Having problems with your Vacuums ?

I want my Outdoor 2-Outlet Timer set for a lighting display to come on in our office at 7:30am and cut off at 1:00am each day. Essentially the lighting display will be on throughout our business day but off in the wee hours of the morning when there is no downtown foot traffic to observe it. I found the dial "am" and "pm" notations confusing. Your assistance is appreciated.

Answers :

I don't know what type of timer this is but usually night hours are darker colored or am/pm is marked on the dial. If you can figure where midnight is, set the off time for one hour later and set the on time to 6-1/2 hours later, counting hours around the dial.
\012If you can give me more info, I can help more.
Repair Help & Product Troubleshooting for Vacuums

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I want my Outdoor 2-Outlet Timer set for a lighting display to come on in our office at 7:30am and cut off at 1:00am each day. Essentially the lighting display will be on throughout our business day but off in the wee hours of the morning when there is no downtown foot traffic to observe it. I found the dial "am" and "pm" notations confusing. Your assistance is appreciated.

I don't know what type of timer this is but usually night hours are darker colored or am/pm is marked on the dial. If you can figure where midnight is, set the off time for one hour later and set the on time to 6-1/2 hours later, counting hours arou ... Vacuums

I can't read the display on bright mornings - light too weak. I notice that the RC-7290 has display adjustment but can't find this for the RC-700 model.

Unfortunately you are correct, the RC-7290 has a switch to adjust brightness, the RC-700 only has the one brightness setting, which yours is on. It's possible the LED's are starting to fail, or the actual board they are plugged into is starting to f ... Vacuums

O.k. this is the 3rd time I'm writing this...not even sure how many times I'm being charged.... Already aggravated and exhausted so Please, Please help me. I bought 2 Westek 1 outlet timers for our Bearded Dragons. They have to have 12 hours each of specific lighting (day and night). I get the "up" are off times and the "down" pins are on times. The problem is the Clock Isn't working.... Any ideas??? I'm about ready to throw them out the window except we're leaving early in the morning and

There is no money indication on this one. I'm speaking for free, so I hope you're asking for free.\015\012\015\012\015\012Oh yea, I already answered this question.\015\012You bought two bad timers!\015\012\015\012Sorry. ... Vacuums

I have an electrolux Enviro multi steamer which I was using this morning. I turned the steamer off for approximately 1 1/2 to do some shopping, and when I turned it on again, the steamer light turned on (green light) and then I waited for the orange light to go on, which too a while. When the orange light does turn on, there is no steam when you press the yellow button on the handle. I have checked for water, and the steamer is full, I have turned it on and off several times just in case that wi

Problem fixed itself. Turned off for couple of hours so unit can cool down completely and when I turned it back on it started working again. ... Vacuums

After being on the charger for days and the green light is on I press the clean button. The Roomba leaves the charging unit and travels about 1 foot then the red light comes on and it beeps and won't do anything more the red light continues to pulse.

Buy a new battery ,the old one isn't holding a charge ... iRobot Roomba Discovery SE Bagless Robotic Vacuum

New battery. Charged for 24 hours. Light is green, but after 20 seconds light turns red and it stops.

What may also help is to reset the internal charging circuit: remove the battery and hold down the Roomba's [Power] button for at least 10 seconds, then re-install the battery and charge for 16 hours. ... Roomba Robotic Floor Bagless Vacuum

Hi, my roomba560 goes one foot straight ahead, then turns right for halv a foot. stops, beeps four times, and the light goes red. I charged it up, measured the voltage to 16.6 on the battery.. same thing every time. Is it battery? i have cleaned it, gearbox, everything..

... iRobot Roomba 560 Robotic Vacuum

I have the 9 foot pre lit sherwood pine-slim tree model #24982LO and need instructions. The lights are not all working, I need directions for plugging in the lights.

... Vacuums

I have a littermaid elite automatic litter disposal system. It stopped cycling and both lights are flashing. Nothing is stuck, it just made several passes at some point overnight without successfully getting to the receptacle due to heavy litter. The box was clear and moving before we went to bed. This morning the lights were flashing. I unplugged, emptied, etc and it will not work. what now? It does not have the reset button at the receptacle button that the old models did. Is there one?

... Vacuums

Hoover Upright U8185-900 agitator brush stopped working...took hood off...PCB display bridge fried...ordered new one & installed...that burned up in 15 seconds...ordered another PCB and new agitator motor...and since I was in there every **** thing else replaced also...took whole thing apart and cleanded even tho agitator brush was not jammed...put all back together...**** thing just sits there with red led lights displayed...this is ridiculous

... Hoover Self-Propelled WindTunnel Bagless Upright VacuumVacuum

I have a Westpointe dehumidifier model MDF1-30AE-BA5 and it won't run. The power light comes on and all of the other lights works on the display board but the unit just won't run. I need assistance for this thing now as my windows in my house all have moisture on them.

... Vacuums

The needle on the pressure gauge of my whitewing steamer does not move even after half an hour to be on. The green light illuminates, and just for the first time it release steam, After that nothing happended even with the green light illuminated. What am I doing wrong?

... Vapor WhiteWing Steamer Canister Vacuum

Roomba 560, the small red light above the schedule button will not reset and the roomba will not run. The problem started when I the roomba sat dead for 12 hours. I tried the spot dock reset trick with no luck. The clock and sunday light stay let also.

