Having problems with your Vacuums ?

My hot water heater won't engage at all. - Vacuums

Answers :

Sounds like the pilot light is not staying lit, provided you have one.\015\012The pilot light is used to keep the gas valve open by way of the thermocouple/switch.\015\012When the pilot light goes out the thermocouple cools down and shuts the supply of gas off to the water heater burner.\015\012It is not unusual for a thermocouple to go bad at which point it needs to be replaced.\015\012The thermocouple is the small rod that sits in or close to the pilot light flame. There is a small copper tube that runs from it up to the gas valve on the outside of the tank. This is where you control the temperature of the water as well as light the pilot light.\015\012If you are not experienced in dealing with hot water heater gas supplies, you should get professional help.
Repair Help & Product Troubleshooting for Vacuums

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

My hot water heater won't engage at all. - Vacuums

Sounds like the pilot light is not staying lit, provided you have one.\015\012The pilot light is used to keep the gas valve open by way of the thermocouple/switch.\015\012When the pilot light goes out the thermocouple cools down and shuts the supply ... Vacuums

I have a Rheem Vanguard 50 gal. gas hot water heater. I suddenly developed a low hot water volume at all fixtures. What would cause this? Ser. No.VG 0497D06003 Mod. No. 6E 713

... Vacuums

I am in ecuador and have had a local "plumber" install a lpg tankless water heater for me. After more difficulty than there should have been it's up on the wall with the water and gas lines attached but it won't light. There are 2 "c" batteries installed that seem to be the ignition system but when i turn on the gas and try to ignite the system nothing happens. No lights no sound no gas smell no hot water. Thoughts?

The system is ignited by turning on a hot water faucet causing water to flow through the unit activating the igniter.You could disconnect the gas line at the unit turn the valve on and off real quick and smell for gas.If there is air in the line you ... Vacuums

My brand new bissel little green proheat pet series is spraying solution however it's not hot when it comes out. I put hot water in the tank & turned the heater on. Isn't this the whole point?

Have you checked the user manual? Can be found at http://www.bissell.com/searchresults.aspx?searchtext=little green&mode=userguides\015\012\015\012If there is no element then the water will cool down naturally. ... Bissell 1425 Little Green ProHeat Handheld Steam Vacuum

Vitapur hot water not working - Vacuums

... Vacuums

I need to download a manual for the Bissell Proheat Steam Vacuum. Is it possible... OR just tell me whether or not the cleaning solution goes right in with the hot water? Thank you.

Hi,Here is a tip that will give you all the information you need to fix your BissellProheat Vacuum Problem.Bissell Proheat Upright Wet/ ... Bissell 1699 ProHeat Clear View Upright Steam Vacuum

Water get hot but no steam - Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

Hi,Here is a tip that I wrote about the Euro-Pro Shark Steam Mop and why it maynot be getting steam to the head...Euro-Pro Shark Steam Mop Problem ... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

Heater does not generate steam / water temperature not hot enough shark S3202 has only been user 10 to 15 times. can a new heating element be installed? where can I buy element?

Hi,The element is not sold anywhere... go figure...Here is a tip that I wrote about the Euro-Pro Shark Steam Mop and why it maynot be getting steam to the head... ... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

Vitapur hot and cold water dispenser - Vacuums

... Vacuums

No steam coming out water is hot - Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

Hi,Here is a tip that I wrote about the Euro-Pro Shark Steam Mop and why it maynot be getting steam to the head...Euro-Pro Shark Steam Mop Problem ... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

I do not have my users manual and have never vacuumed wet with this vacuum. How do I change it from a dry to wet vacuum. Can't find my manual and I need to use the shop vac for water in basement, do I have to change the filter or what lost my user manual never used it to pick up water. need to know how to puit it in wet mode i want to clean the dirty water out of my pool.

\015\012Vacuuming Liquids\015\0121. When picking up small amounts of liquid\015\012the filter may be left in place.\015\0122. When picking up large amounts of liquid\015\012we recommend that the filter be\015\012r ... Craftsman 17765 Canister Wet/Dry Vacuum

I have a hamilton beach water cooler. What is the temp. setting fot the cold / hot water? why is the water holding compartment get hot?

The cold water - 60F/15C. Hot water - 190F/90C. Both temperatures are set in the factory and should not be changed by the customer or the manufacturer can't guarantee that the unit will work as expected.\012\012\012If by water holding compartme ... Vacuums

For some reason, when I tried to put the floor vacuum attachment back on and vacuum the carpet, I realized that the belt was not engaging. the belt is in there and not broken, but it is not turning the beater brush. it is just hanging loose around the brush. When I turn the wheel to engage the brush, it picks the belt up, but when I attach the vacuum to the attachment, the brush is just not turning.

