Having problems with your Vacuums ?

My daughter dopped the remote for my digi box, digihome dv940b into a cup of tea it now dosnt respond. Is there any thing i can do?


Answers :

It's best not to test them after immersion in liquid and it's probably a lost cause, but you can try this:
\015\012
\015\0121. Remove the batteries
\015\0122. Gently split the top and bottom halves of the remote apart with a flat-head screwdriver
\015\0123. Dry inside the case and the circuit board with some kitchen towel - don't rub the circuit board just gently dab it.
\015\0124. Leave the remote somewhere warm for at least 48 hours with the case still in half.
\015\0125 Re-assemble the case and insert new batteries
\015\0126 Test.
\015\012
\015\012If it still doesn't work or the buttons function incorrectly, unfortunately you will need a new remote.
\015\012
\015\012I once spilled a can of coke over an Apple keyboard and washed it out under a tap. I left it to dry for a week and it worked, but that was mostly luck rather than any technical wizardry!
\015\012
\015\012Hope this helps,
\015\012BElectric
\015\012
\015\012
\015\012If your problem has been solved, please be generous and award this solution 4 thumbs-up. This service has been provided FREE - your simple acknowledgement is appreciated. Thanks.
\015\012
Repair Help & Product Troubleshooting for Vacuums

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

My daughter dopped the remote for my digi box, digihome dv940b into a cup of tea it now dosnt respond. Is there any thing i can do?


It's best not to test them after immersion in liquid and it's probably a lost cause, but you can try this:\015\012\015\0121. Remove the batteries\015\0122. Gently split the top and bottom halves of the remote apart with a flat-head ... Vacuums

I have the yellow altima vac. for a while now I can not get the darn thing to pick up properly. Or should i say keep it up.. The vac does seem to be getting everything picked up but as soon as you turn it off, you have a mess under the vac.. I have checked for clogks and can't seem to find any.. I have removed the hose, Nothing there.. And yep have removed the yellow thing inside the trash cup.. Is there anything else you could suggest??


If it smells hot, then there's a strain on the motor no doubt about it. Check the suction channel behind the sole plate and remove all of the hoses to check for a clog. It could well be that there is a clog inside the machine after the dust channel f ... Eureka Altima Upright Vacuum Model 2996AVS Vacuum

Keurig b200 problem; When brewing with cup in unit water will pass into cup and it seems when k cup is full the grinds puch up through the top and water overflows. i pulled out the k cup holder and cleaned so their is nothing that is obstructed included the piercing pin. brewed [product does come through but does not seem to allow it to come through fast enough or if it supposed to be pressurized it is losing its seal on the top of the k cup


... Vacuums

Our Bissell Cleanview II 3576M does a great job except that the filter cup below the dirt cup gets full very fast and the dirt cup barely has anything in it. To clean the whole house, I have to empty the dirt cup and clean the filter several times. It didn't use to work this way. It seems like something is missing, a gasket or seal maybe? I don't think dirt, hair and debris should be going straight to the lower cup and bypassing the upper. I looked at the user guide but can't see why it's happen


Contact Bissell Direct for a parts diagram and support at \015\012\015\012http://uk.bissell.com/EmailUs.aspx\015\012 ... Bissell 3576 CleanView II Bagless Upright Vacuum

Need user manual for Farberware Milennium FSU236. How much coffee for 12 cups, 24 cups and 36 cups of coffee? How long will it take to brew 36 cups?


HelloOK, i am still looking for the specific manual for you model, but, at the link below you will be able to have a loo at a similar unit in capacity. Click ... Vacuums

Cannot remove dirt cup for emptying


It has a release button some where , you need to find it...(my wife had same issue...i left her to find it :)..\015\012\015\012hope it helps...keep the hope :) ... Hoover Fusion Plus Cyclonic Upright Vacuum Vacuum

Went to turn it on after not using for several weeks and it states not ready to brew like usual but after about four minutes it just turns off. Wont let us brew a cup or access the menu even to choose size of cup or anything. It sounds like it's sucking up water to make cup and pokes hole in the coffee but nothing more than that. It is almost brand new


You have posted the fault in the wrong column with no instruction of the make/model.\012Assuming it to be new , Is it passed the warranty period before we take a look ,?\012Just lave it on for sometime and see if there is any change. per ... Vacuums

Kenmore bagless 12 amp upright, model # 216.37045800. the ''cyclone'' blades inside the cup stopped turning, and the cup apparently cannot be dismantled to inspect th e top. is this problem correctable or do i need to replace the cup?


