Having problems with your Vacuums ?

No user manual/guidelines found in carton. Need some explanation of how best to use the canister, and clarification of the battery compartment 0 to 48 hours sliding switch functionality. Thank you.


Answers :

You were supposed to be issued with all the pertinent manuals for the machine. Go back to the dealer and demand your manuals.
Repair Help & Product Troubleshooting for Vacuums

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

No user manual/guidelines found in carton. Need some explanation of how best to use the canister, and clarification of the battery compartment 0 to 48 hours sliding switch functionality. Thank you.


You were supposed to be issued with all the pertinent manuals for the machine. Go back to the dealer and demand your manuals. ... Vacuums

I have a wireless thermometer made by Viking (CE 0197). Have replaced the batteries of the remote sensor RF wireless. In the battery compartment there is button TX and a slide switch for position 1,2,3. Have replaced batteries pused button but no results of recording. Could you help me what to do to make the unit work again. Thank you


... Vacuums

Picked the zig cp3g at car boot sale,just what i was looking for,but no instructions just wires been cut,tidy little unit.on the battery transfer switch, red, green and blue. and from lights green,aux brown,and water pump yellow.....firstly how do i wire to power up,and how does the single wires from unit not have return wires,thanks.


Hi,\015\012\015\012For your requirement wiring will be following: the green wire will be from the knob beside\015\012the tree switch to battery switch. Red wire will be from another side of battery\015\012switch to circuit o ... Vacuums

My bissell carpet cleaner does not spray water even though the water compartment is full and the filter has been cleaned out. Any idea what I should try before having to take it 2 hours out of town for servicing? Thanks for any help


Hi,Here is a tip that will give you all the information you need to fix your BissellProheat Vacuum Problem.Bissell Proheat Upright Wet/ ... Bissell 7920 ProHeat Pro-Tech Upright Wet/Dry Vacuum

New Salter Analyser Scale 9149EF. No instructions in the box. Have inserted batteries and both gadgets show life, but neither functions properly. Have looked for instructions on the web - no luck Very frustrating, and spoils Salter's reputation. Please help. Thank you


... Vacuums

I was given an Auriol H13726A weather station and after 5 days of perfect functioning, now it will not find the wind station. I tried resetting the whole device, but still I have no response from the wind meter. I noticed, when changing the batteries, that the LED on the wind meter will not light up. As this was a gift, I no longer have the receipt and I don't know where the weather station was bought. Thanks for helping,


... Vacuums

My roomba wont work. Pushing the power button doesnt do anything. It charges seemingly normal, going to green in a few hours. ive tried the reset trick, holding the power button down with the battery removed. Now what? thanks


... iRobot Remanufactured Roomba Vacuum Cleaning Robot with Scheduler, Case/Color May Vary Robotic Vacuum

This is crazy, as I've installed about a hundred ceiling fans in my day, but......what is the function of the 3rd pull chain on the Hampton Bay I just installed? It isn't the directional control as the fan has the traditional switch for this. The only thing I can figure is it's a means to control the fan and light with one pull chain. The generic instruction book doesn't address it. Thanks for your help!


Chain #1 = light on/off\012Chain #2 = direction of draft. up / down\012Chain #3 = Slow/med/fast speed control ... Vacuums

I need assistance infiguring out whats wrong with my hampton bay ceiling fan i believe its the romote for the 2 stage lights and 3 stage fan the lower light will flash on and off only i cha nged the battery and stiii will not function model no on remote is o;UC7080T THANK YOU PHIL HILLEN @ [email protected]


Hi phil,I think the battery you inserted are not in a good working condition since it was working well before you changed the battery,I will suggest you replace the batteries,if the problem persists then its obvious the problem is from the remo ... Vacuums

My walkie talkies won't turn on. We've only used them a few times, and not recently. I charged the batteries, but it doesn't seem to want to switch on. I've pushed that grey side button. Is it possible that it's locked off? And, same problem is with both of them. Seems a basic question, I know. They should be working though. Thanks, Bruce


... Vacuums

I have a model u6476 self propelled hoover.The switch will not turn or off all of the time.The plastic slide does not operate the switch but slides over it.The switch seems to work easy enough by hand.Cleaner was purchased 2-23-07 Any iseas?


