Having problems with your Vacuums ?

I have a sandleford safe S201045 the 4 diget code now wont open it and the key wont open it either any ideas?

Answers :

There is no known trick to open this safe. The best option was the key but since it is not working as well, call Sandleford. Here is their contact information.
Repair Help & Product Troubleshooting for Vacuums

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I have a sandleford safe S201045 the 4 diget code now wont open it and the key wont open it either any ideas?

There is no known trick to open this safe. The best option was the key but since it is not working as well, call Sandleford. Here is their contact information. ... Vacuums

Hello, we have a Miele cat and dog turbo 5000 vacuum cleaner which we bought in December. It has just started blowing air out of the grid on the top of the cleaner instead of sucking from the tube. The whole top section which is opened to change the bags doesn't seem to want to clip down properly either. Do you have any ideas> I'm gutted as it was so good until this happened. Thanks Michelle.

The lid not closing properly is almost certainly the cause of your problem. Without that lid sealed tight to the body you will get no suction through the hose. So, the question is: why isn't the lid clipping down properly? Did you just change the bag ... Vacuums

After a brief power outage my Marantec 4700 garage door opener has problems opening/closing. When opening it stops at the fully open position and the lights blink, when closing it automatically reverses just as it fully closes and then the lights start to blink again. I checked for obstructions and tried to reset the limits of travel per the manual, it still does the same thing. Any ideas on what to try next?

This is not a sensor issue, I have a similar problem, sensors work fine, garage door is still fully functional, all operations, including safety sensors work properly, just the overhead lights flash. I suspect there was damage to the power board due ... Vacuums

Trouble opening tank, pushing handle and it wont open

Push down on the handle while lifting the right side of the tank with your other hand. ... iRobot 5800 Scooba Vacuum

Have an alera lateral 2 drawer metal file cabinet. Moved it, and now can not open top drawer. Bottom opens fine. Lock works, but seems to be stuck on top left corner. Ideas?

... Alera ALELA523029BL - Two-Drawer Lateral File Cabinet, 30w x 19-1/4d

I have bought a house with a Bricard electronic wall safe which might be useful but which is locked open (ie the locks are out but the door is open). I do not know the pin code and there does not appear to be a manual. Any ideas on how I can get this back into working order?

... Vacuums

Hello good afternoon, i have a Royal Sovereign water dispenser with a little fridge on the bottom part and the problem i am having is that the dispenser wont release cold water and the fridge wont cool either. i would like to know is there any thing i can buy to fix it or do i have to buy a brand new dispenser! Thank you for your time!!

... Vacuums

I have a Necchi 522, an early mechanical stretch stitch machine. The timing and stitching are great, but over the past few projects I have noticed a balky tendency when I press the knee bar. After my last project the motor almost won't engage. Sometimes there is no sound, and sometimes there is a weak whirring, but no action until I push the hand wheel. I have a feeling that it is either the v belt or that the motor needs new brushes. Are either of these ideas likely, and if so, are they self

Hi,It sounds like the machine is having to work too hard. Have you cleaned and oiled your machine lately? Over time oil will harden and lint and dust will build up on the working parts in the machine causing it to drag and eventually stop ... Vacuums

I shorted out the light socket on my Chamberlain Professional Garage Door opener. Now it wont open, I am looking for a fuse or reset button, but cant find one. Is there a way to reset it or did I fry the solinoid

First check your house fuse. ... Vacuums

In the undercarriage where the green cage that is to open when the yellow tabs are pressed will not open. the right side will unlatch but the left one wont unlatch.

... iRobot Roomba 530 Robotic Vacuum

Miele S5000 (revolution 5000) vacuum cleaner - How do I open the casing? When the power button on the handle is pressed the green power-level lights on the handle light, but the motor sounds like it gives a little 'jump' but nothing more. The orange power light on the body also dims. I assume the motor or fan is jammed, but I can't open the body to find out. I've taken out to screws inside near either end of the handle, but to no apparent effect. I'm assuming the body is held together by plastic

... Vacuums

I have Pro Safe PSF80 and everytime I enter my password, the lights are blinking and can't open the safe. Since the only way to reset my password is when the door opens, I cna't reset it either. I need yuor help, how to fix this problem.

