Having problems with your Vacuums ?

Looking for sears kenmore sewing manual#158.18150


Answers :

Repair Help & Product Troubleshooting for Vacuums

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Looking for sears kenmore sewing manual#158.18150


... Vacuums

SEARS KENMORE CANISTER VACCUM, Model No. 107-23050, Volts 120AC, Type AV, Hertz 60, Amps 11: This is a small model vaccum with an on/off switch on the canister. The on/off switch has gone and the vaccum can only be used by plugging and unplugging it. I am looking for the replacement on/off switch part but Sears Kenmore has no listing for this vaccum or parts. I can't recall just how long ago it was purchased but could be 10 years (or more). As this model is perfect for the application neede


... Vacuums

How do I raise and lower the feed dogs in the sears kenmore sewing machine model 3851960180. also, my material goes into the feed dogs when I start to sew a seam. Please help! Thanks


... Vacuums

Sears kenmore 158.321 sewing machine first broke a needle, needle was relpaced, then next needle bent, needle replaced. Now the thread wont catch in the material . it isnt sewing


Make sure you are inserting the needle correctly. The flat side goes on the left and the thread goes from right to left through the needle. ... Vacuums

I have a model 1315 sears sewing machine and have a new walking foot that doesn't seem to fit or allow me to stitch.......is there a fix? The walking foot is a kenmore brand and we thought it would fit all kenmores?


I am sure that you realize that it has to be for a low shank machine and that you have to take off the presser foot and use the screw to clamp the walking foot on, and the fingers must be on the take up lever screw. Be sure to check the shank size. ... Vacuums

I have an old kenmore sewing machine. When i run fabric through, the bottom stitching turns into a total rats nest. Its as if the bottom is pulling a ton of thread for each stitch. The top stitching looks fine. Not sure what to do and i am a total beginner at sewing! thanks


Check the tension on the bobbin thread and ensure that the bobbin is in the right way, the thread must double back on itself. ... Vacuums

I need a book for a Sears Kenmore sewing machine Model 153.14310


Hi.Model 153.14310 does not exist. Model must be 158.1431 followed by other number.The full manual is not available for online dowload. The manual is available for online purchase: ... Vacuums

Kenmore - Sears Model - 385.15008100 Sewing Machine


... Vacuums

Looking for manual for Sears Kenmore Model 100 85802 Heavy Duty Floor Finishing Machine. Want to get specs. to order brushes and felt pads.


Go here:\012\012http://www.searspartsdirect.com/partsdirect ... Vacuums

Hi, I'm looking for a manual for a Kenmore 19110 sewing machine. Thanks.


You can get the manual on the link below.\015\012\015\012http://www.managemylife.com/ ... Vacuums

Where can i get a user manual for a sears kenmore 1586 sewing machine


... Vacuums

Need a new belt for Sears Kenmore sewing machine Model 1120


... Vacuums

Looking for a free download owners manual on a kenmore 117.580 sewing machine


I have one. I have the machine and the manual, and am willing to make you a copy, if you still need it. ... Vacuums

Instruction Manual for Sears Kenmore Sewing Machine Model 158 13510. Need to know how to change the setting back to the straight stitch


... Vacuums

I need a manual for a Sears kenmore sewing machine model 148.13110


... Vacuums

Looking for a manual on a kenmore 158 10692 model # sewing machine


... Vacuums

Kenmore YM-40-35 R Sewing Machine Manual (or copy) wanted. If a manual is not available, I'd be OK with instructions for threading the needle and bobbin and any additional details that an expert may have. I think the machine may be a Canadian model number, it looks old, made of metal with screwed in presser foot. Thanks v. much. Elizabeth, [email protected]


Hello,please kindly visit the site below to see the comprehensive instruction with video on how to thread and bobbin your sewing machine.http://www.wonderhowto.com/how-to-thread-mechanical-singer-sewing-machine-224245/wish you ... Vacuums

I need a instruction manual for a sears kenmore single dial sewing machine model 158


Most manuals I can find for free online, but I have been looking for quite some time for a 158 manual and the best you can do is $5.00 for the one I will link you to at the bottom of the answer here...Please make sure you rate my answer 4 ... Vacuums

Kenmore Model 116.33922 upright - I need a hose unit - Part # KC84PCDBZV07 - Sears parts told me it was not available to contact the Manufacturer - Kenmore (per them) - Their site sends me to Sears Parts! Where can I find this part?


... Kenmore 31913 Progressive Direct Drive Bagged Upright Vacuum

Have a 3 year old Pfaff Creative Vision. Has less than 14 total sewing hours on it. Has had issues in the past. Breaking needles, wouldn't stitch out designs in acceptable manner(badly distorted looking) breaking needles repeated, now it is changes stitches on its own, then went to sewing the same stitch but isn't sewing it consistantly. I have taken it back to the same professional to repair each time. Can thhis machine be repaired??? Should I trade it off and get another, this isn't my first c


It sounds like this machine has some kind of fault in it for sure. It can be repaired again, but will likely need to be repaired again after that - down the road. Personally I recommend you just get rid of this unit and go for a different model. Y ... Vacuums

My Kenmore sewing machine timing has gotten off. I am sewing a big upholstery project and it starting bunching thread from the bobbin. The thread is so heavy that I had to put some pressure just to get it undone. This happen a few times and then I found it wasn't sewing at all. When I evaluated without the materials in place I could see the needle would catch on the white plastic piece under the bobbin and the thread would not catch on the metal arm. It appears to be off by 1/4 - 3/8 inch.


HelloDisassemble your bobbin case which is realy quite easy, clean\015\012thoroughly with a brush and air, paying particular attention to any\015\012rust that may have formed, and any thread that may have weazeled it's\015\012way into sma ... Kenmore Vacuums

Belt type Ok, thank you for the help! I did have the top off, but did not know the taking the motor loose trick, thank you for that! Now I have a couple of more questions, and thank you so much for all of the help! I got a belt from sears, & the sales guy sold me an off brand belt. It looks just like the belt that broke, although do you have to force the motor back down into place? I think it may be the wrong belt? I have looked on the Hoover website & they do not even have parts listed fo


The belt number is 91001028. The belt will be snug but not real tight, so the belt you got may not be the right one. Most repair shops for vacuums should have this belt in stock. ... Hoover U8145-900 Savvy Bagless Upright Cyclonic Vacuum

The foot pedal on my Kenmore upright vacuum cleaner has broken three times. The vacuum model number is 116.33923 and the Sear's part number is 8174906. Does Sears make this part in metal instead of plastic? It is becoming expensive to keep replacing this piece when it costs around $20 each time (including shipping) Thank you for your time. Jerry DeWulf


... Vacuums

Brand new Kenmore Sewing Machine model 385, 16782 It was sewing fine. But I changed to the zipper foot and now the bottom thread just makes a mess, even when I use the regular thread. Can't think what else has changed - I didnot rethread or touch the bobbin.


... Vacuums

Kenmore Manual I am looking for a manual for a Kenmore Central Vac ....model # 34630


Sears/Kenmore central vacuum systems are no longer being made ergo no manuals available,especially on line on line. If contacting Sears parts directly, maybe one may be purchased ?\015\012\015\012 ... Kenmore Vacuums
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0330 seconds