Having problems with your Vacuums ?

I have a small oil leak around the acorn nut on the mixing shaft. Berkel BX-20 20 qt mixer.


Answers :

Hi.

You need to replace the blade seal. Part 2275 20001

Here the part book.

To get the part contact Berkel Parts calling the toll free number 800-392-5435 .

If solution had been helpful, then please do not forget to accept.

Regards.

Ginko.
Yes. There is a small o'ring seal that is leaking. You will have to remove the nut and replace the seal.
Repair Help & Product Troubleshooting for Vacuums

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I have a small oil leak around the acorn nut on the mixing shaft. Berkel BX-20 20 qt mixer.


Hi.You need to replace the blade seal. Part 2275 20001Here the part book.To get the part contact Berkel Parts calling the ... Vacuums

Oil leaks from my Cuisinart (past warranty) stand mixer SM-55 accessory power port. Can oil be added? Is there a repair part? Cuisinart customer service says that only Cuisinart repair service is capable of repairing the mixer.


Hi,Cuisinart are over packed with oil\015\012 If the motor sits idle, the oil may begin \015\012to drip from the gears and settle. Oil leakage may primarily be seen \015\012from around the beater shaft or p ... Vacuums

I have a very old Hobart meat grinder that oil is leaking around the worm grear shaft and getting into the deer meat I am grinding


... Vacuums

The vacuum leaks dust around the joint between the bag and the vacuum. I unlatched the bag, removed and emptied it, and replaced it. However, the vacuum still leaks dust around the joint and the bag keeps working loose. How can I make sure that the bag is securely latched so that it does not leak or come loose? I have no manual. Thanks.


... Bissell 3065 Power Partner Vacuum

I was mixing a cake mix on an old Kitchenaid Hobart Mixer Model 4 C for 5 Minutes and then white smoke started to come out. I don't think the mixer had been used in many years. Is this repairable or should I junk it. Thanks, Bonnie


... Vacuums

My dyson leaking around around bottom cannister how do i unclog it


... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum

I have a sta rite (pentair) cristal high rate sand filter model T-200-BP-1....its leaking water thru the top of the valve, where the valve cover screws on the valve body assembly. it leaks water out where they go together around the screws. Also when i vacuum it, everything that i vacuum gets washed back in the pool when its on the filter position. Also the backwash leaks when its turned 2 the filter position, does it supposed to do that?...the only way i have gotten it to stop is to put a seper


... Vacuums

Bissell - Model 1697 - Powersteamer Pro - Carpet Cleaner I took the unit apart to replace some broken pieces and I can not seat the bottom to the top without properly engaging the soap/water mixer. What is the proper assembly procedure. What is the orientation of the water/soap mix valve when I seat the top to the bottom? The soap/water mix valve needs to engage the knob screw threads but this assembly is a blind operation. Do I turn to the soap/water mix knob to water only then seat the


Hi,\015\012http://dl.owneriq.net/7/7e477b7e-4440-49cf-a219-b68d301549e3.pdf\015\012This diagram will help you see the diagram plus the part assembly no and place it accordingly.I have also given link for Bissell - Model ... Vacuums

Rainbow E series AquaMate II leaks around the quick connect/disconnect how to i fix the leak??


You have to get new O rings for it. You can find them at an Auto supply store, or hardware store. If where you first go does not have them, keep looking. You will find them.\015\012\015\012If you have any more questions let me know. I am ... Rainbow E series Canister Wet/Dry Vacuum

D4 Rainbow leaking water around the water basin while running. Already replaced the seal. Still leaking.


Clean the water separator. Use a tooth brush if you do not have the Rainbow separator cleaning brush. It is the same thing, and works perfectly. :-)\012\012Ralph ... Rainbow Technologies D4 Bagless Vacuum

Victa Vantage VCS464 148cc purchased 4 months ago. Problem - not starting. checked fuel levels, oil level and air filter. Leaking oil thru muffler when trying to start. Kevin - 0448594628 Melbourne.


