Having problems with your Vacuums ?

Can't find the manual for Biddeford electric blanket (warming blanket) '08. Controls are acting up. One side keeps turning itself off and says 'E'. I'm assuming this means error. The other side only registars '8' and can not change or turn off unless I unplug.

Answers :

Repair Help & Product Troubleshooting for Vacuums

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Can't find the manual for Biddeford electric blanket (warming blanket) '08. Controls are acting up. One side keeps turning itself off and says 'E'. I'm assuming this means error. The other side only registars '8' and can not change or turn off unless I unplug.

... Vacuums

I have a Sleeptight Imetec Electric Blanket with timer and Dual Controls one for each side of the bed recently the timer was set for 45 minutes and when 45 mins elasped it went off and the control light began to flash which is normal however it is since stuck in this mode light flashing will not heat just keeps flashing is there any way of sorting this the other side of the blanket for the other side of the bed seems to be ok although it did the same thing but reset itself any ideas Regards

... Vacuums

Hi, we have a Sunbeam electric blanket model no. BLO750 and type 696. It's a double blanket with dual control that can be used for different settings on either side. Both sides have been working ok but last night one side wouldn't heat and the green light kept flashing and now, whatever we do the green light keeps flashing except, when we set the control to "off". We can't find our Owners Manual to see what we are doing wrong, can you help please...or can you advise us where we may be ab

... Sunbeam Vacuums

I received this electric blanket as a gift and it will not heat up on either side. There is no light on the controls when I turn the blanket on. I need my blanket to work - it's like brand new!

Appears to be that the power is not getting to the temperature controllers.\015\012Suspect a problem in the wiring between the wall outlet (if not the wall outlet) to the temperature controllers.\015\012Look for broken plug at end of cord or a break ... Sunbeam Vacuums

I have a Sunbeam Electric Blanket model BL07050 and plugged it back in after washing. Both controls now have the active light flashing green. Does this mean both controls are faulty or the blanket is faulty. Sunbeam sent instructions but this did not help - can you suggest anything please

... Sunbeam Vacuums

Dual control Bedford electric blanket shows E on one side

... Vacuums

I have a Bissell Proheat Turbo 2x model 9300. It has stopped spraying at the floor. The hand tools will work so I assume this means the problem is at the base somewhere. I cleaned the nozzles but don't know what to try next. It has always had a problem with dumping too much cleaning solution as well, don't know if this is a contributing factor

Hi,Here is a tip that will give you all the information you need to fix your BissellProheat Vacuum Problem.Bissell Proheat Upright Wet/ ... Bissell ProHeat Turbo Deep Cleaner Upright Steam Vacuum

Dyson DC16 What does the flashing 3 light mean on the side?

... Dyson DC16 Root 6 Handheld Vacuum Cleaner

We have a Touch of Class electric blanket. On one side when it is turned on it displays EE. We cannot seem to change this setting back to a heat function.

... Vacuums

Small belt driving the brush...stretched out with hair accumulated in groove beneath belt. Is there a clutch or other means of tightening the belt. Went to store found belt...same size, therefore previously assumed stretched condition does not appear to be valid. I'm missing something. Any help?

You do not by a belt by size, buy it by model only. A new Hoover belt will generally be very snug when installed. As heat builds from use it stretches and becomes worn sometimes as much as 30% oversize. Good that you have cleaned out the hair. Check ... Hoover U6437-900 / U6439-900 Windtunnel Bagged Upright Vacuum

During re-assembly of my conair (model HC91RS) i noticed that my two blades do not line back up. The big blade sits evenly in it's space but the small blade is tilted slightly to one side. Is there any other means of aligning these two blades?

... Vacuums

Controller's small red light flashes constantly, meaning that electric blanket will not heat up. Instructions state switch off, wait, then re-try but this does not solve. Web search for 'Spares' does not actually give spares sellers, only those wishing to sell full new product! Does anybody know of a true spares seller please? Dreamland themselves do not appear to sell spares. UK only.

When the controller is flashing red, this means that there is a problem either with the controller or the wiring inside the blanket. You might try looking on Ebay. You might find a spare there. The safe thing to do though is just purchase a new one. ... Vacuums

The roller turns strong and the belt is new,but the dirt accu-mulates and doesnt get sucked up! there no observable clogs and the filter side vent blows strong.......ive removed beater,belt and am assuming there may be a problem inside the motor housing as all else appears normal..i was an aviation mech in the military and the above is my assessment........

