Having problems with your Vacuums ?

Wertheim diablo hand vac what is the power supply for it?

Answers :

Repair Help & Product Troubleshooting for Vacuums

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Wertheim diablo hand vac what is the power supply for it?

... Vacuums

The battery will not charge in the sweeper. I can remove the battery and wire it to the power supply for charging and it will charge up and run the sweeper. So the power supply and the battery are both good. Obviously there is a circuit failure in the on board charging control. Anyone know a fix or a likely faulty component? I had a shark handheld about 8 years ago and it developed the same problem. I examined the little circuit board inside but saw no visible indications that would isolate t

... Euro-Pro Cordless Bagless Upright Sweeper - Blue/Gray

I have cd mix 2, i lost the power cord, and i used a different 12v cord. The mixer played for a while then the power went off. I checked the fuse at the power supply it has continuity.

May be you unintentionally provided more voltage or current to the appliance and it has got damaged because i feel that if it played at first and then stopped then it might have got damaged due to overvoltage or excess of current .I would highly reco ... Vacuums

Can not find power supply for zoombot smart vacuum model RV501 charging power DC24V 20w. Power DC 14.4v 20W

... Vacuums

Scooba service light and tones go away when re-seating power supply

... iRobot Scooba 350 Robotic Vacuum

My electrolux 2100 vacuum hose broke. I replaced the hose but now I dop not have power at the hose end. is there a curcuit breaker in the canister tha supplies power to the hose??

... Electrolux Guardian Bagged Canister Vacuum

I have a Husqvarna Embroidery Card reader/writer for a Viking Rose sewing machine, and I want to know if I can plug a 8-volt power supply into it. During our move the power attachment go separated and I don't want to risk the wrong voltage. The unit is for an older machine, not the USB version that is now in use, Thank you in advance.

The Reader/Writer's power cord is a transformer, with input 120VAC 60Hz, 9 Watt. Output is 12VAC 500mA. The connector is a standard small round plug-in. The one we have appeard to be generic and is labeled only " ... Vacuums

My Bissell 9200 is not sucking the water into the dirty water resevoir. 1. The gasket on the clear-view seems fine. 2. The suction power just doesn't seem powerful enough (feeling with my hand). 3. The brushes turn fine and belt is fine (not sure if that even matters for this issue). Any help appreciated. Thanks, - Matt

Disassemble all lines and check to see if all O rings are installed. If cracked missing or stretched out of shape no suction will be provided ... Bissell 9200 Upright Vacuum

Wilson Jones auto 130 Shredder - No power out of power supply, and fuse is good. need circuit board.

... Vacuums

Miele vacuum. Model: Medivac: SEB 191 When plugged in, no power to vacuum. Could it be power cord supply, or switch?

... Vacuums

The pump motor in my Bissel Proheat 2x Plus seems to have failed. It was seized so I sprayed WD-40 in it and let it sit for 3 days. Now I can turn it by hand, but when plugged into the unit it still doesn't spin. Here's a picture: http://bbay.dreamhost.com/bissel_proheat_2x_plus/P1070021.JPG I wanted to take the motor out and hook it into another power source to see if I can get it going but it has 3 wires. I'm used to only 2 (+ and -). How can I hook the motor up to another power source,

... Bissell Vacuums

My Hoover Turbo power 4900 does not have enough power to pick up lint off the floor - when I hold my hand up to the attachment, I could say there is not suction - any suggestions?

... Hoover Vacuums

I have been trying to register on line and can't get in. I am having problems with my WindTunnel powered nozzle it doesn't want to run and I just got this as a gift May 1st. The power hand tool works but not the other one and I know all the connectins are good

It will have a years warranty on it. Take it in to a warranty repair shop and tell them that yo got it as a gift and when. ... Vacuums

Poor suction I have a hoover hush s5627 vacuum purchased about 4 years ago from Costco. It's suction power isn't so good anymore. I've checked all the lines & hoses and they're clear and I've changed the bag. I even disconnected the pipe from the vacuum unit and held my hand over the intake. While the machine roars like a jet engine the suction power just ain't like it used to be. What could possibly be the problem?

