Having problems with your Vacuums ?

MY casio FX 100W is showing a incomplete display.But this is not a half digit problem.It shows full display when kept in warm place (while keeeping it on TV top).

Answers :

Repair Help & Product Troubleshooting for Vacuums

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

MY casio FX 100W is showing a incomplete display.But this is not a half digit problem.It shows full display when kept in warm place (while keeeping it on TV top).

... Vacuums

Vacuum cleaner does not start after getting warm, bag, that was full is changed, lights run across dispaly at top when I try to start it, cannot find my manual, can I download a manual for Excellio z 5240. Is there a fuse of something that has bo be reset?

... Electrolux Vacuums

I am attempting to transfer embroidery patterns from my computer to my Innovis 900D sewing machine. I connected the USB cord and placed the files onto the correct drive, but when I go to retrieve them on the sewing machine itself- the data counter at the top show they are there (156/476KB) but I cannot see them on the screen to select and retrieve them. What should I try?

It means the stitch count is too large for the embroidery area. Make sure the pattern is 3.94 mm x 3.94 mm or that the stitch count is not too large ... Vacuums

I cannot fit a Miele SF-AH 50 Active HEPA filter into my S524 Miele vacuum. It doesn't seem to have the rear tabs in the right place to push it into place all the way. When I put it into the place, the top won't close. I'm afraid I'll break something if I force it down. What is wrong?

... Miele S524 Mercury Bagged Canister Vacuum

I have a Zenith ZD300 Dehumidifier. Bucket full light blinks. The water bucket was not completely full. Emptied the water bucket and re-inserted. The bucket full light continues to blink. The humidity setting LCD shows 1%. What is needs to be done to correct the problem?

... Vacuums

Miele Red Velvet Vacuum bag indicator is showing full even with a new bag.

... Miele S558 Red Velvet Bagged Canister Vacuum

It's been awhile since I have used my shampoo system on my Ultimate G series Kirby. Well, as instructed I took it apart and cleaned it. Now I can?t figure out where to put the ?screen cap? and ?sponge filter?. I have my manual in front of me and the only place it shows the filter and sponge (page 35 in the manual) is when it?s been taken apart to clean. It doesn?t show where to put it back. I don?t know what I would do without all the pictures in the Kirby manual. HELP! Thanx. Visual Kirby Vacuu

Hello,\015\012The littlew round screen goes in the hole where the hose attaches to the tank. The round foam filter goes up in the hole underneath the on/off valve for the foam. Here is a guide if you need any more help...\015\012\01 ... Kirby G6 Bagged Upright Vacuum

I can not get the food chute lid to lock on top cover. It will lock but not when the top is locked in place. thanks

Hello!what is the brand and model number?please post back! ... Vacuums

I need to remove the top cover from a Wertheim w4030, I have removed all screws that I can get at. I have notice a further 3 in places that is not possible to access. It looks as though the two buttons on the top if removed will provide the solution but I don't want to break anything by forcing something that is not supposed to be done. Can you help?

... Vacuums

I had to replace the idler arm assembly because it snapped. I then had to put the torsion spring in place and that is where I am having trouble. I cannot seem to find a diagram that shows how it goes back into place.

... Hoover U6437-900 / U6439-900 Windtunnel Bagged Upright Vacuum

I have a GE model #SCA1000HBB02. Recently the control buttons quit working. I thought maybe someone locked the controls but thats not the case. The display lights up shows the time but thats all. I unplugged it and then powered it back up the display comes up to set the time but the buttons will not allow. Any help would be appreciated. Thanks, Gary

Sorry but this is the vacuum area, your problem maybe the main board or a fuse. please go to the microwave forum. ... Vacuums

My dyson DC07 animal does not have the suction it once had I saw a dyson program that showed a filter in the top of the canister I was just aware of the filter around the wheel. Is there one on top of the canister and how do you get to it

Hi\012\012The DC04 Dyson has a filter at the top, but the DC07 has one at the side on the bottom and one underneath the cylender.\012\012Take all the parts off your dyson and throw them in the washing machine and then put them ... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum

Stopped working, lights work, shows full light when not full.