... Vacuums

Hoover Upright U8185-900 agitator brush stopped working...took hood off...PCB display bridge fried...ordered new one & installed...that burned up in 15 seconds...ordered another PCB and new agitator motor...and since I was in there every **** thing else replaced also...took whole thing apart and cleanded even tho agitator brush was not jammed...put all back together...**** thing just sits there with red led lights displayed...this is ridiculous


... Hoover Self-Propelled WindTunnel Bagless Upright VacuumVacuum

Just bought one cant beleive there is no manual or instructions no warranty card no nothing not all pepole have internet so this is not a good thing to me send me all the things i need why they are not with product is the stupidiest thing ive ever seen!


Contact the dealer and insist that he supplies you with the documentation that should have been with the appliance. Don't let him spin you a story, somebody else probably took your copies or he lost them. ... Vacuums

What causes these things to become unbearably loud? We've cleaned evey filter on the machine, pulled every speck of hair and lint off the brushes, changed the belt, no clogs anywhere. I've totally (and I mean totally, down to the brushes on the motor!) torn this thing down and put it back together with no difference. Also have a Eureka bagless, and after minimal use, and almost anal retentive maintance, it does the same thing,to stinkin loud. Wish one would **** up the other to save a trip to th


A clog in the hose or dirt inlet by the brush roll will cause the motor to sound loud. But so will a bad motor bearing, or motor fan, in which case you would have to replace the motor. ... Bissell Vacuums

Hoover F5809 Hello, I seen a few of your post and was hoping you could help me. I just became a member today. My sister gave me her old Hoover Steam Vac-Model F5809. This thing is so dirty and clogged because my sister has pets. So far I've gotten it all taken apart to clean it. I'm not a newbie and taking apart and fixing things. I have fixed things like microwaves, washers, dryers, dishwashers (still learning about TV's-very hard, hehe). Anyway, I got what I believe to be the motor cover off.


That cover is the called the fan cover and is usually pressed on. Tapping on the edge with a flat blade, you may be able to get it off and hope you don't bend it up, you will to put it back on tight enough so it will stay in place. Another thing to ... Vacuums

I have had my Bissell 6591-X for 2 years. I hate it! No matter what I do all the fuzz, hair, whatever fills up around the upper filter before it even starts to deposit in the cup. It has done this ever since I bought it. No matter how much I take it apart, clean it, clean filters, empty the cup, nothing does any good. I spill more dirt onto the vacuum and floor than ever gets in the cup. I will never buy another Bissell.


Sure your not over filling it ? ... Bissell Vacuums

I suspect that "the thing" where the coffe is put in and the water pushes through is not clean enough. Water seems to go/come beside the "thing" I alsohave the feeling that there is coffee in the water tank where I suppose itt should not be. so howdoI clean the thing?


Put in vinegar and run a couple of brews vinegar only(not coffee) till the vinegar is clear when done,(use white vinegar)only so you can see when its clear,then run a brew of clear water to remove vinegar taste this will delime and clean out coffee m ... Vacuums

Dirt devil ud20020 plastic piece at top of dirt cup broke off.whole dirt cup canister will not fasten to vacumn.


... Dirt Devil Vacuums

My pet hair eraser smells like it is burning all the time and sounds funny. The brush will not spin once you have it on the carpet unless you hold it up a little while you are cleaning but then the whole vaccume is not on the floor. I have cleaned all filters and all and it does the same thing. My sister has the same machine because I raved at how wonderful this thing was for pet hair and mine has not worked right since it was about a year old and hers has had the same exact problem since it was


We had the same problem, and it turned out that the roller wheel height setting had broken, for no apparent reason, and was "floppy" so we had to lock it in to one setting with epoxy. Limits utility, but it works. Sort of. ... Bissell Upright Vacuum - The Pet Hair Eraser 1 ea Vacuum

The used Eureka Model 370 Enviro Multi Steamer that I purchased does not have a measuring cup with it. I need to know how much the measuring cup holds so I don't overfill the unit. THANKS.


