Having problems with your Vacuums ?

Do you have a dyson service center in tampa bay area?


Answers :

Repair Help & Product Troubleshooting for Vacuums

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Do you have a dyson service center in tampa bay area?


... Vacuums

Dyson service center locations


... Dyson DC14 Animal Bagless Upright Cyclonic Vacuum

Where can I find a dyson service center. my dyson


On the side of the machine somewhere should be the telephone number for the Dyson Helpline.\015\012\015\012Give them a call and they'll point you in the right direction. ... Dyson DC15 All Floors - The Ball Bagless Upright Cyclonic Vacuum

I need to replace the brushbaron my DC17 Animal model Dyson. It's almost four years old. I can't find the correct part number on the Dyson Website and I can't seem to find a Dyson repair center in Albuquerque, NM. What are my alternatives? If I can't service this machine without returning it to Dyson, I won't ever buy another one.


Hi,\015\012\015\012The original Dyson part number for the brush bar (often called brush roll) is: 911961-01\015\012\015\012If you type the above part number into Google Products (click link below) you will get a list of suppli ... Dyson DC17 Animal Bagless Upright Cyclonic Vacuum

My older Dyson DC14 (the purple one) early model with a clutch on the beater bar belt needs a clutch replacement. The bar has been cleaned and there are no worn or damaged parts so I conclude that the clutch at the motor end of the belt needs to be replaced. I can find the part online but no instructions on how to disassemble the vacuum to get to and replace it. Dysons only advice is to give me the address and phone of the nearest service center. Can you help me?


Have a look at www.dysonmedic.com which has some very useful info on dismantling and repairing Dysons.\015\012\015\012Although this site doesnt actually cover the DC1 ... Dyson DC14 Animal Bagless Upright Cyclonic Vacuum

Dyson service centers - Vacuums


... Vacuums

Just need the names of the service centers in my area


Good evening,Which brand/model do you need serviced? I'd be happy to find you one.In general, most manufacturers list authorized servicing dealers on their website, or provide a 800 number you can contact to talk to Customer ... Vacuums

POWER CORD DAMAGED AND NEEDS REPLACING. wHAT IS THE SECRET TO OPENING THE SWITCH MECHANISM ON MY DC03. I LIVE IN A REMOTE AREA AND CAN'T JUST DUCK IN TO A SERVICE AGENT. CHEERS, KINGSLEY DYSON


I am not an expert to this kind of machine but I can share with you this link below which I am sure would be a big help to you. Good luck. http://www.sparesaver.com/help-and-support/dyson-section/dyson-hints-and-tips-451/dyson-dc03-hints- ... Dyson Vacuums

My Dyson Animal vacuum sounds like the motor is going? It has also lost suction power and I have cleaned all areas and washed the filter. Is there anything I can do to fix the problem? Where is the closest repair center? My zip code is 17972


... Dyson DC14 Animal Bagless Upright Cyclonic Vacuum

Both drive and slave belts are intact and tight on the Bissell ProHeat 2x. The brushes will not turn. When last turned on, there was a loud snap noise and something is broken in the power head drive train. Can we repair this or is there a service center near the Hastings, MI area? We need this fixed ASAP. Thank you.


Sounds likely you should take it in your drive gears might have a problem ... Bissell 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum

I need the locations of dyson service centers


If you call dyson at 1-866-693-9766 they will give you a list of locations near you. And if there aren't any locations near you they will help you arrange to ship it directly to them(don't know about the cost of shipping it though). Good luck. ... Dyson DC14 Animal Bagless Upright Cyclonic Vacuum

Nearest service center in dubai


... Dyson DC14 Animal Bagless Upright Cyclonic Vacuum

Dyson animal We bought a Dyson Animal from Sears a few years ago along with a service contract. We took it each year to be serviced. One year I took it because it lost it's suction. They sent it to the factory, but it came back still not working right. We did the same procedure over ands over many times than I can remember. I now have the cleaner in my garage and am using my old vacuum because I just can't seem to get anywhere with Sears. Please help me. We paid almost $600.00 and now it can't b


As someone who works for Sears, let me just say right now.. The service contract you bought sucks.. and does not really do anything for you. it was just a wast of money ( they have a new one now.. thats so much better because you get your money back ... Dyson DC17 Animal Bagless Upright Cyclonic Vacuum

Two questions: 1. My Dyson howls when it starts but usually the noise decreases with time. What can I do to stop it howling? 2. I've had it for a year and would like to have it professionally serviced. Where can I get it serviced? I live in Kennett Square, PA. Thank you.


... Dyson DC25 All Floors Bagless Upright Vacuum

My Dyson Animal is not picking up very well in the drive position. With the hose the pick up is still very good. I have had it for 2 yrs now with very little problems. I have cleaned out all areas etc pipes, the brush underneath and cant find any blockages. The noise of the dyson is the same as usual. Could you tell me if there is a part that it sounds like it needs?