If the rod isn't pushing the switch, then something inside the handle asm. broke and isn't holding the rod in place. More often then not, it is the switch, but could be the rod in this case. ... Vacuums

Central vac our central vac will not work unless the main vac in the garage is switched on manualy.... its sucking fine but i have to switch it off at the main switch in the garage after i have used it normaly i just plug in the hose and vac away and it switches itself off we have just had cable installed with a fisher guy in the walls do you think that would be the problem thanks a lot


It is possible that the low voltage wiring that controls your central vacuum has been damaged during the cable work. You can check to see if the low voltage relay is working by shorting the two terminals together at the unit. Just disconnect the two ... M&S Systems AirVac AVP1200 Platinum Series Central Vac - 12,000 sq ft Bagged Central System Vacuum

Hello! Where is it possible to buy (internet) new batteries for my vacuum ZB266X (pnc900 081 072) type HA3088. It works usually with 4 batteries but i find now only systems with 6 batteries. Is it possible to adapt 6 batteries on mine? How are the connections? Thanks a lot to answer . Raymond VAILLIER (France)


... Electrolux ZB266X Handheld Vacuum

The battery charger flashes red when the battery is inserted for a charge - does this mean the battery is no good? If so, where can I purchase a new battery and at what cost? Thanks in advance.


Blinking red means it is charging. it will stop blinking when it is fully charged. ... Oreck TEK100 Handheld Vacuum

New battery!, roomba runs for 5 - 10 seconds, stops, starts running, stops, runs, stops, then beeps and low battery flashes. Have taken battery out, held start button 20 seconds, replaced battery and directly connect to charger, 72 hours min., still same problem.


... iRobot Roomba Discovery SE Bagless Robotic Vacuum

After removing the filter, I cannot get to battery on the Dirt Devil Kone M0213, there are two horizontal screws. Removing them does not help getting to the battery, no way to remove the insert where the battery is located.We have two of these, however they did not come with a manual for dis-assembly. Please help or proved a diagram on how to remove the battery. Many thanks, Wesley Lennon


Sheesh, did anyone actually read the person's question? It's about the battery, not the filter.\015\012\015\012You have to get the outer cover off and it's not easy. There are four tabs which need to be released. I have to use a very sha ... Dirt Devil KONE Hand Vacuum MO213BLU Vacuum

Evac Where can I get a battery pack? Haven't used it for a long while because the batteries wouldn't charge anymore and just forgot about it until I stumbled over it the other day. Can I still get a battery pack for this item or should I toss it? Money wasted because I hardly used it in the first place. Thanks for your help.


... Sharper Image Vacuums

I have a ge light switch receiver rf1023, with incandescent bulbs, and when I try to switch it on it just blinks once and goes out. if I hold the switch on the battery-operated wall remote, the lights keep blinking until I let go. It used to work fine, and now it doesn't. I've lost the intallation instructions, so I don't know if there was a trouble-shooting section that covered the problem.


... GE Vacuums

Henry will switch on and stay on, only while the switch is pressed.rnHow can you get at the switch to replace it? There seem to be many crosshead screws under the motor part,- which need to be undone? Thank you.


Sweeper shop to get switch, you could have a wiring problem . Take casing off and check out and get those screws out of there they could cause some damage all while unplugged of course.bare wire coud cause your problem and thoe screws hopefully arent ... Numatic Henry Bagged Canister Vacuum

I have a Shark Cordless Sweeper that needs a new battery as the old one will not charge anymore. Where can I buy this? The number on the battery is Euro-ProX XBP610 7.2v 1.3Ah.It is six batteries enclosed in a white plastic case. Thanks. Joyce


U can order that battery pack from the web site at the link below, it is battery mart. $33.95\015\012 \015\012 ... Vacuums

The handle for my Eureka 5993 AVZ was getting very hot when used. Finally, the wires around the switch melted and now the vacuum will not work. What is wrong? Is the switch bad? The wires only melted in the immediate vicinity of the three-prong switch. Nothing else appears to be wrong; the vacuum worked fine when it was running - except for the handle getting hot. Thank you!


Try cleaning all...\015\012if have sam paoblem need replaced main motor.... ... Eureka 5893AVZ Bagless Upright Cyclonic Vacuum

Can you send me a La Cimbali M22 Premium espresso machine power switch wiring diagram? I have a machine without a power switch. The switch is on order but I still have to connect the 10 loose wires. Thanks, Terry...


... Vacuums

Kirby Hello, I have a generation 3 kirby- it was working - I turned it off & it will not turn on again - is there a safety switch /reset button or did the on/off switch go out - I have had it 15 years & replaced the switch 1 time - Thanks


You either need a switch or a cord. Check out my troubleshooting link which includes links to do-it-yourself guides and parts.\015\012\015\012 ... Kirby Generation 3 Bagged Upright Vacuum

I press the on/off switch on the Dyson DC05 and the vauum cleaner switches on unfortunately when I stop pressing it it switches off again. Please advise how I would need to repair this. Many thanks. Regards Michael Segal


If you can make it work by holding the switch down then it must be the switch or a bad connection on it. The only way to find out is unplug the machine from the mains and remove the switch to check it. A replacement should be cheap enough.pete ... Dyson DC05 Cylinder Bagless Canister Cyclonic Vacuum

I have a Roomba xe 5200 (2004) and need a new battery, where is the best place and cheepest, also what battery will fit. thanks micky.


... Roomba Robotic Floor Bagless Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0755 seconds