Having problems with your Vacuums ?

Smoke alarm keeps chirping. put in new battery and continues


Answers :

Hi,
\012The sensor inside can go bad and that is not repairable...
\012
\012you may need to replace the smoke alarm..
\012
\012heatman101
Repair Help & Product Troubleshooting for Vacuums

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Smoke alarm keeps chirping. put in new battery and continues


Hi,\012The sensor inside can go bad and that is not repairable...\012\012you may need to replace the smoke alarm..\012\012heatman101 ... Vacuums

We bought a new home in march. It is a brand new home, with brand new First Alarm smoke/CO detectors. The very first night, we noticed the iving room (main) smoke alarm was "chirping". So we tried to replace the batteries, but when we did, all of the smoke alarms started going off (they are hardwired). We took out the new battery & dealt with the chirp. It is getting to be too much. So we are trying to fix it, but everytime we replace the batteries, the alarms are silent for a little bit, & then


... Vacuums

Lanson smoke alarm model LANSD240B S/N 139606 Alarm alert beeping. Replaced battery, tried 2 new battries, still beeps. No smoke or fumes found.


Try this, remove the unit and take out the battery you will see 4 small rubber plugs in the back.\012remove these and take out the 4 screws, you will find a lot of dust and insects in there, gently blow out with compressed air and the sensor as w ... Vacuums

We have Lanson Smoke Alarms hardwired to our house. Model Number LANSD240I. They're started beeping for no reason and the red light flashes. I'll get new 9V batteries to try that but is there anything else it could be? Cheers Brett


... Vacuums

Firex smoke alarm keeps sounding in a loud piercing tone. put it in hush mode and after it leaves hush mode it takes about 5-10 minutes and starts sounding again. have change batteries and cleaned units with canned air.


... Vacuums

I replaced the battery into the smoke alarm and the smoke alarm kept intermitentl beeping all night long anyway


... Vacuums

I have a GE 60-848-02-95 smoke detector. It is beeping with the batteries out and unplugged. The previous home owners took the alarm system and there isn't an alarm now. Is that an issue?


... Vacuums

Dustbuster v4810 battery not charging - but I can't find new one!


... Black & Decker V4810 DustBuster Bagless Handheld Vacuum

My hard-wired smoke alarm a "Lifesaver 1225" is chirping. How do I get it apart to replace the battery?


Hi.To replace or install the batteries, you must first remove the alarm from the trim ring, rotating the alarm (see pic). ... Vacuums

Is there any way to repair or replace the belt GUIDE on the inside of the belt compartment of a '97 Hoover Wind Tunnel (not self-propelled)? It became twisted when a belt broke and now the belt rubs against it and sounds really weird, and I'm sure new belts will continue to break.. This guide is a long piece of molded material (part of the compartent wall) to keep the belt from coming off the pulley. It also had a sort of metal clip on it. It was loose and I took it off because of the way the pa


Honestly you should take it to a vac.shop they can fix any vac. ... Windsor SR12 Sensor Bagged Upright Vacuum

I installed a new battery in my Roomba 540. It charges and runs directly with power cord but will not charge on dock. When I push the dock button, it acts like it "sees" the dock and approaches it and even slides on, but then gets back off again and just keeps going back and forth until I turn it off.


... Roomba Robotic Floor Bagless Vacuum

Sm..oke & carbon monoxide alarm keeps beeping after replacing battery


Hi,If that is happening the sensor has gone bad inside the unit...you will need to dispose of the unit and buy a new one...heatman101 ... Vacuums

The Lifesaver smoke alarm model 1225 is hard wired, no battery and is chirping. I have it pulled out with wires coming out of the back, but can't open the front face to get in to disconnect the wire. Anyone know how to open it up?


Hi, you should be able to grasp it and twist it to open/remove it from the juntion box to expose the 120 volt wires. They do not open like one with a battery type, so twist it I believe CCW to remove it from the box to disconnect the wires. Please be ... Vacuums

My beater bar on my Kenmore 116.25615506 canister vacuum keeps turning on and off when I vacuum rugs. The suction continues, but the beater bar seems to be shorting or whatever. I checked the belts and they look like new. Any suggestions? The rest of the vacuum works fine!


