Having problems with your Vacuums ?

Hoover u5209-906 upright

\015 I have a hoover u5209-906 - the hoover website does not list this model for user manualshow do I change the drive belt for the rotating brush pleasecheers Brett\015

Answers :

1. You have to lay it on its front so you can unscrew the two screws in the underside (these are on the plastic panel covering the brush). There are also two holes for you to use a screwdriver in right next to each screwhole. Lever the plastic tabs in the direction indicated next to the holes (I think it is towards the motor). This case should then click up and away N.B. There are 3 tabs fixed into the cover on the front edge of the vacuum head. Be sure you don't snap these off.

2. You then need to use the foot pedal at the back of the vacuum to lay it flat and using a flat bladed screwdriver lever the top cover of the head away from the frame on the two back side corners and across the front of the head. The top case should now be able to come off.

3. The belt should now be able to slip off the motor spindle and off the brush.
Repeat the procedure in reverse once the new belt is on.
Cheers.
Repair Help & Product Troubleshooting for Vacuums

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Hoover u5209-906 upright


1. You have to lay it on its front so you can unscrew the two screws in the underside (these are on the plastic panel covering the brush). There are also two holes for you to use a screwdriver in right next to each screwhole. Lever the plastic tabs ... Vacuums

How to change light bulb in Hoover upright U5209-930 vacuum cleaner


... Hoover U5117-900 Bagged Upright Vacuum

Change impeller on hoover upright - Hoover Commercial C1403 Bagged Upright Vacuum


... Hoover Commercial C1403 Bagged Upright Vacuum

Hi The band snapped the other day on my Vax Swift Turbo upright hoover and i got a new band from a Hoover repair centre. (Im assuming the bloke sold me the correct band). Was tight to go on. And it seemed ok. However, after switching on the band snapped immediately. Kinda burnt as well (at the point it snapped). Any ideas as to what the problem is here? The hoover is roughly 2 years old and used around 3 times per week. thanks Mike


Sounds like the brush roll is bad. Did you check the ends to make sure they turn freely? If not, replace it. ... Vacuums

Hoover upright 2000w, HL2005 001 problems:the hoover made a pop sound & turned off. Tried leaving it for 30 mins as suggested in the manual but it still won turn on. Really cannot afford to buy a new 1 & would like to fix it. partner is an electrician so if we have some guidance as to what the problem may be i am confident we can fix it. the hoover is only 18 months old so not very old at all.


... Vacuums

I have a Swan Petmaster 1800w Hepa Filtration hoover s/r no SU3021 and cant find my instruction manuel. Problem is when on hoover it doesnt seem to be sucking anything up?? I have cleaned the cylinder and filters. Is it something to do with the bit that you can use to clear stairs/car etc and not converting back to an upright hoover again? Please help Julie


... Vacuums

Upright Hoover won't stay upright


... Hoover Vacuums

Hoover 5906-900 how do I attach the hose - Hoover SteamVac F5914-900 SpinScrub Upright Vacuum


Hi. Take the recovery tank out of the cleaner, take off the top. There is a plastic block inserted in the fron of the tank, it slides up, pull it up and out. Take your hose end, the hose end block slides in there in its place.. then you replace you ... Hoover SteamVac F5914-900 SpinScrub Upright Vacuum

How do i fix my hoover u4264-930 - Hoover Soft Light Supreme U4262-930 Bagged Upright Vacuum


... Hoover Soft Light Supreme U4262-930 Bagged Upright Vacuum

After using my attachments I have a hard time getting suction when using upright again - how do I get the suction on my upright? It's a Hoover blue widepath Tempo~ thank you


It may be clogged underneath the vacuum where the roller is. Take the bottom plate off and look into the intake port. There may be some blocking the port. ... Hoover Tempo Widepath Upright Vacuum - Blue

Change belt in hoover turbopower 1500 vaccum - Hoover U5046-930 Turbopower Bagged Upright Vacuum


... Hoover U5046-930 Turbopower Bagged Upright Vacuum

There is no steam on my hoover steam vac - Hoover F6212-900 / F6215-900 SteamVac Agility Upright Vacuum


They do not really "steam." They use hot water to clean your carpets with a mix of cleaner as well. You will not see your unit actually steam. ... Hoover F6212-900 / F6215-900 SteamVac Agility Upright Vacuum

