Having problems with your Vacuums ?

Im trying to replace the cloth bag on my Kirby G6. How do I release the belt that holds the cloth bag at the bottom of the assembly? It is grey and has teeth that grab when tightened on the bottom of the unit.


Answers :

Kirby G6
\015\012Im trying to replace the cloth bag on my Kirby G6. How do I release the belt that holds the cloth bag at the bottom of the assembly? It is grey and has teeth that grab when tightened on the bottom of the unit.
\015\012
\015\012I would advise you to ALWAYS to FIRST UNPLUG YOUR VACUUM before beginning any service procedure.
\015\012There is a vinyl cover over the outside of the cloth bag and underneath the vinyl cover is a
\015\012ny tie that you have to cut off and replace with a new one and the cloth bag will slip off the bottom of the dirt cup @ the bottom of the cloth bag and remove the top cover and the bag should just come off, you can get the ny tie from any local vacuum cleaner dealer that does repairs or you can call the Kirby factory phone number listed below
\015\012http://kirby.com Contact Us
\015\012United States and Canada 1-800-494-8586
\015\012Between the hours of 8:00 am to 5:00 pm EST
\015\012Monday thru Friday
\015\012
Repair Help & Product Troubleshooting for Vacuums

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Im trying to replace the cloth bag on my Kirby G6. How do I release the belt that holds the cloth bag at the bottom of the assembly? It is grey and has teeth that grab when tightened on the bottom of the unit.


Kirby G6\015\012Im trying to replace the cloth bag on my Kirby G6. How do I release the belt that holds the cloth bag at the bottom of the assembly? It is grey and has teeth that grab when tightened on the bottom of the unit. ... Vacuums

Hi, I have a Dirt Devil Model # M08100REDC. I desperately need to change the bag, but I don't see an obvious way to do it. I'm afraid to try pulling on the cloth tab thingy that's just below the handle, between the rubber ring that holds the bag on the vac, because it seems like stuff will fly everywhere from the force required to remove it, and I might not be able to get it back on there. Should I just pull on that cloth tab until the bag comes off? Thanks, Roberta


You can pull on the tab to remove the bag, but probably a better way is to gently pull on the rubber ring that attaches the bag to the back of the vacuum body. If you don't yank and ****, it should come off without spilling the dirt. There may also b ... Dirt Devil Classic M08100 Bagged Handheld Vacuum

We have a beam Serenity plus home vacuum system and there is no longer sucks. I removed the dirt from the bottom plastic container, but I also notice a sack or bag connected to the unit when I removed the bottom container and inside that sack there appears to be lots of dust. How do I access that and remove that dust without damaging the unit. I don't know how to do that


Hello. Let's begin by getting that dust and dirt out of your permanent filter. To do this, get a big clear plastic bag and pull it up aroung your canister, with the dirt receptacle removed. Then Grasp the sewn in weight inside of the filter and sh ... Beam Industries 2900 Serenity Plus Central System Vacuum

The hose inside the cloth bag is detached at the bottom. How do I replace the hose or do I need a whole new outer bag?


Hello, whgrayI was trying to help you out here. Maybe this will help some? I was going backto some customers that asked questions in the recent past and even fartherback. It appeared that no one answeredsome of them, So, I thought I would ... Kirby G4 Bagged Upright Vacuum

I have a Nilfisk GS90 and trying to install the internal fabric filter bag. There is a metal bar. Not sure how this holds the bag in. Trying to find the manual that might explain how to maintain the unit. It is a great vac and is clean to use. Rich


... Nilfisk Vacuums

Can you remove the plastic part on the bottom of the bag or to tighten or is that a crack I see dust blows out of the bottom


There is a hand grip built into the bottom of the housing to help remove it. If it has not been removed on a regular basis to dump out heavy debris, it may be stuck. Use a screwdriver as a lever and pry it outward from the motor unit to remove it and ... Kirby Ultimate G Bagged Upright Vacuum

I have the top of the line kenmore canister vacuum. According to the bottom plate the model nimbler is 116.28015700 I was doing the normal vacuuming and the bag full light came on and the vacuum action stropped. There is still power to the mortorized handle and agitator attachment. Is there some type of circuit breaker reset button for the vacuum function? This unit is probably less that two years old and has had very little use


... Kenmore Vacuums

Dirt smell I seem to have a smell of dust when I vac. I have changed the bag and checked all areas where dirt collects and nothing is plugged. Seems to be puffing out from bottom and behind the unit


Orecks do have a lot of leaks in the airdut system of their machines. Most likely the smell however, is coming from the outer bag itself. That get so coated with fine dust that eventually it will start to smell like dust. Only by replacing the out ... Oreck XL Ultra Bagged Upright Vacuum

I have a Kirby Heritage 84. Great condition except the part that connects the innerbag is missing. I don't even know what it is called. I can open the vacuum cleaner bottom and see that the part is missing. It should be oval where it connects to the vacuum and then extend into the cloth bag. PLEASE HELP!


