Having problems with your Vacuums ?

I do not know were the on/off button is for my vacuum. I have been using a external electrically switch. I have a Sears progressive. I look in the manual and it did not show the on/off button.


Answers :

Do you see a model or a model number anywhere on the vacuum? it would help a lot.
Repair Help & Product Troubleshooting for Vacuums

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I do not know were the on/off button is for my vacuum. I have been using a external electrically switch. I have a Sears progressive. I look in the manual and it did not show the on/off button.


Do you see a model or a model number anywhere on the vacuum? it would help a lot. ... Vacuums

I took my vacuum cleaner apart to clean it because it was clogged inside and now I am having trouble putting it back together. I am looking for a manual of some kind to show me how to assemble it. It is a Kenmore Progressive Model # 11636933502


... Kenmore 31912 Progressive Direct Drive Bagged Upright Vacuum

This is embarassing, but I have just looked at the Dyson DC07 manual and at my Dyson for about 20 minutes, and I can't for the life of me find the wand release button on my actual Dyson.....the manual pictures don't look like the parts on my Dyson....I don't have a hose with a wand release button....the hose just goes straight up inside the handle....Can someone help me? Thanks :)


Hi the wand release button is located directly above the the Cylinder release button. The wand release button looks like the picture below. In order to releease the wand you must firstly make sure the Electrical cable is not wrapped up for storage. S ... Dyson DC07 Bagless Upright Cyclonic Vacuum

I have a whirlpool personal valet steamer system that is mounted to the wall. The system was in the house when I purchased it so I would suspect it's about 8 - 10 years old and I cannot find the manual for it. When I push the start button it automaitcally cancels the set up and will not run. I have unplugged it for a while and then put it back in and it's worked before but not anly longer. How do i get a manual or can I find a repair person to look at it.


... Vacuums

Bissell 8920 proheat x2 brushes not turning i only noticed this after i finished cleaning.. or kinda cleaning because of the brushes ntot turning.. water comes out fine suction is fine but its not scrubbing so its not as clean as it could be. manual part works well water coming out hot. I did take it apart and cleaned off all the hairs in hopes maybe that was it.. put it together still nothing.. No idea how the belts should look onit and i cant find a picture or a video showing how belts look o


Hello,\015\012\015\012Here's a link to a very helpful video that shows you step by step on how to access and replace the belt on your machine. When the brushes stop spinning, but the rest of the machine works fine, this is a tell-tale ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

I have Hoover whisper Cyclonic. I just opend beacuse it was showing Clogged. I removed all dirt etc from the belt and now roller are not moving round and the smell of burning is coming due to rubber not moving on the roller. I looked at the manual which tells me in cased on roller being Jamed if need to use the stich to reset. I looked all over could not find the switch. Can you guys help me please.


... Hoover Sh40080 Zen Whisper Bagless Multi-Cyclonic Canister Vacuum

Model 31320 SkyScan Equity Time Clock -- it did not change with DST but I cannot figure out how to manually set the time. Back of clock shows 4 long buttons: MODE YEAR/SEC ALM/DST/C/F MONTH/HR WAVE/ZONE DATE/MIN 12/24 tHANKS


Hi,You press and release the mode button, then press the adjust button. This is what the instructions say to do. However, I see that you don't have an adjust button listed. I would try pressing and releasing the mode button, then pressing ... Vacuums

I am cleaning the hose to the underneath of the vacum. It is clogged. I need a picture from the manual to show how it all goes back in after i am done. I have a dirt devil quick power compact.. UD... something I have been looking for the manula online. unable to find it.


Go to the website below. Search for your product; either by model number of by type. When you find your model the parts page will also include a link to the manual.\015\012\015\012 ... Dirt Devil Vacuums

How do I find an English manual for my Meile Vacuum Cleaner S748? Specifically looking for drawings that show the filtration system.


The problem with that vacuum is that it's never been released in the American market. Finding a manual for that specific model is going to difficult. If what you're looking for is the S758 and that 4 was a typo then you can find that on Miele's websi ... Miele Vacuums

For some reason the adjustment thats in the front for lowering and highering doesn't seem to be working is there a manual that I could see in adobe that would show me how this is supposed to be I think I have it on right but when I look at the bottom to adjust it doesn't seem to do nothing [email protected]


My printer will not fax it says modem no exheistence?\015\012what does that mean and how can i get into fax settings ... Dirt Devil M086700 Vision Bagless Upright Vacuum

Owner's manual sears progressive 21514 - Vacuums


... Vacuums

Self propel does not work and it is real hard to push this way. We checked the belts and they both ok. Not sure what else to look at, the on line manual does not show any information


Hi there SmartAlec from NelsonVacuums.com.au here. Ok on this particular machine the belts strtch quite a bit and make the machine very hard to push even though the belts s ... Hoover U6616-900 WindTunnel Bagless Upright Vacuum

When removing the canister bag, the plate and spring that it slides into popped out. When I put them back in, the bag full indicator is completely red. It is a new bag and filters. I think I am not getting the plate and spring back in the canister correctly. Any instructions or pictures showing proper insertion and configuration of these? I looked in the manual and the part is only shown while bag being inserted.