... Kirby Ultimate G Bagged Upright Vacuum

I have a GXCFD GE Smartwater hot, cold water dispensor, everything works but the hot water, doesnt light up, or get hot. any suggestions

If there is no hot water coming out from your instant hot-water dispenser, check the following to find out the prolem and fix it :\015\0121.Power: Under-the-counter hot water dispensers are plugged into a standard wall socket that suppli ... GE Vacuums

I have a Craftsman wet dry vac with blower capability (22 L). While I was using it to **** up water, the water came out of the blower hose. Now I can't get it to work as a vacuum. What can I do to fix this problem? Is there a toggle switch somewhere that allows me to choose vacuum or blower? Also, will the vacuum still work without the filter nut attached to the plate? Please let me know at your earliest convenience. Thank you.

... Craftsman Vacuums

Vacuum smells I have a 6 year old rainbow vacuum model E and it smells terrible everytime I use it. Probably because often times i don't remove the water basin after vacuuming and just let it sit. It's my own fault however now I don't know what to do to get rid of this terrible smell. I've water cleaned the hepa filter, not able to remove the separator screw to clean. Can you give me some suggestions?

In addition to vinegar, baking soda (sodium bicarbonate) is also an excellent remedy for many odour problems. Try generously sprinkling baking soda on a rug you wish to clean, and afterwards, vacuum up the spot. Rugs, and dirt ... Vacuums

Brush Roll belt stops turning durring vacuuming on WindTunnel self-propelled, v belt is a little loose with handle down. Tensioning roll is engaged OK, but fully at the end of its travel. Replaced belts flat and v, but still stops turning even on high carpet setting when vacuuming. Carpet setting and height adjustment appears to be working OK, roll is clean and turns easily when out. Also turns easily until it engages the carpet. Self propel function works just fine.

... Hoover U6485900 Bagged Upright Vacuum

The handle for my Eureka 5993 AVZ was getting very hot when used. Finally, the wires around the switch melted and now the vacuum will not work. What is wrong? Is the switch bad? The wires only melted in the immediate vicinity of the three-prong switch. Nothing else appears to be wrong; the vacuum worked fine when it was running - except for the handle getting hot. Thank you!

Try cleaning all...\015\012if have sam paoblem need replaced main motor.... ... Eureka 5893AVZ Bagless Upright Cyclonic Vacuum

I have a sta rite (pentair) cristal high rate sand filter model T-200-BP-1....its leaking water thru the top of the valve, where the valve cover screws on the valve body assembly. it leaks water out where they go together around the screws. Also when i vacuum it, everything that i vacuum gets washed back in the pool when its on the filter position. Also the backwash leaks when its turned 2 the filter position, does it supposed to do that?...the only way i have gotten it to stop is to put a seper

... Vacuums

The soap dispenser on my 2X is not dispensing. I wrote with this initial problem and received a reply. We did everything recommended to find a clog. To begin with, we poked holes thru the little holes on the underside with a toothpick. Next we took the machine all apart as directed and cleaned out anything that had accumulated (such as pet hair). Eventually we emptied out the soap dispenser, filled it with a hot salt water solution and let it sit for 10 min. I ran three tanks of hot water

Hello,The solution to your problem is already solved, since your soap dispenser is still under warrant,What i will suggest is that you contact the company that supply you this product and explain everything to them, it is most ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

Hoover Upright Vacuum model U5470-900 - The On/Off switch on the handle does not properly engage the power switch deeper in the handle assembly. It appears to ride over the lower switch and doesn't engage it to operate it. If I play with it, I can get it to maybe turn on the vacuum, but, then the upper handle switch won't turn it off. Our current workaround is to use the power cord for on/off operation.

... Hoover Vacuums

Hot cord the cord on my vacuum cleaner has been getting very hot the heat is from one end to the other incuding the plug and also where the cord exits the back of the canister please help I love this vacuum cleaner it has been faithful to me for over 15 years!

Likely after all these years that the motor is starting to go bad and draw more amps thasn it should. a new motor at a vac dealer is your best bet. it was likely made by panasonic, so a new panasonic is your best bet, and less $$$than the kenmore for ... Kenmore 23313 Whispertone Bagged Canister Vacuum

Vacuum does not soak up dirt water. Fresh tap water just spilled o

... Eureka Atlantis 2591A Upright Steam Vacuum

The original belt on my upright Kenmore Progressive broke and I replaced it with the spare that was in the vacuum. The vacuum and spare belt are about 10 years old. Then the spare broke after one vacuuming session and there was a burning smell coming from the vacuum. I ordered new belts and replaced it with the new belt. It seems to be working fine with no smell. I checked the belt after I vacuumed the family room and although it was in tact, the belt was very hot. Is that normal? Should t

The belt heats up due to the friction, as well as being in contact with the shaft of a hot motor. It is normal. ... Kenmore Progressive 35922 Bagged Upright Vacuum

Bissell 35k3 lift-off deep cleaner does not vacuum up water when using upholstery attachment.Water sprays out but wil not vacuum up.

... Bissell Vacuums
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0878 seconds