... Vacuums

Belt squeels when the roller starts turning. only used about 10 times. Small belt under cover is very loose, but it shouldn't be worn out after only about 10 uses. does the small bell just rest on the belt control pin or is it supposed to be around it (thinking it could have slipped off)


Ours did the same thing in about 10-15 uses, the idler pully quits holding the v-belt tight and the the aggitator wont turn. ... Hoover U5194-900 Mach5 Multi-Chamber Cyclonic Vacuum Cleaner Bagless Vacuum

My Roomba 560 has started to run in small steps as if it constantly meets an obstacle and turns around in a very small circle. It advances slightly, backs slightly and turns and then does this again and again.


Sounds like your Roomba has the Circle Dance Error. Here is the fix for the Circle Dance. ... iRobot Roomba 560 Robotic Vacuum

Where would OIL come from by the right side back wheel?I have a hoover wind tunnle model # u6425-920. Does the drive moter have oil in it if so and it is leaking should we replace the motor?


The motor does not have oil in it. The onnly thing I can think of is that if soemone had tried to free up something by using a spray lubricant, and not it is running out. I've never seen this issue. You would have to let a repair shop look at it. ... Vacuums

I am losing suction and it sounds as if there is a leak in the vacuum(I hear air rushing around). There is also a high pitched noise. Dyson dc07. Can there be leaks in the gaskets where you clean hoses and filter? are they replaceable. Does the noise suggest the bearings are going in the motor?Is it worth getting fixed?


It wont be a gasket problem - they don't tend to fail. \015\012\015\012A high-pitched noise can be a number of different things. That is too vague to diagnose on here with the description you have given. Can you be more specific? ... Dyson DC07 Bagless Upright Cyclonic Vacuum

Bathroom oil filled radiator is leaking oil fromthe bottom


Time for replacement. there is no repair for this issue. ... Vacuums

The retractable handle doesn't stay in place. a small spring came out near the button that you push to slide the handle up and down to change the length. i need to know where the little spring goes. there is a small pin that the spring fits around but i can't seem to get it to go back in place once the spring is on the pin.


... Panasonic Kenmore Canister Vacuum Vacuum

Power cord leaks green oil


I suggest that you replace that corroding internally power cord. It may not be safe to use that power cord.\015\012\015\012You can get your model information, at the bottom of your vacuum canister, from underneeth, where the water pan att ... Rainbow E series Canister Wet/Dry Vacuum

Dyson leaking air around bottom of cannister now what do i do to fix


... Vacuums

Cleaning Solution leaks out around bottom


Most likely the opening under the seal has cracked or is starting to break away. You will have to replace the water bucket, the soap dispenser come with it, not separately. ... Hoover F7220900 SteamVac V2 Upright Vacuum

I have a Sears shop vac.... i tipped it over this morning and the filter came off. No big deal, but there was a plastic or PVC cup inside, and i can't figure out whether the opening of this cup should face up [ceiling] or face down [floor]. I can't find my manual around, so i need help..... seems like it's leaking dust from the out port now, so.....?


You may need to better describe the cup on the filter, but if it has a handle on it, it's the end cap. The handle part will face the floor and you should be able to screw the cap on, securing the filter. ... Vacuums

I have the Hoover SteamVac Dual Model F7246-900 Serial AA12.0. In the Clean Water Tank the small black plastic check valve leaks water as machine is in use even when the on-off switch is not on. Can I purchase a new valve?


... Hoover Vacuums

My hoover windtunnle modle #u6425-920 leaks oil. where would it be coming from?


There is no oil in these self propelled vacuums. ... Vacuums

Hello! The suction in my Dyson animal is very poor. I discovered small holes in the internal hose, but even after a quick duct tape fix, still having issues...sounds like the seal from the canister to the vacuum is leaking air. I know I need a major repair but my mother in law is coming tonight! Any suggestions? ~Lisa


Or you can do this for free:\015\012\015\012http://www.ehow.com/how_5870417_modify-dyson-prefilter-suction.html ... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum

Have a bissell pro steam cleaner the suction is great but the water leaks out the bottom I think it should spray from the front and the soap cleaner won't dispense from the bottle so I have to mix the soap cleaner in with the water Any solutions


Use this guide!\015\012http://newzealand.bissell.com/images/IncludeContent/Service_Center_Help ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0333 seconds