Having problems with your Vacuums ?

What is the oil gasoline mix for the Weedeater Featherlight Blower, Model # FL1500? Thanks for any info

Answers :

Howdy, 40:1 is the ratio and here is the link to the manual: http://weborder.husqvarna.com/order_static/doc/WOUS/WOUS2002/WOUS2002_530086312.pdf
Repair Help & Product Troubleshooting for Vacuums

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

What is the oil gasoline mix for the Weedeater Featherlight Blower, Model # FL1500? Thanks for any info

Howdy, 40:1 is the ratio and here is the link to the manual: http://weborder.husqvarna.com/order_static/doc/WOUS/WOUS2002/WO ... Vacuums

Royal vacuum cleaner model 4600 wiring diagram I have a Royal Vacumm Power Tank Model 4600. I replaced the switch (6 wire - 3 position) that is on the tank. One side of the switch control just the blower. The other side control the blower and the POWER head - wand with a variable control speed. The middkle position is off. After I installed the swith, the power head - wand is powered in either position. There are three wires comming out of the wand: White, Red and Black. I guess I wired somethin

... Vacuums

I have an old oil lamp. this motor/pump pumps mineral oil up a tubing and then the oil drips down the fishing line for lack of better word. and the pump does not work. On the motor itself it reads UPPCO, Inc. Chicago Model 50 Impedance Protected 120v-60 hz .30 amps P-8365-1 Use sonneborn mineral oil only do NOT use water. Any help would be greatly appreciated. Thanks Shelley

... Vacuums

I have an old Shop Vac model 3331.5. This is a 12 gallon 1.5 hight peak shop vac with a detachable blower. After many years I decided to use the blower feature, but have lost the lost the manual. Question; how do I attach the hoses to the blower? The motor has that cap on it the direct the flow of air in one direction and the wide hoses do not fit over it. I may be missing a part, but I would think the directional cap would have to come off anyway.

Remove the cap that directs the air and insert the hose in there. ... Vacuums

I have a Napoleon Pellet stove insert Model NPI40. When the fire burn rate is extremely low it seems to operate normally. However, when I turn the heat up even a little I eventually get a high pitched noise that seems to be coming from the convection blower. Changing the speed of the blower has no effect on the noise level. I cleaned the blower but did not remove it. There was very little dust on it. Cleaning had no effect on the volum or pitch of the noise.

My theory is based upon 1st hand knowledge with a newer EPA compliant freestanding wood burner, with the air-tight and high efficiency ratings.its possible that its just the high rate of air moving through the air chambers , similar to a o ... Kenmore Whispertone 23312 Bagged Canister Vacuum

Bissell - Model 1697 - Powersteamer Pro - Carpet Cleaner I took the unit apart to replace some broken pieces and I can not seat the bottom to the top without properly engaging the soap/water mixer. What is the proper assembly procedure. What is the orientation of the water/soap mix valve when I seat the top to the bottom? The soap/water mix valve needs to engage the knob screw threads but this assembly is a blind operation. Do I turn to the soap/water mix knob to water only then seat the

Hi,\015\012http://dl.owneriq.net/7/7e477b7e-4440-49cf-a219-b68d301549e3.pdf\015\012This diagram will help you see the diagram plus the part assembly no and place it accordingly.I have also given link for Bissell - Model ... Vacuums

I've lost the mixing blade for my Hitachi Bread Machine, model # HB-B102. The blade model # is 101-901-900 (I believe). Apparently that model is no longer available. Is there one from another bread michine that would work? Judith Miller-Smith

Here is a link to a paddle for your bread machine. ... Hitachi Vacuums

My electrolux sidekick, model 1562 makes a nasty screeching sound.It happens as soon as it is powered on,the noise then gets intermittent after qa few minutes and then goes away.This cycle is repeated evry time i use it.I have checked it for binding and obstructions and oiled the motor.I think it's the roller brush but oiling it didn't seem to help

... Electrolux Vacuums

Found old J.C Penny vacuum cleaner on garage, looks industrial, canister model. It takes intake from the front but just expels it off the back. After opening, I see it needs a bag and a filter, the model is J.C Penny wet/dry 10 gal. MOD-SVP-017 Catalog # 824-4327. Unable to find any info on the web regarding it. Any help??

... Vacuums

I was mixing a cake mix on an old Kitchenaid Hobart Mixer Model 4 C for 5 Minutes and then white smoke started to come out. I don't think the mixer had been used in many years. Is this repairable or should I junk it. Thanks, Bonnie

... Vacuums

Can't find info for hoover steam vac spin scrub model # F5905900 on Hoover website, doesn't show that model number at all...looking for mesh (kind of cone/cylinder shape) that goes in dirty water tank (I think) and also the tool (wand) that slides into front to clean it out. It doesn't pull all the water up very well and the filter has been missing for some time. I don't know if that has anything to do with it or not. As far as the wand tool goes, I have taken the cover off at this point and

The cleanout tool is part # 43514001. The filter is # 90001398. Be sure to leave a 1/2 inch gap between the top of the filter and the bottom of the lid. If you need a manual, try model F5914-900 0r F5912-900 on Hoover.com ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

I am trying to find a user manual for a Keystone sewing machine. Its a older model called. De Luxe Stream liner model DST.2 I can't seem to find any info on it. Serial number is 16826. Thanks

... Vacuums

Where would OIL come from by the right side back wheel?I have a hoover wind tunnle model # u6425-920. Does the drive moter have oil in it if so and it is leaking should we replace the motor?