2 blows with a pickaxe on the hinge and it was open in less than 1 minute ... Vacuums

Our roomba 560 wont charge have replaced the battery Tested the charing unit with another roomba that all seems ok put the uncharged battery into another Roomba but im guessing it now has a memory as this wont charge in the other hoover. Any ideas what may be wrong

Try cleaning the battery contacts with a little rubbing alcohol or contact cleaner on a foam swab, or a bit of paper towel. Take a litle time, it doesn't always dissolve instantly. (Don't use a pink pencil eraser, it would scrub off the plating that ... iRobot Roomba 560 Robotic Vacuum

Hi, have lost keys to my digital electronic safe - S-25EY manufactured by Walter Werkzeuge - have key/lock number, where can I purchase key as battery is dead and I can't open safe?

... Vacuums

My craftsman 1/2 hp garage door opener opened but wont close and clinks and lights flash

... Craftsman Vacuums

Vacume wont **** opened it up see nothing wrong HELP

If no suction usuallly means a clog, either in the hose and the dirt inlet by the brush roll. Sometimes if the belt is stretched, it won't turn the brush roll under load and it would seem like there is no suction. ... Sharp Twin Energy EC-12TWT4 Bagged Upright Vacuum

Shark Steam Blaster lid wont open

... Euro-Pro Shark Steam Blaster Vacuum

The waste door on my dyson 07 wont open, what can be done

... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum

I need a manual for a Ridgid portable wet/dry vac. WD4070 (4 gal and 5 HP) Model # WD40700 and serial #09286R0271. I received this for Christmas and a manual was not included. I'm not sure that the filter is there either, because I can't open the machine.

... Ridgid 9 Gallon Wet/Dry Shop Vac 96882 Canister Vacuum

Hoover washing machine error E14 machine does wash cycle then finishes and says e 14 and wont open

... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

On the DC07, the entire cyclone assembly must be removed to empty the dust, debris, etc. collected when vacuuming. On the top of the cyclone is a "trigger" that you lift with your finger to release the bottom catch, which allows a clear flap to open on the "clear bin," thus letting all the debris fall out. My problem is when you lift the finger trigger, it does not release the catch on the bottom. Since the catch won't release, I cannot remove the entire clear bin either from the cyclone.Any sug

Beofre you go to the extent of buying a replacement canister, you can remove the top and using a straightened coat hanger type thing open that bottom lid. Then maybe you can clean the rim and possibly add some silicone spry to loosen things up. Here' ... Dyson DC07 Bagless Upright Cyclonic Vacuum

Dyson Animal motor is running, beater bar is turning but very little if any suction. No suction from hose either. The inside canister is filling and moving, so there is some dirt being sucked in there. I have thoroughly cleaned all filters but not sure what is causing the problem. Any ideas?

Obstruction in the hose?\015\012Your vac has developed a hairball possibly.... when a piece of flexible media ie.... cardboard, plastic etc... gets lodged in the hose, and begins collecting hair & dust to the point it no longer has enough d ... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum

I can't get the brushes to rotate on my hoover steam vac v. i took them apart and cleaned them and they still wont work. any ideas?

Scrubbing brushes are driven by a belt. The belt either broke or slipped off its pulley. ... Hoover Steam Vac Dual V w/ SpinScrub Vacuum

Dewalt 2gallon corded/cordless vacume...unsed one time brand new wont turn on. motor and switch both tested and work...any ideas

Check the battery contacts... a common problem on this model. they are easily bent and prone to corrosion. ... Dewalt Cordless/Corded Wet/Dry Vac 2 Gallon Vacuum

My miele S277i will not start up The fuse is ok in plug etc Wire not broken anywhere When I opened it up I found that Power is getting all the way to the motor brushes in fact. Any ideas?? Regards Andy

Hi, \015\012\015\012Usually when a Miele doesn't start it's one of several things. Most commonly the cause is a faulty cord reel, however if you get power all the way to the motor brushes, it sounds as if you cord reel is ok, and that an ... Miele Vacuums
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0580 seconds