It comes with a 500cc measuring cup. ... Eureka Enviro Steamer 370 Upright Vacuum

Hi. I have Dyson dc08 hepq+. Thet problem is its not having suction .I checked inside the pipe and foot , ery thing is fine. And if i take the whole dirtbin out ...machine workes fine. when i put ery thing back ....as soon as i start it , after 2 second machine change its voice...and loos suction. I think its just happen because ...the saftey yellow valve inside the machine turns up because the dirt drum is blocked inside some where. Any suggstion ...what can i do with it. I m tahnkful in avance


Hi its Darran at Dyson.From your description of the problem, it sounds as though the bin inner is missing. To confirm this, if you remove the cyclone and bin from the machine, then separate the 2 pieces as if you were going to empty it, w ... Dyson DC08 Hepa Allergy Bagless Canister Cyclonic Vacuum

Dyson animal won't start. Never had any problem with this vacuum. No apparent problem. No electrical problem with house or outlet. If there are some common things I could check/fix, things that might go wrong, I would like to check them out and get this machine going again.


Hi there, if the machine was running and cut out in use, this could be due to the motor overheating. The cause of this would be a blockage or a dirty filter. These checks can be found in the Support section on our website at www.dyson.com. ... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum

It clicks as it is going and stops after about 30 seconds. Two beeps. I have tried cleaning brushes and have pretty much taken the whole thing apart, cleaned the motor, the brushes everything. Still doing to same thing, when this has worked before.


It clunks because the gears are damaged. You will need to replace the CHM. If you have the red cleaning head module, chm, replace it with the green chm. ... Roomba Robotic Floor Bagless Vacuum

Hoover Windtunnel My Hoover Windtunnel is 3 years old. It worked great until yesterday when it lost all suction. I have followed the manual to trouble shoot any possible clogs and could find none. Then I noticed that when I remove the dirt collection cup and held my hand over the vent the suction is fine and strong. So... I replaced the hepa filter thinking that might be the problem. That didnt' work. The motor runs fine. The suction without the dirt cup inserted is strong. As soon as you insert


Either the hose has a clog, or the inlet down by the belt is clogged. Is there suction at the end of the hose, if not then it is clogged. If there is suction, then it has to be clogged down below by the brush roll, check that inlet. There also is ... Vacuums

I have a Sears shop vac.... i tipped it over this morning and the filter came off. No big deal, but there was a plastic or PVC cup inside, and i can't figure out whether the opening of this cup should face up [ceiling] or face down [floor]. I can't find my manual around, so i need help..... seems like it's leaking dust from the out port now, so.....?


You may need to better describe the cup on the filter, but if it has a handle on it, it's the end cap. The handle part will face the floor and you should be able to screw the cap on, securing the filter. ... Vacuums

The bottom bar that encases the brush is flush to the floor when using the vacuum. This causes the suction to "stick" the vacuum to the floor (lamenate) and also as there is no ground clearance debris is just pushed around. We have to nearly stand the thing upright to get the ground clearance to be enough for things to start being sucked up. I have taken apart, re-assembled etc and nothing is working.


I'm having the same problem.  The bottom plate is not level with the floor unless the vacuum is nearly in the upright position.  Its like there should be a spring pushing the bottom plate towards the floor.  Anyone know how to fix this ... Dyson DC07 Bagless Upright Cyclonic Vacuum

We have a Bissell Proheat Cleanshot 2X Model 9500 Steam carpet cleaner. The first time we used it things were great. The second time we used it it left tracks in the carpet. We have no idea what caused this. We tried using the machine on an entirely different carpet and it did the same thing. After vacuuming the carpet about 10 or 12 times, the tracks are still embedded in the carpet - HELP!!!! We're read and reread the manual and contacted customer service and received no help.


First things first. It's only the second time you have used the machine, so it must be fairly new. If you have a receipt and the unit is less than a year old you should take it to an authorized Bissell repair center and have the machine inspected und ... Vacuums

I HAVE LOST THE DIRECTIONS I ALSO HAVE LOST THE WATER CUP, WHERE CAN I FIND DIRECTIONS AND CUP ON SHARK EP95


Http://www.sharkvac.com/productDetails.aspx?ProdID=F%2bTQ%2frBpCD0%3d ... Euro-Pro S3325 Handheld Steam Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0181 seconds