Too much play in upright part of my Hoover upright wind tunnel


No. The handle release pedal is snapped into the bottom base assembly. Look underneath to check for cracks or damage in this area. this is the most likely issue. If it is, then the base will need to be repalced. ... Hoover U6437-900 / U6439-900 Windtunnel Bagged Upright Vacuum

Hoover wont pick up - Hoover WindTunnel Pet Rewind Upright Vacuum


... Hoover WindTunnel Pet Rewind Upright Vacuum

Fix belt on Hoover U5290-900 - Hoover U5290-900 Upright Vacuum


... Hoover U5290-900 Upright Vacuum

Cannot find repair manual for Hoover H3044 - Hoover Floormate H3000 Upright Wet/Dry Vacuum


I found the inner round valve where the tube connects for the cleaning fluid was stuck shut. Although the "trigger" was working fine and the rod pushed againstthe valeve it wasn't working. Here's how I found this out. I tried to blow air through it a ... Hoover Floormate H3000 Upright Wet/Dry Vacuum

Hoover f7452900 brushes wont turn? - Hoover F7452-900 SteamVac Upright Vacuum


Make sure that you have it on the carpet setting and not the hardwood/tile setting. also if you used the hose, make sure that the little door is closed. if all checked... remove the recovery tank, there should be a rubber grament on the stand pipe un ... Hoover F7452-900 SteamVac Upright Vacuum

How to put on the flat belt on hoover mach 5 - Hoover U6437-900 / U6439-900 Windtunnel Bagged Upright Vacuum


Http://geeksquad.fixya.com/ThreadView.aspx?prdid=0&thid=681386\015\012Generic problem for all Vacuums\015\012How to put on the\015\012Posted by jamescook76 on ... Hoover U6437-900 / U6439-900 Windtunnel Bagged Upright Vacuum

Have the empower upright cleaner. belt broke. can not find part #36528-040belt. can find a lot of hoover belts but not this #.Is there another hoover belt that will work on this vac?


No. if the wrong belt you will have problems. This is a common belt for Hoover, it used to be 36528027, but the number changed to the 36528040, also 40201190 is the newest number for this belt. Most repair vacuum repair shops should have this belt. ... Vacuums

Change belt hoover upright vacuum - Hoover Vacuums


Take out the screws on bottom where the brush is pull out brush assembly and look for a broken belt ... Hoover Vacuums

I work for a company and we have bought about 25 hoover upright vacums since november of 2008 from HD supply and we are to refer to hoover for manufacturers warranty. We have a vacum that needs a bag replaced under warranty.


Http://www.geeksquad.fixya.com/ThreadView.aspx?prdid=0&thid=560323\015\012Generic problem for all Vacuums\015\012I work for a company\015\012Posted by dmoses96 ... Vacuums

HOOVER VACUUMS MY MOTHER'S WORK, MERRY MAIDS, USES ALL HOOVER VACS. THEY ARE LIGHTWEIGHT-UPRIGHT-BAGGED VACS. I TRY TO FIX THEM WHEN THE MAIDS BREAK THEM; BUT, I'M HAVING PROBLEMS WITH A BURNING SMELL AND ONE MOTOR EVEN SMOKES. I'M NOT SURE THE MODEL. CAN YOU HELP? THANK YOU.....


Go to thehooverstore - this site lists a whole bunch of hoover machines, exploded diagrams and parts lists. ... Hoover Soft Light Supreme U4262-930 Bagged Upright Vacuum

Product manual for Hoover U6473900 - Hoover U6437-900 / U6439-900 Windtunnel Bagged Upright Vacuum


Go to www.hoover.com and put in your model number, if available, you can down load it. ... Hoover U6437-900 / U6439-900 Windtunnel Bagged Upright Vacuum

Hoover savvy brushes only work in reverse - Hoover U8171-900 / U8172-900 / U8173-900 / U8174-900 Savvy Bagless Upright Vacuum


... Hoover U8171-900 / U8172-900 / U8173-900 / U8174-900 Savvy Bagless Upright Vacuum

I Have a hoover purepower 1800w upright vacuum cleaner that works perfectly except for it wont stand upright anymore. Any advice


Not sure what model of Hoover you have, you may need a new handle release. ... Vacuums
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0624 seconds