Having problems with your Vacuums ?

How do I store my pressure washer for winter?


Answers :

Basically, make sure that it is completely emptied of all water, blow it through with compressed air if you can, and try store it where it is not subject to below freezing temperatures.
Repair Help & Product Troubleshooting for Vacuums

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

How do I store my pressure washer for winter?


Basically, make sure that it is completely emptied of all water, blow it through with compressed air if you can, and try store it where it is not subject to below freezing temperatures. ... Vacuums

Karcher 4.91 m leaking a lot of water as soon as hose is turned on, also rsulting in low pressure. It's approx 15 months old and used approx 12 times. Stored in spare bedroom during the cold winter. Was fine beforehand and now not working having not used it for 3 months.


I could be that the rubber washer that is on the piece that the hose screws on to is dried out. Try replacing it. Any outdoor products store would have it. ... Vacuums

Fantom vpw46h,house pressure washer.the motor runs,it was setting for sometime started,using it,but never had any pressure besides the house hose pressure, with the motor running,then the pressure startes to work great,while using it the wand hose came out of the pressure washer,i put it back in,now the motor will only run when i try to adjust the wand head but will not produce any pressure and will shut the motor off,it seem like as soon as the wand hose came out of the presure washer and after


... Vacuums

MY DIRT DEVIL ND40100 PRESSURE WASHER PRESSURE TURNS ON AND OFF


... Vacuums

Hoover model U6476910 I was cleaning out the bearing sections of the brush when a spring type pressure washer fell on the floor. I did not see the washer when I took it apart and I can't tell where it goes in order to put it back together. It is very thin and measures about 5/8 inch with an 11/32 inch hole. Frank Nething


Hi frank this sounds like its a compression washer, you normally find these on the end of the roller to even out any movement from side to side, as you look at the hoover's brush head, it should slip into a groove on one side with the roller...hope t ... Hoover Self-Propelled WindTunnel Bagless Upright VacuumVacuum

The t racer on my karcher pressure washer is not spinning round, the water pressure is fine and the other attachments are working.


... Vacuums

My Karcher B302 pressure washer runs as soon as it's plugged in, regardless of the switch position and there is no pressure save the increase due to the narrower outlet. Allen keys are too short to reach screws so I can't even look inside.


... Karcher Vacuums

Fault Nilfisk Alto pressure washer


See the diagram and repair swtich: ... Vacuums

Adapter for hoselock to nilfisk pressure washer


... Vacuums

Can I get a manual and parts for my pressure washer


The manufacturers web site should be able to offer the manual you can probably pick the part up from them as well ... Vacuums

Fix euro pro 1300 psi pressure washer


I would take it to a proper repair facility (Sears. I used to work at their Harrisburg Repair Center). They are trained to work on equipment like this. ... Vacuums

I need to get a owners manual for a Factory Reconditioned Power Boss 20344R 2,500 PSI 2.3 GPM 160cc Honda GCV Gas Powered Pressure Washer With 25-Foot Hose model # FO20296


HiIf this works I am a hero - is not I am sure I am a zero -but I think this is close enough to get the job done for you.http://w ... Vacuums

I have a karcher b203 pressure washer looking for a patio cleaner would a T250 fit it?


... Vacuums

Where can I get replacement rubber "o" rings for my Alto Nilfisk Dynamic 4350 pressure washer? I can't seem to find any data relating to the size of the rings for the hoses and accessory wands etc


... Vacuums

Alto force 5000 pressure washer Q:- The motor cuts out and will not start again, I try changing fuses etc. Eventually it starts again? but for a short while before it cuts out again.


... Alto Vacuums

Nilfisk C120 6-6 PCAD X-Tra Big Accessory Pressure Washer manual


... Nilfisk Vacuums

How do i start the dewalt 3750 pressure washer


... Vacuums

Macallister 3 Electric Pressure Washer manual


Manual for mac 3 pressure washer ... Vacuums

My honda gx390 pressure washer is not starting. It is backfireing through the carb. Will run if I pull enough sputters them might kick in and run then will die. I have cleaned the carb & float bowl and changed the oit so it is up to leavel and seem to have spark but could be better spark. It was running (allthough not well ran out of gas and then I filled it up and this is what I have. Thanks for any help.


... Vacuums

I need an owners manual for Karcher Pressure Washer ipx5 hds 945 1.027-881 year 2000


... Karcher Vacuums

We recently bought a Karcher K8.55. The pressure washer part works fine but we can't get the steam cleaner part to fire up. Any tips or hints would be most appriciated.


... Karcher Vacuums

Where to buy on line, plug in and foot pedal cord, plus a pressure foot, for a scholastic 6510


This link may help youhttp://www.singerco.com/accessories/instruction-manuals ... SewShop.com Singer Model 6510 Scholastic Instruction Manual

I have a karcher 350 water blaster that has suddenly lost water pressure. the motor still works but no pressure. If i give it 10 or more seconds it builds up a bit of pressure but when i pull the trigger the high pressure only lasts for a 1/2 second blast then just normal tap pressure. Can anyone offer advice . thanks


... Vacuums

The Lower body of the Bissell QuickSteamer, water pours out from the body. Solution: I took apart the machine and there is a spring loaded valve with a rubber washer at the bottom. Think of the letter T upside down with the rubber washer on it. The washer stretches over the bottom and the spring creates a leakproof plug and won't allow water to pass till the button on the handle is pressed. This old washer came partially off and allowed water to leak. I purchased from the plumbing dept. a mi


... Bissell Vacuums

Kirby vacuum cleaner G4 fitting new fan order of assy of washer and seal ...which way does the soft seal face and assy order of soft washer, I assume the steel washer is next to the retaining nut/pulley. Ozzie


... Vacuums
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0120 seconds