Having problems with your Vacuums ?

Replacement battery for my Haier wine cork remover 6 volt

Answers :

Repair Help & Product Troubleshooting for Vacuums

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Replacement battery for my Haier wine cork remover 6 volt

... Vacuums

Battery replacement I would like to replace the battery on my handheld Black and Decker 9 volt battery Dust Buster. But where is the battery? How do I remove the old battery so I can replace with a new battery?

... Black & Decker CHV9600 Handheld Vacuum

How do I remove the battery in a Dustbuster chv1400 for replacement? I have removed the two screws and removed the cover, but I'm unable to figure out the retaining clips for the battery. Of course I don't want to break the clips.

That model looks similar to my DB200. Instead of the screws, the underside has a latch/panel that you remove. Place a screwdriver in the two slot-like holes that face each other (one at a time) and the 'door' should pop out. Mine was a little stiff ... Black & Decker Vacuums

I think I need to replace the main battery in my small floor vac - the one that can be hand held like a dust buster or work like a small floor vac. I need to know how to remove the battery and replace it with what kind of new battery..

I see my sense of humor is not appreciated...it was only a joke. Anyway, here is what you do: First, slide the battery cover off the bottom of the hand held unit. Remove the battery from the motor housing by pressing the tab on connector “A&rdq ... Vacuums

Battery replacement I tried to follow the owner's manual instructions, but I have been unable to remove the battery cover.

I have opened CHV1400 by removing two screws that are visible when you remove the "accessory" from its holder (located underside of the vacuum). After removing the 2 screws, I had to pull the green colored part by exerting slight force. You will now ... Black & Decker CHV1400 Bagless Handheld Cyclonic Vacuum

WST 1600A I purchased this vaccum about four months ago from Heartland America. Up to this point it's worked fine. After cleaning it this time when I went to start vaccuming again it runa for about 10 seconds and cuts off. I've changed the battery, taken everything that can be removed out checked it and replaced it. THe motor sounds like it's straining. I have not taken the housing off the motor to see what's going on with that. I misplaced my manual.

It sounds like there is a clog. If there is no air flow it could be overheating. ... Westinghouse WST1600 Upright Vacuum

I need a replacement for cooling fan HENG #FS92252M. where can i find it? it is on a Haier wine cooler.

... Vacuums

I need a replacement battery fo my vacuum xb640h 8.4 volts. where can I purchase one?

Find a repair shop that repairs what ever brand this is and see if they can get one for you. ... Vacuums

Replacement of batteries for waring wine opener

Are you supposed to leave the wine charger plugged in at all times or just charge it when you need to use it. ... Vacuums

Can the battery be replaced on my black and Decker dust buster plus 15.6 volt vacuum?

Yes if you can get onehttp://www.ereplacementparts.com/black-and-decker-chv1560-dustbuster-parts-c-4167_888 ... Vacuums

Sunbeam Model HC4800 cordless hair trimmer. I need help on how to remove the back to replace the batteries.

... Vacuums

Norelco razor 6867xl - am planning to replace battery pack. Would be easier to solder if I could remove the whole circuit board system from the hard plastic case. How do you release the metal clips?

The whole circuit board is removable, and I would recommend removing it from the whole external case to work on so nothing is damaged by your soldering iron.\015\012\015\012Battery : 2x NiCd AA\015\012Battery capacity : approx. 700 ... Vacuums

How do you remove and replace the battery for a 940CB chamberlain?

Older version: unscrew the phillips-head screw that holds the battery door on at the bottom of the keybad. \015\012\015\012Newer version: insert a phillips-head screwdriver into the slot at the bottom edge of the unit, and pull gently to ... Vacuums

After removing the filter, I cannot get to battery on the Dirt Devil Kone M0213, there are two horizontal screws. Removing them does not help getting to the battery, no way to remove the insert where the battery is located.We have two of these, however they did not come with a manual for dis-assembly. Please help or proved a diagram on how to remove the battery. Many thanks, Wesley Lennon

Sheesh, did anyone actually read the person's question? It's about the battery, not the filter.\015\012\015\012You have to get the outer cover off and it's not easy. There are four tabs which need to be released. I have to use a very sha ... Dirt Devil KONE Hand Vacuum MO213BLU Vacuum

