Having problems with your Vacuums ?

I do not have the manual for the Kitchenaid Coffeemaker, Model# KCM111OB. How do you set the AUTO timer? I can program the clock but cannot figure how to set the AUTO so my coffee pot turns on before I go to work. Thank you!

Answers :

Repair Help & Product Troubleshooting for Vacuums

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I do not have the manual for the Kitchenaid Coffeemaker, Model# KCM111OB. How do you set the AUTO timer? I can program the clock but cannot figure how to set the AUTO so my coffee pot turns on before I go to work. Thank you!

... Vacuums

Model 31320 SkyScan Equity Time Clock -- it did not change with DST but I cannot figure out how to manually set the time. Back of clock shows 4 long buttons: MODE YEAR/SEC ALM/DST/C/F MONTH/HR WAVE/ZONE DATE/MIN 12/24 tHANKS

Hi,You press and release the mode button, then press the adjust button. This is what the instructions say to do. However, I see that you don't have an adjust button listed. I would try pressing and releasing the mode button, then pressing ... Vacuums

Hi, the main box where all the wires connect to the sensor has the power on, and i've just noticed the small box where you enter the code to set the alarm does not work, yet the buttons are illuminated, normally the led light displays to show the power but no led's are on, the buttons doesn't work to set the alarm. Can you please hepl, many thanks.

Difficult as you didn't say what the equipment is but it sounds like there is a problem with communication between the main box and the keypad box. Have someone check that all the wires in the keypad are connected and there is no break in one of the ... Vacuums

I have a kitchenaid artisan coffee machine which is 15 months old just out of warranty. when you start to make an esspresso coffee the machine runs but no water is being pumped through the coffee to the cup you can hear the machine working but no coffee. Thanks Lloyd

Hello lloyd..... There are a few possible causes of this problem. The first is using coffee which is too fine a grind. The second is a machine which needs to be thoroughly cleaned. Most can fix those two areas themselves. The other causes have to ... Vacuums

Singer 327 lower bobbin thread is wild and loopy after I sew...top stitch fine. Just changed to a large thread spool with the heavy remote base and crook to carry thread to machine and wonder if this changed tension (set at 4 and correctly threaded)? It had been working fine in zigzag but I also went back to reg foot and set stitch width at 0, center needle set. Thanks for your input and help. Deanna

... Singer Vacuums


I couldn't find any warranty information on this iron, but I suspect that the heating element either has a faulty connection or part of it has cracked, making contact at time, but poor contact at other times. The unit will have to be taken apart an ... Rowenta Vacuums

Hi, Have a Oster small cappucino machine model 3296-33. Everything was working and I just used it know and the machine will make coffee however the steamer/milk frother is not working? Solutions? Thanks, Amanda

... Vacuums

Sharp carousel double grill convection microwave oven R820JS/R820BC - the start button won't work when we try to cook in microwave. Can use timer, start button works, can set clock etc. but cannot seem to cook in oven.

... Vacuums

Trying to set up a shampooer on the Kirby G4 vacuum. Cannot figure out how to get the dirtbag off in order to set up the shampooer.

See if this link to kerby helps it has a few videos\015\012\015\012http://www.kirby.com/Portals/0/videos.html ... Kirby G4 Bagged Upright Vacuum

Elna 7200. The bobbin spring seems to have come loose, but cannot figure out how to get it in place again, so we cannot work, Pls help.

The best course of action in your case is to take sewing machine center and let them show you how to get it in place. They may even help for free because you might become a potential costumer. I hope that there is a repair center near you. ... Vacuums

On off switch stopped working 3rd one to do so this one cannot be returned to old ? model QPV10.5b nothing on shop vac site and nothing comes up on Digi-key site really do not want to buy 150.00 vac again but cannot find on off switch! thanks for your help

Use a higher amp rated switch. If this is not available, then solder and insulate the wires where switch should be, then install an aftermarket in-line switch. ... Vacuums

No manual with bush slow cooker. 3 settings high low and auto. need to know cooking times and how auto works.

... Vacuums

We have an Equity Insta-Set model 40001 battery-operated clock. We cannot seem to set the time, month and date. The temperature seems to be operating. There was no instruction guide included in this package. Thank you for any assistance. Sincerely, Jan

Good afternoon,Equity has the instructions on their support page, but no actual instruction sheet is available: ... Vacuums

I have a Pelonis Dehumidifier Model MDF 1-20AE. I am not sure how to set the proper settings. It seems the unit is working but blowing out hot air which making the room rather hot. (My previous old dehumidifier did not have this problem.) Is there a User Manual that I can download on line? Thank you very much.

