Having problems with your Vacuums ?

Guardian 2211-L Garage Door opener. Hand Unit worls but unit in garage is clicking and seems not to respond to RF signal but lights up and can manually close

Answers :

Repair Help & Product Troubleshooting for Vacuums

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Guardian 2211-L Garage Door opener. Hand Unit worls but unit in garage is clicking and seems not to respond to RF signal but lights up and can manually close

... Vacuums

After a brief power outage my Marantec 4700 garage door opener has problems opening/closing. When opening it stops at the fully open position and the lights blink, when closing it automatically reverses just as it fully closes and then the lights start to blink again. I checked for obstructions and tried to reset the limits of travel per the manual, it still does the same thing. Any ideas on what to try next?

This is not a sensor issue, I have a similar problem, sensors work fine, garage door is still fully functional, all operations, including safety sensors work properly, just the overhead lights flash. I suspect there was damage to the power board due ... Vacuums

I have a Liftmaster garage door opener and the garage door faces south. Normally the opener works great except at certain times on a sunny day.The sunlight is not directly hitting one of the sensors but the door will comedown as far as half way and then it will go back up and the lights will flash. If I go inside and use the button I can hold it down until the door is fully closed. However, sure is a pain to have to take the car out, go back into the garage, shut the door and then leave the h

Sounds like a problem with a limit switch or something getting in the way of the electric eye that interrupts for safety reasons. \015\012Clean the electric eye transmitter and sensor of debris and cobwebs and make sure the wires are attached properl ... Vacuums

I have a craftsman garage door opener remote control model TX2028 139.18191. The remote stopped opening or closing the garage door. I replaced the battery and tried to re-program it through the LEARN button as per the manual of the Garage 1/2 HP opener. The process has failed after several trials and the remote is still not working. Is there anything else that I can try or should I get a new remote. Thank you

... Vacuums

I have a genie screw type garage-door opener. the fuse blew on the moter drive board , now the door only opens when you push the light button on the wall console ,will not go closed.green light blinks continually. when I power it up it jumps closed then nothing. It seems like the motor is not reversing.

... Genie Company Vacuums

Doesn't work Our home was built and finished in August 07.  The central vac doesn't work.  There is supposed to be a slot that opens in the kitchen where you sweep the dust and it sucks it up.  Also, the mounted unit on the garage wall has a hose that goes up into the house but there is a hole open at the bottom of the unit.  Where can I get someone to help us?  Or, is there an installation manual I can download to see if the builder did it properly.  He stole our solar heater for our pool and s

Has the slot in the kitchen (VacPan) been installed? Or is it just not working? There should be tubing coming into the unit in the garage, and possibly another piece to exhaust the unit to the outdoors, although this isn't always necessary. The intak ... Electrolux Centralux Vacuum

I have a raynor flight star garage opener. Had a lighting strike 4 days ago. All power is good. The opener even has a little green light on the switch that is attached to it. However the opener is not responding. Is there a way to reset on the motor by taking off the housing? I don't see any reset button on the out side of the housing.thnx w

You could always try unplugging the unit and plugging it back in. If that doesn't work the logic board is probably fried and unfortunately there is no replacement available for it any longer. You would need to buy a new opener. I'd recommend Liftm ... Vacuums

When pluged, in the unit turns on ( green light illuminates ) and feels warm. Yes, I filled the water container. The unit does not generate any steam. For some reason, I do not have an "operation manual" --- but it doesn't seem to be all that complicated! Have left it plugged in for 25 minutes. A small amount of water came out while just sitting. Then another small amount of water comes out when I push the handle in. I will assume that steam should come out when I push the handle in. Well, it do

Hi,Here is a tip that I wrote about the Euro-Pro Shark Steam Mop and why it maynot be getting steam to the head...Euro-Pro Shark Steam Mop Problem ... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

We recently bought a home with a 52" Hampton Bay Berlini Model 729 395 ceiling fan with a light that operates on a remote control. There is also a wall switch plate with two circular controls - one pushes and spins, the other turns with 4 clicks. We can not get the light or the fan to operate using either the switches or the remote. We have checked the circuit breaker. The manual that came with the unit - provided to us from the previous homeowner - really only describes how to install the uni

Nancy do you want to sell the Berlini fan if youstillo have it? ... Vacuums

I own a stanley model 7100 garage door and the light does not come on or off when the garage door is open or closing

Hello. Begin by changing the bulb. Get a new bulb which is vibration proof. J. ... Vacuums

I hit the button and just the light comes on,then i hit the button again and the door closes almost all the way but opens and light keeps flashing . the sensors are on and clear of obstructions . it is a wayne dalton quantum 3212 garage door opener.

