Having problems with your Vacuums ?

I have a remington hc 822 it does not cut at all.if i try cut it pulls my hair.i tryd taking it apart but it still doesnt work.and i want to also knw how 2 reassemble it cos i am quite confused .i got it second hand so i dont have a manuel.ue assistance would be very much appreciated .

Answers :

Repair Help & Product Troubleshooting for Vacuums

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I have a remington hc 822 it does not cut at all.if i try cut it pulls my hair.i tryd taking it apart but it still doesnt work.and i want to also knw how 2 reassemble it cos i am quite confused .i got it second hand so i dont have a manuel.ue assistance would be very much appreciated .

... Vacuums

Bought a shop vac about 3-4 mos ago and while i was using it, it cut off and wont cut back on. This is the second shop vac that done this and I took the first one back and got this one and it did the same thing. It is a 12 gal. 4.5 peak hp.

... Shop Vac 401-12-00 Wet/Dry Vacuum

Miele S318i worked ok till I took it apart to blow really fine ceiling "popcorn" dust that got sucked by the filters. When I plugged back in started for a milli second and quit. At this point I believe the circuit board might be the fault, but I want to test motor before I go and buy the part. Can I simply run 110 to the two moter contacts to bench test? Steve

Yes, you can. ... Miele S318 Bagged Canister Vacuum

I have an Electrolux Commercial Upright vacuum Model U129C. It has a device which turns off the motor driving the beater bar if something gets stuck in it. There is a simple reset button to restart the beater after clearing the obstruction. Just recently on flat dense low pile surfaces the switch cuts in after just a few seconds and turns the beater bar off. This doesn't happen on high pile carpet but the motor doesn't quite sound normal. There is no obstruction - the beater bar can spin freely

The motor is having a problem.There might be two reasons...either the coils inside it got heated up which will be needing rewinding or you can buy a new motor or there r capacitors attached sometimes u can make a check on that also if that's gone Kap ... Vacuums

Got a Electrolux twin clean vacuum cleaner still keeps cutting out every 20 seconds even after cleaning and turning filters around

... Electrolux Vacuums

DC-16 battery vacuum runs for 10 seconds then cuts out. After waiting 30 seconds, it runs for about 10 seconds then cuts out again

... Dyson DC07 Bagless Upright Cyclonic Vacuum

Miele power nozzle quits after 10 seconds of working.

Even though the brush is spinning, you probably need to replace the beltbecause it is st ... Miele Vacuums

Dyson DC31 Animal rotating brush cuts out after a few seconds

... Dyson DC31 Animal Bagless Handheld Cyclonic Vacuum

Confusion and embarrasement have caused me to appeal for expert advice. I need to add a second flourescent light fitting in the loft. I recently added one from the existing wiring circuit via junction box and pull chord switch and it works fine. I have wired in the second light and now neither of them work. I have replaced the starter (as I had a faulty one in the first light. But i annot get them to work. I have installed a second junction box for the second light and wired all like terminals

... Vacuums

I just got this euro pro shark steam mop. I dont have a manual for it so i dont know much about it. I put water in it and it heats up but when you start to use it. It makes a gurgling kind of sound and steam comes out, but not very much i dont think and on the floor you can't hardly tell where you went over the floor at cuz it's not very wet at all. So is it suppose to make a gurgling sound and should'nt the floor be alittle wetter?

Call Shark. They have good cust. support. ... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

Where do you hook the clear hose that is in the compartment with the motor ? Second where the vacuum hose connects to the bag it keeps cutting in and out of power. I replaced the female cord to motor and still cuts out."no suction "

Would you care to tell us the make and model of the vacuum you're asking about? ... Vacuums

I have a nearly 9 year old Electrolux Excellio Z5228 vacuum cleaner. It has recently started cutting out during operation. I cleaned the micro filter (between bag & motor) via brush & hitting against wall & seems / looks quite clean. I washed the gore filter (output from motor to clean the exhaust air) as per instructions, then let to dry. It was very clogged but now very clean. The vacuum clearner still cuts out often. Even after a long rest (say overnight) it still won't start, then ano

... Electrolux Vacuums

Electrolux 2 in 1 Ergorapido stick Vacuum. Motor runs then cuts out after 3 - 4 seconds. Sometimes it will run properly for 10 minutes so batteries are good. Why does it cut our usually?