... Pelonis Vacuums

My Sebo X1 stopped working and my husband tested it and determined that the on off switch was not working. I purchased a replacement switch online but I cannot figure out how to remove the old switch. Please can you help?

Www.manualnguide.com/manual/sebo-x1-repair/page/3/\015\012\015\012Above is your user manual, and below is an exploded diagram so you can see where it all goes. Find all the screws lock ... Sebo Automatic X1 Bagged Upright Vacuum

I have a Model #EC-B130 - 4609 and have no directions with it. Battery isn't working - just got radio today. Cannot get outside temperature to work either. Could use some help and some info. Thanks!

... Sharper Image Vacuums

I just purchased this product and used the Turbobrush on 1 chair and it stopped working already. I have gone through my instructions very closely and I cannot figure out why it now will not work. Help!

It seems to be time to take the machine back to where it was purchased for warranty repair or replacement. Good luck! ... Bissell 1425 Little Green ProHeat Handheld Steam Vacuum

My Sebo X1 stopped working and my husband tested it and determined that the on off switch was not working. I purchased a replacement switch online but I cannot figure out how to remove the old switch. Please can you help?

Thanks for your question!I'm sorry that you haven't received an answer yet.The response rate on FixYa FREE questions is usually over 80%, but sometimes questions go un-answered when:1. the question is unclear, incomplete, or poorly ... Sebo Automatic X1 Bagged Upright Vacuum

I bought one of these units last year and it worked great for about 9 months and then it stopped brewing coffee. Not sure what is wrong. It will not heat the water to make the coffee. Any idea as to what could be wrong?? Thank you. Pierre

Hi,Either the heating element is completely corroded with mineral from the water or the heating element has gone bad...If it is not heating at all there is some kind of electrical problem or the element is gone bad... ... Vacuums

Just got a Polti Vaporetto 1020 from someone and cannot get it to work. One yellow light lit up and was on for a few minutes then turned off...and there is nothing...flip the switch on the handle, nothing...flipped other yellow button, nothing...any suggestions? or where I might get directions on how to use it? didn't come with manual. Many thanks. best, pat

... Polti Vaporetto 2400 Canister Steam Vacuum

Upholstery attachment The nozzle doesn't spray properly, the water just pours out (not alot) instead of spraying. It also has very low suction. The upright part seems to be working fine. I cannot figure out how to take it apart so I can look for a clog, when I look into the hose I don't see anything.

May have a problem in the noozle asm on the hose. Hose part #90001335. \015\012 \015\012 ... Hoover F5837-900 SteamVac Supreme Wet/Dry Vacuum

I also have a Hoover upright and I need to replace the electrical cord. I have dimantled the back, where the tools are stored, and the hose. I still cannot find the screws or whatever, to get to the area behind the cord, so I can replace it. I think I will have to take off the bottom too. Has anyone out there tried to do this? It seems crazy. This machine works great so I hope I can also put it back together. Thanks for the help.

Since I do not know your specific model I can only supply you with general instructions. Be aware that most of the time you only need to gain access to the on/off switch to replace the power cord. Also Make sure that you are replacing the existing co ... Vacuums

I have a whirlpool personal valet steamer system that is mounted to the wall. The system was in the house when I purchased it so I would suspect it's about 8 - 10 years old and I cannot find the manual for it. When I push the start button it automaitcally cancels the set up and will not run. I have unplugged it for a while and then put it back in and it's worked before but not anly longer. How do i get a manual or can I find a repair person to look at it.

... Vacuums

I have a Bissell steam shampoorer..I'm not sure where the water goes. I assume in the bladder (soap & water)..there is a little red plastic piece that I don't know where it goes..somewhere in the bladder?..Anyway, no solution is coming out and of course no vacumming up. Cannot find my manual or instructions. I've had it working before..thanks

Hi,Here is a tip that will give you all the information you need to fix your BissellProheat Vacuum Problem.Bissell Proheat Upright Wet/ ... Bissell ProHeat Turbo Deep Cleaner Upright Steam Vacuum

I have a carpet magic steam machine. The pump worked fine yesterday. Today, I cannot get the pump to prime. (The solution resevoir is full.) Is there anything I can do to help prime the pump? Thanks for any help!

... Vacuums
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mictaservice.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0874 seconds