake. now i dont know how to turn it off. menu is not opening and i cant make a cal... plz help me out.. :(

Take the power button should give you the option to turn off airplane mode ... Vacuums

I have lost the instructions for my Westinghouse photoelectric switch/interupter, model # 28451. I use this to turn on/off the Christmas lights on our porch, etc. Now I'm going crazy running around trying to turn lights on or off! Please help! Thanks, MHH

... Westinghouse Vacuums

Kenmore vaccuum upright moded#721.33289030 vaccuum worked just fine turned it off for a minute turned it back on the light comes on but theres no power from the motor Please Help thanks Valerie

... Vacuums

We have the water hooked up at the back of machine. there is a spout for the water to come in and fill the ice tray.but is does not. If we turn the water on it fills up the space under the ice basket. I keep getting red light and then the two smal llight one ice and one water come on. We can hear the motor trying to fill the ice try and then lights come on. Please help me this so I can use this product. It did not come with a manual.

The water inlet valve on the back of unit opens when the ice maker needs water. If the valve doesn't seal good because of sediment or wear it will continue to drip and when the water reaches the ice maker supply tube it will freeze blocking the fill ... Vacuums

I was steaming my bathroom walls and it turned off on its own (lights off). I figured it was out of water and I waited 30 minutesbefore refilling the steamer and plugged it in and no lights no nothing still. please help!

... Euro-Pro Ultra Steam SharkTM II Hard Surface Steam Cleaner Vacuum

I just bought the NewAir AI-130S Portable Ice Maker. I can't drain the water. I unscrewed the water drainage port but nothing comes out? also, how do I turn it off. When I turned off the on/off button the green light stays on? Please help. Barbara at [email protected] or 305-270-7807

... Vacuums

I have a kenmore vacuum cleaner model # 116.23612. When the hose is attached to the canister it runs, but if you remove the head to just use the hose the unit stops working. Is the motor dead or is there some type of reset or fuse. Could you please tell me how to test this. If so could you please send me instructions on how to replace the motor. Thank you in advance for your help, Tony

... Kenmore Vacuums

I have the IROBOT discovery that just got a new battery. IT ran great! As the battery was dying, I put it into the home base. The "brick" is green, the home base has two green lights and the on/off pulsates red. It never charges though. Eventually the red light stops pulsating. Customer service said to reset it, clean the metal, and nothing works! They told me to just buy another one. The problem is that I know it was working! Help!

The best thing that you can do is take the charger into somewhere that can test it for the proper output voltage. It should be somewhere very close to 22 volts with no fluctuation. The charger is the easiest thing to test in this case. ... iRobot Roomba 4210 Bagless Robotic Vacuum

I have the brother Ls-2000 sewing machine i threaded the top as well as the bobbin but when i try to sew the thread gets stuck and it bunches up and tangles in the bobbin. also the little bit that did sew was tight stitches on one side of the fabric but very loose on the other side I followed the instruction and it keeps happening i need help i dont know how to fix it please help me

Adjust your tension.You probably did not wind your bobbin properly as well.Make sure you oil your machine every month or so and make sure your bobbin is seated properly before you sew.\012\012Go slower with the pressure foot speed and use the r ... Vacuums

Full bag indicator light is on, just changed the bag. Motor turns on the cuts off immediately. I already paid $10.00 and there was no solution. I have an E2000 Does anyone know what all the symbols mean when they light up?

Turn the dial on the top of the vacuum all the way to the right and try it again. ... Electrolux UltraLux 2000 Bagged Canister Vacuum

Sweeper head we took the head apart to clean dust and now it wont work .when you pull the trigger the red light comes on. help please.

First - press the circuit breaker button.If no luck:1. Make sure you have connected it properly (see diagram here)2. If you connected it right ... Rainbow E series Canister Wet/Dry Vacuum

HOOVER SAVVY This is less than a year old (yep, no receipt) and all of a sudden last night the vacuum turns off after a moment of running. Also the red and green lights do not work at all. I've thoroughly cleaned the bagless unit, and it still won't work. It powers on for a split second then turns itself off. Help please.

I had the same problem. Took it in and the repair shop they said it was the switch. It was an $18 switch and $30 labor. Switch was a red on/off button with 2 wire leads and caps to screw on for connection. If you can wire a ceiling fan then this ... Hoover U6630-900 WindTunnel Bagless Upright Vacuum

Dyson 28-animal- Power brush stopped working and power light and carpet level buttons all are blinking. Per the instructions vacuum needs reset by turning it off for 30 seconds. However after doing so it does not reset and work. Help!

... Dyson DC28 Animal Bagless Upright Vacuum

Protection light the protection light on our electrolux 2100 comes on every 45 seconds and the vacuum will just stop and I have to turn off for about 1 minute to get it going again and off again after 45 sec. Please help

It might be the bag or the sensor inside the machine. ... Electrolux UltraLux 2000 Bagged Canister Vacuum

Wiring diagram took wires off motor and do not know which goes where.There are two main from plug in one whit one black then two of same coming from light in front.On the motor ther are more terminals than wires.On diagonal corners there are black dots.Can you please help this cost 800$ and do not want to burn the motor due to crossing pos and neg.Do you have a picture or know where I can find?

... Oreck XL21 Bagged Upright Vacuum

My vacuum is a Kenmore Special Edition with a Power-Mate 12.0 AMPS wand. I ran over the edge of fringed edge of my living room carpet and immediately turned off the vacuum. Although I have removed the fringe pieces from the wand head and I have pushed the overload protector reset button on the wand, the wand brush will not turn. Help- it's the Thanksgiving weekend and guests are coming soon! Thank you.

... Kenmore 25512/ 25513 Progressive Canister Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0996 seconds