Are you sure you have the belt on correctly?\015\012If it is not, the beater brush will push the dirt, etc, in front of itself and not back to the suction port. ... Hoover Tempo Widepath Upright Vacuum - Blue

Dust blowing out of the side of vacuum

Make sure that the filter in the dirt cup is in place. ... Eureka Whirlwind Litespeed 5740 Bagless Upright Cyclonic Vacuum

2002 esb avalon tanning bed 220volts. 2 lights out on top side by side and two on bottom side by side and one by itself checked all fuses on top and bottom one was blown changed it to new fuse and it blew right away what could be the problem

... Vacuums

My Roomba 570 will not go forward. the only thing that it will do is rock side to side or turn to one side then to the other side. The it turns it self off and gives me display signal of "!". I have replaced both wheels.

... iRobot Roomba 570 Robotic Vacuum

Biddeford Blanket Controller flashes error and beeps - can I correct this. Have unplugged all the blanket - controller still beeps when not attached to blanket.

... Vacuums

The one of the controllers for the electric blanket keeps flashing an "e". The other controller is fine. We switched controllers and the same thing happened. We have unplugged the blanket for several minutes and turned off the controller for several minutes. It always goes back to displaying the "e". It is a warmspun blanket and I cannot find any information on the company so that I can contact them to see about the 5 year warranty.

I did some searching-- and I came up with this Linkedin page-- seems to have some information-- Let me know if it helped-http://www.linkedin.com/companies/jla-homeMack B ... Vacuums

I am putting my bissel 8910 back together and behind the motor there is a black 3-way tubing connector. One side goes to the pump discharge, one side goes to a tubing going to the right rear wheel (facing the unit from the front) I don't know where the third side goes to. I do not seem to have another tubing for this one to go to? Maybe it is lost or ?

Hi, its hard to know what its for without seeing it. The best way to test this is to start the machine and vacuum a part of the carpet/ floor. Then let me know wht the vacuum is not doing. This will narrow it down. Please, get back to me. This sounds ... Bissell 8910 ProHeat Clear View Upright Vacuum

Replacing the old chamber filter (cloth on both sides)with filter that has cloth on one side black foam on the other. Which side faces the bag?

... Kenmore 23612 Progressive PowerMate Bagged Canister Vacuum

My bissell brush band has come off and wont stay on thus the brush will not turn, there is also a black arm type thing on a spring inside (on both sides) on the pump belt side it has broken - the side where the brush belt is, help im searching for parts and a way to fix it but im getting no joy, incidentley the brush belt thickness looks way to thick for the small thickness for the brush belt cog (?) to stay on........am i missing something? so i need to get the arm thing replaced plus find a

... Bissell ProHeat Deep Cleaner Upright Vacuum

Miele S5000 (revolution 5000) vacuum cleaner - How do I open the casing? When the power button on the handle is pressed the green power-level lights on the handle light, but the motor sounds like it gives a little 'jump' but nothing more. The orange power light on the body also dims. I assume the motor or fan is jammed, but I can't open the body to find out. I've taken out to screws inside near either end of the handle, but to no apparent effect. I'm assuming the body is held together by plastic

... Vacuums

While vacuuming my carpet, a corner of a throw blanket was sucked into the beater bar. I turned the vacuum off and was able to pull the corner of the throw blanket out without much resistence. I plugged the vacuum in and started it and now the beater bar isn't rotating.

Try pressing the reset button on the nozzle, probably just tripped out the brushroll motor ... Dyson DC15 All Floors - The Ball Bagless Upright Cyclonic Vacuum

I have a hoover light & soft upright sweeper. In replacing the belt a "v"metal clip popped out. It is metal in a shape a "v" with one hole on one side and jagged edges on the other side. Where does it go and how to re-install it????

Its actually for your height adjustment, take off head again and you will see in middle there is alittle grove that fits that piece precisely..let us know ... Hoover Soft Light Supreme U4262-930 Bagged Upright Vacuum

The CV750 stopped working. It will come on sometimes but most of time it will not work. I installed new bag and cleaned filter. Green light on side of unit is on. Switch on side of unit will not make it come on either.

My CV750 comes on but makes a very loud noise. it sounds like something is stuck then it lets loose but the noise sounds terrible and the unit smells warm. I installed a new bag and cleaned filter. Green light on side of unit is on. Switch on side ... Broan-NuTone CV750 Central Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0365 seconds