... Dyson DC17 Animal Bagless Upright Cyclonic Vacuum

Poor Suction Heya! So I just picked up a used Dyson, but when I vacuum with it, the suction is pretty weak and it spits all kinds of stuff out the back and into my feet. When I pull the hose I have good suction, but in regular mode it hardly picks up anything. The brushes are spinning, and it eventually will clean an area if I go over it again and again. Maybe a clog somewhere? Please tell me that Dysons have better suction than my $50 Dirt Devil! Thanks!


I recently bought a second hand Dyson DC07. Its suction was poor. I removed all the un-clipable pipe bits and to remove any blockage but it all looked clear. The Final Sponge and hepper filter did have a lot of dust in it and the rotating brush was f ... Dyson DC07 Bagless Upright Cyclonic Vacuum

My dyson DC04 started to **** a dog toy up the main bit with the brushes - stopped it immediately and removed the toy but since then the suction is still ok/strong with the extension hose picking up but no suction is getting to main scetion/brush area - sounds like a pipe is disconnected from the front area - nothing obvious on the surface....HELP! Thanks in anticipation........... Julie Price


Get a different brand vacuum. Dyson's are easily the worst vacuum I've ever owned. I've tried the DC14, DC25 and DC33 they are all heavy plastic POS's made in Malaysia. I've owned every kind of vacuum under the sun. Rainbow, Kirby, Oreck, Riccar, Seb ... Vacuums

Eureka Boss Smart Vac 4870 evidentally overheated. Allowed unit to cool and observed a spark/smoke at outlet when it was replugged into the power outlet. Unit will not power up now. Circuit breakers in the home are fine. Is there a fuse that can be replaced in the unit? Does the unit need to be serviced? Is there a Eureka Authorized Service Center in Orlando, Florida?


Seems Eureka is putting faulty, insufficient wiring in many models, most especially my model (if you do a search of this site, you will be how many people have experienced fried wires and switches). There should be a class-action lawsuit in my opini ... Vacuums

I have a shark vacuum model EP754C with a Euro-Pro powerhead. The vacuum is working, but the powerhead isn't getting power. I checked the powerhead plugged into a different vacuum and it seems okay. I live in London ON Canada...do you have a service depot or service center here?


... Vacuums

I recently put a call into dyson regarding a problem with my vaccuum and a supervisor was supposed to get back to me. no one has. back in august, we were on the phone with a technician regarding a problem with out machine. after trying a list of things, she said to take it to american vaccuum services and it would be covered by dyson. when i did, the man told me it was clogged and i would owe $45. i would not have taken it for that price! please advise as now i am stuck. i want my vaccuum and th


Unless you can Dyson to intervene and have this repair covered under their warranty, You are stuck to pay for the service. Clogs may not be covered under warranty, but I don't know how their warranty states. If it says that if you have a problem, t ... Vacuums

Sometime when I am vacuuming carpet or a large area rug, my Dyson starts making this loud, horrible, wrenching noise. It stops when I lift one of the wheels up. What is causing this? I have only used my Dyson 3-4 times.


You will need to have the clutch replaced. this is causing your problem. ... Dyson DC07 Bagless Upright Cyclonic Vacuum

Dyson DC14 Animal Vacuum - terrible loud noise


I have purchased six Dyson DC14 vacuums on eBay at rediculously low prices as they were being sold "as is" because they made a "terrible noise" when the brush bar was engaged. Each of the vacuums I received were like new, literally, and did make the ... Dyson DC17 Animal Bagless Upright Cyclonic Vacuum

I need the location of a Dyson service centre in Calgary Alberta


... Dyson Vacuums

Bissell 5770 Healthy Home vacuum fell over and now will not power on. Closest service center is 55 miles away. I'm very hands and can fix most things, but never took apart a vacuum yet. Can I do this?


Same thing happened to me. The handle connects to the unit and actually plugs in. If you are lifting or carrying it by the handle then you can unplug the unit from itself. Reconnect it and you should be good to go. ... Vacuums

Dyson animal loses suction when I let the handle down from the upright position to use, I've cleaned the foam filter, and the plastic filter holder and dried thoroughly, removed and cleared the right side U-bend, and the center, rear U-bend access, also made sure nothing was in the way of the beater bar. Any thoughts? thanks. lorri


Is the noise a loud screaming or a grinding/vibration? The screaming is an air flow problem and you'll want to check your hoses are clear and all the seals are tight. The grinding is an issue with the roller/belt/clutch/motor/housing. From what I'm r ... Dyson DC07 Animal Bagless Upright Cyclonic Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0367 seconds