Having problems with your Vacuums ?

To stop spammers, we sometimes ask you to enter characters before sending your message.


Answers :

When i am sending email on window live a message shown "To Stop spammer we sometime ask you to enter character before sending your message
[email protected]
Not a problem for me --- I hate ' Spam ' myself :-(
\015\012
\015\012c...
Repair Help & Product Troubleshooting for Vacuums

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

To stop spammers, we sometimes ask you to enter characters before sending your message.


When i am sending email on window live a message shown "To Stop spammer we sometime ask you to enter character before sending your [email protected] ... Vacuums

Keep getting message 'please remove and clean Roomba's brushes'. Have removed and cleaned brushes and even fitted new one's but still getting message. Also brushes sometimes rotate, sometimes not and not picking up very well at all. Help!


Must be your inbox is full, Delete old / unwanted messages. It should resolve the problem ... iRobot Roomba 500 Series Virtual Wall Lighthouse 80201 Robotic Vacuum

Kenmore Elite 721.66463500 Microwave died. Didn't even notice until I went to use it. Changed fuse and screen asked to enter the time of day. Entered the time and hit start. The microwave buzzed for 0.5sec and it blew the new fuse I installed.. put in another fuse and the same thing happened.. I measured the resistance in the noise filter. Results: L1-L2 < 1ohm N1-N2 < 1ohm L1 or L2 - N1 or N2 = 0ohms I'm thinking I need a new filter but I also was unable to measure any resistance o


... Vacuums

I have a W580i bought today. When I try to send messages it just says they are in a queue and will not send them? help please!


I rang the customer services in the end and they said try the sim card in another phone which worked then said that it was a fault with the phone.\015\012Took it back today but apparently it wasn't fully activated so all sorted now. ... Vacuums

Rival model CM1100 coffee maker: I can not get the coffee carafe in the right position. Should it lock in? Sometimes the coffee does not enter the pot and overflows onto the counter. Should the handle be on the left or the right or maybe the center? Please help me. I am not a coffee drinker and when I try to serve it to friends, I end up with an embarassing mess.


... Vacuums

I have mobil model 1208 type:rh-105 code:0550326 imei: 356794/02/124438/7 ididnt make asecurity code for my mobile but now it ask me for security code and i enter the master security code but give me code error


... Vacuums

I'm staying in a hotel with a safemark systems room safe. when i enter my passcode i get a message saying "e-bar." the front desk person has no clue what to do with this. any ideas?


The problem was something was pushing against the door from the inside.\015\012Solution, if you can tip the safe back so the contents shift, if not push and try unlocking, or hit the door in hopes it will agian shift the contents enough to unlock ... Vacuums

Need proper wiring connections inside unit, where they have pulled apart from squeeze connectors.(Wiring diagram needed) Can someone E-Mail this to me? Fritz (an ''old'' mechanic) Folks I have talked to, say there is no specific model number for these units. They are just described by name, and serial #. and I have relayed exactly what was labled on the unit. Please post this and quit asking me to enter a "valid" product.


Fritz , thanks please confirm... there are likely more than 2 leads from the motor?? I have not seen or worked on the Tristar CXL as it is very new.You will have a high low function but: Should the power head function at both spee ... Vacuums

I press the start button and sometimes the motor won't continue running. As soon as I release the start button, it turns off. Sometimes, if I remove the cannister and replace it, then it will run correctly. Sometimes not.


... Dyson DC14 Animal Bagless Upright Cyclonic Vacuum

Briggs 8.5 hp snowblower engine, stalls periodically. sometimes under a load, other times no load. sometimes within a minute or so, sometimes 15 minutes into use.


... Vacuums

DZ9080 IRON IS NOT VERY OLD, BUT HAS HEATING AND STEAMING PROBLEMS. IT MAY BE ALL HEATING RELATED! MY WIFE WILL SOMETIMES JUST LEAVE IT "ON" FOR TWO HOURS AND THEN IT WILL START STEAMING AGAIN. I CANNOT MAKE SENSE OF THE HEATING INDICATORS; SOMETIMES IT WILL STAY GREEN NO MATTER WHERE YOU SET THE DIAL ---- AND IT DOES NOT FEEL HOT! WHEN I TRIED IT AGAIN TODAY, THE SHOT-OF-STEAM WORKED FOR A WHILE (AND THE SPRAY WORKED), BUT THEN ALL IT WOULD DO IS DRIP WATER AT THE TIP WHEN TIPPED DOWNWARD.


I couldn't find any warranty information on this iron, but I suspect that the heating element either has a faulty connection or part of it has cracked, making contact at time, but poor contact at other times. The unit will have to be taken apart an ... Rowenta Vacuums

I called almost 2 mos. to send my shark vacuum its broken she give me the address where to send but i missed the address please give me the information again my name is amy gozarin, my e-mail address [email protected] please give me again the address and i registered my product.