This vaccuum has a Fan Blade inside connected to the motor that spins to create the suction you feel. After a few years of use (and misuse) the blades on this (plastic) fan will be broken off, thus damaging the unit. These Fans are replaceable if yo ... Vacuums

I have no power to the roller motor but if I disconnect and connect direct power, at the hand connection, it works. Is there a fuse somewhere I do not know about. If not what is the problem and solution? Thanks, Wayne [email protected]

If you have taken the handset and plugged directly to the head...you have already found your problem to be the hose.\015\012\015\012Either take the hose to local vacuum repair shop or test the continuity of the hose yourself. ... Beam Industries 2775 Serenity Plus Central System Vacuum

I have a Hoover Platinum carpet cleaner, and it has stopped dispensing cleaning agent and water. This model has a separate tank for water and separate tank for shampoo dispensing. It also has a power hand unit that dispenses shampoo. All along the hand unit has continued to dispense shampoo. Symptom #1, the water tank seemed to be taking on shampoo, as it was getting sudsy. Symptom #2 - On wash mode, nothing would come out, on Rinse mode, sudsy water would come out. Later, symptom #3 - not

Somewhere on the outlet is a control tap thats driven by a rubber band and something is up with this control ,best advice here is put it in the boot of the car and take iot to a hoover dealer ,they will do it seconds for you ... Hoover SteamVac Carpet/Upholstery Deep Cleaner Vacuum

Power Supply For Euro-Pro Shark V1730 Cordless Professional. Where?

This power cord / adaptor can be found at http://www.totalvac.com/accessory/parts/1016FM.html ... Vacuums

Need power supply oreck qs110

... Vacuums

Can not figure out how I have to attach the Powered hand Tool

Just got connected it to the main hose and press the switch on ... Hoover S3765-040 WindTunnel Bagless Canister Vacuum

Solution supply hose, for a Bissel Power Steamer Deluxe 1631-1

... Bissell 1631 PowerSteamer ProHeat Canister Vacuum

I need to replace power supply. where the cord

Greetings from GoVacuum.com,Unfortunately there is no fuse on a Kirby Generation model. In my 10 years of repairing Kirby's as well as other vacuums I will tell you that 9 times out of 10, when a Kirby Generation doesn't turn on, it's the ... Kirby Generation 3 Bagged Upright Vacuum

Dirt devil hand held vac (power reach) brush not spinning

... Dirt Devil M082123 Power Pak Handheld Vacuum

I am looking for a contol board for a miele s143 stick vacuum. The vacuum wont start but when I supply power directly to the motor it spins. I think the switches are OK so I have concluded it is the control board Thanks Don Kenney

You should check the cord and switch's for continuity, the boards are usually pretty reliable, you could check the board for any bad solder joints, at least that would be obvious. ... Vacuums

I have a hoover upright bagless - turbo power 6500 The cord has been run over and I just noticed white stuff on the cord where it is tattered. My husband said he saw it 6 months ago and never said anything! Anyway, what is that white stuff in the cord? Is it dangerous in any way? Is it insulation? What is that usually made of? Just concerned since the cord is dragged over the floor and my little boy constantly has his hands and face on the floor. Thanks. Worried mom

It can be potentially dangerous. What you see is the cord insulation, if you move that a little you can see the power wires. They are coated and cannot hurt you if not damaged. If i were you i would wrap it in electrical tape or best thing would to ... Hoover U6616-900 WindTunnel Bagless Upright Vacuum

I am trying to replace the power cord for my 82 year old father-in-law's Oreck XL 2600HH. He already took it apart. I need to know where the semi U shaped spring steel piece is supposed to go inside the Helping Hand Handle? Any drawings or schematics available? Thank you for your time. Arthur

That justs lies on the inner handle whenb you put the spring back. There should be two holds where each end of the spring sits in. ... Oreck XL Ultra Bagged Upright Vacuum
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0384 seconds