This work ok for me ihave a 560 thanks ... iRobot Roomba 560 Robotic Vacuum

I have a GE model #SCA1000HBB02. Recently the control buttons quit working. I thought maybe someone locked the controls but thats not the case. The display lights up shows the time but thats all. I unplugged it and then powered it back up the display comes up to set the time but the buttons will not allow. Any help would be appreciated. Thanks, Gary

Sorry but this is the vacuum area, your problem maybe the main board or a fuse. please go to the microwave forum. ... Vacuums

I have a Roomba Discovery. In the past, I had to replace the charging dock. Then the battery died so I did not use it for two years. I finally bought a new battery and used the Roomba. It worked great. It did not find the docking station, and died. I have been charging it and the red light pulsates, but after 16 hours, it still is not charged...any ideas?

Hello. Turn your robot over and clean the charging contacts with the eraser end of a common pencil. Then Charge it and you should be up and running again. Regards, Joe ... Vacuums

I have replaced the battery in my 4210 and reset the charge cycle. It has supposedly been charging for about 55 hours now and I plan to let it charge the full 72. Is it normal for the power light to become VERY pale?

The power light changes color and on some models goes dim to indicate charge level. It will be ready to go when the light is at maximum illumination. ... iRobot Roomba 4210 Bagless Robotic Vacuum

I have a Toro LX425 lawn tractor with Kohler engine. I just noticed the oil light started flashing and CH6 was being displayed

... Vacuums

After two years, my Euro-Pro Shark Steam Mop, Model S3101, no longer ejects steam. I have used tap water. I think the line is clogged with mineral deposits. The light is on when plugged in, and the unit heats up. I even put in vinegar for about an hour to break up the calcium deposits, but it did not correct the problem. How do I fix it, or, where can I take it locally to be fixed (Orange County, CA)?

Hi,Here is a tip that I wrote about the Euro-Pro Shark Steam Mop and why it maynot be getting steam to the head...Euro-Pro Shark Steam Mop Problem ... Euro-Pro Shark Steam Mop - Gray/ Purple Vacuum

The clean light on the Roomba 520 doesn't quit blinking even when it has been docked for hours, i checked all the plugs and i also pushed the spot button for 10 seconds. it is a a slow continual blink as if it is recharging continually. what is the problem.

Sounds like you didn't remove the batteries protective tape. If this isn't a new roomba, your problem may be the charging cycle. For a brief video of what to do click the link below.http://irobot-homesupport-en-eu.custhelp.com/app/answers ... iRobot Roomba 530 Robotic Vacuum

Water heats up in tank. Light goes on, showing it's ready, but no steam is emitted through hose. Waited several hours.

Sounds like the switch on the hose has gone bad. May want to try taking hose to your trusted local electronics shop. They may be able to open it up and test it for you. Good luck. If you ever find where to find parts (I am looking for the tip and ... Saeco Supervapore 2500 Steam Vacuum

The digital readout on my Redmon brand digital small animal pet scale will not "zero out." When turned on, the weight displays a weight from the memory, which is what the scale should do, but it's then supposed to zero out so you can weigh the animal. I've put new batteries in, and also taken them for a while (up to an hour), then replaced the batteries, and turned the scale on. This has not worked. Any ideas?

... Vacuums

I have a Sebo X4 vacuum cleaner which has lost suction and is displaying the red bag clogged light. There is no apparent blockage in the pipework from brush to bag Any clues as to reasons/solutions?

There could be a few reasons:\015\012\015\012Check that the main filters are completely clean - open the door to see if there is any dirt on the main slide out roll filter and also the main exhaust filter on top of the hood of the X4 (by pushin ... Vacuums

My vacuum cleaner works, all but the "foot". It turns off automatically and the light comes on telling me to "check brushroll". I've done this and removed all hair, strings, etc. It still turns off automatically, while the main vacuum and hose remain on. What else can I do?

Please post back with a brand and advise more info, however , I assume this is a canister vac with hose and `power head``. Often a power head brush roll will build up hair and thread which travels and winds up at the end of the brush wher ... Vacuums

Manual A friend of mine just cleaned out her garage and gave me a Westinghouse WST1600 vacuum that was rarely used. I purchased new #25 fuses and have had the battery pack plugged in for over 10 hours and when I put in into the vacuum and press the on button a green light flashes, but the motor does not start. Can I get this vacuum to work?

Here is a copy of the manual for your vacuumwww.thinkvacuums.com/pdf/uprights/Westinghouse-WST1600A.pdfWhat could be the problem is the battery could be shot after not being used for so many years that the life of the battery ... Westinghouse WST1600 Upright Vacuum

Have Fresh Aire 2.1 about 4 years was running great then went dead. I cant find where the fuse is and have unit apart. I plug in no fan dim display shows to errors. Unit was pretty dirty at the time. I need schematic and suggestions. Also need to knpw how to remove the honeycomb from the light unit to check for blown bulb. Seems brittle and I could break it with trying to pry with augur or sharp screwdiver object.

I'm sorry this may only be a partial help. But fuses are usually very close to the motor, OR where the switch is located. Pretty easy to find by testing but you have to be or so careful you dont electricute yourself. Now if your testing shows v ... Vacuums
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 1.1316 seconds