Hello ccap..... It sounds like one of those sensors has gotten out of alignment with the other. check to see if there is a steady green light on each sensor. If not, adjust until the light is a steady green. Joe\015\012\015\012Thanks ... Vacuums

The hand held dyson does not appear to charge. does the battery come away from the unit as I can't seem to release it? Would there be any point in buying a new battery as I don't know if this is the problem. The red light stays lit all the time it is on charge and when I take it off the machine does not respond at all.

The battery is located at the bottom of the handle. To release it, press and hold down the button on top of the battery case (it has 3 ridges on it). That releases a catch and you can then slide the battery out to the rear. This can be quite ha ... Dyson DC16 Root 6 Bagless Handheld Cyclonic Vacuum

I have a SV777g cordless vac. Nothing turns on but the charging light when I plug in the charger. Where can I take this unit to be looked at close to zip code 07626---- it's about 4 yrs old.

... Vacuums

I purchased a used Minuteman 2400 series buffer/burnisher over the weekend from a store that is closing. The unit is about 7-8 years old. I did not get a manual with this item, can you help me out with this. I would like to read up on it so if I have problems I can look back on it. Even as far as the operation of it would help to have a book for it. Linda

I have this manual available via email. chris321 at gmail. ... Vacuums

I have a genie garage door opener. The unit is 2 weks old. The light comes on but the openere does not open and makes no sound. Help!!

Did it ever work the way it's supposed? ... Vacuums

Manual A friend of mine just cleaned out her garage and gave me a Westinghouse WST1600 vacuum that was rarely used. I purchased new #25 fuses and have had the battery pack plugged in for over 10 hours and when I put in into the vacuum and press the on button a green light flashes, but the motor does not start. Can I get this vacuum to work?

Here is a copy of the manual for your vacuumwww.thinkvacuums.com/pdf/uprights/Westinghouse-WST1600A.pdfWhat could be the problem is the battery could be shot after not being used for so many years that the life of the battery ... Westinghouse WST1600 Upright Vacuum

My CJX Series decided not to brew! I checked the manual's troubleshooting, (The coffee is not brewing) everything is correct! The unit has power and the light comes on, will not start brewing cycle.

Heating elements in coffee makers have an internal thermal protection device to locate it access the bottom cover find the wires leading to the element you will find on one of the wires a silver bullet shaped device this is the culprit, you can check ... Vacuums

My craftsman 1/2 hp garage door opener opened but wont close and clinks and lights flash

... Craftsman Vacuums

Hello, I have a Black&Decker bread maker. Cat: no. 81500 type 2 500w 12dv 60 hz 9408 SX I have lost the instruction manua for baking bread for the above unit, and was wondering if you could supply another manual, or something close that would enable me to use the bread maker again? Any information would be greatly appreceiated. Thank you. Rolf E. Egon 54 Gilbert Rd. E. Weymouth, Ma. 02189-1321

... Black & Decker Vacuums

Have a Genie 2020L garage door opener. Door start to go down then stop and return. Tried cleaner old sensors. Same. Noticed red light on sensor 3blinks then off....repeat constantly. Replaced sensors - same issue. Reset unit...checked all wiring...no jams anywhere.... HELP PLEASE L:-)

... Vacuums

Charge light on roomba won't come on when charging. Light on charger is on and shows unit is docked, but no light comes on roomba red unit itself. Is this a bad battery or problem with unit itself??

... iRobot Roomba Red 4100 Bagless Robotic Vacuum

Red Light lit and it refers me to owner's manual.

Your problem could be many things, causing it to over heat, you need service by and Certified Tech. You can call the home office at 800-344-1840 to find an Authorized Service Center near you. Do not take it to a vac shop or you could end ... Filter Queen Majestic Canister Vacuum

I need a manual on a trim a home christmas tree set its a aspen pine with 600 lights it has a series of steps on how to plug in the numerous plugs on it so that all the lights light up...lost manual need help

... Vacuums

Hooked everything up per directions. I plugged it in to the closest electrical outlet and nothing happened. The lights did not light up, the connected wall control and sensors leds do not light up. It appears the unit doesn't have power. The electrical outlet socket is fine as everything else I plug into it works fine. I have tried every other electrical outlet available. The unit won't power on from any outlet, and all of those outlets run other things, like power tools an refrigerators

Dear Davehibshman,Firstly; dismantle the plug and replace the fuse with the same rating as the one you have just taken out. Replace the plug cover, put the plug into the socket and try again. If this doesnt work, there may be a problem wi ... Vacuums

Looking for users manual for anti-bark dog collar (citrus spray) model name/no: innotek ssb-300. This is a replacement for my original unit which stopped working. Petsafe sent me the manual for the original unit again...not this one, which is slightly different. (categories below do not apply...could not 'un-choose' from the product list??!! - sorry) Darlene - Edmonton, Alberta Canada

Innotek has a manuals download site hereA citrus spray model manual is ... Vacuums
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0588 seconds