... Miele S514 Solaris Bagged Canister Vacuum

Looking for sears kenmore sewing manual#158.18150


... Vacuums

Bought a Kenmore Progressive canister vacuum at a garage sale that looked in better than average condition, filters clean, new bag, all accessories intact, some debris in roller brush. problem is no suction when turned on. There does not appear to be any obstruction in hose. did not have manual


Hello,Carnister vacuum cleaners are all built with the same principle in mind. A motor \015\012generates power which powers a vacuum which, in turn, creates suction to\015\012 lift debris. The most common areas of suction loss are within ... Kenmore 25512/ 25513 Progressive Canister Vacuum

Looking for manual for Sears Kenmore Model 100 85802 Heavy Duty Floor Finishing Machine. Want to get specs. to order brushes and felt pads.


Go here:\012\012http://www.searspartsdirect.com/partsdirect ... Vacuums

I am looking for kenmore progressive 300 user manual


... Kenmore Vacuums

I have a G.E 1.0 Microwave Model JES1039WF02, It has power on the panel but I see a message that says -F3- It will not start or do anything when the buttons are pressed. There is power running to it. The light inside turns on when the door opens. I looked through the owner's manual and there is no reference to this message on the troubleshooting section.


If there is no heating please do not switch on unless you have confirmed the fault. It is possible that the Magnetron is faulty, the temperature cut off is faulty or the main capacitor is short. It is also quite possible that insect can get ... Vacuums

Dc37 can't figure out how to get at the beater bar....manual shows it pulls out somehow...have notice the lock and unlock marks and can't turn to take out the stop button


... Vacuums

I just bought a good Sears Kenmore Progressive 300 upright vacuum (116.38812891) today at a garage sale for five bucks. I left my relic Electrolux with the new owners of my former home during a recent relocation. In the interim I bought a Bissel 3750H which I do not care for, and borrowed a Eureka 7685 AU which performs somewhat better. I cleaned up the Kenmore, and though it seems to run well, noticed the drive belt is showing signs of degeneration. I would like to replace it, but was unable t


... Vacuums

I have a Electrolux , EL6988 Canister Vacum, howeveer the brushes and motor will not run when turned on. I have take the plates and cleaned around the brushes, but it will not come one. The vacum comes on but the motorized bushes do not activate. Thanks I have lost my owners manual, and have looked for the reset button and can't find or know where it is located. Any suggestions.


I need the molded wire harness inside the plastic wand ( one of the prongs is broke off) What is the part # or where can I buy it? Model EL6988 ... Electrolux UltraLux 2000 Bagged Canister Vacuum

I have an endurotronic 4111 electrolux vacuum called ''the boss'' and the cable wont retract into the vacuum when i depress the button on the top. how do i dismantle parts to have a look to see if it will repair or not. does anyone have a repair manual for this vacuum. thx


... Electrolux Vacuums

Looking for repair manual for a WhiteWestinghouse Serger, Model 4500 The Front of the serger had the word Looking for manual owners and /or repair manual for WhiteWestinghouse Serger 4500 - Has Differential Feed on the front also. Can I get a date or can you tell me if the 4500 is the model #


... Westinghouse Vacuums

It's been awhile since I have used my shampoo system on my Ultimate G series Kirby. Well, as instructed I took it apart and cleaned it. Now I can?t figure out where to put the ?screen cap? and ?sponge filter?. I have my manual in front of me and the only place it shows the filter and sponge (page 35 in the manual) is when it?s been taken apart to clean. It doesn?t show where to put it back. I don?t know what I would do without all the pictures in the Kirby manual. HELP! Thanx. Visual Kirby Vacuu


Hello,\015\012The littlew round screen goes in the hole where the hose attaches to the tank. The round foam filter goes up in the hole underneath the on/off valve for the foam. Here is a guide if you need any more help...\015\012\01 ... Kirby G6 Bagged Upright Vacuum

Operating manual i have lost my operating manual for my bissell Model #9500 proheat x2 cleaner. where can i get another manual? on one of the sites it shows that i can download the manual but for some reason i can not down load it. can you please help me with this problem?


BISSELL User's Guides can be downloaded at www.bissell.com\015\012On the front page under Customer Service click on User's Guides and enter the model number of your unit.\015\012User Guide will be displayed as a PDF file. ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0623 seconds