Having problems with your Vacuums ?

What's the difference between settings A and B on my Uniross XPress 3000 battery charger?

Answers :

Repair Help & Product Troubleshooting for Vacuums

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

What's the difference between settings A and B on my Uniross XPress 3000 battery charger?

... Vacuums

I purchased a brand new P113 Ryobi charger about 2 years ago. It has never worked. If I put a P104 battery in for a charge, it looks like it works correctly. I push the battery tester on the battery itself, and it says full charge, but when I go to use the bateery, it dies right away. I have tried three new P104 batteries. The batteries charge on my charger at work with no problem. The funny thing is, I don't need a battery in the charger and the charger does the same thing, It runs the test

If you have your receipt, check with Ryobi to see if it is still under warranty. It comes with either a 2 or 3 year warranty, depending on when it was purchased. If it is still covered, get it replaced/repaired. If it is not, buy the P117 charger. $3 ... Ryobi P113 18 Volt One Charger 140501001

Can you advise which setting should be used on different floors, ie hard floors and carpets, theres 2 different settings and I don't know which setting should be used on the different floors

Turn the machine on and look at the bottom. Turn to the two settings. The setting that stops the platten wheel from moving is for hard wood floors. If you cant tell, then setting 1 is most likely for carpets and 2 is for hard wood floors. Your ma ... Hoover Vacuums

My Oregon Scientific BAR888 has 5 windows, 1. temperature, 2. humidity, 3. mb/hPa or inHg (switch at the back), 4. bars showing pressure changes over 24 hours, and 5. time/date. Window 3 gives an option to set something between 0 and 2500. Oregon say they only have one set of instructions for the BAR888 but they do not match my instrument as there is nothing included for my window 3. Trouble is I don't know what the 0 to 2500 relates to and therefore don't know what to set it at.(My model does n

... Vacuums

My battery charger unit has stated to get hot while charging, is this a fault with the charger or the batteries. I would appreciate you advice

If the charger is left connected without the connection to the battery for several hours and there is no heat on the charger, then it is possible that the battery is using up more charging current .\012This results in heating of the unit for th ... Vacuums

I have iRobot Roomba 4210 and I have a problem with charge battery. The battery is new. When I charging a battery in other iRobot Roomba the battery was full charged. When I charging in my iRobot Roomba the battery was empty. My fast charger is OK.

The charging circuit on the main board is fried. This is a common issue. You need some good electronic repair skills, and equipment, to replace the problem components ... iRobot Roomba 4210 Bagless Robotic Vacuum

We have an Aquanot II charger for our backup sump pump. We unplugged the charger from the battery, and just plug the charger into an outlet. As soon as we plug it into an outlet, the two LEDs lite up, and then the fuse trips within a second. We bought the whole sump pump backup system in June 2009, so it is fairly new. Any idea whether the charger can be repaired?

Https://app.qleapahead.com/rtp/libraryget.aspx?asset=88182,63\012\012Above is the owners manual for your pump system. Included ar ... Vacuums

The battery charger flashes red when the battery is inserted for a charge - does this mean the battery is no good? If so, where can I purchase a new battery and at what cost? Thanks in advance.

Blinking red means it is charging. it will stop blinking when it is fully charged. ... Oreck TEK100 Handheld Vacuum

New battery!, roomba runs for 5 - 10 seconds, stops, starts running, stops, runs, stops, then beeps and low battery flashes. Have taken battery out, held start button 20 seconds, replaced battery and directly connect to charger, 72 hours min., still same problem.