... Kenmore 25512/ 25513 Progressive Canister Vacuum

I purchased a brand new P113 Ryobi charger about 2 years ago. It has never worked. If I put a P104 battery in for a charge, it looks like it works correctly. I push the battery tester on the battery itself, and it says full charge, but when I go to use the bateery, it dies right away. I have tried three new P104 batteries. The batteries charge on my charger at work with no problem. The funny thing is, I don't need a battery in the charger and the charger does the same thing, It runs the test


If you have your receipt, check with Ryobi to see if it is still under warranty. It comes with either a 2 or 3 year warranty, depending on when it was purchased. If it is still covered, get it replaced/repaired. If it is not, buy the P117 charger. $3 ... Ryobi P113 18 Volt One Charger 140501001

I need a manual for the Lifesaver Smoke Alarm - Model 1275, SN 1922968. I have 5 smoke alarms in my house and they have gone off every hour, all night long. The alarm itself gives certain information, but says 'refer to manual' for info other than is printed on the alarm. Can you help?


Here you are:http://www.kidde.com/utcfs/ws-384/Assets/1275H_440381en.pdfBest regards, --W/D-- ... Vacuums

I dropped my battery operated alarm clock: the second hand still works but the alarm doesn't come on at the set time and the hour & minute hands don't "hold" their position - I took the clear front off and discovered that I could move the hands to a more secure place on the center spindle but I discovered during the night that the correct time was no longer showing. I really like this clock b/c it's battery operated and I can hear the alarm (when it worked) plus it has a "night vision" dial tha


The hour and minute hands can be pushed onto their respective shafts at any point in most clocks.\012If you already know the time that the alarm is set, let the clock run until it sounds. \012When the alarm sounds, install the hour hand a ... Vacuums

Battery will not charge. Battery was new 12/09. Do I need a new battery every 4 months?


Reset the charge cycle by removing the battery and holding power 15 seconds. ... iRobot Roomba 560 Robotic Vacuum

Even with a new battery


I was having the same problem. Roomba would run for 30 seconds and then stop. I tried everything -- then I took the small rubber brush out and removed the small nut at the end. It was packed with dust to the point that it could not turn easily. I ... Roomba Robotic Floor Bagless Vacuum

My robot will not charge. Tried multiple resets and new battery from irobot.com (both suggested by Irobot customer service) but got nowhere. The vacuum did work for a short time (until the new partially charged battery ran out). If I bypass the internal charging circuits and charge directly from the charger (with jumpers) the robot seems to work fine. Unfortunatey, there is no mechanism to turn off the charge cycle, so this is not practical.


Replace the battery charger ... iRobot Roomba 4210 Bagless Robotic Vacuum

I have a hand held electrolux vacuum cleaner that needs a new battery. It is a ZB266X. Where could I get a new battery, please?


Check out the Electrolux's Floorcare site here and enter your address. They will show you the nearest location that sells the ZB266X and accessories: ... Electrolux ZB266X Handheld Vacuum

SHARK CORDLESS SWEEPER 3 SPEED CONTROL FLOOR, CARPET, TURBO BATTERY EURO-PRO 8.4V - 1.3 Ah SB617U 3305 BELT Turned on and almost immediately turned off At least four years old - not used all the time - not used in six months Checked belt - seems O.K. Do I need a new battery, if so, where do I get one? Or should I just get a new sweeper? Cost?


... Vacuums

The battery for my Ergorapido is charging but only to about 50% power. What would cause this and where in New Zealand can you purchase a new battery. Thankyou.


... Electrolux Vacuums

I have a new electrolux el7025a-r and it keeps cutting off while I am vacuuming. I am using the small powerhead on hard floors and I have checked the hoses for blockages and the bag is new. I can not figure out why it keeps turning off in the middle of a job.


The wands are notorious for going out on that unit. One or both probably need to be replaced. Try to get it done under warranty if you still have the receipt, but they shouldn't cost you too much if you can't. \015\012\015\01 ... Electrolux EL7020A Oxygen 3 Ultra Canister Vacuum Cleaner Bagged Vacuum

Battery charge I just purchased a new battery pack insert for my Roomba, Replacement was a breeze and it now works great. My question is; The last battery I bought ( not from you) was a full cased roomba battery pack that didn't last a year. Roomba says leave the r Roomba charging all the time so it's ready when you need it, and that's nice but I feel that leaving it charging like that it will kill the battery faster as it is always warm to the touch. These battery's should last at least 5


Dave you are correct. You should never over-charge anything like a Roomba, Cel Phone, etc. That will kill a bettery very quickly. ... Roomba Robotic Floor Bagless Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0456 seconds