If the hand held is working correctly (By itself) try pulling up a little bit on the 4 metal connection tabs on the wand. The connection tabs were not making a proper connection on my unit. ... Electrolux Pronto 2-In-1 Stick/Hand Vacuum - Cayenne

I have a Hoover linx cordless stick vac. I have not had it but several months and it has quit sucking anything up. It worked great when I first got it. I was so excited at how well it worked. It had gotten hair wrapped around the brushes but I got that out and thought it would work better. It is turning and sounds like it is working but it does not pick it up. I could use your help please. Keely

... Hoover Platinum LiNX Cordless Stick Vacuum

Hei, I have sewing machine Brother NV500D and got technical problem need to be service/repair. I'm now in Malaysia and don't have techinical/repair service for sewing machine NV500D. This is overseas model. In sewing machine screen display 'F04'. The problem automatic needle not function and part missing. I dont no how to fix this. Can't i got the instruction manual service picture if i can't fix own. please help me. thank you.

... Vacuums

Press the power button on - good got a green light (new battery) press the clean button - got a green light iRobot runs for a couple of seconds and stops, then starts, then stops. After two or three times I now have a red light on for the Status. All of the wheels seem to be clean. I used compressed air to clean the underside. But still have the start stop problem.

How many times does the red light blink before it pauses? ... iRobot Roomba Discovery SE Bagless Robotic Vacuum

Runs 10 - 20 seconds then quits-restarts on next trigger pull

Check battery maybe is old or not correctly charged. ... Dyson DC16 Root 6 Bagless Handheld Cyclonic Vacuum

Dyson DC35 cuts out after 10 seconds or so, and only starts when it feels like it

... Dyson DC35 Digitial Slim Multi floor cordless vacuum cleaner

My handheld dyson is not working - initially it was cutting out after only a few mins then seconds now it won't work at all despite showing green light ??

Hi there, it's Jack at Dyson.I'm sorry to hear your DC31 Animal is only working intermittently. When fully charged, this machine should have a maximum runtime of 10 minutes, or 6 minutes on the maximum power setting.There are several ... Dyson DC31 Animal Bagless Handheld Cyclonic Vacuum

Panasonic mlc 3001 vacuum keeps cutting out after about 60 seconds

... Vacuums

Dyson DC17 Just got it back from repair, at first use, snagged fringe for a moment, and now get no brsh action again.  Checked the brush belt and it is fine.  Is there a second belt for the clutch, and how do i get to it to check it as well?

Yes you have to take the cover of underneath three srews you will need T15 SCREW DRIVER ... Dyson DC17 Animal Bagless Upright Cyclonic Vacuum

Ive got a miele revolution 5000 power plus and its just cut out the green power button on the handle is on but the orange button on the body does not come on it just flickers unless i open it up, any ideas?????

Http://geeksquad.fixya.com/ThreadView.aspx?prdid=0&thid=640910\015\012Generic problem for all Vacuums\015\012I’ve got a Miele revolution\015\012Posted by ... Vacuums

I have a electrolux el6989 that the power head keeps quitting for a second then comes back on. Acts like it has a short starting

... Electrolux Vacuums

My Sharp cordless sweeper is not charging. It flashes all three red lights, starts for a second and then dies down. Do I need to replace the batteries? Have not used it for long, so confused.

... Sharp Vacuums

Dyson DC7. Problem:- switch the hoover on and it cuts out after approximately 1 second. Any ideas please?

Sounds like the motor is shot. However, try the filters first in case it is just blocked. ... Dyson DC07 Bagless Upright Cyclonic Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0514 seconds