After charging overnight, Roomba only runs about 25 minutes before shutting down with a red light.At this point the battery measures 15.13 volts ( about 1.26 volts per cell ) My hobby experience is that a ni/cad or ni/mh battery nominal charged voltage is about 1.2 volts per cell, and that the recommended end point voltage should be about 1.0 volts per cell. Seems like the battery is ok, butsome kind of voltage regulator is shutting things down prematurely. Is this happening, and , if so, how ca

Reset the Roomba by removing it from the charger, then holding "spot" and "dock" for about twelve seconds. When you let go, the unit will play an ascending series of notes. Then recharge it overnight. If the run time is still short, give Customer Sup ... iRobot Roomba 560 Robotic Vacuum

How to remove battery of Black & Decker V1250 DustBuster Handheld Vacuum

... Black & Decker AV1200 DustBuster Handheld Vacuum

Battery replacement need replacement battery for battery # 598291-00

... Black & Decker CFV9600 DustBuster Bagless Upright Vacuum

I recently purchased a Rowenta electric table lighter that is powered by a Mallory M-215 battery. The battery looks like a regular 9 volt, but only has one contact point (in the center) of each end. It says it is 22 1/2 volts. Can you help me in finding where I can purchase a new battery?

... Rowenta Vacuums

I have a wireless thermometer made by Viking (CE 0197). Have replaced the batteries of the remote sensor RF wireless. In the battery compartment there is button TX and a slide switch for position 1,2,3. Have replaced batteries pused button but no results of recording. Could you help me what to do to make the unit work again. Thank you

... Vacuums

We bought a new home in march. It is a brand new home, with brand new First Alarm smoke/CO detectors. The very first night, we noticed the iving room (main) smoke alarm was "chirping". So we tried to replace the batteries, but when we did, all of the smoke alarms started going off (they are hardwired). We took out the new battery & dealt with the chirp. It is getting to be too much. So we are trying to fix it, but everytime we replace the batteries, the alarms are silent for a little bit, & then

... Vacuums

The switch on our Hoover Windtunnel vacuum cleaner is not working. I have located the replacement part on your website...part#Ho-28161067, I've removed the wires from the switch. Is there any trick to actually removing and replacing the switch itself? It seems to be in there rather tight.

No, follow the directions to replacing the switch and you should be good. if you got the kit then splice the wires and replace them with the wires profied and the wire nuts, you should be good. ... Vacuums

B&D Dustbuster model CHV1400 TYPE 1 not working (no recharge). Does it pay to replace battery or not? If yes, how do I open it up, and how do I replace battery? Price? Where do I buy it?

Sorry to say but the battery pack is 3/4 the price of a newer dust buster. The other solution is the have some one rebuild it. But I would buy a new one. Don't waste you time. ... Black & Decker Vacuums

Our favorite vacuum has stopped oerarating. We believe the battery needs to be replaced. WE HAVE LOST ALL DATA SHEETS THAT WOULD HELP US REPLACE (AND CHARGE) THE BATTERY<Is there someway you could get us this data. We will reenburse. Model R#MOD24A Thanks. Clay Collins

... iRobot Roomba 4210 Bagless Robotic Vacuum

My Euro-Pro UV617 never holds the charge as described from day one. I never it plugged in all the time and it dies after use for 5 mins. Is there a cheaper source to buy replacement battery? Should I spend another $27 for replacement battery or is there a bettter cordless vacuum out there which holds the charge as promised?

I'm going to try this source for a battery: $11.99 ea.+ $6.96 SH or 3/$32.42 + $7.95 SH\015\012\015\012http://store.yahoo.com/buyitnow64/shvacl ... Vacuums

Fan replacement I found the part to replace my broken fan. I've remove many screws, but I can't remove, what seems to be, the obvious plate to get to the broken fan.

Http://reviews.ebay.com/KIRBY-VACUUM-REPAIR-HOW-TO-REPLACE-THE-FAN-IMP ... Kirby Ultimate G Bagged Upright Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0837 seconds