... iRobot Roomba Discovery SE Bagless Robotic Vacuum

What other charger would fit the handheld part of electolux Pronto? using a charger from a different company to charge the handheld electrolux Pronto

Be certain the charger plug is a 15v charger ... Electrolux EL1000A2 Pronto Bagless Stick Cyclonic Vacuum

Singer 327 lower bobbin thread is wild and loopy after I sew...top stitch fine. Just changed to a large thread spool with the heavy remote base and crook to carry thread to machine and wonder if this changed tension (set at 4 and correctly threaded)? It had been working fine in zigzag but I also went back to reg foot and set stitch width at 0, center needle set. Thanks for your input and help. Deanna

... Singer Vacuums

My dc16 dyson root vacuum stopped working abruptly with no indication of a weak battery, the charger does not show a charge on battery. usually the vacuum slowed before it stopped with a dead battery, any suggestions

... Dyson DC16 Root 6 Bagless Handheld Cyclonic Vacuum

My Bernina 807 set on min. speed takes off fast, doesn't go slow at all, although there is a difference in the slow speed setting and high speed setting if I switch from one to the other while stitching. The machine is well oiled and goes well apart from this. I would like min. speed to start smoothly and slowly. I have read it could be capacitor in foot, but DH says it does not look burnt out. Would it help my problem to remove it? thank you, Barbara

... Vacuums

Charging error 5 - battery not workiafter 4 calls and 4 different

Generic works fine, and that charger does too. If your charge light and dock light are on then you'll be okay.Save cash, go generic! ... iRobot Roomba 560 Robotic Vacuum

Can I use a different charger from another company with the electrolux Pronto handheld part?

... Electrolux Pronto 2-In-1 Stick/Hand Vacuum - Cayenne

Battery charger broken

CHARGER WONT WORK MEC B5265 CAN I BUY NEW ONE? ... Hoover 5416-900 WindTunnel Bagged Upright Vacuum


Check Amazon. ... Shop Vac Vacuums

Dropped off countertop. Will not work now. I have bottom Red and two green lights flashing ??? I have had the battery on the charger< and had it tested. The battery is full charged but still will not work ? HELP !!!!! I believe it is the original root hand held .

There is a small magnet on the pre- filter that triggers a switch. Pull it apart and you'll see the magnet but the switch is behind plastic.. Make sure it is seated well against the motor unit. ... Dyson DC16 Root 6 Bagless Handheld Cyclonic Vacuum

I have lost my battery charger for my oreck stick/hand vac serial number 200041103780 for a 9 volt /300mA battery

... Vacuums

I just bought a Samsonite "Freeminder Flex" backpack with handle. My issue is with the lock... The combination for this lock was set to open at 0-0-0. It opened and locked perfectly at first. But after following the instruction to set up the new combination code, it doesnt lock anymore....please help and thanks! Linda

... Vacuums

I dropped my battery operated alarm clock: the second hand still works but the alarm doesn't come on at the set time and the hour & minute hands don't "hold" their position - I took the clear front off and discovered that I could move the hands to a more secure place on the center spindle but I discovered during the night that the correct time was no longer showing. I really like this clock b/c it's battery operated and I can hear the alarm (when it worked) plus it has a "night vision" dial tha

The hour and minute hands can be pushed onto their respective shafts at any point in most clocks.\012If you already know the time that the alarm is set, let the clock run until it sounds. \012When the alarm sounds, install the hour hand a ... Vacuums

I have a Bissell Go Vac that does not want to take acharge from the charger. Where do I replace the battery at? It is a model 3302. Cannot figure out how to replace the battery. Help!

... Bissell Vacuums

My Prosine 2.0 display panel displays Panel Fault: Memory error and the display error as well as all LEDs are off. The unit looks as if it has no power to it. I reset (power off.power on) the Prosine and all LEDs on the display (except for the back lit display) turn on for about 3 seconds then all go off again. I am able to use 120v RV Resort power and all 120v equip works. The Coach batteries do not charge and were low. I charged the Coach batteries with an external charger. The charge works ye

... Vacuums

We ran our Platinum Series 18 volt hand vac until it stopped -- charged the battery overnight but it did not charge. is there a problem with the battery charger or what could cause this?

Most problems with what you have stated have to do with bad contacts between the hand held unit and the battery charger.\015\012With the charger unplugged, make sure the contacts on both the charger and hand held unit are clean and not bent.\015\012C ... Black & Decker CHV1500 Bagless Handheld Cyclonic Vacuum

My swivel sweeper battery will not hold a charge. The light is always red. I even bought a replacement battery -- same deal. Do I need to replace the charger also?

... As Seen On TV Swivel Sweeper Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0350 seconds