Hi,The info is on the manuals link I have here...Here is a tip that I wrote about the Euro-Pro Shark Steam Mop and why it maynot be getting steam to the head... ... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

I kept getting an error message from i-Roomba on charging .. Charging Error 3. I just bought a new battery and it has the same error message.


... Roomba Robotic Floor Bagless Vacuum

It is a Turbo Power 7500. I vacuum for a few minutes 10- 15minutes sometimes more sometimes less.the vacuum shuts itsel***.i wait till it cools and then later I can start it.obviously there is an overheating problem. What do I do to correct this


... Hoover U6630-900 WindTunnel Bagless Upright Vacuum

When connecting the wand into the brush component. sporatic power (sometimes runs sometime nothing) the power is on again off again. when hold pressure down on the wand the power stays on. do you think the coupling connection is bad on the wand? would the wand replacement likely be the culprit?


There is is switch or sensor in the connection. Likely that piece is worn or shorted out. You may be better off getting a new wand piece ... Kenmore 23913 Progressive PowerMate Bagged Canister Vacuum

Intermittent power (turns off at random while operating) and sometimes appears related to the chord and sometimes not


... Miele S558 Red Velvet Bagged Canister Vacuum

Broken Dyson Our Dyson will not stand upright -- it falls flat on the floor as if the catch that keeps it up is broken. Any ideas for a quick fix before I send it in for repairs? Thanks, Please send any responses to; [email protected]


Hi, I went to the Dyson site, searched for the problem AND found the solution -- to hold a button while lifting the rear of the machine up and it clicked back into place. I knew there was a button somewhere but there are soooo many buttons!!\015\012\ ... Dyson DC07 Bagless Upright Cyclonic Vacuum

Every time I get a text message it alerts me by saying "Message from _____" and then the name of the person. I want to silent this feature but I cannot find the feature to do that.


What kind of vacuum is this anyway???\015\012\015\012I will try to help you with your problem even though you have not identified your make and model phone and you are in the wrong category. I will try to help you by telling you what I w ... Vacuums

I unscrewed the 4 screws on the bottom of my gen 3 mistakenly trying to replace wheels. now it turns on sometimes when the on button is pushed and sometimes it doesn't. is there an easy fix?


Easy fix... wow... um.. maybe. \012\012I think that you may have accidently disconnected the metal arm between the foot pedal and the actual switch. Its not a problem, but you will have to open the top of the kirby unit to see if it has b ... Kirby Generation 3 Bagged Upright Vacuum

My Steam Vac does not pick up the water from the carpet why? When I pull the Vac backwards to **** up the water it sucks it up sometimes and sometimes it doesn't Is there a manual I can get I seem to have misplaced mine.


Ebay,google,or the manufacturers website they usually have downloadable manuals... ... Hoover F5858-920 SteamVac Wet/Dry Vacuum

Sony Walkman mp3 NWZ-8143 (4gig) When I was trying to record, the message appeared 'Mem Full'. I deleted a lot of recorded material to free memory but still got the message 'Mem Full'. How can I free memory?


Save your material to another format, then clear your MP3 and start from fresh again. It's like a hard drive that needs defragmenting sometimes. ... Vacuums

Problem starting Sometimes will not start at all. Sometimes will do a quick start and stop. Other times it starts and runs fine????


This can happen if you have an intermittent short in your cord. Try plugging it in and then wiggling the cord around where it goes into the body of the vacuum with the switch set to "on." (If you're not sure whether it's on or off, just click it back ... Dyson DC07 Bagless Upright Cyclonic Vacuum

My electrolux oxygen canister cuts on and off. I have to open and close the vacuum, or take the base of the hose off and then re-insert. I have to do all these things before it will start up again. I sometimes shake the hose around, then it will come back on. If I try to dust with the dust brush (like a lamp shade or shelf) and the suction pulls against the object, the vacuum goes off for awhile. Sometimes I'll have to reset the vacuum by unplugging the electric cord. I never get to finis


Maybe you should have taken it back to that shop, it appartently isn't fixed. I would have replace that board, don't believe in modifing, you usually end up with other problems, like you have. One thing to check is maybe you have a partial clog in ... Vacuums

I GOT A NEW HOOVER VACUUM US140-900 M120 & NO SCREWS WERE IN THE BOX, PLEASE SEND, BOUGHT FROM AMAZON.COM THEY CAN'T SEND THE SCREWS & SAID TO CONTACT YOU


Http://geeksquad.fixya.com/ThreadView.aspx?prdid=0&thid=725726\015\012Generic problem for all Vacuums\015\012I GOT A NEW HOOVER\015\012Posted by junethome on J ... Vacuums

I have a Eureka The Boss Mini (Model # 442) vacuum cleaner. It is not working properly sometimes Today I did a cleaned the roller brush thoroughly and powered it on to see if it spins at all. It spins only in Carpet model, but stops sometimes. Please can you tell me what could be the problem?


... Electrolux Vacuums
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0155 seconds