The Heritage 84 had two different bag assemblies available. One is a dump-out bag. The dirt simply dumps through the bottom. The other is the bagged style which has a full length zipper to open it. Inside it should contain a "bag fill tube", and a to ... Kirby Heritage II Vacuum

I have a Eureka Boss Power Plus and the beater bar is rolling, the belt is turning, but after vacuuming up around the litter box (not a lot of litter), when I turn the vacuum off, the litter, or even household dirt, falls out. When I hold the vacuum back to turn it off so that it doesn't fall on the floor, it's sitting in the cubby where the wheels are. The bag is empty, the hose is not plugged, the hose is securely fitted on both ends of the unit. This vacuum was purchased in July and is being


Even though the brush is spinning, you probably need to replace the belt because it is s ... Eureka Vacuums

How do I detach the cloth bag from my Kirby G3 Vaccuum to wash it


I would clean the bag by blowing it out with compressed air (lightly). If you do wash it, do it by hand in room temp water and air dry. I'm not too sure how to remove the whole bag on that model. You should call your local vacuum dealer to inquire, ... Kirby Generation 3 Bagged Upright Vacuum

I have a HSCU800B upright. The bag slipped off and the contents is inside all over the cloth bag. I need to remove the outer cloth bag in order to get it clean. How can I do that?


... Hoover Vacuums

Broken clip on cloth bag for Kirby G3


... Kirby Generation 3 Bagged Upright Vacuum

I have the Miele S7280...the one without the clog hatch on the back. I took the bag cover off, then continued the remove the screws and cover underneath it to detatch the top from the bottom. Found the clog and cleaned it out. Heres the problem...now the power nozzle light comes on and the vacuum "on" is lite up red, but it will not come on. Checked the filters and the bag. It certaintly seems like the top and bottom are meeting up to latch into each other, but I have no power. Help!!


... Miele S7210 Bagged Upright Vacuum

Need technical help for my miele s2180 momentum canister vacuum .Bought a display open box at fure shop..Came with a filter bag..there are no tears in the bag...Perhaps they put the wrong bag..Anyway after 30 minutes of use..The motor stopped working ..so I opened up the unit only to see,.the dirt was everywhere inside the vacuum...only a little was in the bag itself..can you hepl..Dave


... Vacuums

Dirtbags Hi, I would like to know where can I buy dirt bags for my electrolux z4870. The number on the bag is E80 and I'm struggling to get hold of the bags. I live in Witbank Mpumalanga. Can you please help me and can you tell me if it is possible for me to buy the dirt bags direct from the factory. Regards Patricia


... Electrolux 4870 Bagged Vacuum

Bag was full, changed it, the unit now turns off


Try dialing the control valve to the mid way position. If the unit still shuts down with the bag full light on you have a damaged control valve under the dial on the top of the vac. This valve failure is common in this model and can only be rep ... Electrolux UltraLux 2000 Bagged Canister Vacuum

I have a BC-A41 vacuum cleaner which has been working well, but now it appears to blow stuff away from the cleaner as I hoover. I find the hose packed up with stuff, but no content in bag. I recently changed the bag...could it be that the bag is not fitted correctly..I am puzzled by the instruction to put the bottom under the rib. I am a pensioner on my own, and would welcome any help. Thanks, Jim


I think there should be some probem in the vacuum section..its failing to **** the objects ... Vacuums

I am having problems with the roller on my Oreck DTX-1300. It turns on and off intermittantly while I'm vacuuming. I have completly taken it apart and cleaned and inspected the roller unit.(I am very much mechanically inclined) This has stumped me, I have checked the electrical from the vacuum to the floor unit, and everything else that I could think of. Question: what does the metal sensore plate on the bottom of the roller unit do?? Anything anybody can tell me, I would greatly appreciate. Cap


... Oreck DutchTech DTX1300A Bagged Canister Vacuum

The unit comes on and the exhaust blows out however no suction at all. l placed a wet vac on the unit where the bag goes and all of the outlets pull some air. The unit is the cv350. Thanks.


There would be 2 things potentially wrong here... 1) the black rubber gasket is missing off the body where the pail goes onto the machine. If that is missing there will be no suction. 2) This is a little more complex but will ... Broan-NuTone CV350 Performance Bagged Central System Vacuum

My Kirby bag is filthy as the internal bag broke. How can I take th bottom plastic piece off to wash the bag??? Please can anyone help!!! Thank You


Madam try to shake the bag to remove the dirt if you cant remove the bag. or use a strong electric fan and let it blow the dirt. hope that helps\015\012\015\012\015\012CHARCOIS ... Kirby G5 Bagged Upright Vacuum

Flair S2220 Removed the four screws holding bottom cover but still unable to remove cover. Is there something else holding cover? The cover on the srew end will seperate but something appears to be holding cover on beater bar end.


Pop out the two little rollers underneath, at the front. you will find two little screws holding it on. Unfortunately, I found after I broke it off! ... Hoover S2220 Flair Bagless Upright Vacuum

I have a signature 2000 ac window unit (10,000 BTU). Recently, water begin to slowly drip from the bottom right of the unit. I heard it hitting my floor. I took the front panel off and saw water build up. The unit is mounted in the window perfectly. How do I remove the water? I live on the 2nd story of my apartment building.


... Vacuums

I have a Riccar R-200 upright vac. My wife ran it for an hour without stopping and a full bag. The motor cut off and the unit won't turn back on. Is there a fuse to reset in the unit if it overhe


... Dyson Vacuums

I went to change the bag on my eureka powermite 930a and the whole thing came off. I don't know how to get the part that holds the bag back on. Help!!


... Vacuums
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0494 seconds