The motor does not have oil in it. The onnly thing I can think of is that if soemone had tried to free up something by using a spray lubricant, and not it is running out. I've never seen this issue. You would have to let a repair shop look at it. ... Vacuums

Bissell proheat pro tech model 7901-3 smart mix dial and valve assembly

Turn the knob to the water only, put the piston on the bottom of the knob then turn it slightly so it doesn't fall off, Start to put the cover on, when it is straight, turn the knob to the water only selection and push the top all the way down. The ... Vacuums

How to oil parts on singer. Sewing machine model 7033

... SewShop.com Singer Model 7033 Instruction Manual

Is there a trick to removing the hose from the main tub so I can remove the filter bag on a wet/dry shop vac with detachable blower Model BLB550?

... Vacuums

I have a 1937 Johnson 4.2 HP Outboard Motor LT-37 Serial # 273761. The engine is seized and I am looking for info on the best way to free it. I've started by putting marvel mystery oil down the spark plug cylinders. Any hints and help would be appreciated. Thank you. Ron massauto

Do you think it is the engine or the lower unit? If the engine has set up for a long time it may be the lower unit or the prop gearing. Pull the bottom loose at the flange be-careful of any parts you take off and try and turn the engine then. If it s ... Vacuums

I have a Hoover Windtunnel Farrington upright model U6431-900 It has worked flawlessly until last week. The roller brush has stopped turning and I believe it is the belt that has broken but I am not sure how to remove the cover to inspect it and replace the belt if that is the problem. Please inform me how to perform the operation and what I should I look for? Is there a site with a diagram on how to replace said parts? Thanks for any and all helpful info that you can supply me with. Larry

Http://geeksquad.fixya.com/ThreadView.aspx?prdid=0&thid=783264\015\012Generic problem for all Vacuums\015\012I have a Hoover WindTunnel\015\012Posted by ... Vacuums

Kenmore cannister vacuum model 116.2411290 has begun exhausting a 'burned' smell. Suspect bad blower bearing. How to access?(Can't find manual online.)

Hi,how are you so sure the problem is from the blower bearing and not the belt,well to know if the problem is from the blower bearing or the belt you have to know how to access your vacuum first,so from all angle you need the manual You can download ... Kenmore Vacuums

I need to replace belt #38528-033 on a Hoover WindTunnel vacuum model #U5463-960. I've had the vacuum for a long time and have misplaced all operational and instructional info that came with it. Any help would be appreciated. Thank you.

Replace the belt on a hoover washing machine ... Vacuums

Replacing smart mix plunger bissell proheat model 7901 procedure for proper installation

Hi,Here is a tip that will give you all the information you need to fix your Bissell Proheat Vacuum Problem.B ... Bissell 7901-1 ProHeat Scotchgard Upright Wet/Dry Vacuum

I have a sock stuck in the hose of my vacuum cleaner. Rennaisance canister model. Because of the design of the handle I can't utilize the reverse blower. Please advise. Thanks

LolTry taping a fishing hook or some such onto the end of a straightened out coat hanger. See if you can push it up the hose and hook the sock.Or, remove the hose entirely, and push a broom handle down the hose.Tha ... Vacuums

Suddenly the automatic deterent mixing system in my hoover steamvac widepath (model F7443-940) stopped from working. It does not dispense detergent anymore. What could the problem be?

http://geeksquad.fixya.com/ThreadView.aspx?prdid=0&thid=766252\015\012Generic problem for all Vacuums\015\012Suddenly the automatic detergent mixing\015\012 ... Vacuums

Miele Champagne Vacuum Cleaner Model S548 I was using the vacuum as normal, moved locations so I plugged into another outlet & suddenly there was no power to the vacuum! I tried it in several other outlets, tried the reset button... & still no power to the vacuum. Any ideas what could be causing this? Any info would be greatly appreciated. Thank you!

Greetings from ,\015\012 \015\012This definitely sound like a cord reel issue to me. This is really the only problem that I ever see on a Miele vacuum cleaner. 9 times out of 10 the cord reel needs to be changed. If you purcha ... Miele Blue Moon Bagged Canister Vacuum

Info on how to operate a Bissell Turbo Brush Model 7901-P.

Hi,Here is a tip that will give you all the information you need to fix your BissellProheat Vacuum Problem.Bissell Proheat Upright Wet/ ... Bissell 7901-1 ProHeat Scotchgard Upright Wet/Dry Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.1992 seconds