Remove the bag and put in a fresh bag. Then rotate the dial on top of the vac to the middle position. When cleaning fine dust the vac will shut off before the bag is full as it is sensing a clogged bag and cannot sense proper air flow through the bag ... Electrolux UltraLux 2000 Bagged Canister Vacuum

When i change the bag, the indicator strip shows a full bag. Can't get full suction.

You have a clog, either in the hose, the dirt inlet by the brush roll, or the filters are clogged. ... Vacuums

I have just replaced the bag in my miele and the indicator is showing that the bag is full. The air coming from the exhaust is hot and the machine is making a higher pitched sound as it does when the bag is full. When the hose is detached, the indicator registers as empty and there doesn't seem to be a blockage.

... Miele Vacuums

My telescopic wand height adjustment won't lock the height in place. The wand extends to full height with no locking in place. How do I fix it?

These wands have a very small nub that locks them into place. They wear out very easily. You might have to replace the wand. ... Euro-Pro NV31 Infinity Vacuum

I am working on a u5290-900 hover vacuum ,when operating dust leaks out under dirt cup cover. i put a piece of card board on top of cover so extra presure would be applied to the top of cover. this seams to have stoped the leak , before adding the card board the cover seamed to lift at the back when cover was locked into place. what do you think?

Dear Sir:Will be better idea to replace the cup cover. The pice of card will not function for a long time. Proceed before another extra problem coming.God bless you ... Hoover U5290-900 Upright Vacuum

I have a Eureka 5902AVZ and the brushroll does not work. when i remove the belt, which is not torn nor worn out, the motor spins perfectly fine. Though when i put the brushroll back into place, it shows that the motor is trying to spin, but with resistance. it seems the brushroll will not spin if locked into place, because there is no attachment on the left side of the brushroll that will allow it to spin freely with the belt. am I missing some parts or is there something else wrong?

Hi and welcome to Fixya. I am Kelly. \015\012\015\012You have correctly identified the problem as the brush roll itself. \015\012\015\012There is a bearing under each end cap of the brush roll. You can gain access to the ... Eureka 5902AVZ Bagless Upright Vacuum

Vacuum bag indicator shows full bag but it is not full. Feels hot.

... Sebo Air Belt C2.1 Bagged Canister Vacuum

Keurig b200 problem; When brewing with cup in unit water will pass into cup and it seems when k cup is full the grinds puch up through the top and water overflows. i pulled out the k cup holder and cleaned so their is nothing that is obstructed included the piercing pin. brewed [product does come through but does not seem to allow it to come through fast enough or if it supposed to be pressurized it is losing its seal on the top of the k cup

... Vacuums

Restrictive valve moments after starting the vac the red ball rises to the top and the machine quits sucking. I turn the machine off, the ball drops, I turn the machine on, the ball rises the machine quits sucking, I turn the machine off the ball falls, I turn the machine on........etc. What am I doing wrong? It works fine and then all of the sudden it starts the same stuff again. I thought it was because the retrieving container was getting too full or the cleaning soln container was not full e

The foam filter on the bottom of the tank lid is too far up. Pull it down so you have at least a 1/4 inch gap from the top. ... Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum

Electrolux 2100 new bag placed full bag indicator appears

It appears you have a bad control valve. My suggestion is to take it to your nearest Aerus dealer and have them replace it for you. You can find them by going to aerusonline.com and use their dealer locater. It shouldn't cost much to replace. You can ... Electrolux UltraLux 2000 Bagged Canister Vacuum

Empty bag shows as Full

You have a clog, either in the hose, the dirt inlet by the brush roll or the filters are clogged. ... Vacuums

Bag full signal shows when a bag is still on its

This is often caused by fine dust such as drywall dust or an internal filter behind the bag being clogged. Look for blockage in the bag comaprtment ... Vacuums

Bag showing as full when a new bag is in and all hoses unblocked

Hi There,\015\012\015\012So when this light is displaying, it's says "Bag Full or Clog" on the indicator. If you have changed the bag, and it's still showing this light, it means that you either have a clog in the vacuum, or your filt ... Sebo X4 Bagged Upright Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0258 seconds